I was using Microsoft Fix and one of the messages for me was that "more than one user is currently connected to this computer"

Similar Questions

• I can't run the Microsoft Fix it Center. The message I get "error Troubleshotting Wizard cannot continue.

  I just installed Microsoft Fix it Center. Now I can't run the Troubleshooting Wizard which gives?

  Hello
  I suggest you to follow these steps and check if that helps:

  Method 1:
  Try the running System File Checker and see if it helps:
  http://support.Microsoft.com/kb/310747

  Method 2:
  Try running disk error checking and see if it helps:
  http://support.Microsoft.com/kb/315265

  It will be useful.

• How to use Ready Boost, and what are the requirements for the use of portable hard drives and flash drives for use with Ready Boost?

  I have Windows 7 64 bit Ultimate Edition and try to get Ready Boost to work on my PC using portable hard drives or flash drives. I have 2 portable hard drives (iomega 120gig, Seagate 250gig) and a 8gig sandisk cruzer flash drive. All this deterioration when you try to use the ready boost said that these discs only are not compatible or not supported. So what do I need?

  Not all readers will work with ReadyBoost. There are some readers who actually will specify that they are capable of ReadyBoost.

  By WikiPedia:

  • The device should have an access time of 1ms or less.
  • The device must be capable of 2.5 MB/s for 4 KB random read speeds indicates the spread uniformly across the entire device and 1.75 MB/s write for 512 speed random writes spread uniformly across the device.

  You must also put the device and let it plugged in for ReadyBoost. ReadyBoost is therefore best suited for a small thumbdrive (up to 4 GB) that greater thumbdrive or external HD that you would probably be disconnect from time to time.

  Open solutions Explorer window, find your Cruzer - right-click on it and click Properties. If there is a ReadyBoost tab, you can set up - set it to dedicate this device to ReadyBoost. It will be implemented and save a file on the USB key. Click Apply and're you good to go.

  A caveat which I can testify first-hand. Apparently while booting, Win 7 has trouble with some USB key - it will search the thumbdrive, the operating system, the process of starting to stall and you say: ' Missing Operating System ' - Fortunately the solution is very easy. Shut down the computer, remove the USB key, restart the computer and it will start normally. I had this happen with a 8 GB Cruzer. This seems to be a random thing, because I had the Cruzer plugged in and booted several times without encountering the error of missing operating system message. No idea why or why it is injury. Currently, I use a Kodak USB 2 gig key that seems to work very well.

• I was migrating my main domain and email to the catalyst for business, during which I've updated successfully my adobe connect account however I am now unable to access to the my dashboard sales catalyst or support?

  I was migrating my main area which had previously been hosted elsewhere and his email to the catalyst for business.

  I needed to re-create a mailbox which was also my adobe signon

  so I've updated (successfully) my account login from adobe to another e-mail address

  However, I am now unable to access to the my dashboard sales catalyst or support if I can sign here.

  So I'm partially migrated but completely messed...

  Any help appreciated because I have no idea how to get technical support... arrggghh!

  Hello

  I sent you a personal message, please follow the instructions to reach out to the support team.

• Where do you buy Links 2003 MS or Microsoft Golf and what are the prices for download

  The number of sites that promte the sales of games but leave aside all the essential elements of where to buy and at what price; is ridiculous.

  I want a superior golf game that I can play on my laptop: which is Windows Vista. Can someone please advise? Thank you, GS

  Hello

  It looks like not there is a way to get this game through Microsoft Web sites, so you will need to go to a third party, store or Web site.

  See: http://support.microsoft.com/lifecycle/?p1=8002

  http://support.Microsoft.com/GP/lifeselectindex

  You can have for her shop in a market confidence online, or check a local video game store. If a store does not have it, they should be able to direct you to a place that does.

• I use Windows Vista and continually get the message that "my connection to the server has been terminated" when you use Windows Mail! __

  When do my mail on Windows mail very often get the message "your connection to the server has been terminated...". ». I called technical support with my ISP but also had a tech from my ISP came home, but no problems have been found with my ADSL service. It seems to me that there must be a problem with the server... suggestions?

  Thank you

  Thanks Cody,

  I downloaded Windows Live Mail successfully, but when I connect to my e-mail I always get Windows Mail screen I always had. Is that all I have to do to "transfer" to Windows Live Mail.  Can I remove the Windows Mail program...

  Brian

• Error one of the UBS damage connected to this computer has malfunctioned and windows does not recognize it

  Original title: Canon MF 4500 printer inkjet

  My computer tells me that 'one of UBS damage connected to this computer has malfunctioned and windows does not recognize"it could the cable, as the printer (canon MF 4500) does not work.

  Hello

  1. what operating system is installed on your computer?

  2. when exactly you receive this error?

  3. all USB devices work properly on your computer?

  4. have you made changes on the computer before this problem?

  Method 1:

  You can try running the fix - it from the following link.

  Hardware devices do not work or are not detected in Windows

  http://support.Microsoft.com/mats/hardware_device_problems/

  Method 2:

  You can try to uninstall and reinstall the USB controller. Follow the steps.

  (a) click Start and then click Control Panel.

  (b) click System and Maintenance, click System, and then click Device Manager.

  Note: If Control Panel is in Classic view, double-click System and then click on Device Manager.

  If you are prompted for an administrator password or a confirmation, type the password, or click on allow.

  (c) in Device Manager, double-click to expand the "USB Bus controllers", right click on the controller host, click "Uninstall" and click "OK".

  Check that if at all, there is an exclamation point on the pilot, it suggests problems with the installed driver.

  (d) repeat step 2 to uninstall all items under 'USB Bus controllers'.

  Then, restart your computer and Windows will automatically reinstall all USB controllers.

  It will be useful.

• I can not install 2680317. I get the error code 80070641, not 646. I tried Microsoft fixit and still no installation. Any ideas out there?

  I can't install the update to windows KB2680317 update for Microsoft Works 9.  I get the error code 80070641, not 646.  I tried Microsoft fixit and still no installation.  Any ideas out there?

  Hello

  I would suggest trying the following methods and check if it helps.

  Method 1:

  Put the computer in a clean boot state, and then try to install the updates and check if it works.

  How to troubleshoot a problem by performing a boot in Windows Vista or Windows 7:

  http://support.Microsoft.com/kb/929135

  Note: once you have completed troubleshooting, try the procedure described in step 7 to reset the computer to start as usual.

  Method 2:

  Try the steps in the Microsoft article and check below if the problem persists.

  The problems with the installation of the updates:

  http://Windows.Microsoft.com/en-us/Windows-Vista/troubleshoot-problems-with-installing-updates

  Method 3:

  Try to download updates from the Microsoft Downloads Web site and check.

  http://www.Microsoft.com/download/en/default.aspx

  And also to try the steps in the following Microsoft article.

  http://support.Microsoft.com/kb/818018/en-us

  Hope the information is useful.

• matsgetsapccatalog: cannot use microsoft fixit

  cannot use microsoft fixit

  Hi allyoop432,

  1. what happens when you try to run the fix it? You get the error message?

  2. why you try to run the fix it?

  3. where did you download the fix it?

  Does your message contain all of the required information. View the required information.

  In addition, I suggest you send your query in Microsoft Fix it Center for better support.

• I use microsoft vista and I can not find my webcam to any help

  I use Microsoft vista and I can not find my webcam to any help

  I use Microsoft vista and I can not find my webcam to any help

  Huh?

  Related topics

  Webcam with operating system compatibility
  My computer does not know that it has built in webcam.
  I have a toshiba laptop and I can't get the webcam to work it says its disabled
  Vista cannot locate drivers for my new LifeCam

• I have an account, a download of CC I use at work and one at home, home a fair repeat test expired and yet I never saw computers with it and he's paid for

  I have an account, a doanload I use at work and one at home, home, we repeat myself fair trial exceeded but I never saw computers and it's paid for.

  I want to use photoshop quite desperately at home, I uninstalled everything, but he repeats I just test expired although I paid for it and it works on my work computer!

  Help, please

  FAQ: What should I do if I have a subscription, but my application acts as if I had a trial?

  https://forums.Adobe.com/thread/1962238

• I use 1023TX dm4, and I install the windows 8, it have problem ATI display driver

  I use 1023TX dm4, and I install the windows 8, there is an ATI driver problem, I have two screen, one intel, and one is ATI. but ati driver does not, I need to turn off, can you help me?

  Hi Tomiko094,
  
  More than likely HP won't to material support for W8 on any system purchased before October 1, 2011. Most of the W7 drivers will work W8.
  
  Have a look here http://goo.gl/hmPRB for a document official on the update of drivers and software
  
  This document here http://goo.gl/CO6uV provides information on the upgrade to Windows 8
  
  I hope this helps.

• My Media Player is not let him come his pass. I tired FixIt and followed all the links there and I still can't get media player to read.

  My Media Player is not let him come his pass. I tired FixIt and followed all the links there and I still can't get media player to read suggestions?
  original title: Windows Audio recording

  Hello

  (1) what version of the Windows operating system is installed on your computer?

  (2) did you of recent changes to the computer before the show?

  (3) what is the file format of the files you are trying to play?

  (4) you get an error message?

  (5) you are able to hear the sound of Windows and other applications?

  (6) that Microsoft Fixit ran?

  You can try the following methods and check if it helps.

   

  Method 1: No sound in Windows
  http://Windows.Microsoft.com/en-us/Windows/help/no-sound-in-Windows

   

  Method 2: Problems running Windows Media Player

  Open the troubleshooting Windows Media Player settings Troubleshooter by clicking the Start button, then Control Panel. In the search box, type Troubleshooting, and then click Troubleshooting. Click view all, and then click the Windows Media Player settings.

  See this link:

  http://Windows.Microsoft.com/en-us/Windows7/open-the-Windows-Media-Player-settings-Troubleshooter

  Method 3: Solving problems run Windows Media Player library

  http://Windows.Microsoft.com/en-us/Windows7/open-the-Windows-Media-Player-library-Troubleshooter

• installed my windows 7 Home Premium on a new hard drive, but it says my key is invalid. I bought this copy of the microsoft store and have retained the email with the key.

  installed my windows 7 Home Premium on a new hard drive, but it says my key is invalid. I bought this copy of the microsoft store and have retained the email with the key.

  To analyze and solve problems for Activation and Validation, we need to see a full copy of the report produced by the MGADiag (download and save to the desktop - http://go.microsoft.com/fwlink/?linkid=52012 ) tool
  Once saved, run the tool.
  Click on the button continue, which will produce the report.
  To copy the report in your response, click the button copy in the tool (ignore the error at this stage), and then paste (using r-click and paste or Ctrl + V) in your response.
  -* in your own thread *, please

  What is an upgrade?

  If so, you must install and activate a qualifying operating system before you perform the upgrade.

  For which version and edition of Windows the computer is allowed according to the COA sticker on the case?

• Sunday 15 May 2011 after trying to use Microsoft Update why I get the following error message? [Error number: 0 x 80070020]

  Sunday 15 May 2011 after trying to use Microsoft Update why I get the following error message? [Error number: 0 x 80070020]

  Hi MikeGoodold,

  1. did you of recent changes on the computer?

  2. do you have security software installed on the computer?

  See the below Microsoft article and try the steps mentioned, check if it helps.

  You receive error 0 x 80070020 when you use the Windows Update Web site or the Microsoft Update Web site to install the updates

  http://support.Microsoft.com/kb/883825