Poor start speed on Equium A60

Similar Questions

• Can not start my new Equium A60

  My mom and dad bought me a new Toshiba Equium a60 I recorded the Toshiba laptop and downloaded the update of the bios 1.9 zip as stated in my profile, form that it was compatible, but when I ran the probs have now started the habit of my laptop lights it seems dead all power (cables battery & power everything up).

  I'm really freaked out because I put t know what s that went wrong. They spent a lot of money and has invested a lot of time to have hooked me up to a wireless connection I feel terrible that someone can help me THEEZE

  Hello

  I really the don t understand why you do BIOS update with the new unit. This path is not easy to say how the problem can be, but if you turned off the camera, while the BIOS update it can be this motherboard is faulty now.

  Please, remove the battery and connect the unit to the power running. If all goes well is the LED for power there. Try to start the device. If there is no reaction you must take it to the service partner.

• Ieee 1394 host controller Texas Equium A60-692 does not start

  Hello!

  I have a Toshiba Equium A60-692 about 2 years old. On rare occasions the above will install and also the network/ethernet card etc with it when it starts. But 99% of the time it fails to start upward.

  Tech from Toshiba tell me it's the CMOS battery, but time slept OK for the last week so maybe it could be something else. Other strange things are can only recognize the drive HARD to start from what IDE Standard is chosen in the BIOS options (Enhanced IDE option and I think only used normal overall, ups causes boot errors). Also a green screen with weird graphics on occasion. Also the speed of the processor can be reduced, as shown in the properties of my computer.

  Any ideas from anyone as worried of wasting time to unsolder the battery if this isn't the problem. Could this be a fault of the motherboard that is irreparable? I am a relative novice if need help someone here. This made me!

  Hello

  I think you might be right. Eventually he s a small part on the motherboard that could malfunction.
  If I m not mistaken the controller IEEE 1394 Texas Instruments could be the Firewire port and it s part of the mobo

  Welcome them

• Equium A60 starts on battery

  Hi people I need help if you can help.

  I have an Equium A60 laptop and when I press the button when the laptop is running out of its battery, it does not start, but when I plug in the charger and press it starts very well.
  Thought the battery was dead, but when he starts it says the battery is fully charged and it works fine without the charger plugged in for the duration, what it says on the battery monitoring software.
  basically the on off button works fine when the charger is plugged in but has no effect when running off the battery voltage.

  Would really appreciate some help on this one, if you can imagine all the solutions

  Thank you

  Hello

  In my opinion there is no one-size-fits-all solution for such problems. You can try to remove the battery to put a little time inside and test again.

• Equium A60-157: lines on the start screen

  Hi, I have a problem with my Equium A60-157.
  When the machine starts and get you the LOGO LOGO & P4 TOSHIBA lines running down the screen there is a fault or a common thing with Toshiba?

  Thank you

  Hello

  I don t think that these lines are a common thing on Toshiba laptops.
  This problem occurs after full load of Windows?
  Have you seen these lines on other applications?

• How to start the recovery on Equium A60?

  Hi, I have to do a factory reset on my Equium A60, I put the cd in but cannot get it started the recovery, some can help me please? Thanks in advance

  Hi EPAs

  Turn recovery media in the CD/DVD drive and disappears. Press the power button and hold the C button. This means the unit choose CD/DVD drive as the first boot device.

  Otherwise, you can change the boot priority in the BIOS settings and set the CD/DVD device as the first.

  Good bye

• Equium A60-173 PSA67E does not start

  I don't have a model Equium: Equium A60-173 (PSA67E-00700C8J) that will not start.

  It tries to start hard drive turns, the fan starts, the dvd drive light flashes, the hard disk light flashes and then he died.

  Battery life is very good, charger/power supply is fine.
  Lights on the front shows the unit is on and the battery is being charged, they all light green.

  I removed everything, left power and removed the battery for an hour, but it still will power not on.

  Any ideas?

  It looks like a faulty motherboard, but it is not easy to say.

  You have already removed the battery and the AC adapter and waited upward at the time, so you have to go to an ASP and ask a technician for help. They can check your laptop and exchanging parts.

  On the Toshiba site, you can search an ASP:
  http://EU.computers.Toshiba-Europe.com > support & downloads > download drivers

• Windows won't start on my laptop Equium A60

  Hello

  I wonder if someone can help, I had my laptop Equium A60 3 years and used only last night with no problems, but today when I turned it on it displays the following error message:

  "Windows was not start because the following file is missing or damaged:
  \Windows\system32\config\system

  You can try to repair this file by starting Windows Setup using the original Setup CD.
  Select 'r' in the first screen to start repair. »

  Could not find an installation cd, have tools and software utilities additional one, etc.

  Any suggestions would be much appreciated!

  Thank you
  Mary.

  Hello

  Installation CD is not delivered with your laptop, just recovery CD and recovery CD offers no repair option.

  Try to get the CD of Microsoft facilities. Talk with your friends. I'm sure that someone has this facilities of Windows XP Home edition CD. Check if you can do something by using the R option.

  Also, make sure that Microsoft wrote about it:
  http://support.Microsoft.com/?kbid=307545
  http://support.Microsoft.com/kb/269075/en-us

  Good luck!

• Equium A60 does not start after the BIOS update

  I have an Equium A60. After being caught with some very nasty malware and Trojan horse, I had the disiccion to reformat the machine and reinstall the OS.

  Everything goes well until I updated the bios. Machine crashed and now I can't restart. Press the power button and the machine will start for 3-4 seconds and then stops.

  I know it of because of the bios and want to know if there is anything that I can reset this back to the original settings?

  Thanks in advance for your help

  Hello

  Unfortunately, you can not solve a BIOS is broken down by yourself. At the machine really / judgment of accident during the update process? If Yes, then your machine has disappeared and the only chance to bring back to life is to ask an authorized service partner to help you.
  Maybe they have a software to solve these problems. You should try and contact the nearest ASP in your country:

  http://EU.computers.Toshiba-Europe.com/cgi-bin/ToshibaCSG/generic_content.jsp?service=EU&ID=ASP_SUPPORT

  Good luck

• Equium A60-155 will not start

  Hello

  I have an Equium a60-155, that I knew that she works for a while, but recently I came with a new poroblem... my laptop guard turn off without notice and loses all power.

  The battery has been dead for some time and lasts about 5 seconds, but I've been using the AC adapter.

  Recently, she stops and even the LED lights for the power/battery adapter / is not on.

  At first I thought it was the fuse in the adapter which could have been blown so I replaced it, and it started to work again, but then after a few minutes, it stops and lost all power.

  I had this during the last days and I noticed that it regains power when I unplug the power adapter from the mains supply and remove the fuse and put it back in but his lasts only for a few minutes.

  I don't know if it is a hardware problem or I just need a new adapter. Someone at - it similar problems and can offer any adivce?

  Hello!

  What do you think that the laptop is overheating? I don't know, but if so the laptop would also immediately turn off m.
  So, try to clean the laptop with a jet of compressed air to blow the dust from the cooling fans. So you don't have to disassemble the laptop.

  If it doesn't help it's really hard to say what the reason is for this maybe you should bring the laptop to an authorized service provider. Technicians can check the laptop.

  Good bye

• Equium A60 - beeps at start

  When under tension over an Equium A60, I get a long beep (3-4 seconds) and he then turns off; no error on the screen and no sign of activity.
  I'm assuming that there is a message error and probably serious enough, but no idea what it means.

  What does a single long beep mean?
  Be it on the mains or battery power, or with memory removed makes no difference.

  Thank you

  I guess that there is a hardware problem on your motherboard.
  A long beep is displayed because the laptop can not pass the POST (power on self-test) and, therefore, the machine doesn't start.

  Unfortunately, it's not easy to say what could be wrong with your laptop
  In your case, each unique material part should be checked; RAM, CPU, motherboard, etc.
  But I don't think that you have all the material resources useful and enough technical experience in this regard.

  In my opinion you have only one option, and it is ASP.
  The authorized service provider may check the laptop and can run diagnostics tests

  I wish you good luck

• Equium A60-181: Win XP does not start successfully - the BSOD reboot

  Hello.

  I have an Equium A60-181 which has an operating system problem.
  Loads of XP logo at the beginning, when it happens to show the log on screen, it is a quick blue screen of death error, and it restarts.

  I tried to go into safe mode, but it blocks on atisgkaf.sys.

  Is that what I can do to save the operating system?

  How can I start to diagnose if it's a hardware problem?

  Thank you, Lawrence

  Hello

  The atisgkaf.sys file belongs to the graphics card driver.
  But as Akuma has proposed, the Windows operating system does not load 3rd party in safe mode drivers.
  This is why the ATI graphics card driver should not affect the start-up procedure.

  However, this is only my personal hypothesis and believe me; nothing is impossible, so a hardware problem might be possible.

  But just a question;
  Have you tried to reinstall the OS?
  The installation process goes smoothly through the unique installation steps?

  I think that the new installation of the operating system is a good idea to find out if it is a hardware or software problem.
  Maybe you should try it

• Failed to start after installing the new memory module Equium A60

  I have an Equium A60 laptop with the following specs:
  P4 3.06 GHz
  256 MB Ram (including 64 MB ATI graphics card)
  30 GB HD
  Windows XP Home Edition

  The problem is the following; I bought a bar of memory in order to update my system. I bought a Kingston SO-dimm pc2100 512 MB. After installation of the memory of the laptop wouldn't start, after about 5 seconds after having turned it on, it turns off completely.

  If I remove the memory it starts up fine. I had tested memory and its ok so there seems to be a problem with the laptop itself. I'm confused, so if anyone has an idea of what might cause boot failure, I would be happy to know.

  Thank you very much...

  As far as I know the main reason for the failure of start is the use of non compatible modules.

  According to the specifications of the laptop, you must use PC2700 512 MB (PA3312U - 1 M 51). If you want to buy the module Kingston (products of very good quality) check it please the Kingston MEMORY SEARCH

  Good bye

• Equium A60 has recently started to overheat

  My Equium A60 has recently begun more heating really bad. It's at the stage where I can not install windows XP on it without him turning off during the installation of precession.

  Anyone know what could cause it to fire so quickly?

  Thanks in advance.

  Hello

  Especially the laptop overheats because the cooling module doesn t cool unique pieces in the right way.
  Fans do not twist full implementation because of the dust and debris inside the laptop.
  After a long time working, it s advisable to clean the cooling modules.

  How?
  Well, the simplest method is a use of the vacuum cleaner. But be careful

  If it helps the laptop must be checked by a technician.
  The technician can renew the thermal paste between the CPU and the cooling module.
  Important to take heat from the CPU thermal paste.

  Last but not least do not forget that there is enough free space around the laptop.
  The free space is important for air circulation correctly

• Equium A60 do not start

  Hello

  My Equium A60 primer not. Once the power is on, the Toshiba screen after, nothing else happens. The screen shows that the light is on but nothing is displayed. Fans are working and go to market and stop at intervals.

  During the boot and hold down the F8 key, I tried to load safe mode, but the machine stopped by what follows the on-screen...

  multi (0) disk (0) rdisk (0) partition (1) \WINDOWS\system 32\ntoskrnl.exe
  multi (0) disk (0) rdisk (0) partition (1) \WINDOWS\system 32\hal.dll
  multi (0) disk (0) rdisk (0) partition (1) \WINDOWS\system 32\KDCOM. DLL
  multi (0) disk (0) rdisk (0) partition (1) \WINDOWS\system 32\BOOTVID.dll
  multi (0) disk (0) rdisk (0) partition (1) \WINDOWS\system 32\config\system

  Anyone has any ideas on where to find a solution to this. Is it software or hardware releated etc.

  Thanks much for any help.

  Hello!

  In my view, this could be a problem with the drive HARD or Windows.

  First of all, I would like to check the HARD disk:
  http://www.HitachiGST.com/HDD/support/download.htm#DFT
  With the Drive Fitness Test, you can test your HARD drive. Download the CD image, burn it to a CD and boot from it. You can then the HARD drive.
  On the same site is a user's guide if you want to know more.

  If the HARD drive has no error I would reinstall Windows with the recovery because you disk as no access in safe mode.

  Good bye