Laptop computer 32AV700A REGZA LCD TV using WLan connection

Similar Questions

• When I connect my laptop L300D to my LCD tv using VGA to VGA it works fine for a few minutes then the screens n that the laptop and TV started blinking on and outside. Can someone advise please.

  When I connect my Toshiba L300D laptop to my Samsung 40 inch lcd tv using vga to vga connection it works fine for a few minutes. Then the screens on the laptop and the TV start to turn on and turn off, also jumps around cursor. Can someone tell me what is the problem and how to correct.

  Hello

  Try changing the VGA cables and check if it helps.

  If the problem persists, then I suggest you to update the firmware.

  Note: BIOS change / semiconductor (CMOS) to complementary metal oxide settings can cause serious problems that may prevent your computer from starting properly. Microsoft cannot guarantee that problems resulting from the configuration of the BIOS/CMOS settings can be solved. Changes to settings are at your own risk.

• Can I install the same Windows XP on a laptop computer in our House, by using the Windows XP program that is installed on our desktop computer?

  I am updating a laptop for my preschooler to use older.  It has Windows 2000 on it and I have Windows XP on it.  We have Windows XP on our desktop computer and I wonder if I can use the same software for the laptop using the product key.  I can't find the Windows XP disk, I do not believe that we got with our desktop system.

  I'm sorry, but you can't.  Desktop software and the product key is not valid on any other computer.

• Have 2 pc windows 7 (desktop and laptop computer) and I want to use the password on the home network.

  I recently had to replace the hard drive in my desktop PC. After you have reinstalled, I set up the network to connect to my laptop. I created a password of the UAC on both computers.

  I activated ptected password sharing on two PCs.

  Now when I try to access the network on a pc, a dialog box asks me to enter the network password.  I walked into the UAC password erro and to get that connection is not valid.

  If I disable password sharing each PC is visible to another on the network.

  I prefer to use password protected sharing just as extra protection.

  I must have a parameter simple activation/deactivation.  Can anyone help.

  Hello

  You have a homegroup Setup?

  If you have a configuration of homegroup, I suggest that leave you the homegroup and set it up again.

  Create a homegroup

  http://Windows.Microsoft.com/is-is/Windows7/create-a-HomeGroup

  Home Sweet homegroup
  http://Windows.Microsoft.com/en-us/Windows7/help/home-sweet-HomeGroup-networking-the-easy-way

  I suggest you to change a homegroup password and check if it works:

  a. open homegroup by clicking the Start button, click Control Panel.
  b. type homegroup into the search box, and then clickhomegroup.
  c. clickchange the passwordand click change password.
  d. type the new password you want to use (or accept it suggested), click Nextand then click Finish.

  After you change the password, all connected to your homegroup will ask you to enter the new password.

  For more information, please go to:
  http://Windows.Microsoft.com/en-us/Windows7/change-a-HomeGroup-password

  http://Windows.Microsoft.com/en-us/Windows7/help/home-sweet-HomeGroup-networking-the-easy-way#section_1

• Equium A60 - no wireless but I don't want to use WLan connection

  Hello

  I just bought a laptop Equium A60 without the installed adapter Atheros AR5001 wireless card.
  Do I need to buy this type of card adapter to run wireless or are there other models Atheros card I can use or would it be better to buy a usb wireless adapter.

  Thank you juan

  Hello

  You can purchase a USB WiFi key.
  These sticks are cheap and easy to use!

  If your Wlan router would support WLan 802. 11 B/G or N then I recommend buying a USB WLan stick that favourable two WiFi G and N standards
  802.11 N standard is the most recent and you would get the fastest connection using 802.11 N.

  But like I said; It depends on your WLan router

• Personal laptop computer profile is lost (even if I connect).

  I connect to my laptop, it takes forever to load, then says that my profile has been properly charged. It acts like it's my first time using the computer, so I don't have access to any of my documents or saved settings.

  Help?

  A system restore 1.

  2nd temporary profile.

  Restore point:

  Try typing F8 at startup and in the list of Boot selections, select Mode safe using ARROW top to go there > and then press ENTER.

  Try a restore of the system once, to choose a Restore Point prior to your problem...

  Click Start > programs > Accessories > system tools > system restore > choose another time > next > etc.
  ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

  If the above does not work:

  http://windowshelp.Microsoft.com/Windows/en-AU/help/769495bf-035C-4764-A538-c9b05c22001e1033.mspx

  Difficulty of a corrupted user profile

  After creating the profile, you can copy the files from the existing profile. You must have at least three user accounts on the computer to perform these operations, including the new account that you created.

  ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

  http://support.Microsoft.com/kb/947242

  A temporary profile is loaded after you connect to a Windows Vista-based system

  See you soon.

  Mick Murphy - Microsoft partner

• Satellite L40 - 14F - how to connect to a regza LCD?

  How can I connect my laptop to a regza LCD?

  I have vga connection to my laptop and composite rca and hdmi, scart TV LCD.

  Hello

  As far as I know the laptop was equipped only with VGA (RGB port) port
  There is no TV out port.

  I put t know if that would be possible, but you can try an adapter DVI to HDMI video which would be connected to the TV.
  The other analog VGA <->DVI adapter can be connected to the laptop.
  Then, you need to connect only two cards together.

  Google a bit

  Welcome them

• I have 2 imacs and a laptop computer and you want to back up all three wireless via time capsule on my existing wifi network. If we can also use the time capsule as my wifi and replace my uverse wifi, that would be great. possible?

  I have 2 imacs and a laptop computer and you want to back up all three wireless via time capsule on my existing wifi network. If we can also use the time capsule as my wifi and replace my uverse wifi, that would be great. possible?

  If you want to make sure that you will be able to get the Apple support in case of problems or questions with your backups, you must use the wireless Time Capsule to back up your Mac.

  As long as the time Capsule provides a wireless signal, you can decide who to your 'main' network, then use it wireless Uverse for "guest", or children. If you do not need the Uverse router/modem wireless at all, it is possible to turn off wireless on the device and make it work only as a support modem/router...with Uverse wired.

  At this point, you can start thinking about how you want to configure things and get back in touch if you need some advice on how to do it.  We need to know what operating system that uses the Mac that you normally use to administer the time Capsule, provide good instructions, if you need it.

• How to make hotspot using my laptop computer wifi

  I use the connection internet evdo in my laptop & I have a Nokia E71 mobile. I want to share internet to update using laptop computer wifi connection to use my mobile.

  Hello

  
  There is no way of setting to fulfill your need as material Wi - Fi on the laptop would not receive the signal does not pass.
  
  However, you can try to set up a Wi - Fi hotspot on your laptop and check if your phone can spike the signal.
  
  Unless you have configured a virtual adapter or your laptop has Wi-Fi to transmit material, you won't be able to share the internet on your phone.
  
  Please follow the links below to solve the problem.
  
  Method 1
  
  Set up a computer-to-computer (ad hoc) network
  
  http://Windows.Microsoft.com/en-us/Windows7/set-up-a-computer-to-computer-ad-hoc-network
  
  See also,
  
  5 steps: how to set up your network wireless home
  
  http://www.Microsoft.com/athome/organization/wirelesssetup.aspx#fBid=UXn-6lzI1Mt
  
  Method 2
  
  If the step above does not work, then you must get a wireless / Wi - Fi router and try.
  
  Using ICS (Internet Connection Sharing)
  
  http://Windows.Microsoft.com/en-us/Windows7/using-ICS-Internet-connection-sharing
  
  I hope this helps.

• How to check only my laptop computer use integrated or the AMD graphics card?

  How to check only my laptop computer use integrated or the AMD graphics card? Some games show me that they use the built-in map: http://img849.imageshack.us/img849/4125/98ab1c28dc9f4b51b537435.png ?

  I have no other option. I have disable Intel card in Device Manager, and it shows me that the AMD driver is not installed correctly. Thank you.

• Use of AL1511b laptop computer screen 5820 T-6401 in Italy. Simple adapter or converter needed?

  Use of AL1511b laptop computer screen 5820 T-6401 in Italy. Simple adapter or converter needed? AC adapter / CC seems to be internal. Can I just attach an adapter at the end of the wall to the monitor cord to fit Italian DC connector configuration or do I need a converter between the end of the US AC 3 earth-pin male connector and the Italian DC Jack? Some external adapters have a switch to change from AC to DC and some are just automatic. What is the story here? Any help would be appreciated.

  The power adapter in your laptop will automatically convert between 110 V to 240 V automatically. You must just the adapter to connect it to the outlet in Italy. Your monitor should also automatically convert the voltage as well, you need just the adapter to connect it to a power outlet Italian.

• can not get the printer to work when sending my laptop computer that he used to work the printer is on and functional

  Can't get printer to work when sending my laptop computer that he used to work the printer is on and functional. Canon pixma MP180

  Hi NickManchisi

   

  1. for how long have you been faced with this problem?
  2. what happens when you try to print?
  3. do you receive any error messages?

  Method 1 :
  Please refer to the below mentioned article and check if the given steps help.

  http://support.Microsoft.com/kb/308028

  
  Method 2:

  You can even perform a restore of the system to a previous point, when the issue was not present. The System Restore tool uses points of restore to return the system files and settings to an earlier point in time. You can use it to restore the operating system to a point in time when you have not experienced the problem.

   

  Note: When you use System restore to restore the computer to a previous state, programs and updates that you have installed are removed.

  To do this, there must be a restore point from the system in which the connection was successful.

  Refer to the following help link on performing a system restore.
  http://support.Microsoft.com/kb/306084

   

  I hope this helps.

• I have 2 laptops and one desktop. Desktop & laptop are very good. 2nd laptop computer cannot access the internet. I get a message media disconnected. I tried everything please help. I use Windows XP

  I have 2 laptops and one desktop.  Desktop & laptop are very good. 2nd laptop computer cannot access the internet. I get a message media disconnected. I tried everything please help.  I use Windows XP

  Hi JessaRoy,

  · The computer connected to the network or are they computer autonomous?

  · What is the number and the model of the computer?

  · What is the service pack installed don the computer?

  · What is the full error message with the error code, that's all?

  · What are the steps you tried to solve the problem?

  Try the steps from the link below: to test TCP/IP connections by using the ping and the commands net view: http://www.microsoft.com/resources/documentation/windows/xp/all/proddocs/en-us/sag_tcpip_pro_pingconnect.mspx?mfr=true

  With regard to:

  Samhrutha G S - Microsoft technical support.

• I have lenovo g560 laptop and Windows 7 64 bit, but my laptop computer webcam does not tell me how to use it

  I have lenovo g560 laptop and Windows 7 64 bit, but my laptop computer webcam does not tell me how to use it

  Help/support on the Lenovo support site or their forums, review its their webcam and so does not part of win7

• If I make a bootable pen with my computer, I am able to use it to install windows on my laptop?

  If I make a bootable pen with my computer, I am able to use it to install windows on my laptop?

  Format the stick with the media authoring tool for Windows 10 or Create for Windows 8.1 installation media for Windows 8.1.

  Then use the Key in the BIOS Boot Menu to trigger the ignition key, as a device UEFI so you have a UEFI BIOS.

  Toed installation remember to delete all partitions to make it more clean, as shown in the clean install Windows 10 Upgrade or Clean install Windows 8 or 8.1

  Let us know how it goes.