Pavilion P7-1414: HP-P7-1414 change graphics card

Similar Questions

• Pavilion p7-1414: upgrade graphics card

  http://h30434.www3.HP.com/T5/desktop-hardware-and-upgrade-questions/P7-1414-and-GTX-750-TI-SC-proble...

  As you can see in this thread, my computer will get full performance GTX 750ti due to my PCI ports.  So even if I upgrade my 500 Watt PSU, I always get a maximum return of 750 GTX ti. So in order to get maximum performance, what I have to get a new motherboard supporting the 750 GTX PCI slots ti?

  Greetings,

  Your PC meets the requirements of minimum 300 Watt power supply.

  Your PC has the UEFI BIOS necessary for the performance of the 750Ti. Your BIOS version 8.xx supports UEFI graphics cards.

  Your PC has a PCIe x 16 slot 2.0. The 750Ti will take place in a 2.0 slot, but at a slightly lower rate. It is not as slow as you think. A 3.0 card works fine in a 2.0 slot.

  The 750 will fit in your case, as evidenced by the physical installation of the card described in the link to the other thread user in your message.

  No PIN six additional or power connections 8 pins are required to run the 750Ti.

  I run a GTX 970 in a 2.0 slot and it works fine.

  You need to enter the BIOS (Setup) to disable secure boot and select start inherited before installing the 750 into the slot. You must also uninstall the current graphics drivers before installing the new graphics card. You need to return to the graphics drivers generic windows before installing the 750Ti GTX.

  See you soon!

• HP Pavilion 500-130DE: HP Pavilion 500-130DE do not see the graphics card in windows and can not change the primary graphics card.

  So I got a new (TG 640) graphics card for my pc. I tested it on another computer the day before. Worked well. I plugged my HP Pavilion 500-130DE and started. I changed my slot onboard DVI cable to the GT 640 and cable says no signal. While the pc was still on I switched the cable back to the integrated graphical location motherboard and got the windows login screen. So I thought that BIOS yet configured when the integrated graphics card (Intel HD 4600). I turned off the pc and booted to BIOS. But I've never seen a such limited BIOS before! Only thing you change is boot order. I saw a tab advanced but could not find the settings that I needed. In the only device manager devices that appears is the HD 4600. So I checked power is 300W should be sufficient for a map of 75W (only need the PCI for power). Someone knows how to fix this?

  Hello

  After the PC starts to open the window RUN and enter: MSINFO32

  If the BIOS on your PC version is version 8, and then review the information below.

  HP Secure Boot Windows 8 themes Computer does not start after the installation of a video (Windows 8) card  

  A word of warning: the reality is that there is no guarantee that any particular graphics card will work in any particular PC, even if the graphics card works in other PC or even the same or similar model PCs. Know what the return policy is before you buy.

  Thanks for posting on the forum.

• HP Pavilion p7-1154 does support Dual AMD graphics card?

  I have a Pavilion p7-1154 - serial number {removed privacy} - the motherboard is an AAHD3-HB (stock MB) made by Pegatron. I updated the stock 16 GB of Corsair vengeance 1600 6 GB 1333 RAM and upgraded the processor an AMD A6 3600 to an AMD A8-3850, all according to the guide of HP upgrade for this machine. I've also updated the PSU of 300w for a 500w 80Plus Bronze certified PSU Corsair stock.

  Now that's what I'done this day - what I want to know is the MB (AAHD3-HB) does support Dual AMD graphics card, using the proposed graphics cards, I would use a Radeon 6670 GPU.

  Mike

  Mike, after consultation with the other members, I think that double graphis is unavailable because it is not indicated in the specifications.

  However, here is a Youtube video on the CPU.  If you do not find that you were able to use it by a change in the BIOS, please share this information with the forum.  Thank you!

  If your problem is solved, please click "accept as a Solution.

• Message "no Audio output device is installed" after changing graphics card

  Hello

  Thanks in advance for your help. I have a desktop pavilion, model No. KZ754AA. I just got a new graphics card installed, and as has been done, the above message appears in my "speaker" icon. devices and when I click on playback devices are NVIDIA hdmi output, however, it is said also they are not connected but I know that the cable is properly connected. I used to have installed Realtek I think, but that has now disappeared. I tried d/l of HP drivers, but it still did not work. Help, please. Thank you

  Hello:

  The solution is simple, but obscure.

  So, I'm happy that you came here before making a lot of troubleshooting that most of us would try unless we knew that the answer is simple.

  Why it happened...

  Your PC think you have installed not only a video card, but also a sound card, because it has built-in HDMI sound card.

  Thus, he dutifully automatically disabled the integrated audio system as it disabled the embedded video.

  Restart the computer and press the F10 key at the beginning of the HP welcome screen to access the BIOS.

  Looking for an embedded audio setting normally in the device setup menu.

  You will find it the value auto or off.

  Change the setting to "Enabled". Save the setting it by hitting the F10 key and again when you go out to save settings and exit.

  When you restart in Windows, you should now have your new built-in audio system and when you plug an HDMI cable from your video to your TV card, you should then get the HDMI audio.

  Paul

• Internet does not work after changing graphics card.

  Hello

  I have a HP Pavilion HPE h8-1212 on windows 7 (64-bit) and I changed my graphics card for an AMD Radeon HD 7790 so like my case.

  after reboot and installation of my graphic card drivers, I noticed that I have yet 2 "Bluetooth devices" (bluetooth device) and I don't have a Wifi connection. I am currently connected to my internet via an Ethernet cable.

  Here are some screenshots of my problems:

  

  

  Please help me with this.

  The wifi card, if it's a minimap, as it is in the image, should have had two sons goes to the card wifi which were channelled through the case.  These were responsible for picking up the wifi signals to work.  Since the screenshot shows the weak or no signal, I suspect this is the question.

  

  As to describe the process of removing antennas, I couldn't find the following steps.

  Before you start: Remove the access panel, the collar, the higher optical drive and the upper bezel.

  1. Detach the antennas wireless the wireless LAN card.
  
  
  2. Cut the cable tie fixing connectors antenna for the front i/o cable harness.
  
  
  3. Pull the antenna cables without wire through the access hole in the upper part of the unit.
  
  
  4. Pick up each cable hooks fixing the top of the page of the PC.
  
  
  5. Detach the screws for each antenna.
  
  
  6. Pull the antennas of the unit off.

  In the end, it seems that the antennas are routed right under the top cover.

• Tecra S10 - change graphics card

  Hello

  I hava a Tecra S10 and it's a good computer. The only thing I would change is the graphics card. I have a Nvidia Quadro NVS 150 M and I would like to know if it is possible to change it to another. I wish I had a better game experience.

  Good day
  Thank you

  Hello

  I think that this article is right for you
  http://APS2.toshiba-tro.de/KB0/FAQ7A01ZW0007R01.htm

• Change graphics card on Tecra 9100

  Anyone know if it is possible to change the graphics card? It is a tecra 9100? and where to buy?

  As far as I know that it is not possible to Exchange unique pieces like the graphics card and CPU. Graphics card is part of the main map (fixed mounted). For more information you can contact Toshiba service in your country.

• Satellite A100-784 - change graphics card

  Hi I have a laptop and I want to change my card Graphic (Mobile 945GM/PM/GMS, 943/940GML and 945GT Express Memory Controller Hub) because it is taking does not support hardware T & L and Vertex Shader version 2.0

  Is this possible and if can't update the map Graphic memory from 128 MB to 512 and how?

  Hey Buddy,

  Just check this thread:
  http://forums.computers.Toshiba-Europe.com/forums/thread.jspa?threadID=57984&TSTART=0

  It s among hundreds of them on the upgrade of the graphics card.

  Update of graphics card memory is also not possible because he will be controlled automatically and part of the RAM will be used for the GPU RAM.

• HP Pavilion DV6-C80EL HD 7690 M XT graphics card. Windows 7 64-bit operating system

  I have a PC HP Pavilion DV6-C80EL, with HD 7690 M XT graphics card. Windows 7 64-bit operating system

  B0B34EA TYPE S/N {removed privacy}
  I have try the card READER was updated to use windows 8
  HP told me to turn to AMD.
  AMD housewrap me to turn to HP.
  What should I do?
  THE PC was purchased in June 2012.
  Thank you

  HP has released a disc for the PC in question, associated with 64-bit Windows 8
  Greetings

  http://h10025.www1.HP.com/ewfrf/wc/softwareCategory?OS=4132 & LC = IT & CC = IT & DLC = IT & sw_lang = & Product = 5212723

• HP pavilion p6140in: help expert support-need to graphics card

  Hello

  IM using a hp p6140 5.5 years in
  It comes with a processor Core 2 duo e 7400 2.8ghz, 3 GB of ram ddr2, a ms 7525 Boston motherboard hard drive 7200 RPM, a geforce 210 that was used during the last years of 2.5 and a power supply 250W which ive already upgraded to a corsair vs450w
  now, I want to upgrade my gpu gtx series and ive narrowed it down on the

  MSI NVIDIA N750-2GD5/OC 2 GB GDDR5 graphics card

  .. IM aware that bottleneck issues could be there... I want to ask is if my system supports the card properly...

  the version of the BIOS - Phoenix - AwardBIOS v6.00PG

  a pci express x 16 slot is present and the card is 5.7 inches and it must adapt...

  (the main problems I see people complain are regarding bios and incompatibility)... so... can I use this card?

  Hey, you're welcome!

  No, if it is not broken, do not fix.  If everything works fine, just keep it in game.  If you start to have problems, such as the computer freezing or startup strangely, you may need to change the power supply.

  Good game to a former player.

• HP Pavilion 500-319NA: new to < see below > graphics card

  Hello

  I am new to the computer upgrades and know almost nothing about it, so please keep any simpler answer and understanding as possible.

  My computer is the "HP Pavilion 500-319na".

  It contains the graphics card "NVIDIA GeForce 705" (I think it's a 1 GB model)

  There's a game coming out next year called Overwatch, this graphics card is unable to play the game, so I decided that I want to upgrade this Christmas.

  The graphics card, I have drawn attention is the "ASUS 2 GB GeForce GTX 750 Ti.

  I have mainly two questions:

  • Is my computer compatible with this graphics card?
  • the Geforce 705 dosent require any kind of power, but one that I want (the GTX 750 it) seems to require a power adapter 6 pin or something.

  If anyone could help with any of these things it would be wonderful.

  Thank you, Callie

  You'll be glad you asked, you need to clarify some issues.

  This is your computer.  There really a 180W external PSU?  Or is the power supply inside the box?  There were some variations in generation of HP model #.   If internal, envy is the coast?

  Your computer has a 2.9 Ghz CPU... but Overwatch requires a 3.3 - 3, 46 Ghz CPU. That will slow down the game.

  GTX660 (140W) is far superior to the GTX750Ti (60W), but power is a problem. AQgain, need you a new power supply, but it's an internal model.  See above question. !!!

  You also have a problem of compatibility of the UEFI BIOS.  The GTX750Ti is OK, but the GTX 660 requires BIOS settings inherited.

• HP pavilion e073ed 17: you can replace the graphics card for hp pavilion 17e073ed

  I have a HP pavilion 17e073 ed and I want to replace with a better graphics card. The problem is that I can't find anywhere if I can replace the graphics card. I want to replace it for the best benefits of games. I already bought an SSD and some more RAM.

  Hello:

  There is no graphics removable, replaceable and upgradable 'cards' in your laptop.

  The graphics quite part of the motherboard, and to improve the graphics, you would have to see if there is a motherboard listed in the guide service and maintenance for your laptop that has better graphics.

  Replace the motherboard would be a labor intensive and expensive project.

• Want to change graphics Card

  Where is my graphics card and how is it easy to change it is a Compaq Presario S3040SE I increase my hard drive & ram but I don't understand that the graphics card part.

  Read these articles.

  How to replace a video card.

• HP ENVY 17-j162ss - Enable change graphics card on the BIOS

  Hello

  I would like to change the graphics card (intel vs ati) in my BIOS, but I have not any menu option in there.

  My laptop is a HP ENVY 17-j162ss

  Thank you

  You use the NVIDIA Control Panel to control how and when the graphics card performance can be activated. There is no current option that allows the command BIOS graphics solutions.