my phone (samsung RV410-T01) stop automatically. I removed the battery when I was with her. and then it stopped and I can't open it with a battery or even I plug.

Similar Questions

• SAMSUNG RV510 laptop computer and the built-in webcam was working before and now, if I have the webcam the screen is in night vision which is entirely green.

  I have a SAMSUNG RV510 laptop and the built-in webcam was working before and now, if I have the webcam the screen is in night vision which is entirely green. I tried to restore and re - install the drivers and even removed the chip back and webcam is plugged in but nothing works.
  Please give me a solution for this.
  Thank you

  See its unlikely a MS or Win, Samsung help/support solution or their forums, its their equipment and their program

• NB100: Remove the battery while plugged in that?

  I own a Toshiba NB100 and said that when I use the power cord, I have to remove the battery, after leaving the battery that connected while on hold Cela would damage the battery. Is this correct? Must I remove the battery when the netbook is plugged?

  Hey Buddy

  I started an article on the battery and some advice for her:
  [How to get the most out of the battery | http://aps2.toshiba-tro.de/kb0/HTD9401AZ0001R01.htm]

  Good reading! :)

• Satellite P205-S6277: can I remove the battery and plug the too?

  I'm working on my laptop Toshiba satellite P205-S6277, 80% of my time at home.

  Can I remove the battery and plug the power to a UPS backup system in order to make the longer battery life?
  I can load once a week.

  Of course you can do it. You can remove the battery and work on the power current only. Remember, there is no dust on the desktop and the location of the battery in the notebook of stay clean to be used again.

  Good bye

• In Vista when I hover over the battery icon, it shows plugged in, does not support

  When I hover over the battery icon, it shows plugged in, does not support.  Why my battery not charging?

  Hi Retha_T,

  1. What is the brand and model of your laptop?

  2. when the problem started?

  3. did you of recent changes to the computer?

  You can read the following article and check if it helps to solve the problem:

  Solve battery problems

  Hope this information is useful.

• receive battery WARNING on start up. the battery meter indicates "94% plugged in, does not support".

  When I turn on my laptop a battery warning message.  I checked the battery meter that says the following "94% plugged in, does not support".   The laptop is fine, so why should I get this message and what I would do to this topic?

  Any advice would be appreciated.

  Cheryl

  It is always recommended to run regularly only on battery power. It will actually make the battery last longer to let it discharge once a month. Realistically, if your laptop is on a desktop and plugged all the time, it is better to just remove the battery and only use it when you need portability.

• Is it safe to keep the PC is plugged in after removing the battery?

  As I will not pass my pc for a while, I removed the battery and use the AC power instead.

  But I would like to know if its safe to keep it plugged into the AC 24/7? and if she consumes energy or it damage anything when the pc is turned off?

  its okay, I use to do all the time with the other thinkpads when my battery died on me. It will not damage your laptop.

• Reference Audio Dell - will automatically switch on the headphones when you plug them.

  XPS 9350 - 10 Windows

  Can I do Audio Dell (or something) automatically route the sounds of my helmet when I plug them?  I saw no option in the Audio from Dell menu to toggle this option.

  I do a bit of work to the library of my school, which means I have to be quiet.

  The problem is that when I plug my headphones, I have to wait for Dell Audio for pop - up and then I have to confirm my selection of "headphones with microphone" above all sound will go to them.  Then only will be moving to my helmet.  While I do this, my computer starts hanging and beep all the recent notifications for anyone nearby to hear, until I do the confirmation.

  To make things worse, if I plug my headphones on the Windows lock screen, and then log in, Dell Audio pop up just never came up. However, I still give it Windows notification Center make me notice, but it is non-interactive.  Then I have to unplug the headphones, expect that all of the alerts saying I have disconnected something go, then plug the new.  If I wait more for alerts clear selection Windows Audio Dell don't is not loading.  Once again, beeps and dings are once I have connect and do all this.

  Of course, it's just as much I na not mute until I closed the lid, the last time that I used it.

  SOLUTION: the context menu is not clear.

  If you check the option at the bottom telling not to appear whenever something is plugged in, it will automate just about whether you connect (at least I can assure you that for "headphones with microphone").

  The way that the radio button is made, simply looks like it's supposed to just disable the pop up and nothing more.

• Receives a STOP error: 0xc0000007b & can't open Internet Explorer to download available updates.

  Original title: safe mode

  Hello

  I recently installed norton antivirus 2011 on my computer toshiba laptop, detected the various threats and dealt with, but he also always tried to deal with threats constantly through autoprotect. as a result of all of this that I could not open internet explore to download available updates even if I could send and receive e-mail with outlook express, I tried to uninstall norton, but was still unable to open ie, I re installed norton and still the same.

  I also tried a restore of the system without success. Then, I read on a forum on the attempt at analysis in using msconfig and not F8 safe mode. This stoppped the laptop completely. now it shows just a black screen with options to start in normal mode or in safe mode, when you press F8, the following text is displayed on a black screen

  Windows Advanced options

  safe mode

  safe mode with networking

  line withcommand in sans-echec mode

  Enable Boot logging

  enable vga mode

  last known good configuration

  directory services restore mode

  debug mode

  disable the automatic restart in the event of system failure

  Start windows normally

  reset

  return to the operating system choices menu.

  When I select the option of automatic reboot disable a blue screen with the following error codes displayed

  stop: 0xc0000007b (0xf8c66528, 0xc0000034, 0x00000000, 0x00000000)

  is there any way back from that. ? I downloaded the bitdefender recovery system on my desktop on another pc and it has burned to a disc, but it will not work in computer laptop th!

  Before all this happened, that I was able to access the internet ok, but does not open some sites like microsoft, norton, mcaffee, and when you try to connect to the internet banking I also had security problems.

  Hi Paul,.

  1. what error message you receive when you try to open Internet Explorer?

  2. what happens when you download updates?

  You can follow this link & check if the problem persists:

  Error message "STOP 0x0000007B" when you restart your Windows XP-based computer

  
  Reference: Advanced troubleshooting of errors "Stop 0x0000007B" in Windows XP

  For Internet Explorer, you can follow this link & check if the problem persists:

  Can't access some Web sites in Internet Explorer

  Hope the helps of information.
  Please post back and we do know.

• Automatically log off the internet when the computer is idle for a few moments

  Why my computer (Vista) automatically disconnect internet when it is idle for several minutesand after downloading a file. The message that appears after downloading a file is something the performance data.

  Hi magicre,.

  (1) what is you receive the exact error message?

  (2) since when are you facing this problem?

  (3) remember you to make changes to the computer before this problem?

  Step 1: Disable the security software and then test to see if the problem persists. Follow the steps mentioned in the link below

  Disable antivirus software

  http://Windows.Microsoft.com/en-us/Windows-Vista/disable-antivirus-software

  Important: Activate security software once everything is done.
  
  Step 2:run Internet Explorer in mode "no Add-ons" and then check if the problem persists

  To determine if the error is caused by an add-on, run Internet Explorer in "no Add-ons" mode To do this, follow these steps:

  1. click Startand type Internet Explorer in the box start the search .

  2. click on Internet Explorer (No Add-ons). Internet Explorer opens without Add-ons, toolbars, or plug-ins.

  3. test Internet Explorer to verify that it works correctly. If problems occur always,try step 2

  If no error occurs, the problem is caused by one of the Add-ons that typically load with Internet Explorer. In this case, follow the steps mentioned in the link to determine which add-on is causing the problem

  Optimize internet Explorer
  http://support.Microsoft.com/kb/936213

  (See method 3-2 in the link)

  If the problem persists,

  Step 3: Start the computer in safe mode with network and test it. To do this, follow the steps below:

  Access the menu options advanced start by turning on your computer by pressing key F8 beforeWindows begins. Advanced startup options menu select SafeMode with networking

  http://Windows.Microsoft.com/en-us/Windows-Vista/advanced-startup-options-including-safe-mode

  Let me know if the problem persists in this mode

  Thank you, and in what concerns:

  Ajay K

  Microsoft Answers Support Engineer

  Visit our Microsoft answers feedback Forum and let us know what you think

• If I unplug my charger for my laptop will stop, and then I'll I have to reset the SMC to turn back once again and I can't seem to stop the fan noise.

  My MacBook Pro retina display suddenly stop today and I had to reset the SMC to make it work again (I had a few problems with the reset it) but now, if I unplug the charger it will stop and I have to reset the SMC to run it again and I can't seem to stop the noise of the fan th What should I do?

  With the operation of MBP, if you open information system (Option key down in the Apple Menu), what does say in material > Power?

• My taskbar is lost, explorer.exe is has stopped working and I can only open the Task Manager program...

  Hi, can you help me?
  After that I logged my Windows, I see that my taskbar are lost...
  Windows has said, "Windows Explorer has stopped working"...
  I click on "close the program".
  I use the Task Manager to open explorer.exe again...
  But, the same message still to come...
  So, I can just open my Taskmgr programs...
  What will happen to my laptop?

  Hello

  1. What is the full/exact error message?
  2 were there any hardware or software changes made on the computer before this problem?

  Follow the steps.

   

  Method 1
  Start the computer in safe mode and check if the problem persists, if the question does not persist then perform the clean boot and check if the problem resolves.

  Step 1
  Safe mode starts Windows with a limited set of files and drivers. Startup programs do not work in safe mode, and only the basic drivers needed to start Windows are installed. Please click the below mentioned link.
  http://Windows.Microsoft.com/en-us/Windows7/start-your-computer-in-safe-mode

  Step 2
  Put the computer in a clean boot state to see if there is a software conflict as the clean boot helps eliminate software conflicts.
  http://support.Microsoft.com/kb/929135
  Note: After you have performed the steps in the clean boot troubleshooting, follow step 7 the link to start the computer to a Normal startup mode.

   

  Method 2:
  See the help article and check if it helps.

  Error: Windows Explorer has stopped working

  http://support.Microsoft.com/kb/2694911

  Important: When performing analysis on the hard drive if bad sectors are found on the hard drive when parsing tent repair this sector if all available on which data can be lost.

  An upgrade on the spot is the final solution before you have to reinstall the operating system.
  Note that it takes as much time to do the upgrade as to reinstall the operating system. In addition, some of your custom Windows settings may be lost through this process.

  Response with more information to help you.

• How can I stop automatically going into the tab when I right click on a text of google search?

  before the update every time that I would be a highlighted text and right click to perform a google search would not automatically to it. However, he does now and getting on my nerves. How can we change it?

  Hey kevindigg, you can enter Subject: config in the address bar of firefox, confirm notification of information (where it appears), search for the preference named browser.search.context.loadInBackground & switch true by double-clicking it. This should bring back the old behavior...

• Why plugin - container.exe shows the process when I disabled all extensions and plug-ins?

  Firefox has been slow, locking and become insensitive since 27.0, I now 28.0 installed, but no difference. I suspect the plugin container could cause or contribute to this. You kindly told me why it is still in progress when everything is turned off, I would like to block. In addition, how comes I can watch a YouTube video when the Flash is turned off? I have the original - this plug-in is disabled - view, and then the video begins to play?

  It is possible that the HTML5 Media Player is used to play videos.
  
  If the Flash player would be the you get the context menu Flash Player if you right click on the video player.

  Start Firefox in Safe Mode to check if one of the extensions (Firefox/tools > Modules > Extensions) or if hardware acceleration is the cause of the problem (switch to the DEFAULT theme: Firefox/tools > Modules > appearance).

  • Do NOT click on the reset button on the startup window Mode without failure.
  • https://support.Mozilla.org/KB/safe+mode
  • https://support.Mozilla.org/KB/troubleshooting+extensions+and+themes

  You can create a new profile as a test to see if your profile is the source of the problem.

  See "create a profile":

  • https://support.Mozilla.org/KB/Profile-Manager-create-and-remove-Firefox-profiles
  • http://KB.mozillazine.org/Standard_diagnostic_-_Firefox#Profile_issues

  If the new profile works then you can transfer files from a profile already used in the new profile, but be careful not to copy files corrupted to avoid transporting on the problem

  • http://KB.mozillazine.org/Transferring_data_to_a_new_profile_-_Firefox

• When I click to a new tab, I get a weird Page of the partial Netfix. Is this normal, and I can stop it?

  Firefox 17.0.4

  What is the setting for the new tab page if you check the browser.newtab.url pref on the topic: config page?

  See this article on the page tab (topic: newtab):

  • https://support.Mozilla.org/KB/new-tab-page-show-hide-and-customize-top-sites
  • http://KB.mozillazine.org/about:config