Computer stuck in the loop of update configuration

Similar Questions

• Windows Vista is stuck in the loop of update, install update 3 of 3, 0% complete.

  I don't have a Vista CD and I can not function in safe mode because it continues to bring back me to the loop. Please notify.

  Hello

  1. you made any hardware or software changes to the computer?

  2. which update is installed?

  3. have you started the installation of updates?

  You can try the troubleshooting provided in the link steps to solve the problem.

  Error: Failed to setup of the Windows updates. Restoration of the changes. Do not turn off your computer when you try to install Windows updates

  http://support.Microsoft.com/kb/949358

  Note: If the steps above do not work, you will need to contact your hardware manufacturer.

  Registry warning

  To do: Important This section, method, or task contains steps that tell you how to modify the registry. However, serious problems can occur if you modify the registry incorrectly. Therefore, make sure that you proceed with caution. For added protection, back up the registry before you edit it. Then you can restore the registry if a problem occurs. For more information about how to back up and restore the registry, click on the number below to view the article in the Microsoft Knowledge Base:

  322756 (http://support.microsoft.com/kb/322756/)

  How to back up and restore the registry in Windows

  I hope this helps.

• My computer is stuck in the loop "Update Configuration". Boots only in safe mode.

  My computer is stuck in the loop "Update Configuration". Boots only in safe mode. I tried to do a system restore, but an error message appears that says:

  To perform an offline system restore, you must specify which Windows installation you want to restore. For example, if the installation is in "C:\Windows:" should be restored, enter the following command: rstrui.exe/OFFLINE:C\Windows

  I typed in the "run" command, and it didn't work either. VIsta came installed on the computer, so I don't have a disc to insert and reboot with. Help, please!

  Thanks, Ben

  OK, I found how to fix this problem.

  Go to this site download and buy the repair for Vista disc. Burn it to a disc.
  This link will guide you in burning instructions
  http://NeoSmart.NET/wiki/display/G/Burning+ISO+images+with+ImgBurn
  Start your computer with the disk and follow the instructions
  http://NeoSmart.NET/wiki/display/G/Burning+ISO+images+with+ImgBurn

• computer stuck in a loop with the update

  laptop has crashed and in safe mode, I uninstalled last update now it is stuck in a loop and cannot configure 3/3 before it crashes again.

  Hello

  I suggest you to th this method.

  Error: Failed to setup of the Windows updates. Restoration of the changes. Do not turn off your computer when you try to install Windows updates

  http://support.Microsoft.com/kb/949358

• PC stuck in a loop of update

  My computer is stuck in a loop of update... I've seen people ask about the same problem and followed the advice that has been given to them, but it did not work for me. It is stuck in safe mode and it wont let me do a cover on it, or do the Offline command prompts. I'm not very good at such things and I'm getting very frustrated. Please can someone help?

  Hello

  ·         You get the error message?

  ·         Are you able to boot to the desktop?

  ·         What exactly do you mean by "blocked in safe mode. ?

  ·         Do you get any error messages when you try to run a recovery?

  ·         You can perform a restore of the system to safe mode?

  You can disconnect all external devices attached such as printer, etc. and check if the problem persists.

  Method 1

  Follow the steps in troubleshooting article KB 949358 and check if that helps.

  An update is not installed successfully when you try to install the update in Windows Vista and Windows 7
  http://support.Microsoft.com/kb/949358

  Method 2:

  Also refer to this article and check if it helps:

  Problems with installing updates

  http://Windows.Microsoft.com/en-us/Windows-Vista/troubleshoot-problems-with-installing-updates

• Garage band stuck in the App Store update

  I've recently updated GarageBand for iOS on my iPad, properly installed but is now stuck in the tab "pending updates".  This isn't really a problem, even if it's annoying to have the new update notification red point on the App Store icon.

  Anyone had this before?

  Hello

  try to clear the cache of the Apple Store files by typing ten times on the icon star on the background. The Appstore is charging and your problem could be solved.

• Lenovo Y410P was stuck in the loop of auto repair, but it came out

  So my Lenovo Y410P was stuck in the loop of auto repair, I tried holding the power button and F11 and on as the third seeks the laptop turned on as usual. But now I'm afraid to turn my phone off, how do I know if the problem is solved? And if it is not, what should I do?

  TookMeAWhile wrote:

  So my Lenovo Y410P was stuck in the loop of auto repair, I tried holding the power button and F11 and on as the third seeks the laptop turned on as usual. But now I'm afraid to turn my phone off, how do I know if the problem is solved? And if it is not, what should I do?

  Check the system for corruption files by running sfc/scannow in an elevated command prompt.

• I get my email on two computers. How to make a computer out of the loop?

  I get my email on two computers. How to make a computer out of the loop without jeopardizing my Comcast email account?

  Using Outlook Express? Go to: tools | Accounts and delete the account. If you think you can it in the future, go to the properties of the account, and under the general tab, simply uncheck: include this account when receiving or synchronization.

  If you are interested, you can receive messages at a time without losing them on one.

  On both machines:

  Tools | Accounts | Mail | Properties | Advanced - Check: leave a copy of messages on the server.

  On a single computer only, make sure to delete messages after X days to satisfy your allocated space that you get from your server.

• Windows Update is stuck on the screen check updates for more than an hour.

  Original title: Windows Update problems

  I just got a new update for Windows 7 and got all my drivers installed. However, Windows Update is stuck on the screen check updates for more than an hour. Everything works except that, and I don't know how to fix it. It has updated two things: the Windows Update Agent 7.6.7600.320 and update for Windows (KB958488). He continues to seek constantly and never find anything.

  Please leave for 5 or 6 hours and if he doesn't find anything:

  Please run the Windows Update Troubleshooter:
  http://go.Microsoft.com/?linkid=9830262

  Please provide details of any problem it reports as not fixed.

• computer is stuck in a loop saying updates are not configured correctly. Coming back from changes, do not tun off your computer

  I tried to update in safe mode but can not even in safe mode. I don't have a hot spare provided with your computer.

  Hello

  What day did you tried to install? You may be able to see once you are on the desktop.

  Step 1: You can try using the know last good configuration option and check.

  Step 2: Try the methods of troubleshooting provided in the article.

  The update is not installed successfully, you receive a message, and the computer restarts when you try to install an update in Windows Vista and Windows 7

  http://support.Microsoft.com/kb/949358

• Satellite C660 - 115 Win7 update stuck in the loop. SOLVED!

  I have a Satellite C660-115 which is stuck in a loop "of despair".
  I am a COMPUTER engineer support and a customer brought this laptop of mine, who was stuck in a loop of repair Win7 (64-bit prem) that simply says Win7 could not be repaired.

  I backed up the profiles of subscribers using Hiren boot CD (done chkdsk as well - everything is OK), and then did a factory restore.
  No problem at all with the restoration.

  Started doing the updates for Win7; SP1 seems to install OK without errors.
  The system then picked up 37 Win7 updates automatically and asked to reset.
  Upon reboot, Win7 entered "drvload.exe" and started an auto repair.
  It took time and the system started OK, but without any sign of SP1, looks so much like system restore to an earlier point?

  I though this update to process 3 times now and each time after that a lot of auto update, the same sequence occurs.

  How to exit this loop? What is causing this problem, which I have never seen before?

  No software has been installed, other than that of the recovery process.
  I even uninstalled McAfee, just in case this could be a problem - no change.

  Ah, just took another look. It is stated in Win7 system registers that the restoration was caused by a corrupted file C:\ci.dll. Google to find it was a sign by a rootkit virus in the HARD Master Boot Record disk (the file ci.dll itself is NOT damaged). Found a fix tool

  http://support.Kaspersky.com/viruses/solutions?QID=208280684

  It identified the rootkit and removed.
  Seems to be OK now!

  Hope this post could help others.
  Of course, the factory restore does not erase the HDD MBR rootkit...

  Thanks for sharing!

• Service pack update is stuck in the loop: 3 3 100%

  Hello.  My wife's cell phone is having this problem after trying to install Service Pack 1 for its Vista Home Premium.
  He joined 'Update 3 3 100% ', then he sits for a while before restarting the whole routine - again and again.  We tried to turn it off, and he took over just after turn it on again.  There is no error code.  Any help would be greatly appreciated.

  Hi Dave,.

  Thanks for posting on the Microsoft answers Forums

  Press and hold the power button until your pc is turned off completely.
  then while the computer is turn on before it gets to the loading windows screen, press F8 key several times until you see
  These options
  (With the arrow keys and down, choose "Last known good configuration" then press enter)
  Safe mode
  Safe mode (with networking)
  Last known good configuration<>
  .
  .
  .
  If this does not work, restart your computer. Perform the same steps, but rather start in SafeMode with network. When you're on the desktop, try to do windows updates and stop and start again. After the updates installed successfully restart computer and boot up normally this time.
  When the computer comes back again to run updates again.

  Please post back and let us know if this information was useful or if you are still needing help.

  Thank you

  Martin
  Microsoft Answers Support Engineer
  Visit our Microsoft answers feedback Forum and let us know what you think

• My computer is stuck on the 3/3 update, and even if I force power off and restart, that just guard on that happening. What can I do?

  I run windows vista on my pc, and every time that I turn it on, it just sits on the 3/3 update and will not progress. Even when I force my PC to power off and restart it, it continues to be. The first time he tried this update, I have dropped about 3 hours and returned to the configuration to update: stage 3 of 3-0% screen. Since it always happens. My pc is unusable because of this. What can I do?

  .. .my computer came pre-installed with vista, so I do not have a disk

  Not that I recommend a repair install, but the manufacturer was required to provide a way to reinstall Windows. If the computer came with a set of disks, there is a hidden partition restore (not to be confused with the restoration of the system) you would use to reinstall Vista.

  Assuming that Vista SP2 is not installed, I recommend you open a free support incident, NIC. See the link in my previous answer. ~ Robear Dyer (PA Bear) ~ MS MVP (that is to say, mail, security, Windows & Update Services) since 2002 ~ WARNING: MS MVPs represent or work for Microsoft

• Mail stuck in the loop. Cannot access same Mail preferences!

  Hello to you all. Can anyone help? I'm trying to set up Mail (in lieu of Thunderbird) I want to use the possibilities of synchronizing with Mail on my other Apple devices. The title says it all, and I have attached a screenshot of what I see. Impossible to do anything, except to force them to leave cannot even open Mail preferences! I'm on iMac with El Capitan Version 10.11.3 Mail Version 9.2 (3112). Henry

  

  Hi Aitchb65,

  Thank you for your participation in the communities of Support from Apple.

  I see that the mail is stuck in a loop and the opening of many windows unexpectedly. Try to run Mail in 'safe mode' by following these steps:

  Open Mail and immediately hold down the SHIFT key until the Mail is opened. This causes the Mail to open without any message or box to the selected letters.

  Of Mail if closes unexpectedly when displaying certain messages.

  If the Mail normally opens, try to update your SMTP settings -Mail (El Capitan): list of outgoing mail server settings.

  You can also delete email accounts in Mail preferences and start over after export and save all important messages. To help in this part, see Mail (El Capitan): Configure Mail with your email accounts and Mail (El Capitan): import / export the mailboxes.

  Sincerely.

• Windows 8 stuck in the loop of auto repair

  Hey,.

  Yesterday, I restarted my computer after installing a program, then it started to do this, it will forever... My last pc I could press F11 or something and enter the system recovery, this PC it brings me to the uefi asrock configuration utility, which I have no idea what to do...

  I can't figure out how to start a system recovery, or how to get in safe mode, I know Win7 I could press F8 and choose my boot method, but that doesn't work here, and all I can find on google is how to start in safe mode when your computer is on and I can get on the desktop which is completely unnecessary, because when you use safe mode if your computer was working...

  Before this happened I used my task manager to modify some applications that run at startup, but it was like Samsung Kies and Adobe stuff, nothing to do with the system, and I don't think that it would anyway.

  Then I was installing tortoisesvn on reboot, this happened...

  It's the time of the final, I need to come back on this PC

  Here is a video of my computer law to market

  http://www.YouTube.com/watch?v=aWRDLM68xWo

  I touched the loop after a windows update on 1/19. If you add up all the hours of research to fix poster we should have everything checked. If m$ has been working on that, we would know. canned response makes me cringe like directv told me to hit the red button... I've exhausted all the solutions I found, and that you do not want free files.