Partition lost after diskpart own

Similar Questions

• Partition lost after recovery - Satellite L30

  I had two partitions on my HD (Satellite L30-114).

  I used the Toshiba recovery Cd to restore windows back to my laptop. The CD has not offered me a full mode or an Expert as written here http://support.toshiba-tro.de/kb0/FAQ350072001GR01.htm he has just recovered without any input on my side!

  After recovery, Windows does not see my second partition. I used the disk management utility, and it is said there are 17 GB of disk unassigned space (this is my second Partition!).

  Can and how can I restore it?

  TX a lot!

  Hello

  It seems that the L30 comes with a new version of the recovery cd.
  I think that the recovery procedure is a bit different than the old with 2 different recovery modes (standard and expert)

  I know a little new recovery procedure because a friend of mine bought a new Satellite with this recovery CD. He asked me for the installation of the laptop and we checked.

  It seems that you must press the setting button after the language selection.
  If you n t use the button setting for the configuration if the recovery procedure will be remove and erase everything on the HARD drive. I think you didn't configure the settings and therefore all the partitions have been deleted.

  Unfortunately I think that there is not much to do. You the partition has been deleted and it of not possible to bring back the lost data.

• Partitions disappeared after DiskPart

  I had 5 partitions under disk 1 320 GB, C, D, E, F, G, H, windows running on C 10 GB, I needed to extend the C:, I used diskpart to merge d: 63 GB on c:.

  1. Select volume d:

  2 remove this volume

  3 - Select volume c:

  4-volume range

  5. output

  After that I did a restart of the computer and everything was fine C: is now 73 GB, I got C, E, F, G, H .and of course space was merged into C: D:.

  but after the extinction of the computer, I found the E, F, G H disappeared.

  How can I make these were leaving appear once again, WITHOUT LOSING THE DATA? !!

  TestDisk

  John

• HP 280 G1 (N9E78EA): Partition disappears after power failure, watch now unallocated

  Hello!
  I have a PC
  HP 280 i5 - 4590S G1 / 8 GB/500/DVD-RW/W10P + 7Pro64
  and
  Pro series SSD Plextor 128GB 2.5 "SATA SSD M6.
  
  Partition disappears after power failure, watch now unallocated.
  I tried to use TestDisk to see what was going on. After crossing the 'Analysis' command and deep research, but the partition disappears.
  Any suggestions on what I should do next?

  Your SSD have lost files due to the power failure system sudden. I suggest you run CHKDSK to fix this error. Also remember, if the data stored in your SSD are important to you, then first the software of raw data as WDR pro of stellar phoenix recovery and then apply diagnoses to repair.

• lost after upgrade to El capitan photos

  Help

  I lost priceless pictures of a loved one lost after updating my old OS to El Capitan.

  I now try to revive photos, hold the option key and select another photo library to see if this will bring my photos.

  I was using an old OS and when my iphone 5s was stollen over the weekend, I bought an iphone 6 when I plugged the new phone to put all of my previous settings and data on it said I have to upgrade my operating system to synchronize this phone.

  I hesitate to update the system, but did it anyway.

  then, when she opened the only pictures that remained on the computer are those that have been taken with my iphone or photos that come from the internet or social networks.

  I lost all my albums of photos taken with a canon ios device.

  These photos are not in time machine.

  How can the computer just delete the photos on its own... How does he choose what to keep and what to delete.

  Please help... I refuse to give up and accept that the computer can simply delete photos and videos.

  Take a look in your images folder and see if there is an iPhoto library.

  What OS did you spend.

• Boot Partition lost, cannot start Windows 7

  I was recently install a new OS (Linux) on my netbook (Dell Mini Inspiron 1012) and by mistake I installed in the recovery partition Dell which is at the same time has the boot to Windows 7 files. So, after doing so, I was not able to start on my Windows 7 more.

  I first tried a Windows 7 recovery CD (since a USB bootable as my netbook does not have a CD), and he said: there was no Windows 7 installation file found.

  And then I went on the CD supplied with the thought dell netbook, I can just do a new installation to use, copy it's content from another computer on a USB key, then makes it bootable. But it stops every time on the stage of loading of the installation files.

  I do not understand how we rescue CD with our netbooks with no CD! But even copy the CD contents to a port USB not working!

  Now, I have the Windows 7 partition with all system files, but just startup files are missing. I tried to look for them online, if I found them I can put them in the same partition of Windows 7 and let the recovery (or grub bootloader) to detect them.

  Please help me to recover the deleted partition, or to find startup records, or if I can download the contents of the support of Dell recovery partition. I want to just my Windows 7 back.

  Any help would be appreciated, thanks in advance

  Hello congilia

  If you can start the recovery win7 usb and get to a command prompt,

  Run diskpart and activate the win7 partition then exit diskpart.

  implement this disc %sysroot%\windows\system32

  then run BCDBOOT. EXE C:\Windows

  who should install start-up on the windows partition files 7.

  Hope this helps

  Tom

• HP Pavilion Notebook - 15-p206: WiFi lost after updating the BIOS of HP Pavilion Notebook - 15-p206tx on windows 10

  Hello
  
  WiFi lost after updating the BIOS of HP Pavilion Notebook - 15-p206tx on windows 10.

  Update driver BIOS update effective system is rebooted and the wifi does not.
  
  Please help me.

  In the box to Ask Me whatever it is next to the Windows icon, type in "Installed updates", and then click view installed updates.

  Select the update that is dated from when you had the question.

  Click it to uninstall.

  You have to restart the laptop afterwards.

• WiFi lost after winning 10 improvement on Satellite P745-S4217

  Help! WiFi lost after upgrading to windows on my SATELLITE of P745-S4217 10

  Drivers have installed successfully but when I troubleshoot, windows tells me wireless capability is turned off

  I search on the net, but still no solution to my wireless connection interruption

  Any help will be appreciated thanks

  Hello

  In the past, you need to turn on the WiFi using the FN keys, but I think that this should not be necessary to help to win 10.

  In any case, I think that you must connect to the laptop to the internet using LAN cable.
  Then, you must uninstall the WLan Device Manager driver.
  After that, restart the laptop in order to win 10 to select the Wlan driver automatically.

  As far as I know that Win 10 must check for new drivers available WLan and in the best of cases after the update, the WiFi connection should work again.

• All my tabs are lost after downloading an add on. The tabs start showing my default homepage.

  All my tabs are lost after you download an add-on. The tabs start showing my default homepage. Do I have to have all closed tabs before you download an add-on Firefox? Even the site of add-on Firefox restarts as my default homepage. Is there an add-on to prevent that from happening?

  This has happened

  Each time Firefox opened

  Is always

  Diito. Mozilla/5.0 (Macintosh; U; Intel Mac OS X 10.6. en-US; RV:1.9.2.6) Gecko/20100625 Firefox/3.6.6

• Network is lost after stanby mode - Satellite M40

  I'm from Holland
  I have a Dug Satalite M40 - 170 for several times that the network connection is lost after sleep.
  What is the sollusion. OS = Windows XP prof.

  [Edited by: admin November 23 05 07:07]

  Hello

  My unit is also connected to the company LAN. You use very often stand-by and hibernation mode, but after the awakening of procedure the connection is establish again shortly after.

  Try disabling the network card for a just a few seconds and turn it back on. This option that you can find in tool ConfigFree.

  Good bye

• Bootcamp partition unusable after the failed kidnapping attempt

  Hi, I'm having a problem with my Imac, for reference, it is a model of 2013 with an Intel i5, 32 GB of ram and a 250 GB ssd.  I got it initially setup with a partition boot camp of 100 GB running windows 7 but windows encountered problems and wouldn't start.  I used the boot camp assistant to delete the partition, but after being run for awhile it has failed, and when I looked at the disk utility, is more showed the boot camp partition and only recognizes the 100 GB of space.  Now I have a 156 gb hd mac.  I saved my partition mac with time machine with the intention of all of the disk formatting and reinstalling Mac OS but from the start in my installation key USB, disk utility says it can not access the part of the fuser unit and looks like he lets me only format my mac of 156 gb partition.  I'm stuck and I would be grateful of any advice to recover my hard drive!

  Thank you

  Just to clarify, you have an SSD or a disc Fusion? You seem to indicate both.

• How to recover email files lost after compressing files

  I am using windows XP sp3, two days ago, I performed an outlook express file compression process, after only a quick jump

  and asked me to do. Unfortunately, a part of the e-mail files (year 2011) were found missing in the outmail storage box after file compression.

  I think that they were deleted automatically during file compression. Although I found a backup file in the trash, I can't yet recover

  the e-mails lost after recovery.

  For your information: before compressing files - size storage box outmail - abt, 1.2 GB / after compression 827 MB

  MY mailbox: * address email is removed from the privacy *

  It is a common problem with OE because if we let the dbx files grow beyond a few hundred megabytes, they are subject to corruption.  You should do an immediate backup of your messages in the event of further loss.  So, if you have bak files in the trash or in the message store directory, you can try to recover them.

  For references, see points 2, 3, 4 and 6 here: www.oehelp.com/OETips.aspx#2 and import the bak files see here: www.oehelp.com/backup.aspx#imp1 and if you were unable to recover what was lost, then see here: www.oehelp.com/DBXpress/ the latter is able to scan the entire drive for messages and bypassing the file system and if something can get back them It can.

  Steve

• Ray with Go: rooted status will be lost after reboot?

  Hello

  I intend at the root of my Ray (GB, unlocked bootloader) in order to use Link2SD and win more memory.

  Direction: http://talk.sonymobile.com/message/142152#142152

  Since I need to root the phone, this setting will be lost after the subsequent reboot (which means, not rooted)?

  TKS,

  /arturiu

  Bobbles. It will remain the same, so don't worry

• Permissions lost after reboot

  Hello

  I have an installation of ESXi 5 on a DL380G6, server is automatically added to the esx fine, admins Add Group field, works very well.

  If I add another group, it works until the server is restarted, and then the group is removed from the permissions tab. I tried several groups and the same thing happens.

  If I change the setting advanced under Config > host Agent > Plugins > hostsvc > esxadminsgroup to another group, it remains after a reboot, as well as the Group admins to esx, if I may change back the group is lost after a reboot.

  Is there any solution for this?

  Thank you.

  ESXi works in RAM and configuration data are not saved in real time on the edges.

  Wait at least 1 h before the reboot of the host.

• Start Windows lost after the partitioning of the disk next to Mac!

  Hi, I've lost my windows boot after creating a small new partition in disk utility. Could someone help me pls?

  Can you post the output of the following commands in OSX Terminal?

  diskutil list

  Cs diskutil list

  sudo TPG - vv - r see the/dev/disk0

  sudo fdisk/dev/disk0

  The "sudo" commands will prompt to enter your password, and there do not appear to come back. You can also see caution against improper use 'sudo' and the potential loss of data due to an "abuse" of the order.