Can you have SMU 1062 q turn on without using the power button

I use a q SMU-1062 for a test project that will take place inside a protective case.  The power button on the chassis will be covered by a plate on the protective case that make it boring and difficult to switch on using the power button on the chassis.  The chassis will be plugged into a power strip of travel - lite which is mounted in the case.  Is it possible that I can have the power to frame on when I turn on the power strip?

I found another route.  In the controller BIOS, I changed the parameters of loss of AC power to TURN on after that AC is returned.  This allows me to use the power strip in my configuration to control the electric network distributed to the controller.  The following steps will describe how I got this.

  1. Power of the SMU-8115 controller.

  2. A message will appear on your screen, press to enter SETUP

  3. Select 'Remove' (quickly, because you don't have a lot of time before the window disappears and the controller continues to load normally.)

  4. This will open the main Menu of the BIOS

  5. Select the Advanced tab (use the arrow keys to highlight the selections and the different tabs, select a setting change with 'enter'

  6. Select > Configuration power and rest

  7. Change the configuration to power on when power is restored.

The controller can be normally close by using the start menu, and "shut down".

Start button / stop of the chassis is still capable of turning the power on to the controller, but now when I shut off the AC power strip and then return power, get the controller chassis.

Tags: NI Hardware

Similar Questions

Maybe you are looking for

  • HP ENVY 2 X: key Fn editing operation. No BIOS option.

    OK, so I searched the forum and found many people ask how to change the operation of the Fn key while it is not necessary to press Fn to use the Fn keys. For example, I use software that I need to use several different of the Fn keys. Instead of simp

  • My office does not send signal to monitor

    HP Pavilion a6200t and Desktop HP vp17 monitor My office does not send signal to monitor. I use the monitor to another computer it works fine.

  • If I delete amd should clean drive, deleting all files I buy Windows XP again?

    As I'm having a lot of problems with some points I did not and have not installed and do not know how they got in my system, I'm using a recovery disk to remove all make up the main drive.  If I do this will I have to buy Windows XP to return to the

  • With the new graphics card failure

    I tried to put a graphics card in my desire to 700-210xt, there graphocs of the motherboard and I need the output HDMI and DVI, which he did not.  I added an ASUS silent 210.  Power on or monitor the work and the computer beeps six times.  Monitor ne

  • Watch British TV in Austria on surface RT

    My daughter has Surface Rt and has lived in Austria for a few months.  How can easily watch catch up TV on the surface?