DirecTV + Airport extreme

Similar Questions

• My AirPort Extreme end not implemented with the help of AirPort Utility

  Bought a used AirPort Extreme (Genesis 4) of a person who showed me that he worked at home. When I try to set up as a Wireless extender to my last existing AirPort Extreme, he will not carry out synchronization upward with AirPort Utility. It appears as a new extreme, but get a message 'unexpected error' before or after the name. Have you tried to reset the two while it is powered and turning the as explained in the help.

  When I try to set up as a Wireless extender...

  Gen 4 airport will connect to your existing AirPort Extreme wireless... or... it will connect using wired Ethernet wired, Permanent?

  .. .it will not accomplish the synchronization upward with AirPort Utility.

  Which version of AirPort Utility?  If it's on your Mac... and you don't know what version you have...

  Open AirPort Utility

  Click the AirPort Utility menu in the upper left corner of the screen

  Click on about AirPort Utility

  Report on the version number you see here

  You have an iPhone or a handy iPad that could be used to implement the 4th Gen airport if the problems continue with the help of your Mac?

• Bridge of Airport Extreme wireless

  Hi all

  I have an airport extreme and I wanted to install a wireless bridge.

  IM on the 2nd floor and my router is on the 3rd floor

  my wireless signal is weak on the 2nd floor, so I wanted to bridge so that I get full signal wireless 2nd floor also

  I do not want to use cable (from the router to the most extreme airport)

  can someone explain to me how to do this

  Thank you

  Hi irfan_mu,

  Check this help page: AirPort base stations: install and configure a wireless network extended (802.11n) - Apple Support

• How to fill Airport extreme wth my DSL router

  I am interested to buy an airport extreme and I currently have a DSL WiFi router. can I fill my current setup and then copy it into the new airport extreme, and then turn off my WiFi in my DSL router? in other words, I wish the Airport extreme to be the main WiFi, I hope I'm supposed?

  You cannot copy between dissimilar model routers.

  And there is absolutely no reason and without having to turn off the current router wifi and every reason to leave it on.

  The extreme must be in bridge including the Apple Installer mode to remove the wireless of comments. So I encourage you to just run two wireless networks... (there bandwidth to run 3 without causing problems).

  Create the wireless on the extreme with your own new values wireless... and you connect some Apple devices you want.

  But you can do what you want... just use the existing router SSID in the airport and use his password... However, this can cause problems for clients who expect a single Assembly and find that they are connected to something unknown.

• I want to register to a new Airport extreme

  I am trying to record a new extreme airport bought on Amazon, I don't see where I can do I also bought a 2-year warranty that I have not yet received

  AS FAR AS I KNOW... Airport extreme is a device and not important in the Apple of things.

  There is no available for an Airport Extreme applecare... If you have purchased an extended warranty of 2 years, this is by a third party.

  AppleCare on a computer, an ipad or apple TV covers the Airport Extreme as well.

• set up a branch to the main ethernet using Airport Extreme network

  Could someone help me with this network configuration please?

  I rent an office and we have an ethernet cable coming into our building to the main network (a fiber broadband building next door). The ethernet line give you IP addresses and internet link.

  I would like to set up our own network in our building-

  1 / would put an Airport Extreme there is the ethernet cable and then plug the cable into the WAN port

  2 / I would implement the EA to distribute IP addresses, but using a different pool - so if the main building uses 192.168.1.1 to 192.168.1.256, I would be created my AE to use 10.1.1.1 to 10.1.1.256

  3 / I would then run an ethernet cable between the port LAN on EI to my Netgear 24 port switch.

  4 / I would connect all our other airport extreme and express again our Ethernet switch and put them all to 'bridge mode '. The switch ethernet cables may be connected to the WAN ports on these airports.

  Anyone see any problem here? We would just to have control over our own IP addresses and be able to restart our Airport Extreme, if we must, do not rely on the building next door to the distribution of intellectual property. I know still need to answer on them for the internet connection, but that's fine.

  Thank you!

  It should work. It would be the basis of a network of mobile type.

  A word of caution. With the exception of the "main" AirPort Extreme that performs as a router, connect the other base stations using their respective ports of LAN. We found some inconsistencies when a base station is in bridge mode and the connection is their WAN port.

• AirPort Extreme: extend only 5 GHz network

  I have a Time Capsule 802.11n (4th generation) set up to expand my WiFi network at our show in the stairs.

  The WiFi hotspot, upstairs in my office, is an Airport Extreme 802.11n (5th generation).

  Attached to my TV Sony is a transmitter Brightech DoublePlay HD Bluetooth 4.0, running on the band 2.4 GHz effects seriously communications on my WiFi network (demonstrated unequivocally by the device to the USB port on the TV).

  If I can force time Capsule 802.11n (4th generation) in my living room to expand the WiFi network exclusively on the 5 GHz band.

  I named the Base Station Airport Extreme 802.11n 5 GHz network (5th generation) and have set up time Capsule 802.11n (4th generation) in my living room to expand the 5 GHZ network named (not WiFi Dual Band network) but me uncertain whether time Capsule 802.11n (4th generation) in my living room is locked on the band of 5 GHz. is there a way to check this.

  Appreciate your help, any...

  WiFi performance was dreadful while listening to the sound of movie via Bluetooth head sets, take several hours to be ready to play a movie in iTunes or play will stall and plans several hours to be ready to resume.  If I can lock the time Capsule 802.11n (4th generation) in my living room on the network of WiFi 5 GHz, I think I'll have the trouble of sorting.

  

  

  If I can force time Capsule 802.11n (4th generation) in my living room to expand the WiFi network exclusively on the 5 GHz band.

  Sorry, but no. When you extend an Apple base station, two radio stations are extended.

• My ipad 3 has stopped communicating with my airport extreme.

  My ipad 3 has stopped communicating with my airport extreme.  I rebooted, both so that made a network reset on the ipad.  He sees the airport but does not connect.  It will work on the personal hotspot on my phone.

  Hello

  If your ipad works with a hot spot that's the Aiirport is the problem

  Go to the Apple Web site

  support. Apple.com

  You may need a software update for airport how old is this do you have another

  Router, you can try?

  See you soon

  Brian

• If 2 Airport extreme can stay connected to each other using their LAN ports?

  Hello friends,

  I would like to know if 2 Airport extreme or 1 Airport Extreme and Airport Express can stay connected to each other using LAN ports at the ends? I thought this is the LAN port 1 connected to the WAN port on the 2nd.

  Thank you

  To clarify the issue and the scenario, one of my friend described a typical scenario in which there are 2 AEs. AE1 has an ISP in its port WAN and AE2 has a different ISP in its WAN port. This 2 AE can mutually connected between them by using ports LAN AE1 and AE2 ethernet cable? He said this could be feasible if AE2 remained in bridged mode, without using the ISP attached to its WAN port. I just don't get how this is possible. Friends of the search help.

  Thank you

• The Airport Extreme WiFi intermittent 2nd generation

  I'm having a weird problem with loss of WiFi on my Apple Airport Extreme.

  My 2nd generation that apple Airport Extreme Base Station began to close its WiFi broad signal several times.  It happens usually after 60 minutes or less works very well.  Power on and the new runs for awhile until it stops again the WiFi.  Green light normally forward either static rest without flickering to indicate data transfer, or it will just dark.  Sometimes it will turn off WiFi and then restart WiFi a few minutes later and appear to be good.  But mostly it just stops and I can, he extinguished/turned on to operate correctly with the WiFi again.

  Airport Extreme is connected by ethernet cable to my modem/router main fiber (which is a different floor home) and it is set to "Bridge" Mode  It worked without any problems and I did no changes to my system.  My ISP did update my modem broadband fiber a few weeks ago to a "Virgin Media Hub 3.0"I understand was made by Compal.»  It seems to work perfectly and I have no problems with speed download or reliability in wireframe.  I was away from home for about a week and was able to access my wireless IP camera remotely via my Airport Extreme with no problems.  The problem started almost immediately on my return, but, as I said, I did no changes to my network.  I have never had this kind of problem before with my Airport Extreme.

  I am running OS X Yosemite on an iMac that is connected by a cable ethernet to the Airport Extreme and seems to work very well even when WiFi is de-energized on the Airport Extreme.  Airport utility reports the airport as current firmware version 7.6.7.

  I used network utility, Fing, and it showed that my Airport Extreme has multiple IP addresses, which seem to conflict with the IP address for my three AppleTV.  I manually changed the IP addresses of the Apple TV to another IP address not conflicting, but Fing always shows that my Airport Extreme has three IP addresses and I still have the problem of WiFi.

  Any other suggestions on a probable cause of this problem or the best way to solve the problem would be much appreciated.

  Thank you!

  The question is the 2nd generation AE is now too old.

  I would say the power supply (external or internal) is dying.

  It service life is approximately 5 years... your must be 8 years old. so the solution is simple... buy a new one... or I'll tell... Newish...

• Unable to connect to Airport Extreme after updating iOS 10

  Hey guys.

  OK not sure if anyone else has this problem, but I can't connect to my Airport Extreme update IOS 10 my wife is.

  We all have two iPhone 6 and 64 gb & update at the same time.

  We have an ac 802.11 Airport extreme also an extreme dual band of airport & an express airport which none of us can connect to.

  We can connect to the Home Hub 6 provided by our service provider broadband with no problems but it is only in a part of the House that we are unable to connect to my office or at the back of the House.

  Tried resetting the network settings on the phone thought I might ask before having to try to reset back to factory settings base stations.

  Thank you

  FWIW, I upgraded my iPhone SE 5 and Pro iPad to iOS 10 as well, but knows me not any problems connecting to one of my base station AirPort to Wi - Fi.

  Or the other of your iPhones must all problems connecting to other networks in addition to the Home Hub Wi - Fi? In other words, are they only having problems connecting to your AirPort base station? If Yes, do you have someone nearby who also has an AirPort wireless network that you should check your iPhones with?

  In the meantime, let's take a look at the current configuration of your network. We know that you, at least, three airport base stations. What is the exact models of non - 802.11ac extreme and Express?

  These base stations are all linked back to the Home Hub with Ethernet they are all configured for a mobile network?

• How to create a network redundant ISP failover using 2 Airport Extreme

  Hello friends,

  I have 2 different lines of rented ISP related to my Airport Extreme 2. Was curious to know if these 2 AEs can be interconnected somehow to create a network of ISP failover. Users on AE 1 traffic would be transparent reassigned to the AE 2 and vice versa, if corresponding ISP fails. When the access provider is in place, they will return to their AE in elementary school.

  Thank you.

  Not without a smart dual wan router. That is to say done good load sharing.

  Extreme is about as simple a router you can find... He has the absolute minimum of functionality.

  Users on AE 1 traffic would be reassigned transparent to the AE 2 and vice versa

  You can do this by using some manual intervention... a simple change of entry door is usually sufficient.

• Is there an update for ios10 AirPort Extreme

  My AirPort Extreme has always extended throughout the House - now does not work.  Is there some sort of update?

  If there is no update the firmware it would appear automatically. Open Airport utility. If an update is present, it will inform you.

• How to use Airport Extreme with ethernet leased line

  Hello friends,

  I was wondering if Airport Extreme is a true router, can I connect gout ethernet of my leased line directly in its WAN port, rather than put the provided ISP router between the two? I have lived many positions and all seem to suggest the connection of a cable/dsl modem to the WAN port on the extreme. Not found any information where it shows the ethernet line rented directly linking in the Giga WAN port, without any 2nd device in the meantime.

  If it's possible, then I guess also what public IP provided PSI can be put into the WAN of AE interface. Can someone develop more on it and detail the steps of configuration? Given that EI has basic firewall NAT, I think it's doable, but can someone confirm please.

  Thank you very much.

  Temporarily, if you connect your computer directly to the Ethernet line, can you get a good connection Internet in this way?

  If so, then AIrPort Extreme could function as a router for you, but you are also likely to face a Double NAT error on the network. How well... or, even if... This might work cannot be known until try you it.

  If the computer cannot connect, then what is required of your supplier for the computer to connect and get Internet access?

• How to reset AirPort Extreme 10.11.6 OS? How to work with this pinhole? I'm trying to get rid of this flashing yellow light, which began after I installed a new modem from Comcast.

  How to reset AirPort Extreme 10.11.6 OS? How to work with this pinhole? I'm trying to get rid of this flashing yellow light, which began after I installed a new modem from Comcast.

  How to work with this pinhole?

  Usually a paperclip or toothpick or ball pen.

  Stick it in the hole and reset for about 10 seconds until the front led flashes quickly.

  How to reset AirPort Extreme 10.11.6 OS?

  The software method... Unlike the above material method... is to open airport utility and select restore default settings.

  

  Both methods take you to the same place.

  You can also read the manual...

  Reset to a base station AirPort FAQ - Apple Support