Card problem its satellite Pro M10

Similar Questions

• How to Exchange card WLAN on Satellite Pro M10?

  Can I replace my card Wi - Fi, and how?

  Hello

  Usually, wireless network card is placed under the small cover on the bottom of the laptop side or under the keyboard. The Satellite Pro M10, it should be placed under the keyboard.

  Keyboard is on most of the portable computer models set with three small screws, but to view them, you must remove the plastic placed between the keyboard and the display piece. It should be removed very gently. If you have no experience I really don't know if you can do it alone. If you do not do so on the right track, you may damage the plastic cover.

  If you try do these alone be very gently. After removing the screws, remove the keyboard and check where is the WLAN card. When you find the card disconnect both wireless LAN cables (black and white) antenna of the wireless LAN card.
  At least open the left and right latches holding the wireless LAN Board and remove it.

  I hope that this brief description will help you.

  Good bye

• Looking for video card for my Satellite Pro M10

  I can't find a replacement of the video card for my M10, I deleted and reinstalled the card and the updated drivers, but the problem persists.

  Can anyone offer a cotact for a card or someone at - it or know of one for sale new or used? I'm in New Zealand

  Please don t mix the laptop and desktop PC technology.
  The mobile graphics card can be upgraded or removed as the on the desktop PC.

  The replacement of the graphics card is not possible.

  In this case, the entire motherboard must be replaced!

• Need of new graphics card for my Satellite Pro M10

  Hello

  I guess that my graphics card is broken because the quality of the screen is bad a flickering with green stripes. Almost impossible to read what is on display. In the list of devices, the graphics card is marked with the yellow triangle symbol.

  Its seems not to be a driver issue because it's the same thing at the start when you get into the bios (before windows xp starts).

  Is it possible to change the graphics card myself? I know, could be difficult, but I guess that I am capable of killing.
  But what card I can use? Now, it's a GeForce4 Go 410.
  Can I take a better as long as it's the same size and the need for cooling than the former? How do you know that you can adapt and where to buy?

  I hope someone can help.

  Thanking you in advance.

  Andreas

  Hello

  Unfortunately, you cannot swap the graphics card because it s soldered on the main PCB (printed circuit board). If theres anything with Exchange of DIY. You will need to swap the whole motherboard to fix this error.
  Then if you still have warranty then bring your machine in an ASP. You can also bring your machine to an ASP when not in warranty, but you will be charged for the Exchange/repair of the motherboard and in your case, it could cost about 300-$500 (I'm just guessing, it can be much more expensive..)

  So if you really want a machine to work again then check this link:

  http://EU.computers.Toshiba-Europe.com/cgi-bin/ToshibaCSG/generic_content.jsp?service=EU&ID=ASP_SUPPORT

  Welcome them

• Re: Satellite Pro M10 - strange Boot problem

  Hello.

  My Satellite Pro M10 has developed a strange problem. It will power with its installed hard drive.

  The yellow light beside of the plug symbol starts flashing. When there is no hard drive not connected, or another hard drive from another trendy laptop it starts fine?

  Please help, thanks in advance,

  Destro

  I don't know how to help you. HARD drive changes and everything will be ok.

  Is - this original hard drive that you got with your laptop?

• Unable to connect to internet wireless - WLAN card non - Satellite Pro M10

  Hi, I just got a second hand toshiba satellite pro M10 and I just of him relandscaped and put windows xp home edition on it. What I would like to be able to do is to connect to my network wireless of families so that I can get rid of all the cables on the floor. My laptop seems to think that there is no wireless card installed well. Now, I had the same problem with the lan cable, but I went on the tosibas Web site and downloaded a patch and update the driver in Device Manager. I am not able to do it with the wireless as there are no drivers to download for it and there is apparently no for this device in the Device Manager. Could someone please help me and tell me what to do and how I can download a patch or fix the problem. Thank you, Andrew Reid

  Hello

  first of all, have you installed the drivers according to the installation instructions?
  If this is not the case, this can cause problems.

  When you see the wireless card works correctly in the Device Manager, check if you get a signal of any router. If there is nothing the card WLAN is defective, or the router works with another standard (a, b, g).

  Good bye

• Satellite pro M10: CPU cooler problems

  Hello
  I am using a Satellite pro M10 1.5 G.
  The cooler cpu or fan, makes a strange noise. It seems that some module between the wheels of a bike. It's very annoying. The pc is not so quiet as it was before.

  What can I do?

  Hello

  It sounds like there is something caught in the cooling that is contagious fans the fan blades. Visually check the fans through the aspiration air grills to see if you can see what it is.

  Unfortunately access to all fans will involve some disassembly so I would try to suck debris on the grids of aspiration of fan with a vacuum cleaner.

  If the problem persists, it may be necessary to take the unit to a Service Agent authorized to check/replace cooling fans.

  HTH

• Satellite Pro M10 - starting problems

  Hello

  I have a Satellite Pro M10, only 2 years old, but has big problems at the start line.

  The message that appears when you turn on it is:

  'Intel(r) Boot Agent FE v4.1.09
  Copyright (C) 1997-2002, Intel Corporation
  PXE - E61: Media test failure, check cable of
  PXE - MOF: Exit Intel Boot Agent.
  Insert system disk in drive.
  Press any key when ready... »

  Now, I talked to a few people and they all say I need a new drive hard etc., but I don't see how replace you it as it looks like it is built in instead of something that can be drawn.

  Also I don't have a system disk, and the guy who provided it has decided not to return my emails?

  Can anyone help please?

  Chris

  Hi Chris,

  It is possible that this notebook you trying to boot from the CD rather than the hard drive. Check in your BIOS settings to make sure that the boot order is correctly specified as HD first. I would not recopmmend change the hard disk at this stage, since it would mean having to restore your system from a recent backup (if you have a) or re-installing the CD recovery.

  HTH

• Satellite Pro M10 attempted to upgrade processor

  Hello

  I tried to upgrade cpu original 400 fsb 1.4 mhz centrino centrino 1.6 mhz 1 MB cache 400 fsb cache 2 MB (SL7EG), it works but only the minimum frequency (+-670 Mhz), it remains each time to the lowest frequency even if a lot of work is invited to the cpu (tried a lot of cpu stress tools).

  I really don' t know how solve this problem... can someone help me please?

  Bios version 1.50, version of the firmware 83,72, 23/05/2003 date of the bios.
  Thanks for advantage

  NB: only in documents from toshiba, the CPU seems to be fully compatible with Satellite PRO M10

  Hey Buddy,

  Just a quick question: you know that upgrading the CPU is not supported by Toshiba?
  With other words, it means that no one can tell if another CPU works correctly, and if you can use the higher speed.

  I guess if you can use t as the higher speed, the CPU is not taken in charge and that s a limitation of the card motherboard/BIOS.

• Satellite Pro M10 displays the characters currupt at startup

  I have a Toshiba Satellite Pro M10 that collapsed. When the system boots, the Toshiba logo seems to have a few points here and there. When displaying messages on the screen during startup, the characters seem corropted. For example, the message "Insert system disk", I and T of the insertion of the word seems to be half upper ASCII characters. The system S is the "less than or equal to sign." and the k of the scratch disk is {.} I already did the following:

  -tried to start with one of my two memory card and I tried the two memory cards.
  -swapped my memory card.
  -reloaded windows and Linux

  I have dropped it once but worked OK for a month after I dropped it. I deleted the operating system, but now seems to have problems to load a CD operatig system (CD works OK). Anyone have an idea what is wrong?

  Thank you
  Peter Loo

  Hello

  You suggested that the cell phone dropped twice.
  Well, you can try to connect the external monitor to the laptop to see if it s a screen failure or malfunction of the graphics card.

  You have problems with the installation of the OS? Maybe there's something wrong with the disk and the HARD disk. But maybe only loses connection is responsible for the problems. Check the pins.

  It is possible that the screen and other devices was damage due to falling down.

• Satellite Pro M10 - horizontal lines on the screen in different areas

  Hi all

  I hope someone can help.
  My Satellite Pro M10 seems to suffer a display problem where I have horizontal lines on the screen in different areas.
  It would be well for 10 minutes and when the laptop seems to warm up this problem begins, then shortly after
  The laptop would crash and enter in a resolution of 800 x 600 16 colors or sometimes freeze.

  Graphic drivers have been resettled, and even a new installation of Windows XP from the recovery CD does not help.
  A reboot doesn't solve what the same thing happens again and after one minute of use, so I thought it might be a video or cooling problem.
  I changed the video card I had a spare part of my last motherboard hoping this would solve the problems, but the problem persists.
  Perhaps a cooling problem? Or problems of motherboard?
  The motherboard has been replaced twice, hoping that this isn't another mobo problem.

  Any advice would be great.

  Thank you.

  Hello

  I m not 100% sure but to me it looks a bit like an overheating problem
  Maybe the graphics card may not be properly cooled after a certain period of time and that's why these strange horizontal lines appear on the screen.

  I wonder how you were able to replace the graphics chip on the motherboard?  :|
  If I m not wrong not the chip is fixed and the replacement is very easy and difficult

  It of always difficult to say what's maybe wrong without running several diagnostic tests in most cases this problem may be related to the defective chip or motherboard and so the following should be checked

  Sorry, but that's all I can suggest.

  Best regards from my friend

• Satellite Pro M10: Cannot get a resolution of 1680 x 1050 px

  Hello

  Recently I have bougth a screen Dell 2005FPW with a native resolution of 1680 x 1050.
  With the standarddrivers of the geforce4 420 go in my satellite pro m10, I can't get this resolution (max 1280 x 1024).
  How can I solve this problem and work to the full capacity of my screen?

  Hello Jorré

  Sorry, but I don't see any problem. The fact is that there is a restriction of the graphics card and if the max resolution is 1280 x 1024 you cannot set upward for external LCD.

  Maybe you can try with something like this http://eshop.macsales.com/item/Viewsonic/VTBOOK/

  Good bye

• How to remove the password of BIOS on Satellite Pro M10

  Hi guys,.

  I searched all over the web to find an answer, but has no success. So I really hope one of you can help out me.

  I have a very old Toshiba Satellite Pro M10 with 512 MB in it. The laptop is protected by a BIOS password that I know. However, the problem is that I want to remove the password of BIOS completely. I know this isn't a big deal, but I find it annoying to type the BIOS password over and over again. Mostly because I am preparing this old lady for my oldest daughter. Furthermore, I just installed Windows 7 and it works well, but I have all the original software Toshiba, for example the HW configuration utility. I expect the download somewhere on the net, but unfortunately this is not as simple as that.

  Any help is appreciated!

  Thank you

  Jeroen

  Hey Buddy,

  It is easy to remove the BIOS password. Follow the instructions posted by Al - eX.
  As new password just enter anything and then the password is removed.

  I m wondering that you have installed Windows 7 on Satellite Pro M10. It is a very old book, and in my opinion Windows XP would be the best choice.
  In addition there are no downloads available for this model and Windows 7 on Toshiba page

• Satellite Pro M10 PS630E does not start after upgrading CPU

  I tried to install a new processor for my Toshiba Satellite Pro M10-PS630E.
  He initially has a 1500, I tried to put a 1766.

  I follow the maintenance manual, later the computer change is not star upward.
  When I connet to power it show that the luminous power of orange/amber color and make 5 flashes, then 3 and then restart blinking.

  My question is "is it posible to do a reset of the bios parametrers" or "reset the CMOS?
  Is it possible to get it working again.

  Hello

  The flashing light means that it has detected a hardware problem on the motherboard!
  Perhaps you have used a wrong CPU and is not compatible.

  Perhaps the BIOS does not support this processor and therefore this flashing error code appears.

  What say you can't update the BIOS! First of all, that's not possible since only focused on the victory of BIOS is available for download. You must run the Windows operating system to update the BIOS.
  Secondly the update of the BIOS won't help you with this problem!

  You must use a CPU that is fully compatible!

  Welcome them

• Satellite Pro M10: image on the screen is very dark

  I have a portable Satellite Pro M10, which has a black screen, i.e. the backlight does not work. There is an image on the screen, but it is very dark. When you connect an external monitor, I get a normal picture on this screen.

  Information from other messages here, I conclude that there is a problem with the backlight of the lcd screen or the inverter. I checked all connections, but it does not solve the problem. If I bring the laptop to a service center how much it will cost about for repair? The thing is 2-3 years, so if it is very expensive I could better get a new laptop.

  I'm sure I'll be able to change the inverter Board myself, but how am I going to be able to determine that the inverter is the problem? How to get a new inverter? Is anyone of you know the number of good product?

  My Pro M10 itself has PS630E-G205Z-OF product number.

  Hello

  I agree with Tobi. You sounds description as a faulty FL inverter.
  This part is placed behind the LCD screen under the lid.
  As mentioned this part isn t very expensive and you could order the partner of Toshiba service in your country. But be aware that if you have no experience of replacement if you ask technicians for assistance.