Network of comments can be hidden?

Similar Questions

• I am not able to connect to the main wifi network but can connect to the network of comments.

  Hello

  This is something new, I am facing to where I am not able to connect to a main network of airport extreme, but can connect to the network of comments. Guest network works perfectly fine while the main network does not connect to devices in the home. I also found that none of my base stations are visible in the airport utility (I Airpot extreme and Airport Express on the same network). Help, please.

  The first step in troubleshooting with this type of problem is to perform a complete network power cycle on your network. If you decide to do...

  Power off all the devices on your network... modem, routers, computers, printers, etc... in any order you want.

  Wait a minute

  Turn on the modem first and leave a few minutes, he managed by itself

  Turn on the next device that is connected to a modem and leaves turn a good minute

  Keep turn on devices one by one at a time, one minute apart, until the entire network is back

  Recheck the network and report on your results

• Extend a network of comments with AEBS and TC set up a connection

  Hi all-

  I was wondering if anyone has had any success with that extends a network invited on two airports or more that are wired together.  I use currently a Time Capsule as my main router (802.11ac), and have it configured with DHCP and NAT like fashion.  It connects via a connection wired to an Airport Extreme Base Station (802.11ac), which is set in Bridge mode and configured with a static IP address to the primary time Capsule.  The time Capsule is configured with a network of comments that is fully functional, and the AEBS extends the primary network using the same SSID and encryption on 2.4 and 5 GHz.  However, when I turn on the AEBS remote networking reviews, I can connect to the AEBS, but cannot obtain an IP address (the computer displays an automatic address assigned).  The SSID and the encryption is the same for both networks of comments.  I tried to use "extend a wireless network" on the AEBS and that will extend the network, but it is extremely slow due to the wireless connection it creates between two access points (I have the TC and wired together AEBS to offer increased coverage, because my house is not very "friendly wifi").

  I would greatly appreciate any help or insight anyone can provide, even if it's to tell me that a cable extension of the network of comments is not possible.

  Thank you

  Mike

  Wired to the guest network feature extension is indeed possible and should be implemented and enabled automatically if you are using "Assistant" Installation from Apple to expand the networks main and guests.

  I had this set up on the 2 airports and sometimes 3 for a few years and not a single hiccup.

  Suggest that you reset the AEBS back to default settings and then use configuration Apple "Wizard" to set up the AEBS again. It automatically adapts the AEBS to expand networks main and guests.  Everything you really need to do is enter a name of device to the AEBS, the wizard takes care of everything else for you.  It is one of the simplest game ups ever.

  Once you have the updated AEBS up and running, you can assign a static unit IP address if you want to, but it should not be necessary.

  After the back if you need some advice on the use of the Apple Setup Assistant to do the work for you.

• Network of comments Airport Extreme (7.7.3) has stopped working

  Our network of comments Airport Extreme (7.7.3) has stopped working.  We moved offices and even if my MacBook Air (13-inch mid-2013, El Capitan 10.11.3) can see the two networks, the option of comments does not connect to internet at all.  I did a reset of the Airport (essentially started above) and always the option of comments does not connect.  All software are up to date.  AAACCCKKKKK!

  You probably had AirPort Extreme to the old office set up as a router to provide DHCP and NAT services for the network.

  Now, the AirPort Extreme in the new offices may have probably been implemented in Bridge Mode to work correctly with the "new" network  If this is the case, then the guest network will not work correctly when the AirPort Extreme in Bridge Mode.

  Check this option as follows:

  Open Finder > Applications > utilities > AirPort Utility

  Click on the image of the AirPort Extreme

  Click on edit in the window that appears

  Click on the network at the top of the next window tab

  

  Check the settings for the router Mode.  Is is "Off (Bridge Mode).

  If so, the guest network is unable to function properly in this environment.

• How to prevent users to access network of comments?

  Hello everyone,

  I have a business network (users are using NAM, User and Pass of AD and chaining EAP) and a network of comments (authentication Web portal, local database ISE).

  I don't want my corporate users to access the network of comments (to assume she got a user and pass for this). How I do that?

  I know that it is possible to block connections on NAM, but I would like to know if we can control it at the ISE, and not on the client.

  Thank you.

  Unfortunately no, unless you have an identity store that contains the machine of the company mac addresses, you cannot differentiate between comments and pc peripheral companies. Your users don't take their machines outside the corporate network normally?

• Wireless and network of comments and HREAP

  Hello

  I inherited a wireless infrastructure that consists of a head office with WCS and WLC more LWAPP access points.

  There is a satellite office in another city who want to deploy a wireless infrastructure and it seemed to me like they want to only deploy a couple of AP that HREAP would be good to use this senario.

  However, they also want to use the network without comment thread that we at Headquarters but I don't want their guest to come to our DSL modem that we have put in place for the guest HO wireless traffic. The two offices are connected via a MPLS who no longer have need of traffic thereon.

  Is it possible to set up the HREAP and the WLC and WCS so that auxiliary office broke out locally for comments and even the admin Hall to HO can control the password?

  Thank you very much

  Hi Nell,

  the feature you're looking for is "local switching REAP H."

  So, you can set the access point remote mode H-REAP (which optimizes for "behind a WAN link") and from there, you can define multiple SSID as "local switching.

  This means that everything related to the phase of authentication is managed by WLC, but after authentication, traffic fell locally to the AP and not transit through the WLC.

  Guest SSID must be enabled for local switching, and then, on the APs REAP H, go to the configuration of the AP (in tab 'Wireless' WLC, then click ap) and on the hreap tab, you can configure the vlan where the traffic of comments will be abandoned at the remote site. It must be a vlan that exists on the remote site, and users will receive a DHCP address on this vlan.

  Kind regards

  Nicolas

• My macbook pro was factory reset and now it lights up with flashing? And when I go beyond that to choose the network but I can't go beyond that

  My Mac Pro was factory reset now it is coming with flashing? And when if and when I passed it will choose the network and I can't go beyond what I'm doing

  The flashing? the Mac is to tell you that it is unable to produce a valid system for starting.

  Try to make a recovery of the internet start-up as described in OS X: on OS X Recovery - Apple Support

  Looks like your hard drive is dead.

  I hope that you have a backup.

• All my iTunes music is on a disk hard Ext. connected to my home network through a router. Is it possible that devices that are part of my home network share iTunes can access the music on this disc hard Ext. without my laptop being on?

  All my iTunes music is on a disk hard Ext. connected to my home network through a router. Is it possible that devices that are part of my home network share iTunes can access the music on this disc hard Ext. without my laptop being on?

  Additional information: the laptop is what I used to install all the music, via iTunes, which is located on the external hard drive connected through home network router.

  Is it possible that devices that are part of my home network share iTunes can access the music on this disc hard Ext. without my laptop being on?

  Laughing out loud

• A web page like facebook can be hidden from the family safe?

  a web page like facebook can be hidden from the family safe

  Moved from feedback

  Original title: family secure

  Hello!

  What do you mean by parental control can be hidden?
  Is it hidden in the activity reports? Or able to access Facebook, where it is blocked?
  If both Yes, which is not possible.
  Thank you!

• I installed a new OS and now I have no wireless on the list of the network. I can't connect to my pro overdrive unless it is attached. Is there a download I need?

  I installed a new OS and now I have no wireless on the list of the network. I can't connect to my pro overdrive unless it is attached. Is there a download I need?

  Download wireless network drivers

  Visit the manufacturer's Web site and select your model (this is usually done in the Support section). You should be able to download drivers for your model if they have drivers for your version of Windows. Download the driver (s) and follow the instructions to install - every computer is different, so I can't give you exact directions.

  If you cannot access to the use of the internet, another computer and save the driver on a CD/DVD/card reader.

• My new system see the the old system in the network, but I can't get the passwords to work and I tried all the. Now what?

  ESTABLISHING A NETWORK.

  My new system see the the old system in the network, but I can't get the passwords to work and I tried all the. Now what?

  Hello

  1. don't you make changes on the computer before the show?
  2. what version of operating system you are using on the computer?
  3. which network you're talking about (home wireless network or group)?
  4. which steps have tried?

  
  If you use a group home on the computer, see the link for more information.
  Home Sweet homegroup
  http://Windows.Microsoft.com/en-us/Windows7/help/home-sweet-HomeGroup-networking-the-easy-way

  You can also check out the link.
  Microsoft's strategy concerning lost or forgotten passwords
  http://support.Microsoft.com/kb/189126

   
  Provide us more information for you to help.

• A computer is visible on the network, but I can't find another computer on the home network.

  Networking troubleshooting maxed out. Need help

  2 running XP Pro Machines on the same network home. At the Working Group under the same name. Check the properties of LAN connection sharing to share. My firewall except for sharing/printer. PING was successful at both. A computer is visible on the network, BUT I can't find another computer on the home network. Any help would be appreciated.

  Hello

  Check if you are able to access the computer.

  (a) press the Windows key + R.

  (b) type the name of the other computer in the open: box in this format:

  \\computer

  (c) press on enter

  You can also try the steps of troubleshooting provided in the link below.

  How to troubleshoot a network home in Windows XP

  http://support.Microsoft.com/kb/308007

  See also;

  Network map doesn't display your Windows XP computers

  http://TechNet.Microsoft.com/en-us/library/cc754938 (WS.10) .aspx

• I can't access my email works through outlook over a VPN. The signin VPN works ok, I can see my network co., but can not use outlook. 'Microsoft Exchange Server' reported an error (0 x 80040115)

  prospects for bt infinity

  I recently changed my home to infinity of BT broadband.  Now I can't access my email works through outlook over a VPN.  The signin VPN works ok, I can see my network co., but can not use outlook.   I get the following error at startup of outlook.

  Task 'Microsoft Exchange Server' reported an error (0 x 80040115): ' the connection to the Microsoft Exchange Server is unavailable.  Outlook must be online or connected to complete this action. »

  Anyone have any ideas?

  Allan M

  Hello

  Your question of Windows 7 is more complex than what is generally answered in the Microsoft Answers forums. It is better suited for the IT Pro TechNet public. Please post your question in the TechNet Windows 7 networking forum.

  http://social.technet.Microsoft.com/forums/en-us/w7itpronetworking/threads

  Kind regards

  Ramata Thakur

• XP has disappeared from the network and I can't get it back

  My XP machine does not appear on my network more.  My network with both XP and a MAC wireless machines worked fine until I added a desktop Windows 7 computer.  Now, one of my XP machines disappeared from the network and I can not get it back.  I have run the Configuration Wizard from the network a million times, but the device still does not appear.  What I am doing wrong?

  From the other thread: http://answers.microsoft.com/en-us/windows/forum/windows_xp-networking/windows-xp-machine-does-not-show-up-on-network/fadc36ac-73de-428f-9018-bedebd72cb2d

  Title: Windows XP machine does not appear on the network after that Windows 7 has been added. Also have Mac on the network as well.

  I set up a home network with two XP machines connected to my router and a Mac with a Wi - Fi connection.  I added a Windows 7 machine and now one of the XP machines does not appear as a member of the Working Group on all machines (including itself!) even after the wizard as many times.  Curiously, I can share files and printers.  How can I get this machine to appear on the network?

  original title: home network problem

  Hello

  The following article might be useful:

  Solve problems with computers not appearing is not in the network map

• I'm trying to set up an ad - hoc network if I can use my laptop to share our wireless internet connection.

  I'm trying to set up an ad - hoc network if I can use my laptop to share our wireless internet connection. first time I tried, I managed to do this successfully. When I was through, I deleted the network connection. now, when I try the implementation of another, I get a "windows could not set up * network name." No matter what I change, the settings of the firewall market, I can't work. My laptop is connected to the internet through the LAN.

  I am running windows vista Home premium. Computer is Hp Pavilion dv6
  original title: try to set up an ad-hoc connection

  Hello

  Follow the suggestions from the link and check if it helps:

  Error message when you try to connect to an ad-hoc connection in Windows Vista or Windows 7: "Windows cannot connect to" " "»

  http://support.Microsoft.com/kb/946481

  Reference: Set up a computer-to-computer (ad hoc) network

  http://Windows.Microsoft.com/en-us/Windows-Vista/set-up-a-computer-to-computer-ad-hoc-network

  Ad-hoc networking

  http://Windows.Microsoft.com/en-us/Windows-Vista/ad-hoc-networking-how-the-network-with-the-funny-name-can-make-your-life-easier