My Satellite A100 does not support SDHC cards with the internal card reader

Similar Questions

• Update KB937287 keep apearing as the only updated, try install many times, but does not work, tried it with the standalone version and it keeps apearing

  Update KB937287 keep apearing that the only update, tried to install a lot of times, but does not work, tried it with the standalone version and it keeps apearing, when I install it does not display an error message, just say that again was successful but when I try to look for more updated it apears again.

  Hi mayortom,

  Thank you for visiting the Microsoft answers Forum.

  You can follow the steps outlined in the article below:

  Troubleshooting Windows Update or Microsoft Update when you are repeatedly offered an update
  http://support.Microsoft.com/kb/910339/

  I hope that helps!

  Thank you and best regards,
  Abdelouahab Microsoft responds to the technical support engineer

• computer does not boot, blue screen with the message: Stop: 0 x 00000024 (0 x 00190203, 0 X 86949258, 0xC0000102, 0x00000000)

  computer does not boot, blue screen with the message: Stop: 0 x 00000024 (0 x 00190203, 0 X 86949258, 0xC0000102, 0x00000000)

  Hello

  1 how long have you been faced with this problem?
  2. don't you make changes on the computer before this problem?

  Start the computer by using the Microsoft Windows XP recovery console, and then perform a check disk on the file system.

  To do this, follow these steps:

  1. Insert the Windows XP CD in the CD-ROM or DVD - ROM drive, and then restart the computer. Select the required options to start the computer from the CD-ROM or DVD - ROM drive if you are prompted to do so.
  2. once the Welcome to Setup screen appears, press R to start the Recovery Console.
  3. If your computer is configured to dual-boot or multiple boot, select the appropriate installation of Windows XP.
  4. When you are prompted to do so, type the administrator password and press ENTER. NOTE: In Windows XP Home Edition, the administrator password is blank by default.
  5. at the command prompt, type the following command and press ENTER: cd system32
  6. type the following command and press ENTER: chkdsk /r /p
  7. remove the Windows XP CD in the disc drive.
  8. Type exit to restart your computer.

  Important: Running chkdsk on the drive if bad sectors are found on the disk hard when chkdsk attempts to repair this area if all available on which data may be lost

• Slot for memory card does not support SDHC memory cards.

  Dear friends,

  I have a Windows XP Pavilion dv4000 laptop from 2005 with a memory card slot that does not support current SDHC memory cards.  Is there an updated driver for this niche that I need to view these maps?

  Greetings to all from

  John P. Owens

  Dear BH,

  Who did it!   I am running with the memory cards SDHC now.  Thank you 1 million.

  Kind regards

  Jack Owens

• Satellite A200 does not support 4 GB SD card

  Hello...

  I have SD card problem. My computer read the 1 GB SD card but not read 4 GB SD cards. My operating system is vista Home premium. I test my SD card with the other laptop and it works.

  Thank you...

  Hello

  If your bed computer card of 1 GB but not 4 GB, this indicates a problem with the system to read higher capacity SD cards. for SD 4 GB capacity and above, there has been a change to the higher capacity SDHC cards, so, your system may need an update to fix this. to correct this problem, please install Service Pack 1 for Windows Vista or the update from the Microsoft Web site in the following link: http://www.microsoft.com/downloads/details.aspx?FamilyID=e42fc131-6a76-4b27-934a-fb19dd323dab&DisplayLang=en

  I hope this helps

• Nexus10 version does not support pdf files in the web site.

  I have a new Nexus 10 and installed Firefox and the Epson Print software. When I go to the bath of Rockville and center of fitness, full screen, it will show me a button on the right side hourly. Click on that to start a download (it should just show me the contents of the file as does the true Firefox). If I go to the download section of Firefox, the download is listed, but when I try to do with the word app, it says that the file is not present. If I try to do with the Epson application, she argues that the application has stopped. If I go to epson print and look around, I can find the file and read it. But it's exceedingly complex.
  The same died of problem with crome, crome, but does not support full screen. This problem is not present on the ipad from apple with the web browser by default.

  in the original post, I am fearless "PDF viewer" as a name for a standalone application, and as I said in my reply, I installed this app. you suggested that what I needed was an Add on Firefox. I installed this add-on and could see page.
  I think you still have a bug in the download page, so that it appears not to pass the correct name to the app non-firefox that you want to use.

• 'Page' does not name a type with the given Code problem

  Hello

  I try the code on this page , but I'm getting 'Page' does not designate a type in the Test.hpp file with the following line

  private:

  Page * appPage;

  Container * mRootContainer;

  };

  What could be the solution for this problem?

  OK I solved this problem with the addition of bb::cascades with the page
  Please take a look at the following code

  private:

  BB::Cascades:page * appPage;

  BB::Cascades:container * mRootContainer;

  };

• SD card does not work in on my Satellite A100-163 5-in-1 card reader

  Hello

  I recently bought a 1 GB SD card and tried to plug it into my A100-163 built-in 5-in-1 card reader. Nothing appears in my computer. I tried to go to the Device Manager and, under "drives" "Secure Digital Storage Device" with a bit of yellow! Select this option. I tried updating the driver Module SD, but whenever I do that the installer comes up with an error, basically saying he can find SD Secure Module.msi. He tries to find in a dark temp folder that involves me Installer is not extracted properly.

  Can someone help me read my SD card? Help, please!

  UPDATE: on the occasion of the strange, it appears in my computer as "Secure Digital Storage Device. When I double click on it, it says:

  "E:\ is not accessible. The request cannot be performed because of an i/o device error."

  Thank you.

  Mike.

  Post edited by: toto8462

  Hello Mike

  One thing confuses me. If the unit has the multi card reader factory settings must be configured correctly. You use your own installation of the OS?

  In any case, try to remove device from digital storage secure from Device Manager, then restart the device.

• Re: Satellite A100 - do not have my card with me

  My uncle bought me this laptop 9 months ago. It s the Satellite A100 series. It does not give me the papers or what so ever.
  Now it turns out that the motherboard needs a replacement and that I don t have all the papers with I need to buy it.
  Can someone tell me if there is a way to get my warranty card? :(

  I don't know where you live, but I recommend to follow: check http://eu.computers.toshiba-europe.com/ > support & downloads > find an ASP.

  You can find the closest service provider authorized in your country. Contact them and explain the situation. They will help and I hope that they can tell you what you can do.

• Satellite A100 - signal not supported from PC to TV

  Hello

  I have a Satellite A100-SK8 I used to connect it to my Sony 40v2500 using a cable of AVG. However, recently it will no longer connect and I get the mesaage "signal not supported set the output to your pc" on the TV. I use the same cable to connect my another PC to the same TV and it works correctly.

  Any help is very appreciated!

  Thank you
  Shain_20

  Hi shain_20,

  Can you explain which is an AVG cable? I've never heard of this

  In any case, he s strange that he doesn t work then you change some parameters of display or any other driver/software driver?

  Maybe reinstall the display driver could help...
  Usually, you can switch between monitors using the FN + F5 key combination.

• Satellite A100 does not start - no action

  Hello

  I have a Toshiba Satellite A100, which does nothing. He went flat when he was asleep, and a few minutes later I plugged it and when I press the power button / nothing happens. I do not show that the battery recharges in illuminating the charging light. The power button does not illuminate.

  If I hold the power button for a long period of time, a few lights.
  The caps lock light. Light under F10 and F11 and wireless internet light keeps coming back even if it is disabled.
  Battery light comes on a few times, but it is wider than on.

  My thoughts are that power don't is not computer (I think than lights that come on are those who come usually on after you press the power button) I'll try and the hand to get on another charger to try but snacks that don't work there at - it suggestions?

  DESPERATE isn't my computer!
  CJ15

  Hmm can be a motherboard problem.

  Try reinstalling the memory and battery and see how it goes. If not, send it to an ASP for a quote.

• Satellite A100 does not supply power to the top

  I have a client who has the Satellite A100 (PSAA2C-LE100E) and its not turn on the power. He bought a new AC adapter and tried the battery in and out and still not solve.

  Should there be a light at the front of the laptop when it is plugged in and turned off?

  Is it hard by exchanging the DC IN 19V on the phone jack?

  Thanks :)

  Is this a Toshiba adapter? If the tension or the polarity is wrong, it can damage the motherboard.

  DC IN (power cable icon) light should illuminate when the AC adapter is plugged in, if the adapter does not work. You can use a multimeter to check the volts and amps of the adapter.

  If not, then a new Mainboard.

• Satellite A100 does not display an image at boot

  Hey all.

  I'm having a problem with my laptop (A100), which is a little perculiar. I keep my PC the other day to restart. But when it restarts, it does not display an image. I saw any activity usual boot sequence, as HD-activity and other. But no picture.

  I tried to remove the believer battery which would solve the problem... but it didn't, and I simply dropped.

  The next day I started the machine, and it returned to the top and ran exactly as usual. So today I rebooted the machine, and he did the same thing. No image... but the normal boot sequence. I noticed that the battery - led is lit constantly, which is NOT normal. And when I remove the AC power the machine dies simply indicating that the battery is completely dead. But what is odd, behold, the machine will actually start (although without a picture) when I remove the battery and just plug in the AC power.

  Of course, I tried the usual things, want to do a test of the fool to make sure that the power is really and I've been busy pressing FN + screen-switch-button, but nothing seems to help.

  Now my question really comes in two parts:

  1. what may be the cause of this problem? I guess the battery is dead - and past 1.5 years is probably what I read. But why it works when I remove the battery and just use the normal power cable? Clues as to what I can do here?

  2. How can I retrieve my data from my hard drive? The data are quite valuable, and even though I have backups of it, I always lose hourse valuable work if I'm not activate somehow of the transfer to another machine. I have a Dell laptop, but I don't know there that a hard drive from a Toshiba will go in a Dell. Maybe you can me if they work together?

  Look forward to hearing from you and thanks in advance for your help!

  Looks like there is a bad connection between the video card and display, or the VGA or LCD card have an intermittent fault.

  To back up your data, you can attach the HARD drive to another PC using a USB SATA 2.5 "HDD adapter.

• Satellite A100 does not recognize the new CD/DVD drive

  I bought a new CD/DVD drive for my A-100 of Toshiba Satellite age of four year old went crazy and wouldn't work.

  Unfortunately, I bought a DVD of Toshiba Portege A100 / reader Combo CD - RW that is not exactly what I had before the jump that it will still work.

  Unfortunately, I'm surprised because it does not recognize the CD/DVD drive at all: /...
  It seems to work, and the light blinks I think that it is not broken.

  I just plugged it because that's the way I was told to do.
  I need to download the drivers to operate?
  It will work on my laptop, or is it a "most recent" CD player that will not work with my laptop?

  I'd appreciate any help. THX

  The BIOS does not recognize this new CURIOUS because the player seems not to be fully compatible.
  I think there bad master/slave/c-salt settings

  As you know these settings can be changed on the external CD/DVD drive for desktop switching jumper. But it is not possible for computers portable CD/DVD players.

  You can solve it only purchase a new compatible disc.

  Usually the ASP in your country could help you buy this disc of these guys here
  However, you can consult the user manual if there are a few details on the compatible sides.
  My user manual provides this information.

• Built at the microphone of the Satellite A100 does not work

  According to the specifications of this laptop is supposed to have a built-in microphone.
  Impossible to get this working, tried test through Control Panel of configuration/sounds but nothing does.

  The voice said test not detected. All ideas, where is the mic, or should get just the external microphone
  Thank you
  Carlos

  Hello

  I agree with the JohnnyS. As far as I know that others of the A100 don t supported an internal microphone.
  If you want to use the microphone, you will need to connect an external to the mic socket.

  Greetings