Management Engine Interface (MEI) driver update?

Similar Questions

• 8086 3b 64 = driver Intel Management Engine Interface (MEI)?

  I have a new computer that was custom built for me by a shop.
  The computer works fine, I noticed in Device Manager, however, that in the other devices section
  There is something called "PCI Simple Communications Controller" which has a yellow exclamation point.

  On the site www.pcidatabase.com
  I looked at the details of the pilot, the vendor: 8086 Dev: b 3 64 SubSys:83831043

  On the page of intel, it is listed at the bottom article pending... the chip is listed as Intel Management Engine Interface
  What is c? The note on the pcidatabase said something about laptops that confused me.
  Googling "Intel Management Engine Interface" did not come with something relevant.

  What is the IMEI, I download this driver? Can someone enlighten me?

  Im running windows 7 64-bit, intel core i5 750 processor desktop computer.

  Hello

  The "Intel Management Engine Interface" is a part of the VPro technology from intel.

  This IMEI technology allows you to manage your remote pc.

  You can download the update of the driver for your chipset.

  See the link below for the procedure to install this update.

  http://communities.Intel.com/community/openportit/vproexpert/Microsoft-vPro/blog/2009/02/24/management-engine-interface-Mei-and-serial-over-LAN-Sol-device-driver-compatibility-in-Windows-7

  Kind regards
  Amal-Microsoft Support.
  Visit our Microsoft answers feedback Forum and let us know what you think.

• Driver Intel management engine interface not supported

  I use HP2000-2116TU laptop, installed with WINDOWS (32 bit) operating system 8.1. When I try to install the driver Intel management engine interface, downloaded from the hp Web page, it says that it is incompitable with the system. When I check the Device Manager, it shows pci communications driver is missing. However, driver bluetooth, preferred for my system in HP Web page also is incompitable with WINDOWS 8.1 operating system.

  Please give me a solution for this problem.

  Details of the problem:

  1 PCI device:

  The drivers for this device are not installed. (Code 28)

  Hardware ID:

  PCI\VEN_10EC & DEV_5229 & SUBSYS_1858103C & REV_01
  PCI\VEN_10EC & DEV_5229 & SUBSYS_1858103C
  PCI\VEN_10EC & DEV_5229 & CC_FF0000
  PCI\VEN_10EC & DEV_5229 & CC_FF00

  Compitable ids:

  PCI\VEN_10EC & DEV_5229 & REV_01
  PCI\VEN_10EC & DEV_5229
  PCI\VEN_10EC & CC_FF0000
  PCI\VEN_10EC & CC_FF00
  PCI\VEN_10EC
  PCI\CC_FF0000
  PCI\CC_FF00

  Hello:

  It's the driver who interested, if unfortunately, I don't know why it does not work.

  Try to force the installation...

  Download and run the file again.

  Now, go to Device Manager and click the comms controller simple pci who need the driver.

  Click the driver tab.  Click on set to update driver. Select her browse my computer for driver software method, then at the bottom of the window, let him choose from a list of drivers for devices on my computer.

  Click on disk and navigate to the folder of the driver that was created when you ran the file.

  That will be located in C:\SWSetup\sp58464\Drivers\MEI\HECI\and, select the device Intel(r) Management Engine Interface in the list and see if the pilot goes like this.

• CQ2909E0 - Intel Management Engine Interface driver for Windows 7

  Hello

  I installed Windows 7 on my desktop CQ2909E0, but need me a "PCI Simple communications controller" and the Ethernet controller. I think I must install the com controller before I can install the ethernet controller. It is; I can't find the right driver for the PCI card.

  Please notify.

  You should be able to use software HP and Driver Downloads page of the desktop HP Pavilion p2 - 1117 c. This unit and your, use the same motherboard basis and therefore most of the drivers should work on your computer.

  Simple Communication controller is the Intel Management Engine Interface driver and the ethernet controller is Atheros network controller driver. The rest of the driver should work as well.

  Please send BRAVO

• Intel® Management Engine Interface driver

  Intel® Management Engine Interface Driver for Windows 8 Pro. 64 bit
  one that I find DOES not work... everyone you have a difficulty?

  Please provide the name of the model of your VAIO computer.

• Re: update type Intel Management Engine Interface

  Simply receive uprgade notes...

  * heci - 20150320101654.zip *.
  Data di ultima changes 20/03/15
  Ragione social Intel
  Type Intel Management Engine Interface

  Whatever it is, what to do?

  It is necessary? It is safe?
  Thank you
  Giovanni

  Can you please tell us which laptop model you have and what operating system are you using?

• How can I reinstall the Intel Management Engine Interface?

  Hey there. I have a Lenovo Yoga 2 13, i5 and have some problems with the boot and sleep.

  Startup problem: it takes 30 sec - 1 min at startup and display the Lenovo logo and the rotating circle

  Pépin to sleep: the most of the time, if I close the lid for more than 20 seconds and open it again the screen starts flashing and then the computer shuts off.

  So I tried the problem to resolve these issues, which lead me to the "Device Manager" where I have a past by each element and check for driver updates. Surprisingly, there were about 5-6 required. But the "Intel Management Engine Interface" did not work. The first time, it gave me an error and the second time (he had always the sign of error small triangle on yellow), he said that all the drivers are up to date. In my reading of the internet, some people were saying that the most recent update for this chipset was causing problems (ver.11) and that I should downgrade to version 9. So I uninstalled the driver, and then (I have a feeling that it was my mistake) also uninstalled the "Intel Management Engine Interface" how it disappeared from my list of 'Device Manager '. But when I tried to install the driver again for version 9 the error that appears is "this computer does not meet the minimum requirements for installing the software. Worm. 11 also gives me an error (even if I don't remember right now).

  I have scowered the internets and found nothing even come close to answering that question. Any help appreciated.

  As a side note, I also have some freezing problems when I plug in the power adapter, even if I think that maybe I should ask this question in another post...

  J

  Fixed. She appeared again in the device again Manager and I was able to do the downgrade. Don't know if I've seen a much improved...

• (Redirected) Alienware Aurora R4 - cannot install Intel Management Engine Interface

  Hello

  I had this problem for quite a while now. Since I reinstalled Windows 7, the "Intel Management Engine Interface" driver does not install correctly. It gives me an error code 10. I can't find solutions for this problem.

  Help, please.

  Thanks in advance,

  Qubn

  Better in this position in the Alienware owners Club Forum, here:

  http://en.community.Dell.com/Owners-Club/Alienware/default.aspx

  Bev.

• Intel(r) management Engine Interface cannot start (code 10), I get this message whem check the computer Device Manager

  I get this message whem check the computer Device Manager

  Intel(r) management Engine Interface cannot start (code 10)

  Thanks Ephraim

  Please provide us with your administrative Event Viewer logs by following these steps:

  Click on Start Menu
  Type eventvwr in the find programs and files (do not hit enter)
  Click with the right button on eventvwr.exe and click Run as administrator
  Expand custom views
  Click the administrative events
  Right-click Administrative events
  Record all events in custom view as...
  Save them to a folder where you will remember which folder and save it as Errors.evtx
  Go where you saved Errors.evtx
  Make a right click Errors.evtx-> send to compressed (zipped) folder of->
  Download .zip here (if you can) to skydrive or a file sharing service

• I tried to update intel management engine interface to the version 8.1.0.1248 but giving error

  
  

  Hi Virginia.

  The problem has been solved now. You can now download the drivers here: http://esupport.sony.com/US/p/select-system.pl?DIRECTOR=DRIVER

  Note: If my post answered your question, please mark it as an "accepted Solution".

• How to fix error code 10 in Intel(r) Management engine interface

  Device Manager reports an error code 10 for device of the EMI. Gigabyte Z68XP-UD5. I already tried to install the new driver, did not work... Reinstallation does not work either.

  Hello

  Did you change your computer?

  Method 1:

  The Code 10 error code is generated when the Device Manager has not enough information or error that spread upwards by device drivers is not recognized by Device Manager. In addition, this error may occur if one of the pilots who needs the unit does not start. If multiple drivers are used by a particular device, it can be difficult to determine which failed.

  Description of errors related to the 10 Code that generates the Device Manager in Windows on computers

  http://support.Microsoft.com/kb/943104

  Method 2:

  I suggest you run the fix it tool and check.

  Hardware devices do not work or are not detected in Windows FIX IT:

  http://support.Microsoft.com/mats/hardware_device_problems

  Method 3:

  I suggest update you also the drivers and check.

  Update of the hardware driver that is not working properly:

  http://Windows.Microsoft.com/en-us/Windows7/update-a-driver-for-hardware-that-isn ' t-work correctly

  What to do when a device is not installed correctly:

  http://Windows.Microsoft.com/en-us/Windows7/what-to-do-when-a-device-isn ' t-installed-correctly

  I also suggest you to communicate with the computer manufacturing and check.

• Intel Management Engine Interface T400s

  In Device Manager, I see that this material cannot start.  The version of the driver is up-to-date.  What do I need for, and, if I need, how can I do?

  Thank you, John

  jrose1g wrote:

  In Device Manager, I see that this material cannot start.  The version of the driver is up-to-date.  What do I need for, and, if I need, how can I do?

  Thank you, John

  What operating system do you use?

  Unless the laptop is used in a managed corporate network (IE, if it's your personal computer) you can safely disable the engine Intel AMT in the bios.  (and uninstall the drivers).  This will free up memory as speed up your startup process.

• Intel Management Engine Interface problem

  This device cannot start. (Code 10)

  STATUS_DEVICE_POWER_FAILURE

  Have installed intel latest driver for this on my Dell 8700 and it is always marked as non-operational in the Device Manager.

  Always include the version of Windows.

  Read this at Microsoft forum.

  I would like to start by erasing the BIOS (for example, the last message out there):

  1. Reboot and immediately press F2 to open the BIOS Setup
  2. Copy down all current settings
  3. Power off, unplug
  4. Power button press / hold for about 15 seconds
  5. Open the case and remove the motherboard battery
  6. Power button press / hold for about 30 seconds
  7. Reinstall the battery
  8. Case of close and restart

• Satellite Pro S500 - 11 c - lack of driver Intel engine Interface

  Hello

  I had a Satellite Pro S500 - 11 c Windows 7, I see an unknown device in the information system. The missing driver appears on PCIdatabase.com as Intel Management Engine Interface (MEI) driver, but I can't find it on the Toshiba site, and when I go to the Intel site there are several versions with no obvious way to tell than I need.

  Can someone tell me what version I want or where I can get it?

  Thank you

  Try to download this driver:

  http://www.DriverCure.com/driver/driver_captcha.php?device_driver_id=5CFDA707-11B0-4FEC-8C89-65E3E4EA9AFD

• HP Pavilion x 360: back issues of sleep and stop; MEI driver moved

  I have upgraded to Windows 10 last summer and, like many people, I had sleep and close issues. The computer wouldn't wake him up after he went to sleep and when I stop the computer the light remained on and the fan will continue running. I was able to fix by updating the graphics card and the driver of MEI.

  Windows has released a new update a few days ago and it has been applied automatically to my computer. Now, sleep and shutdown questions have returned.  This time, the graphics card is fully updated, but now I can't downgrade my MEI driver back to version 8.1 of Windows ( 9.5.24.1790 1.5 M ). When I try to install the driver it says 'Setup progam was able to start one or more application processes' and stops. I tried running the installation through Setup of HP and download directly, and none worked.

  Does anyone else have this problem? Any advice?

  Open Device Manager, expand the 'System devices' section, and then find "Intel Management Engine interface", double click it and go to the driver tab, and then click on "roll back driver" button, it will come back to the previous driver.

  You can do most any device in the device manager driver.

  If roll back driver button is gray, then there is no older driver to restore.