No boot, the file is possibly corrupt

Similar Questions

• Toshiba satellite running Vista. The file is possibly corrupted. The file header checksum does not match the checksum calculated

  Toshiba satellite running Vista. The file is possibly corrupted. The file header checksum does not match the checksum calculated. Tried all posisible boots and no joy, continues to turn it back on! Frustration...

  Hey James,.

  I does no change, I didn't download a document from my email (from a sender of confidence). I tried to start in safe mode, just, it restarts and goes back to the corrupted checksum display... Last known good config was the same result! The only error message is one that is in the title of this post, not others. Another detail, that I forgot to add is that it does not get insofar as a logo windows before it fails, just the toshiba start screen, then either passes the corrupt message checksum or a blue screen and restarts before I can read the text on the blue screen. Thanks for your response! Any additional help would be excellent if you can. In the meantime, I'll try your methods. Thanks again
  OK, I have now managed a Startup Repair trying over and over again. Restore all settings and now looks very good, thanks for your help!

• startup error message: the file is possibly corrupted. the file header checksum does not match the checksum calculated

  there about a week after my regular weekly backup, I use windows 7. Alert Center said action my changing the backup settings wre I like to keep the changes that I ticked Yes and continue as usual I did some scans using norton 360 newspapers has restarted my computer and it would not stop so I close it down manually to I restart applicant organisation a normal start then all sorts of things happened first a message that says windows has been stop because of the ether hardwre or software recently andded likely to damage my system, I tried to get a recovery screen not go short verison.nothing work but after a new aaand powwersupply erase the bios I have go as far as the above message and it nothing going on this point, there is an office on my home network so I, m using my notebook. hope this will be enough.

  Hello

  Use the Windows recovery environment (WinRE) to run the system restore.

  Try the procedure described in the following article: http://support.microsoft.com/kb/940765

• error indicates "file is possibly corrupted. The checksum does not match the checksum calculated.

  Hello world

  I use Vista Home Basic, SP2. Windows takes a lot of time in the judgment and often fails to do this completely. Windows after logout again a soft purr at the disk continues. Windows fails to start quickly. After several reboot it starts and sometimes even refuse except CD assisted.

  In order to repair boot directly from CD is not possible either. Jump the trunk and windows from the Windows CD start loading.

  Error, States "Checksum error. The file is possibly corrupted. The checksum does not match the checksum calculated'.

  Do I have to reinstall windows or any help please.

  Jean-Philippe

  Hello

  I suggest you to follow the methods and check.

  I suggest you perform a check disk in Windows Recovery Options.

  What are the system recovery options in Windows Vista?

  http://Windows.Microsoft.com/en-us/Windows-Vista/what-are-the-system-recovery-options-in-Windows-Vista

  Warning of Chkdsk.

  Important: If all data on the hard disk may be lost when running chkdsk, as the chkdsk attempts to repair that affected sector.

  Diagnosing memory problems on your computer

  http://Windows.Microsoft.com/en-us/Windows7/diagnosing-memory-problems-on-your-computer

• Windows cannot install required files. File is possibly corrupted or missing. Error code 0 x 80070570

  I have Windows 7 Professional upgrade disk. I select custom installation. the trial ends approximately 54% then displays this message: Windows cannot install required files. File is possibly corrupted or missing. Error code 0 x 80070570 do - what I do?

  try to install by removing a strip of memory (RAM) If you have 2 stick of ram installed.

• Error: 0 x 87160129 the file may be corrupted or in a format does not recognize this Director

  Try to make a video about windows live movie maker... and download the photos to my computer and I get this message!

  Error: 0 x 87160129 the file may be corrupted or in a format does not recognize this Director

  It's a Windows vista... Home (64-Bit operating system)

  Thanks for any input.

  Hi BrendaKennedy,

  When you use Windows Live Movie Maker and the question you have posted is related to Windows Live, so it would be better suited in the Windows Live community. Please visit the link below to find a community that will provide the best support.

   

  Movie Maker Portal

  http://windowslivehelp.com/product.aspx?ProductID=5

  I hope this helps.

• "Information MS cannot open this file. The file may be corrupt or incompatible with this version of the information system. »

  Original title:

  MS Info

  I need to send a file Ms Info to Wb tech support so that they can help me with the game on steam download. Whenever they open the file it says it gives the following message "information MS cannot open this file. The file may be corrupt or incompatible with this version of the information system. "I tried to open it too and had the same error message how can I send a file not corrupted for them?

  Information MS cannot open this file.

  They should use Notepad to open the file when it is a txt file.

  Another way to create a portable system information file is to select the hotkey Win + R, type msinfo32 , and press ENTER . Click file, Save and name the file. This method creates a file with an extension of nfo file. Perhaps the recipient expects the file in this format.

• I DELETED MY PDF FILES AND AGAIN USING THE RECOVERY SOFTWARE I FIND ALL MY FILES BUT NOW WHEN I OPEN FILES THAT IT SHOWS (THE FILE MAY BE CORRUPTED OR NOT SUPPORTED FORMAT.NO HOW CAN I OPEN THE FILES.) ALL OF THEM ARE MY DOCUMENTS IS VERY IMPORTANT. PLEAS

  I DELETED MY PDF FILES AND AGAIN USING THE RECOVERY SOFTWARE I FIND ALL MY FILES BUT NOW WHEN I OPEN FILES THAT IT SHOWS (THE FILE MAY BE CORRUPTED OR NOT SUPPORTED FORMAT.NO HOW CAN I OPEN THE FILES.) ALL OF THEM ARE MY DOCUMENTS IS VERY IMPORTANT. PLEASE PROVIDE ME WITH A

  Deleted file recovery can recover incomplete files, i.e. the part of these files may be missing.  Recover deleted files is much more reliable if recovery of a backup, instead of using recovery software.

  These things depend on the operating system and the file system.

  One thing, you can see: open one of these files damaged with a text editor, and then make sure that the constant % PDF is somewhere in the first 1024 bytes.

  PS please do not post ALL uppercase; It is very difficult to read!

• Does not start Satellite A200 - checksum of the header file is possibly corrupted

  Does my Toshiba Satellite A200 on Vista.

  The following message appears on the screen: "the file is maybe damaged. The checksum of the file header does not match the checksum calculated.

  I tried reinstall drive, but it does not solve the problem.
  The following message is displayed: status: = xc0000428 (as well as instructions that do not seem to help at all).

  What can I do?

  Hello

  You mean that the new installation of operating system using Toshiba Recovery disk didn't?
  Hmmm, in this case, it seems like a RAM problem

  I searched a bit on the net about this error and found some info that might be linked to the faulty RAM memory.

  You should try to verify if a single one single module of RAM is affected.
  Otherwise you need to replace the two modules and then should try reinstalling the operating system.

  Welcome them

• Adobe Captivate could not open... Ensure that the file is not opened, the file is not corrupted... etc.

  Captivate 5

  I have

  I worked on this project (slide @175).  Suddenly, that I save my changes, the program freezes & has close & it seems now the file is corrupted.  Am I basically screwed here?  Is there a hope for this file?  I read that Captivate 5 manages so-called projects with 400 + slides, so mine should not be a problem.

  There are no other open programs, the file is not already open.  I guess I'm screwed & spend 2 days to redo the work I just do.  Fortunately, I have a backup, but a backup that does not include about 16 hours of changes.  This has always been a fragile product and I had hoped that Captivate 5 which had improved, but I do not.

  Any help is appreciated

  

  Hello

  See if the link below will help you.

  Click here to see

  See you soon... Rick

  Useful and practical links Captivate wish form/Bug report form Certified Adobe Captivate training SorcerStone blog Captivate eBooks

• File is possibly corrupted (Checksum)

  Hello, I have Windows Vista Home Edition 32 - bit office, it's about 2-3 years. And, when I start my computer, I get a black screen saying "the file is maybe damaged. The file header checksum does not match the checksum calculated. "Help, please! Thank you!

  Hello, thank you for answering... It seems that it is the dust that was plaguing the hard drive... Thanks again!

• Cannot open an image of PS. I think that the file has been corrupted?

  Well, I'm an artist and I use Photoshop to draw. I was in the middle of working on a drawing, and then my computer crashed. What it a few times and I saved the image fairly recently, so I was not too concerned. But when I tried to open the file after I restarted my computer it says "could not complete your request because it is not a valid Photoshop Document." I tried to see if I could open on Sai and it wouldn't let me (and Yes, SAI is comparable with PS files i ' v open PS files it several times before). I tried to copy the file and open the file copied, but that did not work ethier. How can I fix? I'm quite upset because I lost all my progress in the arts, especially when I liked how it came out.

  Thanks for any response.

  Hi roseh82388884,

  Please try steps below and see if they help

  1. first create a copy of the image as a back up

  2. check this link below to enable filename extensions

  http://blog.LapTopMag.com/show-file-extensions

  3. now, please try it out below mentioned steps.

  • Right-click on the file-properties
  • Under general, change the file for the name.tif file extension
  • Click on apply and then ok

  Now open the file and see if that helps

  Concerning

  Rohit

• After typing password password protected document (ABSA) I get the following message: "Adobe Reader could not open 'index.html' because it is not a type of file supported or because the file has been corrupted (for example, he was sent as an email.

  After typing password password protected document (ABSA) I get the following message: "Adobe Reader could not open 'index.html' because it is not a supported file type or because the file has been damaged (for example, it was sent as an attachment to e-mail and has not been correctly decoded)" when I send the attachment to my husband that he can open it.  P

  Hi idwa,.

  As I mentioned this file must be opened with the correct application. You will get the best understanding of your problem on this forum link: what is required to read the files .emc of ABSA bank

  Kind regards

  Ajlan Huda

• When I tried to open the bought one of the files with Adobe Reader purchase ebook, he said Adobe Reader could not open ' URLlink (2) .acsm ' because it is not a type of file supported or because the file has been corrupted (for example, it was sent

  When I tried to open the bought one of the files with Adobe Reader purchase ebook, he said

  Adobe Reader could not open ' URLlink (2) .acsm ' because it is not a type of supported file or because the file has been damaged (for example, it was sent as an attachment to e-mail and has not been correctly decoded).

  Adobe Reader can open PDF files; for the .acsm file, you need Adobe Digital Editions.

• Windows cannot install required files. File is possibly corrupted or missing. Make sure all files required for installation are available, and restart the installation. Error code 0 x 80070017

  Try to install vista to a friend after that one completely uninstalled.  I start to install and then stops and says file corrupt or missing.  Error code 0 x 80070017

  How to clean install Vista:

  Go to your Bios/Setup, or the Boot Menu at startup and change the Boot order to make the DVD/CD drive 1st in the boot order, then reboot with the disk in the drive.

  At the startup/power on you should see at the bottom of the screen either F2 or DELETE, go to Setup/Bios or F12 for the Boot Menu

  http://support.Microsoft.com/default.aspx/KB/918884

  MS advice on the conduct of clean install.

  http://www.theeldergeekvista.com/vista_clean_installation.htm

  A tutorial on the use of a clean install

  http://www.winsupersite.com/showcase/winvista_install_03.asp

  Super Guide Windows Vista Installation

  After installation > go to the website of the manufacturer of your computer/notebook > drivers and downloads Section > key in your model number > get latest Vista drivers for it > download/install them.

  See you soon.

  Mick Murphy - Microsoft partner