N9010a

Similar Questions

• Configure N9010A attenuation in mode EPI

  Hello

  With CVI 2009 IVI Driver for the Agilent N9010A, I'm measuring spurius...

  in order to better search criteria, I need to apply the attenuation of 0 dB to the instrument.

  I can't find the API related to the mode of the SPUR and mitigation and the APU 'agmxa_ConfigureElectricalAttenuation' in the Setup menu only apply to the

  SCAN mode.

  any suggestions?

  Cordially Ofir

  Hello ofirga,

  I downloaded the IVI driver for the device you specified and noticed a few function calls from the IPS Configuration. I found these slot tree library instrument under Configuration > measurement Setup

  

  Hope that helps!

• LabVIEW for signal N9010A Agilent analyzer Analyzer

  Hello

  I have filtered signal in Labview, I want to see in the Agilent EXA, N9010A signal Analyzer. Is there software support/drivers to interface, helps that I can send this signal USB cable to monitor signals and display it in the signal Analyzer display.

  Thank you in advance.

  Livingstone

  Lol the input signal is not via the usb port. You seem familiar with the instrument.

• Agilent n9010a does not not at all of the frequency

  Hello

  I'm tring to control the instrument, but using the APi agmxa_ConfigureFrequencyStartStop sets the starting frequency as the Central frequency and the frequency of stop don't noting at all.

  is there a solution for the bug?

  Hi Scott

  I'm sorry my mistake...

  It works very well

  look of Ofir

• Problem with 2 GPIB instruments

  Hello everyone,

  I work in a program with LabView 2015 this control 2 instruments, the Rohde & Schwarz Smiq02b signal generator and Analyzer of spectrum n9010a Agilent EXA. I use the cable Agilent - 82357 B USB/GPIB to connect my laptop with these two instruments (PC-> EXA-> Doganovic). I also installed the two drivers of instruments from their official websites.

  The program worked correctly until I had to format my computer and reinstall LabView but something wrong now.

  The problem comes when I run the program, is unable to initialize the SMIQ02b, the program stops and opens a new window of block diagram. This block diagram belongs to a block driver the instruments within this scheme, there is a VISA write flashing block.

  

  This only happens when I'm initializing two instruments in the same program, if I create a new VI and use the Doganovic only, I have no problem.

  I don't know what is happening, it is very strange that it worked well before, and now this happens.

  That's what I installed in my laptop:

  -2015 LabView
  -NI Device Drivers (included NI-VISA 14.0 and NOR-488. 2 14.0)

  -Agilent IO libraries Suite (configured as secondary VISA) 17.1

  -Passport OR VISA for tulip IT

  I'll be very grateful if someone could help me with this.

  Thank you!

  You set a breakpoint, it's what's causing the break.