Model acer ES1-711-P1UV have sauldered ram or can it be upgrade

Similar Questions

• Question of ES1-711 P1UV pilot

  Good evening everyone. I have an Acer ES1-711 P1UV that I recently formatted the disc for. I'm currently trying reinstaling the drivers. The Device Manager shows the unknown device error. I sought the material under properties ID and found this... ACPI\VEN_INT DEV_33BD & brings me to the fabric side-band device driver driver. I downloaded the driver and went to install and I get the error message 'Setup.cfg' not found however the setup.cfg file is directly straight above the configuration file in the download file. So why it can't be found and how do I load this driver so that I can clear the error in Device Manager?

  Thank you all for any help.

  M13a77

  Have you installed as an administrator?

• Equium M - 50 192: what RAM I can use to upgrade?

  Hello

  Does anyone know what I can use to upgrade RAM?

  I currently have 2 x 512 MB. Does this mean that all my slots are taken? I want to move to their maximum capacity (2 GB or more). I have to replace the two modules?

  The reason is that I was a little miffed to discover that my 128 MB of video RAM was infact static RAM. I guess that's my fault for not asking the right questions...

  Now, I do a lot of video editing and games. If I increase the RAM will be her claim to improve performance?

  Hello

  I checked the properties of this device and it seems that it of possible to upgrade the memory for max 2048 MB.
  There are 2 available memory slots, and you can use the modules of memory 2x1024Mo.
  These modules are supported:
  DDR2 400/533 256 MB (PA3389U - 1 M 25)
  512 MB DDR2-400/533 (PA3412U - 1 M 51)
  1 GB OF DDR2 400/533 (PA3411U-1M1G)

  Hope I could help.

• I have a model end of 2013 13 MacBook Pro with 4 GB or RAM retina and think to upgrade to El Capitan. Is this enough RAM

  I have a model end of 2013 13 MacBook Pro with 4 GB or RAM retina and think to upgrade to El Capitan. Is this enough RAM

  Of course you can upgrade to El Capitan. But I think better if you can change the internal hard drive (SATA drive) in the SSD drive. You will get better results, faster than still, you only have 4 GB. This is mine... MacBook pro in early 2011.

  

• Acer Aspire problem Touchpad ES1-711-C231

  Hi all I recently reinstalled windows 8.1 in my laptop Acer Aspire ES1-711-C231, the touchpad worked fine before, but since the re - install is no more recognized/detected by windows 8.1. I download the device on the support page (Elantech touchpad) driver but still no joy. Help, please. What about Paul

  Hi all, problem solved had not correctly installed the driver intel I/O.

  Paul

• I have an Acer - processor AMD A10, 16gig ram desktop pc, I've upgraded to windows windows 10 8. When I open lightroom everything is ok in the library. When I select develop LR does not and I have to close it. If I delete a photo from the library of the h

  I have an Acer - processor AMD A10, 16gig ram desktop pc, I've upgraded to windows windows 10 8. When I open lightroom everything is ok in the library. When I select develop LR does not and I have to close it. If I delete a photo from the library of the same thing happens. How can I fix this., he can be to stop what is happening

  Hello Sarika

  Thanks for your help.

  It's not that simple I thought he'd be when I used your method that whenever I tried to uncheck 'Use graphics processor' Lightroom 6 crashed.

  At least you put me on the right track and I persevered and found the file relevant agprefs of Lightroom web help and followed the instructions to change manually.

  I have changed two files with the same name but stored in different locations.

  Everything works fine now.

  Thank you once again.

  Mick

• Software driver for Acer ES1-511-C1UU for Windows 7 64 bit

  Hello

  I bought an Acer Aspire E 15, ES1-511-C1UU a few weeks before with version 8.1 of Windows authentic. Now that I'm not very comfortable with this version of the OS, I want to convert my lpatop in the version of operating system Windows 7. So please inform me if there is a website to download the software driver Windows 7.

  Thank you.

  Hello...

  Windows 7 drivers are not available for this phone, because it was delivered with Windows 8.1.

  In this case, you can install the drivers from the website of the manufacturers as Intel, Atheros etc. for each of the components as the video card, wireless card etc...

  Find provided below for information about the hardware on the laptop:

  Chipset: Intel Bay Trail-M SoC BGA1170

  VGA: Intel (R) Graphics HD

  Audio codec: Realtek ALC283

  LAN Chipset: Realtek RTL8111GUS

  WIFI

  If it is Atheros,

  Wireless card: Atheros WB335

  Chipset: QCA9565

  If it's Broadcom,

  Wireless card: Broadcom 43142

  Chipset: BCM943142

  Before you install the driver, you can download and run the hardware detection utility on your laptop that will identify the name of the provider of the VGA, WiFi, LAN etc. on the laptop.

  Once you have this information, you can go to the respective manufacturer (for example: VGA, go to Intel, for audio go to Realtek etc.) and install the compatible driver for Windows 7.

  I hope this helps.

• I can't upgrade to El Capitan as it says I don't have enough RAM (2 GB) - anyway it round at all by freeing RAM etc.

  I can't upgrade to El Capitan as it says I don't have enough RAM (2 GB) - no sense this at all by freeing RAM etc?

  The only way is to upgrade RAM.

• Satellite 1800: Model who exactly should I have?

  I now have a second hand satellite 1800 in my possession, by the manual in PDF on this computer HARD disk laptop I know it's a series 1800, but I know nothing more... How can know which specific model I?
  I tried to download the drivers etc, but I don't know who... I have tried to identify with the specifications of the American site of computers, but differ from European models... I have 1.1 Celeron, cd drive, LAN, standard modem where can I somehow understand this?

  Hi Gamca,

  There should be a sticker on the bottom of your laptop that will give you an exact model number, you can then search on the Toshiba site.

  Kind regards

• DDR4 Ram how can I upgrade worms in my Acer Aspire E5-553-14 year and how many ram slots is there?

  DDR4 Ram how can I upgrade worms in my Acer Aspire E5-553-14 year and how many ram slots is there?

  Thanks for all the help Brummyfan.

• processor x 86 family 6 model 6 stepping 2 authenticAMD 1599 mhz ram capacity

  processor x 86 family 6 model 6 stepping 2 authenticAMD 1599 mhz ram capacity

  How much ram can be installed with this processor

  Since it is an x 86 machine and not x 64, you can only use 4 GB regardless of how the system card can contain.

  I hope this helps.

• ACER ES1-512-P8VK (NX. MRWET.027)

  Hi, can you tell me how many banks ddr laptop ACER ES1-512-P8VK (NX. MRWET.027) and what type of DDR use?

  1 plug

  PC3-12800 1600 Mhz DDR3L SDRAM SO DIMM 204-pin

• Vista - Boot error x 490 - does not have enough RAM

  Original title: help

  Hi my computer constantly breaks down on startup.  I get error code 0 x 490.  He also tells me I don't have enough RAM and anything else he can think.  I rebooted in safe mode, do the F8 thing, completely erase the hard drive and again, moved RAM to virtual RAM disk and usually do what is recommended on the way.  The machine works well for 1 or 2 days, and then it starts again.

  What is going on??

  Hello

  Perform the steps from the link below and see if it helps.

  How to use the Bootrec.exe tool in the Windows recovery environment to troubleshoot and repair startup issues in Windows

  Hope this informationm helps.

• Need help to save this document... does not have enough RAM

  I have Photoshop Elements 5.0.  I have worked on some pages of the book and had no problem to save photo-lourds pages.  I had all the pictures and photos closed pages and started working on a page that was all text. Towards the end of the page, I tried to save it and told me I don't have enough RAM.  I have 19 layers of text up to now... is - that's why he won't save?   I know that I can assign more RAM, but it will not take effect until I have to restart the program.  Is it possible to save work that I already have?

  Close all other open documents.

  If you have other applications running, close those.

  In pse5, go to Edition > purge and choose all.

  See if that makes a difference.

  

  MTSTUNER

• Acer Aspire V15 V3 - 575 - 50TD Ram upgrade

  Hello, I just bought a laptop named in the subject.

  The stock of RAM according to CPU - Z is ACR16D3LS1KNG/4 G.

  

  I tried with RAM Module Kingston KVR16S11/8 (1.5V) and did NOT work.

  I want to know what type of ram can I use upgrade.

  I also want to know if the voltage is the only problem here, or should be another conflict.

  My upgrade must be:

  SLOT1: 8 GB (new)

  Slot2: 4 GB (stock)

  Total: 12 GB.

  Thank you.

  Hello

  No, it will not work. DDR3 won't work at 1.35v and your laptop will provide just 1.35v. You must DDR3L.

  According to crucial, your laptop can handle up to 16 GB of RAM, so a 4 GB with an 8 GB stick should be good.  But the two should be DDR3L