MSVCR71.dll missing. I installed Windows 7 Pro to Vista Home Edition. EU back up my HARD drive. When I try to put things on the HARD drive I get the message that msvcr71.dll is missing. How to install Windows 7?
I installed Windows 7 Pro to Vista Home Prem Edition. Back up my HARD drive with the included HP software. Now I can't get my info on the HARD drive. When I try to open the computer file backup says msvcr71.dll is missing. How to install and where?
Hi dezertdawg,
Welcome to the Microsoft Answers site!
Msvcr71.dll errors are caused by situations that lead to the removal or corruption of the msvcr71 DLL file. In some cases, the msvcr71.dll errors might indicate a
problem of registry, a virus or malware problem, or even a hardware failure.
You can use the tool (SFC.exe) System File Checker to ensure that the system files are intact and replace the file. Follow these steps:
1. Click Start and type cmd in the box start the search.
2. right click on cmd in the list programs and then click Run as administrator.
If you are prompted for an administrator password or a confirmation, type your password or click on continue
3. at the command prompt, the following line, and then press ENTER:
sfc/scannow
http://support.Microsoft.com/kb/929833
Kind regards
Amal-Microsoft Support.
Visit our Microsoft answers feedback Forum and let us know what you think.
Tags: Windows
Similar Questions
-
Also, I get the message
Your request is forbidden, because that would create a cycle.
Hi szdon,
I tested this by logging in my Yahoo! Mail account and it was accessed normally. How do you access your Yahoo! Mail account (by example of favorites, link specific address)?
Please try to access it two different methods to see if there is a difference in the result:
- Try to access your account by going to mail.yahoo.com
- Please try to access your account by going to www.yahoo.com and click on the Mail link on the left side of the page.
I hope that this helps, please let us know the results.
Thank you!
-Ralph -
email error
I came home from work today and he was going to check my mail, but when I did that my account has been blocked. so I reset my password and it worked the first, only that my new password that I have not worked, while I was going to try again, but I couldn't because I remember not allot of what was asked as my secret question, or emails recently and I want to say that I said 12 when I did my hotmail , but I need to get it back and I really need help here. p.s. I hope I have not nerd rage
Hello
Answers is a peer group supported and unfortunately has no real influence on Hotmail.
HotMail has its own Forums, so you can ask your questions there.
Windows Live Solution Center - HotMail - HotMail Forums Solutions
http://windowslivehelp.com/Hotmail - Forums
http://windowslivehelp.com/forums.aspx?ProductID=1Hotmail - Solutions
http://windowslivehelp.com/solutions.aspx?ProductID=1How to contact Windows Live Hotmail Support
http://email.about.com/od/hotmailtips/Qt/et_hotmail_supp.htmWindows Live Hotmail Top issues and Support information
http://support.Microsoft.com/kb/316659/en-usCompromised account - access unauthorized account - how to recover your account
http://windowslivehelp.com/solution.aspx?SolutionID=6ea0c7b3-1473-4176-b03f-145b951dcb41Hotmail hacked? Take these steps
http://blogs.msdn.com/b/securitytipstalk/archive/2010/07/07/Hotmail-hacked-take-these-steps.aspxI hope this helps.
Rob Brown - Microsoft MVP<- profile="" -="" windows="" expert="" -="" consumer="" :="" bicycle="" -="" mark="" twain="" said="" it="">->
-
When you try to access a service of my browser, I get a message saying that I can't because my default mail client is not properly installed, but it doesn't tell me what I'm supposed to do either. So... What am I supposed to do?
Go to control panel | Default programs and set your default email program, if you have a. If you use the webmail, you probably can't set.
Steve
-
"When you try to upgrade to photos in app store I get this message"the object you requested is not available in the store US."does anyone else have this problem or can you tell me how to find pictures in the app store" someone else meets this. Is it me or is it pictures?
Ever photos first? It should have been included when you first update of Yosemite and now El Capitan. I know that iPhotos updates get a message like that, but I didn't know the Photos app with a message with it.
-
I can't load my iTunes to my iphone 5 s. When I plug it to my computer for access to, I get a message that says: I need a newer version of Itunes. I go on the website, I download but nothing changes
What is the number of current version of iTunes you have on the computer? What computer OS do you use? If Windows, what version, so OS X, what version number?
-
You need to reset and or change my old iCloud account of moms on the phone with another. When I try to reset it with the information that we know that it says "blocked account"
ACCOUNT SAFETY CONTACT NUMBERS
-
When you try to put a password or start to enter a google search that restores my page down
If I enter the first letter in the search google my page disappears and I get my desktop. If I enter the first letter in my Inbox password, I get a pop up asking if I want to access this page in my favorites. When I do it or not when I try to enter my password in I get the same pop up again, please if you could help me I would appreciate it :)
Hi Lloydanderson,
· What browser do you use?
I suggest you to reset Internet explorer and check to see if it helps.
How to reset Internet Explorer settings
http://support.Microsoft.com/kb/923737
You can also consult the supplied below article to resolve problems with Internet Explorer:
Tips for solving problems with Internet Explorer
http://Windows.Microsoft.com/en-us/Windows-Vista/tips-for-solving-problems-with-Internet-Explorer
Note: Please note that reset the settings of Internet Explorer running resets all of the settings defined by the user, including those established by the installed extensions, toolbars and other add-ons for IE by default. This includes all the security, privacy and settings area. Also this will erase browsing history, delete all temporary Internet, cookies, form data files and especially all the passwords.
I would also suggest you to run a scan line and MSRT from the links below:
Windows Live OneCare scanner
http://OneCare.live.com/site/en-us/default.htm?keyword=scannerhome
(MSRT) malicious software removal tool
http://www.Microsoft.com/security/PC-Security/Malware-removal.aspx
-
Hello;
I really need help because I can't use my computer with it this way. First of all, how it works so slow that it drives me crazy! Now, he has started to do something new; When I try to go to another site, it will be like freeze and then tell Internet Explorer {or any site that I find myself be on} has stopped working due to a long-running script and then when I look, and I can finally close this box bottom, he says that I need to retrieve the web page. I don't know what is happening, or what to do. The only thing I found which offers any kind of help, was supposed to deliver {I think} Windows, but that would be to remove all my toolbars, modules, everything and I just can't do that. Can someone help me please? Best Buy has won ' t even talk to me unless I have pay $60,00 the outset simply to look at; and then God knows how much more I have simply don't have everything. Any advice would be greatly appreciated! Thank you
Bones1961
Hi Bones1961,
· Did you do changes on the computer before the show?
· What version of IE are you using?
· What is the full error message?
· The issue is limited to any particular Web site?
Follow these methods.
For the question of Internet Explorer:
Method 1: Follow the steps in the article.
How to troubleshoot script errors in Internet Explorer
Method 2: Perform an optimization of Internet Explorer.
How to optimize Internet Explorer
Note: Reset the Internet Explorer settings can reset security settings or privacy settings that you have added to the list of Trusted Sites. Reset the Internet Explorer settings can also reset parental control settings. We recommend that you note these sites before you use the reset Internet Explorer settings.
For the computer running slow-release:
Method 1: Follow these steps:
Step 1: Start the computer in safe mode and check if the problem persists.
Step 2: If the problem does not persist in safe mode with networking, perform a clean boot to see if there is a software conflict as the clean boot helps eliminate software conflicts.
Note: After completing the steps in the clean boot troubleshooting, follow step 7 the link to start the computer to a Normal startupmode.
Method 2: Follow the steps in the article.
Optimize Windows 7 for better performance
For reference:
-
Try to send a photo by e-mail on Picasa, the message comes back that they don't recognize or accept
Internet Explorer - that is what I have. Makes no sense.
Then ask Picasa Help.
-
I am trying to add music to video, that I created on Windows Media Player... When I select the song in my Itunes list it says file not found. Don't know why he is here... somewhere! Any tips?
Because Windows Media Player cannot create videos I have
assume that you are talking about Windows Movie Maker.Try to browse to your music folder and see if you can
Add a music file to your project. If you have problems
You may need to convert the music file to the. WMA
format before importing. -
I imported just pictures earlier today on the same card, so I don't know what is the issue.
Check that you are allowed to write to the destination folder.
-
Unable to defragment the hard drive get a message that says: incosistancies in the file system
Original title: cannot defragment the hard drive
I have windows xp. All dates are updated. Whenever I try to defragmant my c drive I get a message that says: incosistancies in the file system and told me to run chkdsk and scan disk and try to defragment again but I keep getting same message. How can I fix it?
Hi cliffordsevec,
Follow these methods.
Method 1: Follow these steps:
Step 1: Relocation of defragmentation
(a) in the disk, find the directory c:\Windows\Inf. If the system directory is not on the c: drive or not named Windows, find by clicking on "Start", then "run" and type %Windir%\Inf in the area.
(b) find the file called dfrg.inf.
(c) right click on the file and select "install".
Step 2: Repair defrag
un) Click on "Start", then "run", run this command: regsvr32 dfrgsnap.dll.
(b) click "Start", then "run" and execute this command: regsvr32 dfrgui.dll.
(c) run Defrag.
Method 2: Follow the steps in the article.
Disk Defragmenter does not work on a Windows XP-based computer
http://support.Microsoft.com/kb/922379
Method 3: Follow the steps in the article to check the drive for errors.
How to perform disk error checking in Windows XP
http://support.Microsoft.com/kb/315265
Note: If bad sectors are found in the hard drive, then it could try to fix this particular sector. If you have any data on that, it can get lost.
-
I get a message that my disk key is not valid. He has worked the last time I started.
When I enter the code from the back of the drive, I get a message that the code is not valid. The operating system worked this am. What gives?
What part of the installation are you get the invalid key error? Installation of Windows 7 is a bit different from Vista. Vista allows you to ignore enter a product key when you are in the early stages of the installation. Windows 7 lets you skip entering your key when the facility is in its final stages of installation.
If you're running Vista and you try to do a clean install using upgrade disc, do not enter a product key and complete the installation.
When you reach the desktop, click Start, right-click on computer
Click on properties
Scroll down to the Windows Activation
Click the link x days before activation.
Click on the link that says: "show me other ways to activate.
Enter the product key
Click next
Select the Activation of the phone
Click Next when you enter your key page
Select your country
Click Next, call the number listed
Be sure to explain your situation to the Appeals Officer.
They will give a confirmation ID, enter it
Click next to complete the activation.
You said that the license came with your old computer, please note, that would mean its OEM license. OEM licenses are not transferable to another computer, they are related to the computer, they came with, so if you try to use it on another computer, this may be why you encounter this error message.
-
Original title: iTunes Question
I recently bought a new Windows 7 laptop and downloaded iTunes. I have hundreds of songs already purchased and need to download on this computer... when I access my account and then click on download, I get a message that says that I must allow the computer. Any suggestions on what to do?
Thank you!
You can check with Apple because they created iTunes. Check the Apple Web site, I found the following FAQ on what you need to do to allow a new device:
- Open iTunes
- From the Store menu, choose authorize this computer.
- When prompted, enter your Apple ID and password, and then click allow.
Note: if you already allowed iTunes to another PC and that you no longer use this computer, you should have allowed him out before getting rid of it. If you don't do this, you might consider off allowing all devices first, then allowing the new PC.
Maybe you are looking for
-
When I close FireFox the story line fades to restart firefox. What is?
Since the upgrade to 7.0.1 history on the url line does not keep the URL history for the next session. I even down loaded and reinstalled this version to see if it would work. Nothing helps. It is a pain by typing in URLS often used.Thanks for any in
-
Hello My Airport Extreme began to behave badly. I'll GET noisy fan, the orange indicator light starts to Flash and then all stops and light turns green. Repeat this every so often. Anyone out there have any ideas? Thank you Rex
-
Hello My PC are Win10 and I can't use the nor myDAQ (badly installed driver or Automation). The driver is present and it worked before! I reinstalled labview, but nothing has changed. Is that someone had the same problem? Thank you
-
binding ssl IIS7 lost on reboot
Hey,. For a company, I work, I recently had to move a bunch of sites IIS6 a IIS7.5 (using MS deploy tools). This figure includes many many sites that share an SSL wildcard certificate. Since iron out the bumps with the sites I just found that, whenev
-
I have 2 x 2 TB hard drives that I put as dynamic disks and mirrored Volumes (software through Windows 7). There are data on the disks and when I created first the mirror and he finished re-synchronization status has been set to healthy. Now after re