at the opening of some programs it will run for a few seconds and then show a blue or white screen screen or a screen scratched
occurs when you have a few seconds in the program sometimes it happens on the web
Hello
1 did you change on your computer before this problem?
2. what programs you're talking about?
3. you receive an error message?
4. what anti-virus software is running on your computer?
You can follow the suggestions and check out them.
Method 1
You can run the fix of the article.
Difficulty of Windows system performance slow computer problems
http://support.Microsoft.com/mats/slow_windows_performance/en-us
Method 2
You can follow the procedure in the article.
Slow PC? Optimize your computer for peak performance
http://www.Microsoft.com/athome/Setup/optimize.aspx#fBid=c4ypPwpWrR1
Note: All by performing the check disk on the hard drive if bad sectors are found then check disk will attempt to repair this area, all available data on this sector can be lost.
Method 3
You can check if the problem exists in a clean boot state to see if a third-party service is causing the issue.
How to configure Windows XP to start in a "clean boot" State
http://support.Microsoft.com/kb/310353
Note: After you have used the boot is a way to solve your problem, you can follow these steps to configure Windows XP to start normally.
a. click Startand then click run.
b. type msconfigand click OK.
The System Configuration utility dialog box appears.
c. click on the general tab, click Normal Startup - load all device drivers and servicesand then click OK.
d. When you are prompted, click restart to restart the computer.
Method 4
You can disable temporary of your security software.
a. log in as an administrator on the Windows XP computer.
b. in the notification area in the taskbar, right-click on the icon of the antivirus program.
c. click on disable. Antivirus protection is now disabled.
Note: Antivirus software can help protect your computer against viruses and other security threats. In most cases, you should not disable your antivirus software. If you do not disable temporarily to install other software, you must reactivate as soon as you are finished. If you are connected to the Internet or a network during the time that your antivirus software is disabled, your computer is vulnerable to attacks.
Tags: Windows
Similar Questions
-
Original title: download
Just upgraded to Win.8 when I try and play BBC I player or the BBC radio he will play for about 30 seconds and then starts to put in the memory buffer, all of the ideas.
Hi Mike,.
This could be a problem with Internet streaming on BBC iplayer or BBC radio.
I would like to gather some details related to the query:
(1) is this problem specific to the reader of the BBC or BBC radio? Are you having the same problem watching videos online or listen to music online on the computer?
(2) deal with the issue with a single channel on the radio?
(3) how you try to use the iplayer? It uses the browser? If so, what is the Internet browser?
If this problem is specific to the BBC radio or iplayer, you can post the query on the forum from the BBC to help:
http://www.BBC.co.UK/iPlayer/episode/p0196ln8/The_Forum_Fragility_in_Nature/#
Please get back to us if the issue is not specific to the BBC player and we would be happy to help you come.
-
Hold the head of reading for a few seconds, and then go
Hello world
How to hold the head of a frame for a few seconds and then have the read head continue to play? I don't know how to do this in AS3.
Thank you
Rafa.
These things indicate (to me), you have done a good thing and studied the help files for how to use the function, although you may have considered in the section of AS2. In addition, get rid of them. They are specific to some example were the help files. The bit in quotes is an argument that would be sent to the function, which receives it as arg1. I can only imagine that one of the mistakes was to not to declare the type of argument, that requires AS3, but like I said, just get rid of them altogether. For AS3, things are slightly different, the return value is a uint
Stop();
var setHold:uint = setTimeout (holdPlayhead, 2000);function holdPlayhead () {}
gotoAndPlay (26);
} -
Videos will play for a few seconds and start the buffering again.
Buffering
When I go to watch videos like on MSN or MSNBC buffer? Then play for a few seconds and start
buffering again. Other Web sites that I can watch the video, but most of the videos to start the buffering. I run Windows Vista.
Y at - it a cure?
Thank you-Richard
When I go to watch videos like on MSN or MSNBC buffer? Then play for a few seconds and start
buffering again. Other Web sites that I can watch the video, but most of the videos to start the buffering. I run Windows Vista.
Y at - it a cure?
Thank you-Richard
You download the video more slowly as you watch it. So when he says "buffering", he expects to catch up and download what you are willing to watch next.
This type of internet connection do you have? Dialup? DSL? Cable? Whatever it is, it's too slow for what you do, or do you have some problem that it slows down.
-
Hello world
I have a Vista Ultimate SP2 system and all updates, my hardware is an AMD Athlon 64 x 2 3.2 Ghz with a RAID 0 (2 discs), 4 GB of RAM, video memory shared up to 1 GB, Asus M2A-VM Motherboard.
My problem is that sometimes when you work with any my computer shutdown application package to meet any keyboard or mouse control for 2-3 seconds and suddenly come back with tasks in the queue and fast as usual.
I've updated my Chipset and RAID drivers.
I uninstalled ASUS ACPI Center who could be one of the causes of this problem, rename the executable to Center asus acpi.
I ran TuneUp Disk Doctor to verify my RAID and fix problems
I update and updated my Antivirus ESET Smart Security in order to improve the performance of the process EKRN who sometimes take a large part of the time CPU.
Can someone advice me how track and what tools to use to run a diagnosis of systemd and check if my problem is with the hardware or the operating system?
Kind regards.
JUOX.
Run process monitor. Stop the trace when your problem occurs. Look through the timestamps of the gaps.
See this for an example of the use of Process Monitor to diagnose a deadlock:
http://blogs.technet.com/markrussinovich/archive/2010/01/13/3305263.aspx
-
fact it for about a week now. have ran antivirus scans and asked a lot of people who were not able to help me at the moment.
It looks like a hardware problem. Your monitor, cable or even the video card in your computer goes wrong. My bet is on the screen. Try to swap the monitor with another computer and see if the problem follows the monitor or the computer.
HTH,
JW -
After the installation of 8500 a909n printer works wireless for a few months and then quit?
Wireless worked for two months after the installation of replacement printer, then he stipped works, but still compatible with USB. Technical support phone could not operate either. What should do?
Nothing that I said. The printer was a replacement for one that would not connect at all, then the tech team India talking my client through cannecting it then a few months later it stop responding wireless but worked hard when the USB is connected. I was able to remedy through the convenience store a couple of times and selecting the difficulty of choosing the default printer for the correct choice rather than the fax machine. I chose HP officejet (network). Thank you for your time.
-
How to make a paper with some boxes to fill required for me to sign, and then some other boxes needed for the next person to sign. I want the boxes I've filled to be locked the next person.
Hi johanb64152807,
You can use eSign service, where you can send the document for signatures of several signatories, but the document will be sent to the following signatory after the earlier signed & it is not possible for him to make the changes.
Documents KB for help: -.
- Get started | Cloud of Document Adobe Tutorials
- Quick Installation Guide | Services Adobe eSign
- Send for electronic signature in eSign Adobe Document Cloud services | Adobe Acrobat DC tutorials
- Send agreements and collecting signatures. eSign services
- FREQUENTLY ASKED QUESTIONS | Services Adobe eSign
Kind regards
Nicos -
I installed Creative cloud on my Mac (10.10.5) and when I start the CC icon doesn't appears in the taskbar for a few seconds and disappear it again. CC never opens. I tried to uninstall and install several times. (lightroom 4 has already been installed on the Mac) Any help?
Well in this case I would advice you Contact Customer Care
-
Relatively new MacBook OSX El Cap 11.4
My internet connection is lost at home after a few minutes. I stop the wifi, then turn it back on and it works again for a few minutes and then repeats. It works fine everywhere else?
Please see recommended settings of WiFi routers and access Apple points.
Despite these recommendations, some routers will work better with the latest Mac models if you turn the radio 2.4 GHz mode in settings and only use the 5 GHz. Note, however, that very old devices Apple and some third-party devices can then not connect at all.
Some third party routers have advanced that you may need to change the settings:
The encryption algorithm must be AES.
The group key interval must be 3200.
I can't give you specific instructions on how to change these settings, because all routers are different. Refer to the documentation for the provider.
-
Vista wouldn't boot - the system starts for a few seconds and powers down.
I have a laptop computer HP6915 under Vista Premium. When I turn on the system starts for a few seconds and turns back. I don't know if there is a hardware problem or if Vista is somehow corrupted. I tried to enter the net bios, but the machine does not respond to the F2 command. Ideas?
Hello
Symptoms, especially since it will be impossible to access BIOS, mean that you need a real computer
Shop (not the leeks and the glances at a Best Buy or other stores) or HP support.Support HP & drivers
http://welcome.HP.com/country/us/en/support.htmlContact HP
http://welcome.HP.com/country/us/en/contact_us.htmlHP forums
http://h30434.www3.HP.com/PSG/I hope this helps.
-
The video starts for a few seconds and stops. I think it may have something to do with the project settings match & camera. I have a Canon HF 20. The settings are 30 PF; MPX 24; mode cinema; .mts;. 29.97 frame rate;. Computer (PC) has 16 GB of Ram. Intel7 on video; 85 GB free space-free workplace.
I tried changing the settings in the program, although I don't think that I'm doing it correctly. Video plays perfectly in the canon software. Any ideas? Thanks Steve
Pf30 soul it records progressive, but puts it as interlaced on internal memory.
Better is to implement a project of 30 p manually as elements are likely to be interpreted as 60i
If so, you need to interpret all the clips in the assets of the project at 30 p.
MXP mode means that it has been saved in 24 Mbit/s.
-
When I launch the new photo or the new HDR feature fusion device, they start for about 10 seconds, but then I get the message error "an unknown error has occurred." What should I do?
There is a problem with these models of Leica cameras providing accurate information in the EXIF data F stop. Photomerge for HDR and Panorama will use this information to "mix" the image files. A solution has been found using an EXIF here Editor:
Re: LR/ACR Pano merger combining Glitch
This may or may not be the source of your problem, but worth investigating. Try to use any other device non-Leica and do a quick test Panorama or HDR and see if you get the same message.
-
My computer operating system Mac Pro OS X EL Capitan 10.10.3, ink 13"early 2015 screen off for a few seconds and back on without turning off the unit.
This has happened several times, regardless of the period in which stays on.
Don't know what is happening with your publication details. You posted in space of the Macbook Pro forum & even your profile indicates: ' MacBook Pro (retina, 13-inch, early 2015), OS X Yosemite (10.10.3)..
Your post indicates you are using a Mac Pro, which is a desktop computer and with the help of El Capitan who is 10.11.2 not 10.10.3 which is Yosemite - 'my computer operating system Mac Pro OS X EL Capitan 10.10.3.
-
HELP me get my E mail.
When I turn on my emachine and try to check my e-mail, I get my homepage to google for about 1 second and then the screen turns white with bee.pl.
http://INFOTEP.bee.pl/info.php?avted=; I'm not that day on computers, and many of their functions and a few times I get a little lost in there so if anyone can help me I really appreciate it. Thank you!!!
Hello
1. what operating system do you use?
2. What mail client do you use?
3. you have made any changes to your
4. what site you're talking about?
5. How do you access the webpage?
6. you use Internet explorer or another browser to access the site?
The link give http://infotep.bee.pl/info.php?avted takes me to a blank Web page
Are you referring to http://www.bee.pl/index
Refer to the following, who says that the sites host malware
http://www.Google.com/SafeBrowsing/diagnostic?site=monidopo.bee.pl/
Maybe you are looking for
-
My IDT audio works fine and its works my laptop well, but when I curls upward from my laptop to my TV via a HDMI cable, I output my laptop displays on my TV but no sound from my laptop on my TV came out. I think the problem is because there is someth
-
I want to use my D6200 as a router only. However, after doing a factory reset I can't after installation of genius. It won't let me choose I want to put internet myself and clicking then only responds when I choose to have help of genius or use backu
-
K209a: Questions of K209a printer inkjet
We always buy original cartridges. Black has stopped working - only unique fine lines every inch or two have been printed to a PDF of the IRS form. I removed both cartridges, ran water ove rthem and reinstalled them (after dry for days). Now, the ink
-
Touchpad arrow jumps everywhere how can I fix?
I have a Compaq laptop with windows 7. The arrow for the touchpad jumps around and it takes me three times as long to do a job. How can I make less sensitive or something else to make it more controllable? Any information would be grateful. Thank
-
Hello I have a HP Pavilion dv5 laptop, purchased abt 1.5 years, OS - Windows Vista Home Basic - service Pack2. These last days, I have a problem. Whenever I start my laptop, the touchpad works fine for a while - like 20-30 min and after the error mes