Equium A60 go in standby mode after the reinstallation of the OS

Similar Questions

• Equium A60-173 does not start after the BIOS update

  Hello people,

  I downloaded a BIOS updated toshiba for my Equium A60 - 173 and while it was loading on, restarted my laptop. Now, whenever I turn it on, the power light comes on for a few seconds, there is nothing on the screen and then it turns off again. I'm really worried, I've done some serious damage. I know a bit of the BIOS, but not that much. I need help, this is how I put a BIOS on here if I can't turn it on and the current one is damaged. Is it possible to get the loaded BIOS on without being able to turn it on?

  Any help will be greatly appreciated! Thanks in advance.

  Concerning
  James

  You could try to remove the battery, wait 2 minutes and then go back, however he only its not very likely that your BIOS update was not successful. If I remember correctly when I flashed my A60-181 this process takes about 10 minutes. If your laptop prematurely reloaded until the program has finished, I'm afraid you have no choice but to send new to Toshiba to be fixed.

  Richard S.

• Equium A60-692 - no power and removing the HARD drive

  The power has gone on my A60-692, the adapter is ok but there is just no no LED on the laptop. I had to get replaced a few years ago so maybe it is related to that of the power connector.

  I took to a local repair place, he said, it would cost more to fix this, so I should really find it useful laptop only think about recover my data.

  Is it really so hard to fix these things?
  How hard is it to make the hard drive out, & how would then access down my data?

  Thank you
  Dave

  Hello

  > I took to a local repair place, he said, it would cost more to fix this, so I should really find it useful laptop only think about recover my data.
  I agree with the authorized service provider. My personal opinion is that it s a malfunction of the motherboard and it is a very expensive part. Besides, Equium A60 is pretty old model so it would be better buy you a new laptop and recover your data.

  > How difficult is it to make the hard drive out, & how would then access down my data?
  It of not difficult, but I m really wondering why you need access to these data. You don t have a backup? In my opinion the backup is the most important thing you need to do on a computer.
  Anyway, normally on the underside of your laptop there is a HARD drive cover which is guaranteed by one or two screws. You must remove this cover and then you can see the HARD drive and you're able to remove it.
  Also buy an external HARD drive enclosure where you can install the HARD drive. Then you can connect it to another computer to back up your data. ;)

• Equium A60-157 PSA67E: where to find the Toshiba common module

  Slowly work his problems but can someone tell me what is the "Toshiba common module" as one of the programs will not because he can't find it.

  Also the Intervideo windvd v5.0b11.288 - srs has been modified to Toshiba systems and it's around anywhere?

  Thank you very much David

  Hello

  I checked the Equium A60 driver download area and there is no common module for download.
  In General, the common Module is a tool for Win XP that is required for the execution of other tools of Toshiba correctly.

  I guess that common Modules are not necessary for this model of laptop.

  With regard to the windvd: WinDVD can be downloaded from the Toshiba page, because it is not a tool of Toshiba and this tool has been a part of the recovery disk

• Equium L350 - Vista fails to start after the installation of recovery

  Hello world

  I have an Equium L350 after an accident I couldn't restart my pc. I tried to solve by using the recovery f8 menu and it did not work so I contacted Toshiba and got a restore disc. I reinstalled from the disc, after the instalation it said complete installation but visa does not start.
  I get: Windows cannot repair this computer automatically click finished to turn off your pc

  After a format and reinstall my computer broken? He is 13 months here for out of warranty

  Hello

  Normally after the installation of recovery your laptop should work fine again.

  In my opinion, it could be a malfunction of the equipment. Did you test the HARD drive for bad sectors? You can do this with Drive Fitness Test: http://www.hitachigst.com/hdd/support/download.htm#DFT
  Download the ISO image and burn it to a disk. Then you can boot from it and test your HARD drive for errors.

  I also recommend to check the RAM for errors: http://memtest86.com/
  Memtest is a good diagnostic tool for the RAM.

  I hope I could help a bit. :)

• Equium A60 - DVD player does not read the data disks

  Hello

  I'm having a problem with my DVD drive on my laptop Toshiba Equium A60. The DVD drive (Pioneer DVD - RW DVR-K13A) will play store bought movies etc. without problem. He will also read a blank DVD when you put it in the drive, but once the information/data are on the disc, it won t detect the drive.

  I'm not really good with computer so any help would be grateful. The computer used for any play he stopped just do a few months back.

  Many thanks, Phil

  Hello Phil

  It is not easy to find explanations for these issues. What you can try is to create own data CD and check if the drive can read. I recommend buying a blank DVD-R from TDK. Over the past 7 years I never had no problem read/write TDK media.

  Media that cannot be read properly? Is - this DVD-R, DVD - RW, DVD + R or a DVD + RW?
  Please give us more information.

• Equium A60-155 died - how to change the motherboard?

  Hello

  A week ago, I used my laptop Equium A60-155, I turned it off for the night. The next morning, he lights up no battery or AC, the lights on the front of the LT do not come on either.

  I tested the AC and it is very much pushing the 14.8V.

  On another forum suggested to abolish the HD to see if that would help (it didn't).

  So it might be that the MOBOs dead (in which case I'll have to buy a new one when I get a job, or internal theers fuse who jumped (if it exists).)

  If there is an internal fuse can I replace it myself and what is? (I'm on a job and can not afford the repair costs, some charge 70 Quid to pick it up, and another Bill 110 quid + parts)

  I guess it's just a matter of undoing the screws on the bottom?

  Hello

  I suggest also to contact the ASP in your country, because he can do a diagnostic test and can give you a detailed response.
  Maybe you n t need to change the Board of Directors, and perhaps only the part low cost has a failure.
  But to find out the laptop must be verified.

• Equium A60 - I'd like to update the RAM

  I have an Equium A60 with 256 MB of RAM - I would like to upgrade to as much RAM as possible

  Can anyone tell what is the maximum amount of RAM I can crack and what kind of RAM I need?

  Thank you...

  Hi guys

  I checked the manual and it says that you can use the 256 MB, 512 MB and 1 GB PC2100 or PC2700 RAM memory module can be improved up to 1.5 GB (1 GB + 512 MB) why?
  Because it has 512 MB internal memory, which is NOT removable!

  A module can be inserted into the slot that is placed at the bottom of the unit
  You should see a slot cover in the middle of the Panel which is fixed with a screw.
  Remove this screw and you would be abele to remove the cover of the location too.

  More details are mentioned in the user manual!

• Equium A60-155: energy saver ends at the beginning upward

  I had a lot of problems with breaking that I did a new install, but when I put all the drivers and stuff on the eve software power puts an end to started and I can not install hotkey-dd-xp-10008sa-en. It says drivers not found.
  I used a Xp slipstreamed sp2 installation disc got the updates that I needed Microsoft.

  Can the poster me an iso of the original installation disk for Equium A60 - 155 that I've not had one, or we shed some light on the problem

  Hello

  I guess you can not install the Toshiba Power Saver because you use an order of bad installation.
  All important information about the installation of the driver s you will find on the page of Toshiba diver.

  In addition, if you have installed the SP2 of Microsoft so you should check fact sheet Microsoft Windows XP SP2 update on the necessary and important Toshiba updates.

  Good bye

• Equium A60 does not work properly with the Logitech Quickcam Fusion

  If someone managed to use a webcam Logitech Quickcam Fusion with an Equium A60?

  I installed the latest available drivers and software and most of the time it screws right up to the operation of the computer. He ends by crashes so bad that I can't recover even using Manager Windows task! If I leave the USB cable connected to the PC, 9 times out of ten, it won't boot into Windows, until I have remove lead :(

  I installed the same software and drivers on my desktop PC and the device works very well every time and the boots OK with the camera connected to a USB port.

  Two computers use Win XP with SP2 and all updates.

  Hello Bill

  Do you have problems with the USB ports if you are using other devices? I really don? t know what can be the problem. Check the Logitech SUPPORT PAGE

  Maybe you'll find some tips there.

• Equium L40 shows wrong screen resolution after the mode 'sleep'

  Hello

  My Equium L40 in restart mode 'sleep' is always a screen resolution greater than when he went to sleep!
  Someone knows what's going on?

  You have an external monitor attached?

  Have you updated display drivers and BIOS?

  It XP or Vista?

• Drivers are interfering with Windows out of the standby mode after installation of Windows Vista Home Premium Service Pack 2.

  I followed the instructions of service newsletter and reduced to an Intel Graphics Kernel Mode Driver (igdkmd32.sys) that slows him back. The pilot is the more up-to-date version and the update of a windows wants.

  What are my options? I guess I need this driver as is the graphics found in the device manager driver. "Rollback Driver" is not appear as an option. I need to restore Service Pack 2 to resolve this problem? Thanks for your suggestions...

  For issues related to Vista SP2, there is FREE Microsoft Support assistance is available at: https://support.microsoft.com/oas/default.aspx?prid=13014&gprid=582034&st=1&wfxredirect=1.  I suggst contact you and get their expert help for your problem that was caused by SP2.

  I hope this helps.

  Good luck!

  Lorien - MCSA/MCSE/network + / has + - if this post solves your problem, please click the 'Mark as answer' or 'Useful' button at the top of this message. Marking a post as answer, or relatively useful, you help others find the answer more quickly.

• A60: Error Message blue screen after the recovery procedure

  I have an A60 and in the course of the last 3 months, I ran the recovery of 10 to 15 times disc, windows installs fine, then a few days later the computer either freezes and gives a blue screen of death, when you try to turn it on, or it turns on and comes up with a message saying "Windows Explorer has encountered a problem" and then completely stops responding , or gives a similar message on the subject of what we call the Dr. Watson debugger core and similarly, unresponsive, now. After trying to format and analysis as well as on my knees and beg the computer please please please work, I'm out of ideas, the hard drive is perhaps the problem? is this a common fault of A60?

  also in a completely different topic, where can I get a new 'c' key, mine keeps falling off the coast for some reason any.

  Hello

  The blue screen appears usually due to hardware malfunction or bad software.
  If you, I suggest that there could be something wrong with the hardware. Of course there is also something wrong with the HARD drive. But to be 100% sure, you should contact Toshiba service. He can do some diagnostic tests.
  You can also order the additional keys of the Toshiba service partner who is responsible for your country.

• Sat Pro A60 - screen backlight turns off after the connection with the Vodafone 3g data card

  I have a Sam Pro A60 which took a mounted Vodafone 3g data card. It connects OK data card but then the screen becomes 'empty' you can see the icons if you get the light from the window in the right direction, but permanently unusable.

  A reboot and the screen comes back. Are there keys, I can try to put light or ideas to test if it's a hardware or software problem?
  Thanks in advance.

  Hello

  It s a very strange problem. But I'll try my best ;)

  I noticed a similar problem on my second book. The display light didn't stop but the blue screen of death (BSOD) appeared and I could not continue my work.

  After a lengthy investigation, I found some useful tips.
  Someone told me that I have to disable HT technology (Hyper-Threading Technology) in the system BIOS settings.

  It's a key!

  As I remember the Satellite Pro A60 also supports this Hyper-Threading Technology.
  You can disable this function in the Toshiba HWSetup tool, in the CPU tab.

  Check it out and maybe it's a key as in my case.

  Dude good luck

• Equium A60: Is it possible to update the graphics card?

  Because the graphics card in the A60 Equium is not very good and I was wondering if I could get a different graphics card and plug it into the back and used instead.

  If someone could tell me if I can I would be very grateful

  Hello

  No, it s not possible to update the graphics card to another.
  As you certainly know, the laptop technology is not the same as the desktop PC simply. It s the motherboard technology all just different. You know that heat is a bigger problem for every laptop and generally of designer, developer and manufacturing. In addition, the various interfaces are not equal.

  For example: what do you think, why Intel doesn't produce chips with speeds of 10 GHz, 100GHz, or 1000GHz. Because of the heat.

  I think that the graphics card performance will produce more heat, and this could lead to overheating problems.
  The other graphics card needs another module of cooling and the cooling module must be compatible with the motherboard. Everything needs to be changed (the case design, interfaces, etc.) before the upgrade might be possible. In my view it is simply not possible at the moment.