HP Touchsmart 600-1105xt - PCI card

Similar Questions

• TouchSmart 600-1120 graphics card

  I bought the nVidia GeForce GT 230 M DDR3 1 GB MXM VGA card and installed.
  I have an HP Touchsmart 600-1120 all-in-one PC and there a processor intel on board the grap. card. But a top model of this comp. has nvidia gt230m so I installed it on the mxm slot. It took a lot of time, it was difficult to open the case...
  Now, when I press the Start button, sometimes a blue screen, then color screen scratched, then 2 times beep beep sound and the computer shuts itself.
  What can be the problem?
  Thank you very much...

  OK thanks dianebrat

  God bless HP...

• TouchSmart 600: touchsmart 600 x 64 wireless network card

  Ralink 802.11 Wireless Lan Card on my PC seems defective.  Wireless internet began to drop out of school for weeks, then finally wouldn't connect to the internet.  This is the latest driver to June 2014.  My computer laptop HP, 2 tablets and 2 smart phones have no connection problems, so this isn't my wireless network.  The PC is unable to connect to DHCP and manually configure IP addresses.  Diagnosis point always restart the modem (not on the PC).

  The wireless network card is replaceable?

  If so, are their any instructions on how to replace and where the card (or a compatible card) can be purchased?

  Hello again @tmburson,

  Thanks for the information on your product. According to the page of HP TouchSmart 600-1000 t desktop PC product specifications and configurable Options , your computer has a wireless card "802.11 b/g/n PCI Express half-Mini Card + Bluetooth wireless". As long as you get the same type of card you'll be fine. I provide you with instructions on how to change it below:

  Removal of the Mini PCI Wireless LAN card
        
  To remove the WLAN Mini card, first remove

  • the hard drive and memory cover
  • the stand
  • the cover of the e/s
  • the feet
  • the back cover
  • the shield of the amp Board

  
      
  Remove the shield from the motherboard.

  
      
  Carefully remove the connectors of two antenna to the card.

  
      
  Remove the two small screws of the Mini PCI card in place.
   
  
   
  Point the card upward and remove the card.

  
      
  Replacing the Mini PCI Wireless LAN card

  To replace the Mini PCI card, orient the card in the slot at a 45 degree angle and press down.

     
   
  Keep it pressed all by replacing the first of the two screws.

  
   
  Reattach the connectors of two antenna to the card.

  

  Reconnect the:

  • the shield of the motherboard
  • the hard drive and memory cover
  • the stand
  • the cover of the e/s
  • the feet
  • the back cover
  • the shield of the amp Board

  I hope this helps. Thanks for posting on the HP Forums. Have a great day!

• These enhancements are compatible with the HP TouchSmart 600-1120

  IM thinking to do this

  Intel Core i5 430 M Dual Core (A)

  and I was wondering if it would be good for the games because I think intel core i7 is a bit expensive. If not, which ones is better for about the price of SMEs?

  IM also thinking about getting more RAM and I was wonderingif the ram card would be compatible with my computer.

  G.SKILL 8 GB (2 x 4 GB) 204-pin DDR3 SO-DIMM DDR3 1333 (PC3 10600) laptop memory model F3-10600CL9D-8GBSQ

   

  also, can someone send me a link on where to find video cards I think look terrible, and I hope that I can update if I get the new processor intel core. and which ones would work for the game, at least its unnecessary.

  Hello

  The following link shows the specifications of your computer:

  HP TouchSmart 600-1120 desktop PC

  1. CPU: no problem you can see a list of the CPU support on the link above.

  2 for the RAM: please check the following specifications:

  Upgrade memory information:

  • Dual channel memory architecture

  • Two DDR3 SO-DIMM Sockets (204 PIN)

    • SO-DIMM type-PC3-10600 (DDR3-1333)

  • Memory non - ECC, unbuffered

  • Supports 4 GB DDR3 SO-DIMM

  • Supports up to 8 GB on 64 bit computers

    Memory maximum only if you use DDR3 SO-DIMMS to 4 GB modules.

  • Supports up to 4 GB * on 32-bit computers

• repair for HP touchsmart 600-1350

  Hello, everyone-

  I have a HP Touchsmart 600-1350 with what is considered as a default card mother Pegatron IMPIP-M5.  I am told that HP has no available replacement parts and that I should just throw this PC and buy a new computer.  This seems a little extreme and am looking for a second opinion.

  Please share with me your experiences related to this topic.

  Thank you...

  ButchBob-

  Hello

  Computer TS/AIO uses a card mother desktp normal, it uses a very similar motherboard for laptop. If you wish, you can get all the parts for your machine from the following link. You can buy here (if available) or use the part number to find online like eBay stores.

  http://PartSurfer.HP.com/search.aspx?SearchText=BT554AA

  Kind regards.

• DVI PCI Card/s for G3 minitour

  I am a new Member of this forum and I hope that someone has the necessary answersI. I have a Power Macintosh G3 Beige minitour @ 333 MHz, and I'm on OS 8.5.1. There is a reason, I must stay with OS 8.5.1.

  I am wanting to know if there is a Dual-DVI PCI card that will work in this machine, so I can run two monitors via DVI in order to get a higher resolution than is available with VGA. My understanding is that VGA tops out at 1280 x 1024 and I need just a little more.

  If there is not an available Dual-DVI card that will work with my setup, how about two single DVI cards? If, by chance, there are two ways, that would be better and two monitors can also..., run off PCI cards without involving the port of regular monitor of the factory. If the port of the factory to be used, is there an adapter (or adapter cable) him/DVI.

  I know it's several questions, but get them out of here, in my first post may save some back.

  Thanks for any help, Tom

  Hi & welcome!

  In fact, VGA will give you more resolution than DVI.

  Radeon 7000

  The 32 MB memory DDR (Double Data Rate) will also help, allowing your computer to display very high resolutions up to 2048 x 1536 at 60 Hz if your analog monitor supports. Resolutions up to 1600 x 1200 are supported using digital flat screen, depending on the individual abilities of your LCD monitor.

  http://www.Macworld.com/article/1004789/radeon7000.html

  http://www.xlr8yourmac.com/graphics/radeon_7000_feedback.html

  There are faster cards still better, but more rare and the fastest I had were Formac cards, can have a couple somewhere here.

• HP TouchSmart 600: HP TouchSmart 600 does not power on and flashing lights

  Hello

  Need your expert help! My HP TouchSmart 600 won't turn on. The lighting at the bottom of the screen will flash green. It worked fine the day before. Is it the motherboard? Or a power supply problem?

  Hi @YUL_TechWriter,

  You can go surf part HP

  On the right, select the country

  In the quick search, enter the serial number and it came with the part for this computer list.

• 600-1050 HP Touchsmart All in: upgrading ram touchsmart 600

  I bought a

  Memory RAM-DDR3-1333 8 GB [2x4gb] Upgrade Kit for

  to upgrade my HP Touchsmart 600-1050 all-in-one.

  However, he had not worked and shows only a black screen after the installation.

  The discription is

  Memory 4GB DDR3 - 1333 PC3 - 10600 Non - ECC Unbuffered 204 pin 1.5V = 9 CL

  Then after, I bought another

  8GB (4GBx2) DDR3 1600 MT/s Kit (PC3 - 12800) CL11 SODIMM Notebook Memory Modules CT2KIT51264BF160B / CT2CP51264BF160B to amaozn.com

  It has the same problem.

  Those who are not compitable with my computer?

  If so, let me know a compitable memory set for upgrade.

  Yes, that would be true, but that model is an all-in-one computer, it is not flexible for the replacement of the Board of Directors, as a regular desktop would be. You probably only have the option of a Board.

• Satellite A30 - 303 install wireless mini PCI card internal

  Hello
  I am installing a PA3300U (Atheros) mini PCI WiFi internal card and have a basic question that I hope someone will be able to answer. There are two cables, white and black (under the cover of the wireless card on the case) which I suppose are for the internal antenna. The question is where do these attach to on the mini-PCI card (unfortunately I have no instructions for the card mounting)?
  I'll be very grateful for any assistance with this.
  Best regards, Dave.

  Hello

  I don't actually see one of the Atheros cards, but on other brands, there are two connectors that are marked with the HAND and to THE.
  A white cable normally goes to the HAND and a black to the auxiliary voltage

  BR

  Tom

• SP A10 with mini PCI card

  Help!

  Had great success with Toshiba would like to use it in wireless mode. LAN mini PCI card switch have still can not find the drivers on the computer to enable.

  Any suggestions

  Thank you very much

  Steve

  Hello

  What type of card LAN Mini PCI do you own?

  Please publish the name of the vendor, the name of the map and so on!

  Goodbye, Meier

• TouchSmart 600: Low battery for the keyboard will not disappear

  After upgrade to windows 10 in PC all-in-one TouchSmart 600; whenever the PC wakes up from sleep mode, low battery for the keyboard warning message appears despite the fact that the batteries are new.   The message 'form' has no way of closing other that "remind me later".

  Solution: new keyboard, Logitech > bought.  Must say that I was so tired of the current fake e-mail I just replaced my HP keyboard and mouse with another third-party.  Thanks for all those who have responded or tried to help.

• Using a usb to hdmi cable can I connect my TouchSmart 600 computer to my TV without damaging my PC?

  Using a usb to hdmi cable can I connect my TouchSmart 600 computer to my TV without damaging my PC?

  Suzanne,

  With the help of a video-to-USB device like the EVGA UV plus + 19 will not damage your computer or HDTV. The EVGA UV + 19 more is an active device and is not just a passive cable. To the best of my knowledge, there is no passive cable which will convert the USB ports in HDMI ports.

  Frank

• Startup gets "Network cable unplugged" on (new) wireless mini-PCI card

  Repost in the previous topic was locked, but has not been resolved. Original post below, please see previous post for more details

  I recently installed a Netgear DG834GT wireless router and now have intermittent problems connecting my Tecra 9100. If the 9100 has been off for awhile (like overnight), when I restart I get always "Network cable unplugged" for the wireless connection. Reboot several times (anything from 3 upwards) I finally get connected to the router and everything then works fine for hours. Even a quick restart at this point (that is, once that the wireless adapter is connected) does not cause a problem, but as soon as I leave the stop of the machine during a time he fails again on restart.

  There are no errors in the event log.

  I am using wireless mini-PCI cards and have already updated to the latest version of the driver.

  Any ideas gratefully received, for now every morning is a 20 to 30 minutes of rebooting frustration trying to get my connection work.

  (Running Win2K professional)

  Hello

  I have the same problem if I stand for laptop and access point at the same time. If the access point is already in use, the connection is established shortly after. First the access point must establish a connection to the modem. Now the wireless connection is not available.

  I guess after the second reboot, the connection between the AP and the modem is already finished and you can use the network wireless successfully.

  Good bye

• Satellite 2450-101 Mini PCI card please

  I have a Satellite 2450-101, which is longer under warranty. I upgraded the memory and noticed a mini-pci slot with two waiting for a card antenna cables. I need a g card (the 3300 looks like a good bet). The manual refers to a mini-pci slot and the CD from the laptop comes with Atheros drivers for the same... I am currently using a PCMCIA card but want to spend money with Toshiba to get a good onboard solution. I called Toshiba who say that he is not a slot in my laptop... Please please don't refer me to a partner because I've never actually talked to one yet. Honest answer please... can I mount a mini-pci card... is the 3300 OK, and how do I join the cables (if this is difficult, I won't)...
  Thank you

  Hello

  I found information that your device is ready for the Mini PCI Wireless card. As you know on the wireless card there are two connectors that are marked of PRINCIPAL and auxiliary normally a white cable goes to the ESSENTIAL and a black to the auxiliary voltage

  Sorry, but I can't tell you exactly what wireless card will be the best for you. In my opinion, you should contact partner in your country. I'm sure they can give you correct information, which is compatible with your device and how much it will cost.

  Good luck!

• A30-151 Mini PCI card Possible?

  Hello everyone, I have a Satellite A30 151, which says that the manual site and toshiba, is capable of receiving an internal wireless Mini PCI card, the site lists even more compatible models(PA3300U-1MPC). However, I rang Toshiba support they said initially the cell phone was not compatible, but seem to display of their minds and say that the site must be right. Has anyone installed one of these cards for an A30 151? I opened the slot of the wireless card, it has a slot, but no antenna wires that I could see, swich wireless is also absent. I would really like to know if this laptop / card are compatible and if I would be able to adapt or if he has to go to a Toshiba Service Center? Please help if you can. Thank you.

  Hello

  Toshiba Support gives you the right information. You can use Wireless LAN Mini PCI Card (802. 11 b / g) PA3300U-1MPC.

  Don worry on on/OFF switch. You can turn on/off in Control Panel > network connections.

  If your laptop is not is not more than two years, it will be best to contact the Toshiba authorized Service partner.

  Good bye