Light WGB

Similar Questions

• 1242 light characteristic WGB

  I have a LAP that is associated with a WLC 4400 1242. Cisco publishes an Image that supports WGB on 1242 with 4400 WLC lightweight access point. It has been supported only with a stand-alone AP 1242.

  I guess we don't have a TAG should be in stand-alone Mode...

  Let me know if that answers your question...

  Concerning
  Surendra
  ====
  Please do not forget to note positions that answered your question and mark as answer or was useful

• Autonomous light WLAN AP 1252 bridge

  I have a Cisco WLC 5508 manage several 1252 s in light mode.  There is a laptop on campus that has an independent network, but not wiring to tie it to the corporate network.  I have an another 1252 which is in stand-alone mode.  Could I essentially set up as a bridge with the same SSID and security to meet the enterprise WLAN?  If not, what are my options?  Best regards, Dee

  That looks like one. Basically, you go take the autonomous access point and make the WGB configured to connect to your SSID. You can have up to 254 devices behind a WGB normally, which could be different with CUWN well. This doc should tell you the limits.

  Sent by Cisco Support technique iPad App

• Where are the options of the trackpad in Sierra OS?  In El Capitan the trackpad there NO light tap (ENTER) and just one click HARD (ENTER) and could move the cursor.

  Where are the options of the trackpad in Sierra OS? In El Capitan the trackpad there NO light tap (ENTER) and just one click HARD (ENTER) and could move the cursor.

  System Preferences > Trackpad!

• Don't Dim green light no fix

  My 2012 Macbook Pro 13 inch lost its charge a week ago. The charger lights a green light. When I press the button on the side of the Mac to see the power, only the first green light blinks then turns off. The Mac does not load.  It took to pcworld and connected to one of their Chargers it bright green illuminated (should be orange) and still won't turn.

  I tried SMC

  Tried to remove the battery and put back

  Nothing works

  You might have against accidental damage to the logic or the Board of Directors of magsafe DC. You must bring it into an Apple store for troubleshooting.

  Here's an article on what charger you need for your model. I'll try to test a known good charger with your battery installed and started. What is your state of the battery when disconnected and plugged?

• 13-inch early 2011 macbook pro. light green mag extremely shoddy security cordon, macbook pro stopped charging bought new magsafe. and the led does not illuminate or strings. SMC reset now mac does not recognize battery. unplugged

  13-inch early 2011 macbook pro. light green mag extremely shoddy security cordon, macbook pro stopped charging bought new magsafe. and the led does not illuminate or strings. SMC reset now mac does not recognize battery. disconnected the battery and security cordon mag, maintained hold button / stop for 5 seconds, nothing. Another SMC reset and it is the only way Mac powered on that she has no back light for the keyboard and the fan works on high all the time, please can someone HELP, thanks.

  This is the Office Mac Pro forum. I asked that your post be moved to the MacBook Pro laptop forum.

• I have no sound coming out of my macbook pro and see a red light in the hole of the listener.

  I do not have its coming out of my macbook pro os x 10.8.1 but if an earphone is connected I hear the sound and there is a red light through the matter of earphone. What is happening to you can help me?

  The red light of the headset jack means the MacBook Pro thinking that an optical audio cable is plugged into the port. Try to have disconnected and reconnected a headphone plug into the port several times. There is a tiny sensor inside the port that determines if the port is operating in analog or optical mode. Something similar by plugging should trigger the sensor and restore the analog signal.

  If you don't feel capable in doing so the folks at Apple Genius Bar will be able to help.

• After turning on my wireless keyboard led green lights, then begins to blink, and then turns off. The batteries are fresh.

  After turning on my wireless keyboard led green lights, then begins to blink, and then turns off. The batteries are fresh.

  Possible explanation.  It is likely that batteries, so fresh, can be irregular in size.   The uncertain connection would therefore tend to lead to a failure to blink and you declare.   Read my thing...

  Batteries.

• How to use the App home to plan lights?

  I want to my porch and patio lamp lights to turn off at specific times. I know that I can get WiFi connected bulbs. The host application will control the time or what I need to buy some sort of hub?  Source of confusion.

  Hello

  Start here > http://www.apple.com/ios/home/

  And here > http://www.apple.com/shop/accessories/all-accessories/home-automation

• Our time capsule will blink a light amber and utilities said that it is overheating. What is the problem?

  We had a problem with our (less than 2 years) time capsule - the light yellow flashing, the fan runs often and looking in "utility" on my mac, it says that it is overheating. What is the cause of this?

  The Time Capsule fan runs constantly, so you shouldn't be aware of the fan running on the time Capsule 'often'.

  If you receive a message that the Time Capsule is overheating, there is probably a problem with the internal power supply on the Time Capsule.

  If you have an Apple Store near you, it would be wise to take the time Capsule to let the experts check the issue and discuss your options.

• Drive light external HARD disk Warrior exploded

  I use DiskWarrior do a reconstruction of the hard drive to save the files, if possible. Hard drive does not appear on the desktop, which had been seen as a USB device on system information. During the reconstruction, the Seagate external HARD disk light exploded and is no longer visible to the Profiler system as a USB device. Should I cancel the reconstruction? Should I try disk referee to 'stabilize' the disc and run Disk Warrior?

  Can you describe the real problem which caused you to run DiskWarrior "to save the files?  Who can provide a clue about your current situation.

  If DiskWarrior' forever,' you have to cancel rebuild it later.  How long it has beed running?  It may take time, if repairs are done by DiskWarrior.

  DiskWarrior works repairing data directory player (which defines where the files are stored).  There are other types of utilities who hunt the disc for actual data.  For example

  https://www.prosofteng.com/data-rescue-recovery-software/

• Indicator light power cord

  That means the light orange on the power cord?

  Support actively at a high rate.

• The new iPhone 7, display lights on the move - is this normal?

  I just bought an iPhone 7.  Whenever I pick it up the screen lights up before I hit the home button.  Is this normal?

  I guess that when I'm carrying it, it will keep light upward, and then jump.

  Yes, it is a new feature in iOS 10 called "Raising to wake", where you can check the notifications on the lockscreen without hitting the power button / stop or the "home" button.  I don't know if I like it or not, but I currently have always it turned on.

  To disable this option, go to settings, display and brightness and toggle the revival to Wake OFF.

  I played around with it a bit, and it activates especially when moved from horizontal to vertical (for example pick up placed on a desk), but no say, low vertical, high portrait.  So depending on how you wear the phone (pants pocket, Pocket jacket, holster, backpack, etc.), it may or may not turn on unintentionally.

• MacBook pro screen does not light

  Hi, I have a macbook pro 13 inch edition at the beginning of 2015. A few days when I tried to turn on my computer, screen not turn on including the lamp to the rear logo. but I heard the startup sound with the keyboard backlight on. I plugged the computer to an external monitor, then I saw in this computer monitor works fine. I tried to make configurations LANDAU and SMC. screen still does not work. but sometimes laptop screen lights up, then when I restart the computer, the screen will come up again. help me guys what should I do? Thank you

  If you're lucky, the connection to the screen is not correctly connected or must be replaced.  If you are unlucky, the display needs to be replaced.  Make an appointment at an Apple store genius bar for a FREE evaluation.

  Ciao.

• Since recent iOS updated my 6s lights (lock screen) when moving or touching the screen

  Incredibly annoying and battery draining experience that only began just after I updated the iOS

  The lock screen lights up constantly, even when I'm not in contact with one of the buttons (I'm still not near the Home button).

  I have since disabled touch 3D , but it still happens.

  Try a forced reboot. No data is affected by this. To force the reboot your device, press and hold the two buttons of sleep/wake and home for at least ten seconds, until you see the Apple logo.