After the installation of recovery, I am unable to start my Satellite C650

Similar Questions

• Equium L350 - Vista fails to start after the installation of recovery

  Hello world

  I have an Equium L350 after an accident I couldn't restart my pc. I tried to solve by using the recovery f8 menu and it did not work so I contacted Toshiba and got a restore disc. I reinstalled from the disc, after the instalation it said complete installation but visa does not start.
  I get: Windows cannot repair this computer automatically click finished to turn off your pc

  After a format and reinstall my computer broken? He is 13 months here for out of warranty

  Hello

  Normally after the installation of recovery your laptop should work fine again.

  In my opinion, it could be a malfunction of the equipment. Did you test the HARD drive for bad sectors? You can do this with Drive Fitness Test: http://www.hitachigst.com/hdd/support/download.htm#DFT
  Download the ISO image and burn it to a disk. Then you can boot from it and test your HARD drive for errors.

  I also recommend to check the RAM for errors: http://memtest86.com/
  Memtest is a good diagnostic tool for the RAM.

  I hope I could help a bit. :)

• Satellite P100-119 - software after the installation of recovery

  I use a Toshiba Satellite P100-119 since 2006. I want to run the original liveries Product Recovery CD after you back up all my data, so that with a vacuum system, the laptop gets even faster.

  But as there were pre-installed software (office, Toshiba programms) when I bought it, I don't know if they went after the recovery. I do not have CD for these programs, they were just pre-installed and what my Windows xp, should recover fully with the cd?

  Hey Buddy,

  After the installation of recovery, you have the same settings that bought the laptop. With other words recovery disk will restore the box settings.

  Firstly the recovery disk will wipe the entire HARD drive and remove all. After this Windows will be installed all the drivers and tools. In addition, will be also installed software preinstalled such as office, etc. and you can use it again. :)

  Backup all important data like the photo, music, etc. but everything will be removed for a clean install of Windows.

• Problems after the installation of recovery disk

  Hello

  I just reinstalled Windows with my restore disk after that I install all my backups were useless because I had installed and not 32-bit 64-bit applications

  Thanks for this report, but before you begin the installation of recovery, you must know exactly what you're doing that.
  Be careful next time and don t install wrong OS version.

  Bye and good luck

• Satellite M70 - black screen after the installation of recovery

  So far, what I did is put in the Recovery DVD - ROM product. Then when my computer restarts I was invited to restore my computer failing and said. After that he went through this process, that he told me to remove the disc that I did. Now he only get a black screen after the Toshiba screen that gives me options f2 for Setup and f12 for options.

  I don't know what to do now to make my laptop works again. Help, please.

  Hi Zach_1,

  Have you tried to launch the installation of recovery again? Maybe that something was wrong during the first installation, it might have arrived
  Then retry the recovery facility and see what happens.

  If it doesn't work you should try a normal Microsoft disk so determine if the problem is related to hardware or recovery disk.

• Satellite U500 - Code 52 after the installation of recovery

  Hello

  I tried to reinstall my U500. After installtion some devices work not (code 52 in Device Manager).

  It is related to driver signing. When I imagined "disable driver sign" in the F8 boot menu some of them work properly.
  I tried to change bcdedit to ignore driver signing with no luck.

  Please notify.

  Long ago, I had the same machine. I got it several times but I never noticed this problem. did you notice immediately after the recovery image installation or later, after connection to the installation of Internet and Windows updates?

• Satellite L450D - 11G - hangs after the installation of recovery

  The recovery disc provided does not work. After you install all the files, it goes into a boot loop with "installing Windows for the first time, through 'Please wait', for flashing to the top of the home screen and then stop and restart.

  Is there any solution for this?

  Hey Buddy,

  You must wait a few minutes. On my laptop Satellite and Windows 7, I had the same problem. Windows will be reinstalled several times until the installation is complete and you will always see the same screen.

  Don t so worry about this. Everything is ok with your laptop! :)

• Re: Tecra M10 - after the installation of recovery XP - Boot time 3-4 Minutes

  Hey,.

  Hey well Im installing this laptop for a client and I used the XP CD recovery.
  Now every time you start taking 3-4 minutes after the Windows XP logo. Black screen and the HARD disk is almost not in use.

  I get the following in windows logs event: event 7026 - Source: Service control management
  Failed to start or systemdrivers - atapi and PCIIde
  Device Manager is fine, all green

  Google search but found nothing useful. So what can I do the notebook starts up fast as usual?

  Post edited by: HansiHusten

  Hmm, check if the Tempro software is installed.
  If Yes, then you have two options; would it remove the system or if you want to use Tempro then you need to update this tool.

  The Tempro software is a tool of Toshiba which monitors the HARD disk and the operating system and send you a notice if a new update of driver/tool is available on the European driver Toshiba page.
  I deleted this tool because I don t need.

  I have always followed this suggestion; never change a running system you know :)

• Re: Satellite A660 - 11 M - Random freezing after the installation of recovery

  Hello

  I recently bought an A660 - 11 m, which I was happy for a few months and then it started to crash/freeze randomly in windows. I'd do something and then it just would freeze indefinitely, requiring a second 5 press the power button to turn it off manually. The fan and hard drives would continue to work if he did something, or they wouldn't be if I was not doing something at the time (this has happened four times). After that it's the only thing to do would be to reinstall the entire operating system by using the manufacturers recovery disk. The computer will then work fine for a few days or a few weeks (never more than 2 weeks) and it would be demanding full gel reinstall again. I had reinstall my programs every time but I stopped on the last 2 times and it made no difference.

  After that the computer crashed it would then refuse to boot into windows. It would be still stuck just at the moment where the sign of windows appears. I would like to know that he had crashed as the 4 colored dots appear. The computer would simply wants at this point, continually getting stuck there after the reboot of several manual. Once and only once it booted into windows on its own, but it took almost 30 minutes and the computer is very slow and unresponsive. The computer will sometimes start in safe mode, but it varies. I tried Startup Repair tool and all stages of system restore, but none of these work.

  I got to use Acronis true image10 and creating an image of the system which can then replace the whole computer in all 25mins. This saves me time, rather than wait 2 hours or whatever it is to reinstall the toshiba, but becomes quite ridiculous to have to keep re install every two weeks.

  I also tried to buy a stand-alone copy of windows 7 (while recording an image of the partition of toshiba in the case where I need) I think it might be due to all toshiba programs and other bits and pieces that are installed on the computer - it makes much faster startup, but the computer still crashes the same after awhile.

  I am sure its some ware conflicts or driver pretty hard, but I don't know what.

  Any help please!

  Rob

  Hi Rob,

  I m also do not know what exactly is the problem and I believe that no one here can say that just because it s just a user to user forum.

  Fact is that if you have already tried restore factory Toshiba recovery disc multiple times, it s not a software or driver issue because it s an image pre-tested by Toshiba.

  I guess it must be a hardware malfunction and therefore, you should contact a service provider for help. Guys can check your laptop and if it of under warranty, the repair is free.

  You can find a list of aspic here:
  http://EU.computers.Toshiba-Europe.com > support & downloads > find an authorized service provider

  Good luck! :)

• SATELLITE A30 ERROR! AFTER THE INSTALLATION OF RECOVERY DISKS

  INSTALLED BOTH DISKS AS MANUAL... GET THE ERROR MESSAGE... AT THE END OF DISC 2. CAN FIND NO WAY OUT OR FOLLOWING THE INSTALLATION... REMOVED DISC SEVERAL TIMES AND BEGAN THE PROCEEDINGS WITH THE SAME RESULT. NO ERROR; MESSAGE 437... ; CANNOT READ THE FILE... LOADS OF OTHER WRITTEN IS ALSO ON THE SCREEN... I THEN PRESS ESCAPE; AND HE LOOKS LIKE HE NEEDS A CASE NUMBER? NOW I REMOVE THE DISC; I CANNOT START THE SAME PROCEDURE TO NEW NOTHING WORKS ON PC...
  DISKS CAME WITH THE PC AND I'VE USED THEM TWICE MORE EASILY
  LAPTOP CODE A30 (PSA30E) 14 OLD WORK OK SOMETIMES SAID HE WOULD HAVE TO CLOSE BECAUSE THE GENERIC HOST HAD ENCOUNTERED A PROBLEM... RECOVERY DISKS ARE NOT SCRATCHED CAN ANYONE HELP?

  Hello

  upgrade your laptop with a special as material upgrading of RAM or else!
  It may be that an upgrade of hardware are problems when you use the recovery of th disc!

  Alternatively, you can try to reset the default BIOS settings.

  Sammy Bye

• Satellite T110-121 - blue screen after the installation of recovery

  Hello everyone! My name is Melanie and I want to apologize for my English: I m french! I have big problems on my laptop, I will explain:

  I had to install windows yesteday and I used the partition recovery, all worked but the last seetings, my computer fixed: blue screen. I have it reboot and I can log in on windows, now Toshiba software run at the end of the installation: install wireless and bluetouth BUT this software always get it fixed my computer or my screen is frozen, or screen of blus.

  Then, I removed it from the startep of the software list and tried to install the drivers I found on the Toshiba site but for the wireless, I run the software add anything, and for the bluetooth it says error 2753: setupdiu.exe is not marked for installation.

  So I m really disappointed, could you have some tips to help me please? I thought reinstall windows, but I can't reach the recovery: whose touch is?

  I m looking forward getting help.

  My best,

  Mel.

  Hey,.

  I think that something goes wrong when installing recovery and thus you get a blue screen and can t install the WLAN software. The best option would be to run the recovery process.

  But why you can't reach t recovery more? I mean you can use HARD drive recovery as often as you like and you can start if you enter Windows Advanced Boot menu (press F8 before Windows starts) and choose fix my computer. Select Toshiba HDD recovery, then follow the instructions on the screen. Windows will be reinstalled with all drivers and tools.

  Check this box!

• Satellite C55 - A - no USB after the installation of recovery

  Hello

  I have a C55 - A Satellite and last week I have reset the laptop back to factory settings. But now I can't use the USB ports. On the site of Toshiba drivers, I downloaded new drivers but still the same problem. Now I can not use mu or other devices of dusb usb key. Can someone tell me what driver I need to install and where I can find it?

  I have windows 8.1 6 bits.

  I wonder why the USB ports do not work after restoring the laptop...

  Were you running the HARD drive recovery process or have you installed a clean windows system?

  Generally, all drivers are part of the image of Toshiba and all devices should work correctly after the laptop was recovered.

  Have you tried to connect various USB devices; Mouse USB, USB HDD, etc...?
  Your comments would be appreciated.

• Unable to access the computer after the installation of recovery

  I just had to use my drive recovery re - install windows Vista... at the end I wonder, as a newspaper, for... "' another user ' and the password... like the HARD drive has been cleaned and my original user name and password do not work how am I supposed to access my computer?

  Any suggestion would be more useful...
  Thanks Steve

  In General, something like this is not possible.
  Saved on DVD of recovery recovery image is the same you have on the laptop after purchase and first start.
  Have you been asked for username and password when you started your laptop for the first time?

  Anyway, what model of laptop you have exactly?
  Do you use this recovery media for the first time?

• Satellite L670-11R - SD cards were not after the installation of recovery

  Hallo,

  After that I got a virus I couldn't find my SD cards in the workplace (I hope, be called 'place of work' in English').
  So I started the recovery of HARD drive and restore the system to the original terms.

  But now, I have the same problem:
  When I put an SD card in the slot, the dialog box in the lower right shows me, that the drivers have been installed, but I can't find my card. When I put the card SD and back, nothing happens... Only after reinstalling the card-slot-driver from the toshiba-homepage, I can see the dialog box by putting in the SD card. But even once only once and nothing else happens.

  So, I don't know if it's a hardware problem (the slot recognizes the card) or a driver problem (with exactly the same system that everything worked fine a year ago).
  Does anyone have an idea? If possible, please answer in German, if not, I would be very grateful for each answer.

  Timon

  Hello

  As far as I know the laptop L670-11R supports the Realtek card reader controller. I think you should try the Realtek Realtek driver page driver.

  Here you can find the latest version of the driver:
  * PCIE card reader driver for XP/Vista/Win7 *.
  http://www.Realtek.com.tw/downloads/downloadsView.aspx?langid=1&PNid=15&PFID=25&level= 4 & Conn = 3 & DownTypeID = 3 & GetDown = false

• Re: How can I recover my MS Office key after the installation of recovery?

  I restored my computer (laptop TOSHIBA PORTEGE) using HARD drive recovery. Everything worked well and I want to have a new pc now. Unfortunately, I need to save my version of office and 4 digits on the back of my pc have been erased. How can I get the key?

  Thank you for every response.

  As much as I know Toshiba does not offer preinstalled Office product key. It's actually version 60 days.
  Either you use the valid license key if you have already registered it in the past, or you can check-in online.