NB100 will not boot from the XP CD in the external USB CD/DVD drive

Similar Questions

• Portege Z930 - impossible to boot from the external USB CD/DVD drive

  I have a portege Z930 14U
  I am not able to boot from an external linke (Samsun SE-218) CD player via USB

  I already set the boot sequence and choosed CSM as model BIOS

  Thank you
  Andrea

  Try disabling secure boot in the BIOS too.
  Then connect the CD/DVD from the laptop drive and switch on the device.
  Press F12 and choose from the menu to boot from the USB device

• Z575 will not boot from the hard drive or restore DVD

  Need help on a laptop Z575 age of 2 years that immediately after an automatic update of windows, will not start either from the hard disk or restore DVDs (blue screen). Does not start in safe mode, not booting from a rescue of third party DVD. Attempt to start, it will show you the ability to start the Startup Repair tool. Repair shows that it is unable to fix with the detail following problem error messages:
  Signature of the problem 1: 6.1.7600.16385
  Signature of problem 2: 6.1.7600.16385
  Signature of the problem 3: unknown
  Signature of the 4:21200196 problem
  Signature problem 5: auto failover
  Signature of the problem 6:7
  Signature of the 7 problem: bad driver
  OS version: 6.1.7601.2.1.0.256.1

  Normally think that the hard drive has failed or that windows update caused a software problem, but the inability to boot from any restore disk that makes me think that there is another serious problem with the hardware of the laptop.

  Any help would be appreciated. THX

  Additional note: when you try to boot from a restore disc, blue screen, error message:
  Stop: 0x0000007B (0xF78DA640, 0xC0000034, 0x00000000, 0x00000000)
  It is a hardware failure that cannot be restarted soft.

  I also removed the hard drive and RAM, reinstalled and rebooted, no change.

  Additional note: I was able to access the hard drive with a recovery of old program, focused on the (SpaceFM) ram charged through the DVD player. Hard drive data appears intact. Still does not start from the hard disk or a DVD of windows system.

  Thank you. Rather than buying a 4 GB or more large key USB comes from put this into hard drive replacement. Installed correctly, boots very well now. No other error of the optical drive... and no explanation I can see, but that's it.

  Unless something else pops up we'll just call cela a HARD drive failed after 2 years of common use. Thanks again.

• Windows 7 for Lenovo G50-70 - the computer will not boot from the CD

  Hello world

  I hope that someone here will be able to help

  I bought a new laptop with Windows 8.1. I want to install Windows 7 on that I know well because I can't use the new windows. I changed the settings in the BIOS to get the machine to boot from the CD, but it won't be fair. I also tried to restore the system to boot from the CD, but it installs just the Windows pre-installed, new instead. Also, I can't access the CD from the drive while all my other computers are capable of (what is strange)

  Can someone help, please?

  See you soon

  PS. : I can turn on the computer through the small "boot botton" on the side and select the DVD drive to boot from. But this is not followed by the message "Press any key to boot from CD" and the computer starts just W8 yet;

  I contacted customer service and followed your advice. They refused to help him on the ground that there nothing wrong with the machine in their opinion, and since I wanted to change operating system. All preinstalled spyprogrammes Lenovo has been erased with this downgrade. So far, I've owned a laptop computer brand new and expensive for a year I used only to waste my time, trying to make it work, that was not why I bought it in the first place. What a RIP-OFF!

• HP Pavilion p7-1414 will not boot from the CD

  Hello

  I recently bought your desktop HP Pavilion p7 1414, I am trying to boot from a CD to reinstall Windows 8 - I put the CD to start first in the BIOS, but when I restart the computer and I have the CD, "press any key to boot from the CD" is not displayed.  It starts just directly to the computer HARD disk in Windows to connect.

  I have 64-bit Windows 8. 6 GB of RAM and a terabyte of HARD drive space.  I'm looking to reinstall Windows 8 for a new start.  Any ideas why it won't boot from the CD?

  Very happy!

  Hello:

  You must go into the BIOS and enable the legacy Mode and disable secure boot.

• Tecra M3 PTM30A will not boot from the cd to reinstall windows

  Hi all

  Totally new here and I have a question. I replaced the hard drive in the laptop, the old man died.
  I set the bios to boot from the cd. He reads the Windows XP cd for a minute then jump to trying to boot on the network adapter.

  Do I need to have the cd of recovery or must it be able to boot from a plain old XP cd?
  If it can boot from a normal cd is the stuffed ROM or am I missing something?

  Thanks in advance to anyone who can help you.

  Hello

  > I replaced the hard drive in the laptop, the old man died

  Your new hard drive is recognized by the Bios?

  > Do I need to have the cd of recovery or must it be able to boot from a plain old XP cd?

  You can use a recovery (if available) disk or Windows disk copy. In the Bios, you must set the Cd/DVD-ROM as 1st boot device and press F10 save and exit. Turn it back on. Thus, your computer you should start the installation of the Cd drive.

• Portege Z930-118 does not recognize the external USB CD/DVD drive

  My new Z930-118, with windows 7 64 bit home, does not recognize the external CD/DVD drive when I plug it into the USB port.

  The CD/DVD device does not even appear at all in Device Manager.

  The reader is a SE-S084 Samsun and works well on another laptop.

  I already checked for the "upper_filter", "lower_filter" with the regedit, but entries are not there, so no help.

  Hello
  I m not very well how to help you.

  I found some information about this WEIRD disc and it seems that he didn't need an external power supply. Its USB bus powered so I guess around 500mA power since it is the default value provided by a USB 2.0 port.

  I don t think that there is a problem of missing software. It is a plug n play device so you need to connect it to the USB port and the system should automatically recognise.

  From my point of view of the few you try to connect the external USB ODD two ports to aid a * Y * Cableusb.
  I think the reader needs more power provided by a single USB port.

• M91p will not boot from the CD

  I try to install a new SSD in my M91p, but when I press Enter for the splash screen, change the boot order have only Boot from CD rom, then reboot, I get a "error 1962: OS not found" message.

  I checked the DVD rom is functional by returning to the old HARD drive and use it.

  What Miss me?

  
  

• Stops on his own computer and will not boot from the CD

  someone entered cmd and did something to my computer, now, the computer shuts itself, what can I do I tried to reinstall windows and the computer does not start from cd?

  * original title - someone entered cmd and did something to my computer, now, the computer shuts itself, what can I do I tried to reinstall windows and the computer does not start from cd? *

  At the startup/power on you should see at the bottom of the screen either F2 or DELETE, go to Setup/Bios or F12 for the Boot Menu

  Go to your Bios/Setup, or the Boot Menu at startup and change the Boot order to make the DVD/CD drive 1st in the boot order, then reboot with the disk in the drive.

  See you soon.

  Mick Murphy - Microsoft partner

• Windows 8 HP laptop Pavilion will not boot from the cd?

  Hi all

  I have a Windows 8 HP Pavilion laptop. I forgot the password of my account, but I wasn't worried because I had a recovery disc. However, even with the cd in the laptop, I directed to the login page every time. I want the cd to run the place and recover my account! I have enabled the legacy in BIOS and disable secure startup, and I even changed my boot order to put the boot first CD. None of this works well. Can someone help me? I really want to access my laptop soon.

  Thank you

  Alice

  Immediately after switching on the laptop, press the ESC key to get a menu. Then press F9 boot options. Use the arrow key to move down and select/highlight the CD/DVD drive, and then press the Enter key.

• Re: satellite A300 screen turns off after the toshiba logo, will not boot from the CD/DVD

  Hello, I have this problem with Toshiba satellite A300.

  I deleted several files and folders of my drives C and E. To restart the computer, it only shows the Toshiba logo then a slightly gray white screen on a thorough inspection. Whenever I press CRL + ALT + DELETE, the computer restarts and behaves in the same way.

  I tried to use an external monitor, but there is no difference. The tent to start using a CD/DVD, same behaviour occurs, it does not start and screen remains blank after the Toshiba logo, I tried even to change g the order of boot, but in vain.

  What could happen?
  Thanks in advance.

  Hello

  It seems that you deleted system files and Windows no longer starts. Have you tried to restore the disk image factory settings or hard drive recovery? Or do copy the Windows installation... It is easier to reinstall rather fix the problem.

• R3000 Presario will not boot from the cd after installation of windows 7

  Hello

  I have an old Presario R3000, someone updated to windows 7, has a few problems, including the cd player read don't not bootable disc, because I would like to install Vista instead, any suggestions on how to solve this problem, thanks in advance.

  chefey aka David

  Hi Futoji

  Portable office, dismissed plugged DVD and voila, it worked. I have an installation disc Windows 7 Starter and installed as I thought it would be better for! GB of memory, was not bothered with it runs, so Vista, installed fine. Some drivers are missing, sound and player card, as it's XP, so no drivers HP, I have a fixed front sound, means add files in a folder of the directory, will have to google search it again once, thank you very much for your advice, which fixed the problem, I am not too bad for a surfer of money. I know the numbers of the missing drivers, it's just a case of locaing, some of the download sites are very confused. Once agai thanks.

  David

• error 303_will will not boot from the optical drive W / re disc

  Thanks for your time

  I have a pre Home HP G71 449WM computer PORTABLE PC WINDOWS 7 X 64

  I ran diag, he gave me (hard disk 1 (303) quick test full 10% complete)

  (305) full hard disk 1, HARD TEST drive has FAILED: what about hard disk

  failing or failed in any case, I changed the HARD drive for an ssd sata 2 and installed

  He also ordered the discs (3) of recovering formatted the SSD to another

  PC (primary healthy NTFS partition) No. DRIVE LETTER when formatted

  I loaded the 1st recovery disc in the optical drive, but it wouldn't start

  optical drive AND MY SCREEN IS WHITE

  the recovery disc are Moose HP (BDPX4721)

  THE SSD WORKED OK IN THE OTHER PC... ANY IDEAS WHAT I AM DOING WRONG?

  the printer has to do with boot_recovery_error 303

• Portege R100 - boot from the external HARD drive

  I have a Portege R100 and the HARD drive has failed. I installed a new HARD drive and I have the Toshiba recovery disks. I tried to boot from a generic USB CD-ROM but the laptop did not recognize.

  I have a disk of Toshiba USB drive it does not recognize and I have a restore disc but I don't know how from there. Do I have to buy a CD external Toshiba and if so, which?
  Any useful suggestions?

  Hello

  Boot from the external USB CD/DVD drive is not possible.
  You will also be able to boot from USB HDD!

  If you want to boot from the CD, you must use a compatible PCMCIA cards (16-bit and 32-bit Cardbus) CD/DVD drive.

  For more information, see this article from Toshiba:
  http://support.toshiba-tro.de/KB0/TSB5100S70004R01.htm

  and this other thread:
  http://forums.computers.Toshiba-Europe.com/forums/thread.jspa?MessageID=97343𗰿
  http://forums.computers.Toshiba-Europe.com/forums/thread.jspa?threadID=8991&MessageID=31246

  Good bye

• 3490CT: is is possible to boot from the CD USB drive?

  While I read in this forum that it is not possible to start a ct 3049 since an external USB CD drive, I read elsewhere on the web (I can find is no longer the link) it is possible to boot from a USB CD drive as long as it's an Iomega brand player.

  Can anyone confirm on deny for me please?

  Hello

  You can boot from the external USB CD drive, but you need a supported drive.
  Please also check this topic on the forum:
  http://forums.computers.Toshiba-Europe.com/forums/thread.jspa?threadID=944&MessageID=2086#2086

  Good bye