access to the video mode in Skype Windows encounters a problem and closes

Similar Questions

• When I try to make a video call via Skype. I can see and hear the people on the other end, but they cannot hear me.

  I just got a new laptop with the latest softwear Microsoft and McAfee. Everything works fine EXCEPT when I try to make a video call via Skype. I can see and hear the people on the other end, but they cannot hear me.  The microphone settings seem to be OK.  the antivirus that was installed would cause the problem?  I tried to ask Skype. but do not seem to be able to communicate with them...

  The following support Skype may have something that will help: http://support.skype.com/en-us/category/CALL_QUALITY/

• On windows, the command prompt window (XP) start appears and closes what can be the problem

  On windows, the command prompt window (XP) start appears and closes with 2 to 3 seconds what can be the problem

  Hello
  I suggest you to follow these steps and check if that helps:

  Method 1:

  Start the computer in safe mode and check if the same problem occurs:

  http://www.Microsoft.com/resources/documentation/Windows/XP/all/proddocs/en-us/boot_failsafe.mspx?mfr=true

  Method 2:

  Try to perform the clean boot and check if it helps:

  http://support.Microsoft.com/kb/310353

  NOTE: When you are finished troubleshooting, make sure that you put the computer in mode normal startup such as suggested in the article.

  Check if that helps.

• When youtube ask me if I used to open the video full screen, I press none by mistike and save it the mozilla and now I can't open full screen more, what to do

  When youtube ask me if I used to open the video full screen, I press none by mistike and save it the mozilla and now I can't open full screen more, what to do

  Hello ronbn1, while you are on youtube.com, make a right click on a blank spot on the page, go to view page info > permissions and re - activate the approval of full screen in the list.

• Windows Services has problems and get the error code 80246008 when I try to update windows

  I have 64 bit Vista Home Premium.  I have disabled UAC for short time (just to stop and restart).  Immediately, Windows Services has problems and my services files seem to suffer (fixit would not fixit).  He could have a latent virus that only suspended in no time I had disabled UAC?  I run the computer as an administrator, which I now realize is a problem.  I have a firewall and protection ESET and had all updates until two days ago, if that's any help.

  Also note: BITS of problems that seem to be linked to the system events to COM + service problem - she won't start - error 230: the pipe state is invalid.

  1. http://support.microsoft.com/kb/956706

  Error message when you search for available updates on the Windows Update Web site or on the Microsoft Update Web site: "0 x 80246008.

  2. http://support.microsoft.com/kb/910337
  If the fixit does not work in the article, read the article to other troubleshooting suggestions.

  PS - repair tool: http://www.microsoft.com/en-au/download/details.aspx?id=7997 (64-bit)

• Can someone tell me if I should delete the following startup programs for Windows 7: customer ComcastAntispy and FlexNet connect?

  Can someone tell me if I should delete the following startup programs for Windows 7: customer ComcastAntispy and FlexNet connect?  I have read several articles and most of them say that I should remove.

  Original title: startup programs in Windows 7

  They are third-party programs and only you can know if you need and uninstall, if so

• I would disable the adobe one of my windows system creative license and want to activate the license even on MAC. Kindly give me the wise steps to do...

  I would disable the adobe one of my windows system creative license and want to activate the license even on MAC. Kindly give me the wise steps to do...

  Hi ano.

  First of all, you can follow the article: connect and disconnect activate Cloud Creative applications which help to deactivate the license of the existing computer. Once this is done, then you can follow the article: download and install Adobe Creative Cloud apps that will help you to install the application on your second machine.

  Let us know if it works or not.

  Thank you
  Yann Arora

• Buttons on the right side of my window a 'comment' field and 'fill and sign' open whenever I open a document. In order to read the text, I need to minimize this field. As I open many documents every day I change the settings so

  Buttons on the right side of my window a 'comment' field and 'fill and sign' open whenever I open a document. In order to read the text, I need to minimize this field. As I open many documents every day, I would like to change the settings so that this field is reduced by default. Is this possible?

  Hi joelh68258411,

  The issue was already fixed in the update, please refer to this note of release hide the tools Panel in Acrobat and Acrobat Reader DC at all times.

  Kind regards

  Nicos

• Skype says he has encountered a problem and closes immediately

  Skype says he has encountered a problem and closes immediately.  Windows is looking for the solution?  What should I do to get Skype to work?

  Original title: network programs network networking Internet Web site Site Web Web Site URL

  The following support Skype can help:

  http://support.Skype.com/en-us/FAQ/FA10634/how-can-I-completely-uninstall-and-then-reinstall-Skype

  http://support.Skype.com/en-us/FAQ/FA10382/why-does-Skype-crash-on-my-computer

  If those who do not help, Skype has its own forum that may be useful: http://community.skype.com/t5/English/ct-p/English?profile.language=en

• I want to use the digital books from the library, but Explorer encounters a problem and needs to close when I try to get the security update.

  I want to use the digital books in the library. When I try to use the link below to get the media player update security, as soon as I got to the page, I get a a get several times the same error - Internet Explorer has encountered a problem and must be closed and the page goes dead. Explorer trys to regen of the page, but it keeps getting an error. What should I do now?

  You can download the upgrade of Windows Media Play Security 2.5.0.1 under the following link.
  
  The security component upgrade
  http://drmlicense.one.Microsoft.com/Indivsite/en/indivit.asp

  Hello

  Follow the steps below and check, if it helps:

  1 reset the management of digital rights (DRM):

  a. Click Start, click Run, type explorer.exe and then click OK.

  b. on the Tools menu, click on Folder Options and then click the view tab.

  (c) in the area of advanced settings, under hidden files and folders, click Show hidden files and folders.

  d. clear the skin protected operating system files check box and then click OK.

  e. Locate the DRM folder on the hard drive. The DRM folder is usually located at the following location: C:\Documents and Settings\All Users\DRM Windows

  f. rename the folder to DRMbackup DRM.

  2 remove the DRM registry key:

  Important: This section, method, or task contains steps that tell you how to modify the registry. However, serious problems can occur if you modify the registry incorrectly. Therefore, make sure that you proceed with caution. For added protection, back up the registry before you edit it. Then you can restore the registry if a problem occurs. For more information about how to back up and restore the registry, click on the number below to view the article in the Microsoft Knowledge Base: How do I back up and restore the registry in Windows: http://support.microsoft.com/kb/322756

  a. close all open Windows Explorer Windows.

  b. Click Start and then click Run.

  (c) in the Open box, type regedit and then click OK.

  d. look for, and then click the following registry subkey:

  e. HKEY_LOCAL_MACHINE\Software\Microsoft\DRM

  f. remove the key and restart the computer

• money more sunset "files needed to run the Planner missing or corrupted" then program encounters problem and closes. Downloaded multiple times on multiple computers

  money more sunset "files needed to run the Planner missing or corrupted" then program encounters problem and closes. Downloaded multiple times on multiple computers

  Hello

  I suggest you post the same question in Microsoft Technet forum for Microsoft Money Plus Sunset related issues. We have a dedicated team to help you with the problems of Microsoft Money Plus sunset.

  Microsoft Money:

  http://social.Microsoft.com/forums/is/category/money

  Hope this information is useful.

• The print spooler has a problem and closes its doors.

  The print spooler has a problem and closes its doors. This often happens when I'm trying to print something with multiple copies. Any program that I use either Wordperfect or editor he has a problem. It helps that I could restart the computer and it clear, but not even this works now.

  Try to uninstall and reinstall the printers.  Update the drivers for the printers you use.  Try to have both installed printer and see if you can isolate / how printer driver may be involved in the issue.

  Another option to consider is to...

  (Post by marc_lebowski)

  Clear printer spooler files and restart the Spooler Service

  =================================

  1. click on start, type "Services.msc" (without the quotes) in the search box and press ENTER.

  2. double-click on "Printer Spooler" in the Services list.

  3. click on stop, and then click OK.

  4. click on start, type "% WINDIR%\system32\spool\printers" in the search box and press ENTER, remove all files in this folder.

  5. click on start, type "Services.msc" (without the quotes) in the search box and press ENTER.

  6 double click on "Printer Spooler" in the Services list.

  7. click on start. In the Startup Type list, make sure that "Automatic" is selected and click OK.

  See if the problem persists.

• Access to the Safe Mode on Windows 8

  Hello

  I understand sometimes through troubleshooting or for other reasons, there is a need to access safe mode when using windows 8. What many people do not know is Windows 8 does not use F8 at startup to access the secure mode. It needs to be done inside of Windows 8, himself. The screenshots below will show you how to access safe mode when you use Windows 8.

  On the startup screen, click settings:

  

  Then click on change settings for PC:

  

  Click gernal on the left side of the page:

  

  On the right side scroll advanced boot:

  

  The computer then stops, and you want to click on troubleshoot:

  

  Click on advanced options:

  

  Click startup parameters:

  

  You will then see a page that lists information, click Restart on the right:

  

  You will then choose which environment you want to connect to:

  

  I hope this information is useful

• Hi I have a new monitor but when I turn it on it turns on but then disappears and the middle of it, he says display something cannot get the video mode so u can help me change

  Hello

  My name is Karen, I just got a new monitor used, but when you turn it on, it turns on, but then you can't see something that he disappeared and in the middle of the screen it says u can not display this video mode, your help would be great thanks.

  Hi Karen,.

  Welcome to the Microsoft community. According to the description, you are not able to get the display on the monitor.

  ·         What is the full error message?

  I'll help you with this problem. I suggest you follow the steps in the article.

  Troubleshoot monitor and video card

  I hope this helps. Let us know if you need help with Windows related issues. We will be happy to help you.

• The update for the video player is for Windows, I have a Mac, is an another scheduled update?

  I received two notifications that the video player for Firefox should be updated. When I try to install the update, I get the message that it cannot do so because it is impossible to run Windows applications on a Mac. An update is planned for Macs? Also, if an update is only for Windows, is there a way I can indicate that I don't need, so I continue to receive messages?

  You have malicious software! (Yes, Macs can get malware).

  Please remove this extension and see if that helps: MediaPlayer 3.3.2

  You can do this on the page modules. Either:

  • CMD + SHIFT + a
  • "3-bar" menu button (or tools) > Add-ons

  In the left column, click Extensions. Then find this suspicious extension on the right side and remove (or, in case of doubt, disable).

  Often, a link will appear above at least an extension disabled/removed to restart Firefox. You can complete your work on the tab and click one of the links in the last step.

  Which solves the misleading guests?