I send the confirmation link to the wrong address. My safety is compromised?

Similar Questions

• I signed up to send Adobe & track today and I used the wrong address for billing. How can I change the email address, or Adobe ID?

  I signed up to send Adobe & track today and I used the wrong address for billing. How can I change the email address, or Adobe ID?

  Welcome to Adobe Send & Track!  Here is a link to update your Adobe ID information: your Adobe ID account management

• I put the wrong address of the user, how do I fix

  I put the wrong address of the user, how can I fix - should I cancel and then reallocate?

  Hello

  You are right.

  All you need to do is just to remove the user from the license, and then assign the license to the correct e-mail address.

  Using creative cloud | Creative cloud to teams

  Kind regards

  Sheena

• SMU-8431/8 RS-422 serial card sends the wrong number of bits

  I use a card series SMU-8431/8 RS-422 configuration for talking to a camera that has the speed of transmission parameters following 38400, 7 data bits, 1 stop bit, odd parity. I confirmed that the device certainly has these settings I can communicate with him using a separate Linux PC.

  When I try to use the serial port of EITHER the device does not react. Then, I connected the serial port OR on my Linux PC to see which sent the port NO. It is garbage. Nonprinting characters, control commands and the other characters are converted (for example I send the ascii character '1' and get the ascii character 'a').

  I made sure to add the terminating resistor 120 ohm NI RX + RX-lines and as mentioned in other posts on these forums, but it is only for the reception and did not solve the problem.

  I put a scope on the TX + and TX-lines from the map OR track seems reasonable that sent bits is correctly 38400 and voltage levels are correct moving between +/-3V. What I've noticed, is that the map series, NEITHER seems to be send to the 11 data bits. I expect 10-bit (1 start bit, 7 data, 1 parity, and 1 stop). I changed to 8 and then 6 bits of data and the total number sent passes to 12, then 10, respectively.

  I get the same behavior if I use Labview screws, Panel VISA for the port of MAX, or to remove the software NOR entirely and use Hyperterminal. This would seem to indicate that the problem is something in the settings of low level on the card itself.

  I tried a second SMU-8431/8 card and the same results, this isn't a fault map (may be two defective cards, I guess!).

  Any ideas?

  Many thanks in advance,

  Ian

  Discovered it was: used a scope to view the track both the Linux PC and the serial port OR to compare. The trace OR was significantly longer than the Linux. When I measured the width of the track OR whole, it worked to have a frequency of about 33 000, or much less that the 38400 assigned him. I was getting the wrong characters every bit of data from the port because NEITHER was out of sync with the Linux PC.

  I increased the port baud rate NOR and found that setting in 45 000 made it align correctly the Linux PC and I now the communication between the two devices.

  For the record, I don't have the terminating resistor 120 ohm or the anchor line to be included in the cable series between ports OR and Linux.

• I typed in the wrong address to save the new computer

  Just got a new computer HP (yahoo!). During registration it I typed in the wrong email address.  I put .com instead of .net. Where should I go on the computer to change this?

  ConcreteGirl, welcome to the forum.

  Here's a guide that should help you resolve your problem.

  https://register.HP.com/Americas/flowPage/default/defaultExperience/en_US/FAQ.do#11

  Please see the question at the bottom of the page.

  If your problem is solved, please click "accept as a Solution.

• Home App has the wrong address for my house

  I am creating a location of automation in the Home app on iOS 10. The problem is that this app and only this app, does not show my house to the right place.

  My contact card has the right address it and maps shows my house to the correct place. Home app shows a marker a few blocks away and I don't know where he is from this place, because I can't find any way to change the address of a House HomeKit.

  In addition, address location automation search does not at all. He suggested addresses in places ranging from nearby towns to the country across the ocean, but nothing for the town that I live.

  If this had happened to me, I remove and re-add my house such as described here (bottom):

  Use the app on your iPhone, iPad and iPod touch - Apple Support Home

• Links in gmail, go to the wrong address

  It started to happen after I upgraded to 3.6.15 this week. I happens in Firefox, but not in Google Chrome.

  When I click on a link in gmail, it goes to
  https://mail.Google.com/mail/?UI=2 & View = BSP & ver = ohhl4rw8mbn4
  A screen empty and the State says 'done '.
  This happens with old emails that worked before my upgrade.
  If I right click and select "Open link in a new window", it goes to the correct page.

  Hiya saraphen!

  I just changed my mail to view "Basic HTML" rather than see 'standard' and the clicking on the links works this way... You got me thinking about trying it when you mentioned the switching to Google Chrome, thank you!

  Guess that's the way I'll leave it until another update is displayed because no one seems concerned to tackle the problem more...

  Thanks again!
  8-)

• I can't delete an email address that appears only in my list when I and rated ready to send an email. The wrong address does not appear on the regualr email list.

  When you attempt to send an email from my hotmail account I go to the list of contacts and get an e-mail address I would like to remove from my list.  This e-mail does not appear when I open a new message to send.  I would like to delete two items: (room Nakedfun) and (regular email1) these addresses appear only when a new email is open must be sent.  There is no message on my regualr so email list.

  In Hotmail,.
  1. Click on Contacts.
  2. Click on View invitations.
  3. Click groups.
  4. Click No, thank you to those who show themselves.
  5. Click on change settings of your invitation
  6. Select private.

  Hotmail has its own support at the Windows Live Solution Centerforums. Please address any questions you may have about Hotmail to one of the forums on the right side of this page.

  Noel

• Validation of creative cloud e-mail is sent to the wrong address

  So when I open the creative cloud, it sends an email to an address verification in my house, no one knows how to access. Any help on how to change that address is email the verification email get sent?

  A few changes/Verify account https://forums.adobe.com/thread/1465499 links that can help

  -e-mail https://forums.adobe.com/thread/1446019

  -http://helpx.adobe.com/x-productkb/global/didn-t-receive-expected-email.html

  or

  While the forums are open 24/7 you can't contact Adobe support at any time

  Chat support: Mon - Fri 05:00-19:00 (US Pacific Time)<=== note="" days="" and="">

  Don't forget to stay signed with your Adobe ID before accessing the link below

  Creative cloud support (all creative cloud customer service problems)

  http://helpx.Adobe.com/x-productkb/global/service-CCM.html

• I am not able to delete a message in Windows Mail that got the wrong address? Tell me always Windows Mail does not. How can I delete the message?

  I had extra punctuation in a speech, and now it will not send.  I tried to delete the email but it won't let me.  It keeps just freezing and telling me that Windows does not.  I need my Outbox.  Help.

  Check work offline. Can delete you it now? If this is not the case, see this.

  How to remove an Undeletable Message stuck in Windows Mail
  http://www.Vistax64.com/tutorials/62560-Windows-Mail-problems.html

  If still no joy, try to compact and repair the database.

  WMUtil
  http://www.oehelp.com/WMUtil/default.aspx

• Web form by e-mail to the wrong address

  I have two simple web forms on a site of Muse and I'm having a problem, I have never met before. The forms are to be sent to me, not the customer. Any ideas as to why this is happening?

  Here is a link to one of the DISTRIBUTORS forms

  Paula

  Please check the value of the field "Email from" in the options form, it should include your customer e-mail address.

  Thank you

  Sanjit

• Update of 27.0 causes downloads for go to the wrong address

  I want downloads to go with my RAMdisk (not surprisingly, R:\), but since the patch v27, all downloads go to C:\Users\Me\Downloads. My Options are set correctly, I checked my profile (I:\Firefox\Profiles) location and all bookmarks and Extensions are perfectly fine - it's just the download location that is messed up.

  This is a universal problem with v27 (unlikely) or a fix has been found (I hope)?

  Hello Viridel, I think it's a general regression in firefox 27 that will not download files on the root drive. Please try to create a subfolder (like R:\Downloads) and set as the default location for downloads...

  Edit: see also bug #958899

• go to the wrong address of e-mail Notification

  It seems that my email is correct in my Microsoft account.

  But when I renewed my subscription to Xbox live gold,.

  email notification went to an old e-mail address.

  Please notify

  Wayne

  Hello

  Your Question is beyond the scope of this community.

  I suggest that repost you in the correct forum.

  'Home'

  http://forums.Xbox.com/

  "Xbox forums.

  http://forums.Xbox.com/xbox_forums/general_discussion/f/3817.aspx

  "Xbox Forums directory.

  http://www.Xbox.com/en-us/forums

  See you soon.

• My windows live account has been temporarily blocked, and I want to know specifically why in the case of my safety is compromised.

  How can I find what 'suspicious activity' is happening in my account I can take steps to correct and minimize my vulnerability?

  Hello

              
  The question you have posted is related to Windows Live and will be well suited in the Windows Live Forum. Click on the link below.
  Windows Live Solution Center
  http://www.windowslivehelp.com/product.aspx?ProductID=1

• Trying to send the e-mail verification code is more associated with Windows Live account

  When I try to change my live billing on Windows information it says that it does not recognize my computer - wtf? - and attempts to send a confirmation code to my email address. However, the problem is I changed the email associated with my account and he's trying to send this code to my old email address. Ive changed my coordinates into my Windows Live account so that this old email is in no way associated with my account. The braniacs at microsoft customer support told me to post my question on this forum and client technical support technicians will help me as soon as POSSIBLE. If they were not lying to me then please PROVE ME WRONG AND help me FIX MY ACCOUNT!

  This forum has nothing to do with Microsoft, including XBox, Hotmail or Windows Live services.  It is filled by volunteers, not employees of Microsoft, and no one here can help you with your problem.  You need to use the resources of contact that you previously used to solve your problem.