Equium A210-1AS - it gets hot after BIOS update

Similar Questions

• Equium A210-1as turns off during the Bios flash

  Hello group,

  My computer laptop girls off for a flash bios because of blocked fan (dog hairs dust etc.) and its fried bios chip.
  I think that there is a partition on the Bios chip which can upgrade the bios in a critical state of flash using combinations of keys.

  I tried all of this and have a laptop dead yet.
  I contacted someone on the net that sells preloaded Bios chips and instructions to replace them, but I must first of all identify the chip on the card.
  Is there any reading that can identify it for me on a toshiba Equium A210-1as... psafje-005005ks

  Thanks for any help Paul G...

  Hi mate

  Usually it s is not necessary to replace the BIOS ROM chip on the motherboard.
  In most cases, the ROM module has to be reflashed again.
  It seems that the module ROM was not properly flashed and the process interrupted
  The technician of the ASP can reflash the module using a disc of the BIOS crisis.

  I recommend you to get in touch with the guys from the ASP in your country and ask reflash BIOSES.

  Good luck

• Equium A60-173 does not work after bios update

  Computer laptop girls. A lot of windows screen blue/broken files. Who sets. Site Web de Toshiba says 1.8 bios c can stop it again - Web site also announces 1.90 bios. To go with this...

  Tried to Flash the Bios 1.90 which you have to do in the (stupid) windows. Naturally it hangs during the "preparing for the bios update", with only 15% of progress. WAITED a very long time (30-45 minutes) - no progress took place. Had to turn off the machine and had clearly not worked.

  Now the machine will even not respond to the switch. I was expecting a momentary start - but it's like the power switch has been disconnected. Actually attaching the power supply does not even turn on the power light!

  Can a flash failure turn off the machine so much?
  Or would it be another fault (as well!)?

  Thanks for the tips...

  > Not waited a very long time (30-45 minutes) - no progress has occurred. Had to turn off the machine

  Looks like you broke upward from the procedure of updating the BIOS and it's deadly!
  I put t see any other possibility as to contact the ASP in your country for assistance!

  Maybe you are a lucky man and module ROM on the motherboard is not damage and must be flashed only
  Please note that the update of the BIOS is risky! If you use an incorrect BIOS or update wrong procedure can damage the MB

• Equium L20-264: unknown device PCI after Bios Update

  Hi all
  I just updated the bios on my Equium L20-264 (PSL2ZE) to V1.80.
  After restarting windows XP has detected a new PCI device but no driver for it.
  Everything seems to work and all of the devices, I expected were there.
  The name of the device is device PCI PCI\VEN_1002 & DEV_437B & SUBSYS_00000000 & REV_01\3 & 0B0C5 13 c & 0 & A2.
  Any ideas?

  Hello

  Select this device and right click and install or update the driver.
  For the source of driver, please choose this path:
  C:\Windows\System32

  Check if the driver has been found.

• Satellite A110 (PSAB0) running hot after BIOS update

  I've updated the BIOS on my Satellite A110 (PSAB0) to the latest version and now the laptop works warm - fan runs continuously and the battery runs out of full of emptiness in a few minutes.

  Y at - it a setting or an other update to address this problem or how to restore the old BIOS?
  I'm sure that I opted to save the old version during the update, but I can't find it on my laptop.

  Thanks for any help

  Have you tried to reset the BIOS to its default settings?

  Also try to update the Toshiba Power Saver and common Modules and make sure the power options are on dynamic processor to avoid the CPU to run at full speed all the time.

• Equium A210-1AS: Windows unexpectedI/Oerror bootmanager status took place

  Hi everyone, I really hope there, can someone help me today!
  My daughter is in the middle of her GCSE exams and has a problem with its Equium A210 - 1AS.

  It was working fine until last night and now all she gets while booting is:

  "Boot Windows display manager".
  Windows has encountered a problem communicating with a device connected to your computer.

  Thiserror can be caused by unplugging a removable storage device, such as an external USB drive while the appliance is in use, or by faulty hardware such as a hard drive or CD ROM drive which is a failure.
  Make sure that all removable storage is properly connected, and then restart your computer.

  If you continue to receive this error message, contact the manufacturer of the equipment.

  File: \Boot\BCD
  Info: An unexpected i/o error has occurred.
  ENTER = continue»

  She said she had her sex cam plugged and I tried to restart and reconnected, but this has not solved the problem.

  There, can someone help me please because we are desperate to work on his pc!

  Thanks a lot if you can.

  Kind regards
  A

  Hello

  > She says she had her sex cam plugged and I tried to restart and reconnected, but this did not solve the problem

  Is this means that the laptop can not boot Windows OS?
  Please disconnect any external devices. Then switch on and press F8.
  Now you should see the advanced boot menu.
  Please check if you start the machine in safe mode.

  Otherwise I recommend the BIOS.
  Ensure that the HARD drive has been recognized by the BIOS.
  If there is just no drive listed then the HARD drive could malfunctions.
  If the HARD drive is there, so you must set it as first boot device.

  If anything would help him, then a system restore would be desirable.

• A few problems with my Equium A210-1AS

  OK, having some problems with my Equium A210-1AS and if all goes well there's a simple answer that someone here will know...

  First of all how hot is the laptop supposed to get... Mine seems to get the point where it is bad uncomfortable typing as the areas around the mouse pad plastic get really hot and the underside of the laptop is very hot, too... but this is crazy as the system itself was never to the point of crashing or anything through heat... Well well not that i know of anyway.

  The second question that I met while surfing on the net as is every now and then it seems the internet just completely dies and is loading not pages... It's the same thing on Internet explore, firefox and chrome! None of them will display websites - and that's with or without firewalls - it get just halfway through the loading status bit bar and you're nothing... If I close one of internet browsers and try and open them again he won't let me as I said there is still a version running... and when I go in the Manager of tasks, there is nothing in the window but the browser process is still running under the tab process... and no mater how many times you click it and end the process there is always there... The only way I can get rid of it or get the internet is to make a hard re-boot... which seems to take forever to shutdown before restarting (or quckily if I hold down the power button, but I do not do that!)

  Get IT is really annoying! as it is not within the time limits or any of some websites that I can pin point... It is randomly... sometimes as fast as 5 minutes... Other times, it can go more than 8 hours and stay working...

  It is not the router connection or by phone if my desktop machine works no stop without problem as do other cell phones in the House... It's just what seems to be the problem.

  Computer laptop im wise under a Toshiba A210-1AS with Windows Vista Home Premium service pack 1...

  So any ideas what could be the problem or, more importantly, a solution!

  On the first problem: I would like to clean the fan. Do not disassemble the laptop. Use the jet of compressed air and could blow the dust from the cooling fans.
  If you have any success with this tip, I would go to a local ASP. They should check your laptop.

  For the second question I would first do a driver update from the LAN or WLAN. Furthermore, this type of connection you are using?
  If you use WLAN make you the laptop and the router uses the same standard. In addition, the intensity of the signal should be good or very good.

  Tell me what happened.

• Equium A210-1AS: Touchpad problem - the mouse becomes unusable

  Hello

  I have problems with the touchpad of my laptop Equium A210-1AS.
  After some time of use of the mouse becomes unusable and just starts bouncing around the screen and becomes uncontrollable.

  The only solution then is to unplug the laptop and turn the power off, re start the touchpad works again.

  I use Windows Vista and downloaded the latest touchpad drivers.

  Any help would be appreciated.

  See you soon
  Widdy1961

  This problem very strange s.
  Could you please tell me if this problem occurs after you reinstall the OS from the Toshiba Recovery CD?
  I read on several forums of Vista that some Microsoft Vista updates may have a bad influence on the touchpad driver
  Therefore, it would be very interesting to know if this problem appears immediately after the use of the recovery CD.

  Greetings

• Equium A210-1AS sometimes stops

  My recently purchased Equium A210-1AS sometimes completely cut and the screen is blank. Someone knows why?

  Maybe a little better explanation of the problem can help to better understand what's happening exactly and how many times.

• Re: Equium A210-1AS - blue screen and cannot start

  My computer was working fine, I stopped him, the next time I start up, it shows windows loading screen, then a second a blue screen flashes by, it restarts and repeats, I stopped and began to tap F8 until the advanced boot options appears, safemode ect... None of them work and lead all the blue screen If I select the repair option at the top 'Repair your computer' it begins to load with a background of vista and a cursor and then displays the error "the installed program cannot start. Click OK to turn off the computer. »

  in Advanced Startup Options that I try "disable automatic restart in the event of system failure" and the rest of the blue screen to the top, so I can see, it shows an error on usual blue screen, read:

  UNMOUNTABLE_BOOT_VOLUME
  STOP: 0X000000ED (0X85DDA600, 0 X 0000000, 0XC000009C, 0 X 0000000)

  I don't have a recovery CD, as I believe, there is a recovery partition, but I don't know how to access it-
  I use Equium A210-1AS
  Part number: PSAFJE-005005KS
  Windows vista 32 bit

  Thank you

  I know know that the recovery partition is consulted theough 'Repair your computer' but shows just "the installed program cannot start. Click OK to turn off the computer. »  :/

  null

  > I don't have a recovery CD as I believe, there is a recovery partition, but I don't know how to access to this

  http://forums.computers.Toshiba-Europe.com/forums/Ann.jspa?annID=58

• Question about the power of the battery on Equium A210-1AS

  Hello...

  the battery on my Equium A210-1as life is supposed to be around 2 and a half hour but it s more in 20 minutes.
  No idea why?

  That sounds like a bad battery.
  I think that Windows displays a fully charged battery or not loading stops at XX %?

  If your laptop is still under warranty, go to a local ASP and allow your battery to change.

  If your computer laptop doesn t have guaranteed, an ASP may also make a bid for a new battery. This part doesn't have to be so expensive.

• Unknown device on the Satellite A100-153, after BIOS update to 5.1

  ACPI\TOS1901 * TOS1901<--- this="" is="" the="" unknown="" device="" after="" bios="" update="" to="" 5.10="" on="" my="" satellite="" a100-153="">

  Vista now shows it in as unknown device manager; the TOS1900 showed up too, but after installation of Toshiba Value Pack for Vista, it went.

  Help, please. WHICH IS: ACPI\TOS1901 * TOS1901

  Hello

  ACPI-> Advanced Configuration and Power Interface
  ACPI defines hardware and software interfaces that allow focus on the OS configuration and power management to enumerate and configure motherboard devices.
  For example: ACPI is necessary for the standby and hibernation mode.

  Now your question; the new BIOS has been updated and configured to using VISTA.
  It seems that VISTA was not compatible with the previous version of BIOS because the ACPI interface. Now you can install Vista on the laptop, but it seems that you need a driver. Possibly new chipset driver version might help. But as you probably know, the drivers are not available at this time. Unfortunately

• Satellite L450D - 13 X - blue screen after BIOS update

  I have the blue screen after BIOS update. Satellite L450D - 13 X worked ok before that ideas?

  Is there contact information for Support TOSHIBA?

  Hey,.

  > Is there any TOSHIBA support contact information?
  No, becaue, must contact an authorized service provider. Guys can help on any hardware and software problems and can also order spare parts from Toshiba.

  Here is a list of aspic, where you can look closer:
  http://EU.computers.Toshiba-Europe.com/innovation/generic/ASP_SUPPORT

  Good luck! :)
  ?

• Equium A210-1AS - after update BIOS screen no longer works

  I tried to find the same problem but impossible.

  I had to reinstall Windows Vista after mistakes with programs (recovery was useless so install fress was necessary) and everything worked fine. I downloaded all the drivers and updates section of drivers Toshiba, I installed the ATI graphics driver, then update the BIOS.
  While the closed laptop, now when I turn it on, the fan on the works of graphics card, battery, power and load turns on but the screen remains off (not illuminated). I tried an external monitor and the same problem again. As the screen worked fine until the update im guessing its something that the BIOS has done, or the graphics update.

  TOSHIBA SATELLITE A210 - 1AS
  PSAFJE
  -AMD Turion 64 X 2 Dual-Core Mobile Technology TL-58-
  Genuine Windows® Vista® Home Premium edition-
  DVD Super Multi (Double Layer) drive-
  2 048 (1 024 + 1 024) MB of RAM DDR2 (667 MHz)-
  15.4 "TFT display 1280 x 800

  Thanks to all who can help.

  To me, it sounds like the update of the BIOS's not on your laptop. If the BIOS update fails more often than computer start doesn t more you can see anything on the screen but you can hear the fan, etc.

  In any case, you can try this workaround: remove the battery and the AC adapter. Wait an hour and then reconnect the two devices. Now try to start Notepad and hope this works ;)

  If it doesn't work, you should contact the nearest authorized service provider. Technicians can try to reflash the ROM module

  Good luck!

• Equium A210-1AS - cannot update windows Vista

  Hello

  I have about a new A210-1AS Equium with Vista on it. I could not update the OS and Im having the same problem with norton 2007

  Did you get any error messages?
  What s wrong exactly?

  Maybe your firewall doesn't allow updates?