How to recharge the battery of digital camera WX220 disc Cybersht

Cyibershot Sony to the Canada WX220. We live in Italy... How to charge the battery he's dead?

Don't have a charger battery here in Italy and could not find one in the store

Try to use another USB port on your laptop (if it exists) and see if will charge. Some laptops will have 1 USB port with a higher output voltage. If you can not always charge the battery, then you need to get a charger. Check in other stores where cameras are sold locally and see if they can help you. If this isn't the case, then you will need to order one online. With a good charger if it still doen't load so its likely you will need to have the camera repaired.

Edit: Also make sure that your laptop does not go to sleep while it loads.

Tags: Sony Products

Similar Questions

  • How to charge the battery to split x 2

    in my hp splitx2 how to recharge the battery after 1 get fullly battery then only 2 gets battery .my question being made the damage from battery 1 more load, even in the case of discharging.and how to hp requires 8 hours of battery life when he worked as a laptop.

    OK, since the draw, including hp knows... my #1 battery (the Tablet) 84%, battery #2 (base) 1%...

    removed from the Tablet and load the base... worked... but I think that it will not overload or the other battery when they are 100%...keep check the battery levels and see if it says "plugged in-no charging in progress" when one gets to 100%...

  • Satellite A100-1011E - how to extend the battery life

    Hello world

    I would like to ask you for advice. Given that I just bought this laptop, I would not my battery life shorten as soon as my old laptop. You plug the power cable when the battery is fully charged? Since I'm on cell regularly, 3 h battery is not enough for me. All do you advise me to take the battery out and use that? We hope to get all the valuable tips here. Thank you!

    Hi jimmytee,
    After the available studies, newsletters and my experience, there is no need to remove the battery if fully charged when working with AC plugged in. It is recommended only to tell - and recharge the battery once a month, not more. You should not work with AC plugged on and removed the battery.
    Furthermore, I'm fighting currently with the battery in a new unit. The battery itself was very fast discharge with the unit is turned off and removed ca connection. Now, the Toshiba service changed the battery. Will see how the situation will be after a few days.

  • How to optimize the battery in my MacBook Pro?

    Hey,.

    I just bought a new MacBook Pro 2015 13 inches and I love it so far! Mainly, I bought it for use at the University since I am a student in Architecture and I was told that the MacBook Pro are great for this.

    Anyway, as I always take careful care of my business, I want to know how to maximize the battery in my MacBook Pro? Is it true that whenever I have my MacBook Pro connected to the charger and it reaches the max (100%), the charger stops charging? Also, should I turn off or put to sleep when I'm not using it?

    I have read online some tips, but I want to just make sure that all of its clear. I have a lot of questions to be honest, but if someone can give a brief explanation I would really appreciate it!

    Thanks in advance.

    Hi Josetroti:

    When you leave your MacBook Pro is plugged, it stops to load automatically when it reaches 100%. There's no need to unplug it.

    I turn on my Macbook Pro in the morning and left running unless I'm going out for a few hours in this case, I if it turned off.

    In the night I turned off it. I don't use mode 'sleep', as with the SSD climbing boots Macbook very quickly. But that's just my preference.

    I heard that if you leave your computer connected permanently, a once a month, you must let sink to about 30% and then recharge.

    It is not good to let it drop below 10%.

    Here are some tips on using the battery. Batteries for laptops on Mac - Apple Support

  • 2011 Vixia HFS20 camcorder don't recharge the battery

    VIXIA HS20 don't recharge the battery and won't hold a charge.

    I bought the camera in 2011.

    I have two Canon brand batteries dead.
    I've tried three off-brands so far.

    Blinks seven times slow, 1-2 second break, seven blinks.

    Tried to charge 18 hours 12 hours. and 2 days.

    The best I can get fee of 78 minutes. If I check and just leave, 48 minutes in less than 20 battery

    Therefore, unresponsive responses to what to do when the battery is not:

    If your camcorder works fine with power, and your battery will not charge.

    Now what?
    I'm supposed to get a CANON battery for $130, IF I CAN FIND ONE? Seriously?

    Richard wrote:

    Hi Tuckerdognc,

    Thank you for taking the time to post.

    Even if the battery is not charged in your camcorder, you can recharge the battery of your camcorder using the battery charger CG-800.

    I know. I found a market after charger that revives my BP-808 and bought a market after BP-819. So far so good. Have not really tried to use in the field yet, but I tested by turn on the recorder and to let it go for about an hour with 819 and then reloaded. 150 minutes is it is top. the 808 as I let it go 1/2 and I'm getting a load of 80 min. If they don't unload just to be attached to the camera, I'll be good. (Which seems to happen before I bought the charger).

  • I have the lS PowerShot SX30 after recharging the battery, the display does not illuminate?

    Hello, I hope someone can help me! I have not used my camera in several months so I recharged the battery and for some reason that the screen does not light. I'll be honest, I'm a little bit challenged with this device. Can someone help me please? Thank you, Vickie

    I have two batteries, so I just put in the other battery and it works now! I also put the other battery I thought I had reloaded on charger. Thank you for your response. Have a blessed day.

  • How to recharge the remote control for Apple TV 4

    How to recharge the remote control for Apple TV 4

    Recharge your Siri or Apple TV Remote - Support Apple Remote

  • How to replace the battery CMOS on TECRA M3?

    Could someone tell this newbie how to change the battery CMOS on a Tecra M3?
    I can see it is located under the hard drive that I can remove, but cannot see how to strip all along to get to the battery.

    Thank you very much

    nilocp

    The CMOS battery swap is not so simply, and to do this you need to disassemble the laptop everything.
    Can you do that as a beginner?
    It's maintenance manual isn't public document and how to explain the exact disassembly steps now.

    Have you tried to load the CMOS battery properly? Leave laptop on the power supply more than 48 hours and it must be fully charged again.

  • Bad battery live on Sat M35X - how to reset the battery meter?

    Hello world

    I have a few years old Satellite M35X-S149, no problem so far however I have been affected by the life of the very poor battery (like 10 minutes of full load at 0%). I've reconfigured the power options so that she wouldn't do anything even when the battery went to 0% (not set auto standby extended) and it runs for another 45-60 minutes after 0% battery.

    So I guess the battery is faulty but not dead, and in my opinion, there is a sort of 'meter' that does not work as assumed, is it possible to reset o calibrate?

    Anyone ran into this same problem?

    Thank you!

    Hello

    I can give you a tip how to recalibrate the battery:

    1. the battery should be fully charged to 100%
    2. then you will need to change the profile of powersaving as follows-> Hibernate & standby off, disable the options that cuts off the machine when you batt. stabilize so that the machine stops when the battery is at 0%
    3 let the machine work for how long does the battery last
    4. once the machine stops itself when the battery is COMPLETELY empty, let the battery charge (the laptop must be turned off)
    5. check if it worked and repeat the operation if the result does not satisfy you
    6. in the case of NO success, I would replace the battery

    Welcome and good luck

  • Equium A100: How to manage the battery and the AC adapter

    Advice please...

    I use my laptop (A100) mainly as a desktop replacement. What should we do. the power supply cord. Leave it permanently, but don't damage the battery and the means of the laptop is permantly on standby, or constantly updated to recharge the battery every two hours, which is not very practical.

    First laptop, so probably stupid question.

    Hello

    There are different meanings to this topic.

    I manage like this:
    I work on the current, and sometimes only with the battery until it is almost empty. Then I charge the battery while he was still working on current alternative.

    After awhile of use, each battery life to shorten.

    Good bye

  • How to calibrate the battery for Satellite P750

    I have a Satellite P750 seems to also have a problem with the battery when it is asleep and NOT trendy
    She stops going flat in about 3 hours.

    Nothing connected except a dongle for the mouse. And he sleeps there is no display going.
    It is a few months old... I think it can be calibrated

    Can someone please tell me how to recalibrate the battery.

    Thanks in advance

    Hello

    You can calibrate the battery very easily.
    Disconnect the power adapter and leave the laptop disconnected until the battery is completely discharged.
    Then plug in the power adapter and charge the battery until the battery indicator (LED) would turn to green.
    This must be done and repeated 2 - 3 times in the line.

  • Satellite A300-1PH - how to improve the battery life

    I want to get an extended battery...
    How to improve the battery life?
    I have the Satellite A300-1PH.

    Hello

    You want to extend the battery work in order to use the laptop longer with the battery power?

    Well, in order to extend the battery work, you should check the Vista power settings.
    Here, you can assign some settings like brightness etc. who would save the energy of the battery of the screen.

    For more details, see this document how:
    + How to manage Windows Vista power management features? +
    http://forums.computers.Toshiba-Europe.com/forums/Ann.jspa?annID=41

    If you want to know wow to get the most out of the battery, consult this FAQ from Toshiba:
    http://forums.computers.Toshiba-Europe.com/forums/Ann.jspa?annID=20

    See you soon

  • How to change the battery internal on a G11?

    How to change the battery internal on a G11?

    Found this:

    http://www.dpreview.com/forums/thread/2877144

  • How to calibrate the battery

    I would like to know how to calibrate the battery from the computer? Please help me.

    You give all the details on your computer.

    Contact computer desk mfr of support, as in their forums, or watch its knowledge base / faq.

  • How to get the battery level and status in the cpp file?

    Hi all

    BatteryInfo class so I can I know how to get the battery level and the State in .cpp class?

    Hi Benecore,

    I have Add method below,

    #include

    But I only variable BatteryInfoPrivate not get variable BatteryInfo. You can also check on your side.

    So let me know how to get batteryInfo instance?

Maybe you are looking for

  • Apple tv 4 stuttering on youtube

    4th Gen is stuttering from time to time, my youtube on Apple TV.  I always have to restart the device to solve.  Never had this problem before until what I have updated with the latest version.

  • Compatibility of 611 series HP 3050 has

    I bought a HP 3050 has this weekend. Tried to download the software from the website, it had Windows XP as a choice, but says that "the system is not required for installation. The software does not support this version of windows? It works with Wind

  • m276nw: currently have M276nw and wish to print on transparencies?

    Hi all I had a HP M276nw for about a year and impossible to know in printing on transparencies, go to Kinkos in doing this, I know that office photocopiers, you can do this, but don't know if I should improve my color laser printer doing myself. Curr

  • Custom Manager does not scroll

    I have a custom handler that I can't scroll. class TextMenuManager extends Manager{TextMenuManager(){Super(Manager.VERTICAL_SCROLL |) Manager.VERTICAL_SCROLLBAR); I have replace getPreferredHeight, getPreferredWidth and sublayout. protected void subl

  • Not taken CS2 support MAC OS?

    I spent nearly a thousand dollars, or even more, on CS2 for my PC back in the day.  Added a few very expensive actions.  Now, Microsoft will not support Vista, so upgraded to a MAC and spent thousands more.  Downloaded the link from Adobe to use CS2