Apple Watch died after the load.

Similar Questions

• Apple Watch stuck on the load screen

  My watch was almost dead when I put it on the charger, I checked on this shortly after and now it just displays the red indicator (red Flash) and next to the load time. Completely insensitive to everything I do and yes I tried a hard rese, the problem persists. Try to empty the battery and recharge. This to see if anyone else has had this problem and if there is no solutio announcement, thank you.

  Hello

  Your watch is entered mode of power reserve. This happens automatically when the battery reaches a low battery level.

  What you can do for now is to tell the time (by pressing once the button). This is designed to keep this function available as long as possible, until you can recharge the watch again.

  To turn back on your watch: press and hold the side button until you see the Apple logo and wait for your watch to restart.

  However, you need to charge your watch for a little longer first. Try to recharge for at least 2.5 hours, following the instructions here:

  • Check your battery and load your Apple Watch - Apple Support

  More information:

  With the help of power reserve - Apple Support

• Apple Watch back in the range

  I would like to know if the Apple Watch returns in the range with the iPhone, is pushed and shown on the watch notification?

  Hello

  Non - Apple Watch does not provide a notification alert when it comes back within the range of the paired iPhone.

  However, while it is disconnected via Bluetooth, if the watch is also impossible to connect to a Wi - Fi network, known at that time, it will display the icon disconnected at the top of the face of the Watch:

  

  After the devices have reconnected automatically (after back to within reach of the other), this status icon no longer appears on the dial of the watch.

  More information:

  On Bluetooth and Wi - Fi on Apple Watch - Apple Support

• Anyone know when will fixed the problem of material with the "IPAD PRO"? The question that keeps it from starting after the load.

  Anyone know when will fixed the problem of material with the "IPAD PRO"? The question that keeps it from starting after the load.

  According to Apple, it has been addressed in the latest update of the iOS, iOS 9.2.

• Why Apple Watch cannot show the heart rate all implement open outdoor execution on?

  Why Apple Watch cannot show the heart rate all implement open outdoor execution on?

  Technical data has shown that he can do, but in fact can not?

  It is not good advertising. During the race I'm not for the convenience of drag any function. It is wet.

  This link should help you your heart rate. What it means, and where on Apple Watch you will find. -Apple Support

• Apple Watch: can I receive all messages from whatsapp on my Apple Watch, but not the Group whatsapp messages, don't know why... Help, please. Besides, my watch is custom in Spanish, but only answer messages Whatsapp understands English... someone kn

  I can receive all messages from whatsapp on my Apple Watch, but not the Group whatsapp messages, don't know why... Help, please.

  Besides, my watch is custom in Spanish, but only answer messages Whatsapp understands English... anyone know why? Thanks to you all!

  Hello

  To change the language for a response on your watch: Press answer > firmly press the screen > press on choose language > select Spanish.

• Apple removes all functions of the Apple watches sold in the UNITED Arab Emirates, as they do for Iphones and Ipads

  I am considering the purchase of an Apple Watch in the Dubai UAE UNITED. I bought an Ipad in Dubai and was horrified when I discovered that Facetime is disabled on all Apple devices sold in the UNITED Arab Emirates. I want to know is whether Apple are also turning off features Apple Watch som please the Government of the UNITED Arab Emirates?

  Hi, Rodolphe

  There are no regional differences for Apple Watch in hardware or software.

  The included USB adapter pins will be located in the country of purchase.

• After the loading of barbie, equestrian club, his game is ok but the screen is black and doesn't let me do anything

  After the loading of barbie, equestrian club, his game is ok but the screen is black and doesn't let me do anything

  Hello

  1. what operating system is installed on your computer?
  2. is it works much earlier?
  3. don't you make changes before the problem?

  Check if the game is compatible with Windows 7 Compatibility Web site. The game mentioned above is not listed in the compatibility Web site, it may or may not be compatible with Windows 7.

  I suggest that you follow these steps and check if the problem persists.

  Step 1:

  Update of your display drivers and check if the problem persists.

  Step 2:

  Reduce hardware acceleration and check.
   
  a. click the Start button, Control Panel.
  b. now, select appearance and personalization. under display, select adjust screen resolution.
  c. now, select adjust the resolution.
  d. click Advanced settings.
  e. now, click the Troubleshooting tab, and select the change settings button.
  f. in the Security dialog box, click on continue.
  g. move the hardware acceleration slider to the third notch.
  h. click OK.
  i. restart Windows.

  Step 3:

  If the game worked fine in the earlier version of the operating system, I suggest you run the game in compatibility mode.

• Vista black screen after the loading bar

  I have the problem that I am assuming that almost all users of Windows Vista have probably experiences - the black screen with the white cursor lonely after the loading bar 'Microsoft Corporation'. Here are the steps that I tried to solve the problem, but have not yet worked:

  • With the help of "last known good configuration" brings back me to the screen and the white slider
  • Go into safe mode which brings back me to the screen and the cursor
  • Activate the video mode low resolution which brings back me to the black screen and a cursor
  • Using Ctrl + SHIFT + ESC to appear during the black screen Task Manager
  • CTRL + Alt + Delete does not work on the black screen
  • I do not have access to the installation CD, as it was preinstalled on the computer

  Yes, as usual, what happened after a windows update - I really should stop waiting for something good to these updates.

  I'm under the original version of Vista Home Premium without service pack - these caused a similar problem, but at least I was able to return the system restore.

  Thank you in advance, I know how useful these forums can be.

  Yes, a new installation of Windows 7 was the way for me. Lucky he composed a back all my documents, however. Thanks for the help all. Unfortunately I have no where near more closely to solve the problem, then when I started.

• I have two Toshiba laptops, and both died after the installation of Windows Vista SP2

  I have two Toshiba laptops, and both died after the installation of the Windows Vista SP2 (home edition).
  Now, it does not... even not start BIOS... Try to boot from the CD, no luck. When WVista SP2 installed and restarted, after a while, he came to the flashing message: 0xC0190036 1183/62494...

  I can't help that if it does not start even. I don't have a CD WVista. Both laptop came pre-installed. In addition, no rescue CD.

  Any help will be appreciated. I really need help.
  Thank you.

  Well, try this:

  1. If the power is off.
  2. Start the laptop and keep press F8
  3. then select restore.

  And? :)

• Apple Watch Sport after bath fertilizer accidental cleaning. Do I have to take home or I have to pay the 69,99 AppleCare or anything like that?

  Last night, I was in the greenhouse and in the greenh we have tubs of water, maybe 150 gallons. They are floating pond plants to keep alive in the winter to save money on these ridiculous plant plives. In any case, I went to adjust the pump which is between 1-2 feet underwater, completely forgetting that I was wearing my beloved watch. The water is full of hydroponic fertilizers to be red-brown. Needless to say, I knocked. It is only in for maybe 10 to 15 seconds, but I thought I was doomed! He immediately flew out, cleared down that I removed the tape and dried as best I could. I know also apple not advise, but I used a very soft vacuum with the smallest attachment that you could imagine. Maybe a half inch in diameter setting suction pipe. The water came out. Dry the front if a fan on the bottom of the next day and charge it for 4 hours this morning. I probably should have waited longer to let him settle down, but the watch seems to work exactly as it should so far. Calls are clear, could be, I've owned that for a month and a half so back is not an option. I have AppleCare +, but they want me to pay the $70.00, according to me, it costs, if something is wrong? It's my fault after all. They have a detector of water on watches? is there a specific way, should I clean fertilizer in water? Thanks for reading my novel and any help would greatly appreciated more than you know.

  Hello

  If you are concerned that you may have damaged your watch, contact Apple support (mail service may be available) or make a Genius Bar reservation to check the warranty. I'm afraid that no one here can tell you that Apple would decide against all costs (it is a community of support based on the user and it is not allowed here to speculate on Apple decisions):

  https://www.Apple.com/support/watch/contact/

  The instructions recommended for the cleaning of your watch are:

  -Remove the charger and turn it off.

  -Clean with a cloth recommended - one that is non-abrasive and lint.

  -If necessary, you can moisten the cloth with water bit.

  -Dry your Apple Watch with a recommended cloth.

  More information: cleaning and port Apple Watch - Apple Support

• My Apple Watch died suddenly

  I bought a Apple Watch in December 2015 and yesterday he died suddenly. I have it plugged into its charger, but it does not turn on. Is it a problem that I can fix myself? If negative, I have another problem. I bought the product in the USA, but I live in the Qatar. It will be my next trip to the United States after expiration of the warranty.

  Thanks in advance for your suggestions.

  Hello..

  "Is it a problem that I can fix myself?

  
  

  If all goes well, Yes.

  Try the above troubleshooting steps > If your Apple Watch does not respond or won't turn on - Apple Support

• Apple Watch waterproof to the water

  I must do something before I want to go swim with my series 2 Watch? Lock it?

  Hello

  Swimming workouts

  Begin a swim practice in the application of the workout on Apple Watch series 2 models automatically activates the lock of the water, which locks the screen to avoid accidental interactions during your workout.

  To complete your workout and to evacuate all the water:

  • Press the digital Crown and side button at the same time (which makes a break from the workout).
  • Turn the digital Crown, which opens the screen and erases all the water inside of the watch (it can make a sound).
  • Forehand and press end.

  Other swimming

  If you plan to get your Apple Watch series 2 wet in other circumstances that when training of swimming - as to the course of General wear in a pool - you can manually lock the screen first and then drain the water from the speaker subsequently:

  • Slide up from the bottom of the face of the watch to open Control Center > tap water from lock to lock the screen.
  • When you're done: turn the digital Crown to unlock the screen and drained the water from the speaker.
  • The lock can also be unexpected water activated and unlocked immediately after exposure to the water.

  After bathing, make sure to clean your Apple Watch series 2 by rinsing them with hot water from the tap. Watch and the band should be dried with a non abrasive and non fluffy cloth.

  Strips of leather and stainless steel (Milanese Loop and Bracelet links) are not water resistant, so should not be worn when swimming.

  More information:

  Work with your Apple Watch - Apple Support

  On the resistance to water Apple Watch - Apple Support

  https://help.Apple.com/watch/#/apd707b42a5e

• Apple Watch freezes during the race

  I used my Apple Watch during a 21K run. I used the training software to monitor my heart rate during the race.

  After the mark at halfway, the screen dimmed, and the screen froze. (stopped adding distance, and heart rate has been replaced by '-'.)

  thinking that it was because of the excessive sweat on the sensors, I tried to wipe the back of the better watch that I have (which is not a lot considering everything that I had on me was wet). by pressing the digital Crown to return the screen to the face of the watch, but whenever I go to the app to drive he would show the same frozen screen.

  It is only after a kilometer (about 7 minutes) made the response to training app and worked normally until the end of the race.

  for the purposes of the workout on my Apple Watch concerns, I had only run 19,71 km instead of the 21 K who I actually ran.

  question: How can I prevent this happening again?

  Hello

  As a first step, if you have not already done so, it can help to upgrade your iPhone and Apple Watch to the latest version of the software, from your iPhone:

  • Update the software on your iPhone, iPad or iPod touch - Apple Support iOS
  • Update the software on your Apple Watch - Apple Support

  It can also help to revive your watch:

  • Restart your Apple Watch - Apple Support

• Apple Watch will record the fibrillation little finger?

  Will be Apple Watch monitor and record the heart rate so that an incident of fibrillation little finger would be visible after the fact by a doctor?

  While the screen of the watch displays your heart rate, it does not record as an instrument of EKG, as the watch is not a certified medical device. It will show your rates and if you feel that you have an incident, you can get it to save your rate once again, otherwise, it doesn't save specific intervals on a regular basis. It is not defined to be able to recognize a change in the rate, and then save.