I need support for the second hard drive on my Aspire 8942 G...

Similar Questions

• Re: Satellite P300 - need support for the 2nd HARD drive

  Anyone know where to find support for a 2nd hard drive of my P300-17R laptop? Modelnumber; "PSPC4E-04701LDU.
  It must be sent to the Netherlands.

  Check eBay. You will find everything.

• Location for the second hard drive to 500-164 Pavilion

  Cannot find place to install the second hard drive in the box. Where it is installed?

  HP has not produced a manual upgrade. Please see this manual, because it could help you.

• Satellite A300 - Questions about the second HARD drive Bay

  To the underside of the laptop, there is an empty Bay for a second HDD internal.
  It is in the lower left corner (the first internal hard drive is on the lower side right) and the Bay has a sata connector.
  The plastic cover of the empty Bay extended columns so nothing (not even a hard disk) can be positioned on the inside.

  Someone knows:
  -If the sata connector works
  -If I can connect a secondary internal hard drive which work together with the primary
  -Where I could order the support for the secondary hard drive (i.e. toshiba code)
  -Where I could order a plastic cover without extensive columns, bcz I want to break.

  If my question is not clear, I can upload a photo.

  Thanks in advance

  Hello

  You can order all the parts of the ASP from Toshiba in your country.
  Get in touch with some guys in the ASP and ask for the parts you need.

  Welcome them

• How to install the second hard drive in the Satellite A200-1 of body weight?

  I see my new Satellite A200-1 of body weight has two hard drive bays, the research in the second span, I don't see how a second drive can be mounted as the plug into the Jack seems to be missing.

  What parts do I have to mount to place a second drive that they are held in stock by out of the local computer and are quite cheap, can someone advise me on part numbers etc of the bits I need.
  Thank you
  Steve

  Hello

  I know that this empty place for second HARD drive is a bit confusing, but the same situation is with my A200-1CR. The fact is that some A200 models come with 2 hard drives and laptop case design this place must be prepared for this second HDD.

  But this does not mean that each A200 can be improved for the second HARD drive.

• What needs to install a second hard drive in the XPS 410 desktop computer

  I want to install an internal drive repaired as a second drive in my office, so I can recover the data. A few threads in this area and I see support. Would just need a SATA HD cable? The power cable would already be there?

  userx_076

  Requires addititional hard drive, a SATA data cable and a power connector SATA, the default XPS 410 has a SATA power connector power to spare for a second hard drive.

  You will need to buy a SATA data cable, probably a 24 "x 90 * [square] x 180 * right SATA cable, similar to the cable as shown here:"

  http://www.Newegg.com/product/product.aspx?item=N82E16812816303

  The procedures to install a second HD are here, on page 30:

  http://FTP.Dell.com/manuals/all-products/esuprt_desktop/esuprt_dimension_desktops/dimension-9200_service%20manual_en-us.PDF

  Bev.

• How to use the second HARD drive of Satellite A210 - BP1 for mirroring

  Satellite A210-BP1 came with 2 HDD (160 GB).
  Now, I want to use the second hard drive mirrored the first, one that has Vista installed.
  This should be done without supervision and in real time - as a RAID 1.

  How can I do this?
  I also have Vista professional available and I would be willing to use 3rd party software as well.

  Thanks in advance for your answers.

  Hi Jan

  I doubt that this is possible
  Why? The point is that you need to use two hard drives in mirroring, RAID striping, mode etc technology
  Satellite A210 can't RAID. It s only a SATA controller without RAID capacity!

  Therefore, the final answer is; NO, it is not possible to use mirroring

  Concerning

• What do I need install the second hard drive HP PAVILION: p6633w

  What do I need install the second hard drive HP PAVILION: p6633w?

  donp815 wrote:
  

  What do I need install the second hard drive HP PAVILION: p6633w?

  Hello

  You need two cables, one is a sata cable:

  http://www.play.com/PC/PCs/4-/30305659/706331346/STARTech-com-6in-SATA-to-right-angle-SATA-serial-ATA-cable-female-SATA-female-SATA-6-inch-red/ListingDetails.html?_%24JA=TSID:13315% 7Ccat: 30305659% 7Cprd: 30305659 & kw = {keyword}

  This cable is only for data and connect the hard drive to the SATA connector on the motherboard.

  The other cable is energy:

  http://www.itpartsdirect.com/STARTech-15-24cm-4-pin-Molex-to-SATA-power-cable-adaptor.html

  It connects the hard drive to the PSU.

  You can also buy a combo like this cable:

  http://www.Amazon.co.UK/DP/B00064GBT4/?tag=hydra0b-21&hvadid=9550951989&ref=asc_df_B00064GBT4

  All you have to do is to connect the hard drive and that's it. Make sure that the main drive with the operating system is connected to the primary SATA connector (I think there are the numbers 1, 2, 3...)

• Message need to get an administrator authority, during the passage of the second hard drive.

  Original title: pass to the second hard drive

  My computer has two hard drives of 500 GB.  One is almost full.  I want to start using the other hard drive, however when I tried my computer said that I need the authority of a Director and that I don't have that power.  I am the only administrator on the computer, so I don't understand why it says that.  In addition, as the original hard disk memory becomes more complete, my computer crashes more.

  Can anyone help?

  Hi ColMarriott,

  Using a hard drive internal or external?

  You can try the second formatting hard drive after taking a backup of the data on the disk.

  If you use an external hard drive, you can try the following steps.

  a. connect the external drive.

  b. find the external hard drive in windows Explorer

  c. right-click on the drive and select format.

  You can check the following items and check:

  Install or remove a hard drive

  Create and format a hard disk partition

  Important: Make sure that you have backed up all the data before going forward with the format.

  Since the first hard disk is full and crashing, you can try to move some data and check only files not programs drive different or another location.

  Hope this information is useful.

• Add the second hard drive

  I replaced a faulty computer with a second hand replacement. Both are programmed with XP and the same browser. I installed the HDD in the position of the Tower slave, plugged the cable and Ribbon secondary and put power cord.  The computer does not recognize the additional hardware. Y at - it an easy way to simple transfer of data to the new hard drive, or is there a way to access the second hard disk drive so I can use the computer program?

  I replaced a faulty computer with a second hand replacement. Both are programmed with XP and the same browser. I installed the HDD in the position of the Tower slave, plugged the cable and Ribbon secondary and put power cord.  The computer does not recognize the additional hardware. Y at - it an easy way to simple transfer of data to the new hard drive, or is there a way to access the second hard disk drive so I can use the computer program?

  You have misused terminology in this issue, so it's a little difficult to determine what your problem may be caused.

  What do you mean by "the computer does not recognize the additional hardware?  Only shows drive in disk management (start > run > diskmgmt.msc > OK)?  If the player appears in disk management, but not in my computer, you may need to use disk management to assign a drive letter.

  It seems that if you want to take the faulty computer hard drive (in condition, of course, was not the hard drive itself which was defective) and put it in another computer.

  There is no such thing as a "slave of the Tower position."  Likely, you just put the old drive into an available drive Bay.

  Generally, the 'secondary' water is used for optical drives - not a second hard drive.  Usually, if there is only one hard drive, it is connected to the connector at the end of the water and the second hard drive is connected via the connector in the middle of the cable.  The cable connected to the primary IDE connector on the motherboard should be a 80 wire cable, while the other may be a 40 wire cable:http://www.mikeshardware.com/howtos/howto_connect_ide_hd.html

  When you have 2 drives connected on the same cable 80 wire, one is the 'master' (the one linked at the end of the cable) and the other is the "slave".  You specify the drive to this topic, what you are doing by correctly setting the jumper on the pins at the rear of the car.  You set the jumper on a 'master' and the other as 'slave' or two disks can be set for "Cable Select" If both support this and you have the special cable Select "Cable".

  However you connect, you must make sure that the drive of the old computer is defined as the slave drive, because you do NOT want to start from this installation of Windows.

  The foregoing assumes that both drives are the older IDE type of walk.  If one or both are SATA drives, it is quite something different.

• Satellite P70 - how to use the second HARD drive?

  I have recently bought a satellite P70 - A - 10 d.

  I see that there is no second location on hard disk, so I can install a second disk.
  You can see the second slot in this video http://www.youtube.com/watch?v=uW75IsuFeoY.

  But I can't understand how screed the disc.
  Do I need additional items for it or he'll be safe just plug the drive and leave it without screws?

  Hello

  If the second HARD drive bay contains the HARD drive connector, you can connect the HARD drive using the 2.5 HARD disk as [this | http://www.newmodeus.com/shop/images/TOS-X505%20sm.jpg] a

  Welcome them

• Satellite A350-122 - how to install the second HARD drive?

  Hello

  I'm a french owner of an A350-122 (serial no: 39169719K)

  In the french of the manual user, page 1-5, it is written that it is possible to insert another disc hard, and on page 2-6, the rear of the A350-122 view shows a second branch on the left for a second hard drive.

  So, I bought an SSD Intel X 25-M to put in the second location. I opened the second location and there is nothing: no sata, no power connector connector, only a location empty.

  So, what's the problem with this Satellite A350-122?

  Thank you for your response.

  Hey Buddy,

  I agree with the user above. Not all Satellite A350 models support a second HDD. The point is that laptops are country specific products and this feature is not available everywhere. In addition, all models A350 by using the same notebook case in order to have a crack but no connector.

  In any case, you can use t a second HDD. :(

• Install the Second hard drive on the HP Pavilion DV7-4270us laptop

  Hello

  My laptop has a space for a second hard drive, but not of connectors. I use Windows 7 Pro 64 bit and I would like to add a second drive in this niche. My main drive is 1 TB and I'm running out of room. I am currently using a 1 to external but it is cumbersome when you travel. What should I do to use the second drive?

  TIA,

  Marty

  Hi Marty,

  An example of what you need to use the 2nd HARD drive Bay is at the link below.

  http://www.newmodeus.com/shop/index.php?Main_Page=product_info&products_id=345

  Kind regards

  DP - K

• keep the second hard drive as duplicate in case of failure of the first disc

  I installed the second hard drive of the same size mfg and would not lead copy. Now I want to keep up-to-date with the first hard drive so that if the first drive fails, can I use the second drive until I get replacement for the failed drive. Never forget backups all have problems when you need them.

  You can not do it legally.

  Vista installation rules:

  A single license is a single Installation.

  This applies even on the same computer.

  See you soon.

  Mick Murphy - Microsoft partner

• Setting up the second hard drive preinstalled

  I have a Pavilion m9250f equipped of Windows Vista 64-bit with two 500 GB hard drives.  The first hard disk is almost at capacity (available 15%), and I want to know how to set up the second disc for use.

  Hello

  The SATA controller mode setting is in the bios. F10 will get you into the bios. Back up your data before attempting to make any changes.  If you use the RAID mode then then you will need to enter the Intel RAID CTRL + I utility at startup to disable the parring.  RAID 1 is extra protection in case you have a hard drive failure.  If you disable the RAID 1 parring so be sure to perform backups at a frequency you can live if you experience a hard drive failure.  When the RAID 1 parring is disabled, then the second hard drive will be available for data storage (more than 500GB).  If get you there, then you can do a quick format on the second hard drive.  Now you should be able to move the folders you want to the second hard drive.