Re: My C50-A-156 Satellite will not turn on

Similar Questions

• My C50-A-1DV Satellite will not start

  Hello

  Yesterday my C50 Satellite would not start. When turned on, it shows the Toshiba logo and then the little circles just keep them.

  I booted into recovery mode and ran chkdsk, but there are no errors on the disc.

  When I restarted, then she says the following:

  Preparation auto repair
  Diagnose your PC
  Check disk for errors
  Auto repair attempt

  Then at the stge small circles just continue.

  I started in safe mode and activated the boot record.

  Attached is the NTBTLOG file

  Thank you very much

  BigD

  Turning off the laptop
  Then press the power button and immediately after that, press the F12 button
  Then you should see a screen similar to this one:

  

  Then I recommend you to choose the option to drive HARD recovery... The last option in this menu.
  This would start the HDD recovery procedure and would restore the laptop back to factory settings...

  More details here:
  http://APS2.toshiba-tro.de/KB0/HTD1303440001R02.htm

• C50-B-13N satellite will not support the RAM recommended

  Hi guys, I have a new Satellite C50 8.1 Win.

  On the Toshiba site, for this particular model, it can be upgraded to 8 GB of ram.
  There is no easy access on the background of this laptop Panel, so the complete lower cover must be removed, and there is only 1 RAM slot.

  So I bought a single stick of ram 8 GB DDR3 at 1333 MHz (recommended speed on http://www.toshiba.co.uk/laptops/satellite/c50-b/satellite-c50-b-13n/ site Tosh).
  Problem is he can't ram 1333 MHz speed - NOT just because it was an 8GB stick (I also had 1, 2 and 4 GB available sticks to test).

  On cuts size of 1333 MHz laptop tries to power on then feeds directly to the output.
  Its not too fast - for one, it's a portable Gen current with a processor that will gladly help 1333 MHz, but - GET THIS - the ram that came out was a stick of 4 GB 1600 MHz.

  To try to contact Toshiba support I gave by telephone of the sales representative who had no idea what I was feeling and finally told Topaz ring, Toshiba repair and warranty the guys, who were quite confused as to why I was told to ring the.

  So what about £55 in the sewers, because the package is opened and Toshiba play dumb on a possible serious failure.

  If anyone has any ideas or suggestions, they would be much appreciated.

  Thanks in advance
  Simon@Brokenbox

  Well, the processor Intel® Celeron® N2830 supports modules DDR3L-1333.
  Here is the page of Intel Ark
  http://Ark.Intel.com/products/81071/

  That is why the seepage of support max is 1333 Mhz even if you use faster modules

• My C50-A-1DV Satellite will not work without power

  Hello

  I have a new Satellite C50 A 1 DV.
  It doesn't work unless it is plugged.

  Anyone know if that is correct?
  It seems odd.

  Also the far left in the front (AC IN) never turns on.
  Is it OK?

  I would be grateful if someone could put my mind at rest!

  Thank you
  JO

  > It does not work unless it is plugged.
  > Anyone know if this is true?

  No, this isn't correct. If the main battery is fully charged, the laptop must run also without the power adapter connected.
  In case, the battery not charging properly, get in touch with certified maintainer Toshiba in order to check the battery and if necessary replace it with another, a new.

  Greetings

• C50-A-1DV satellite will not start

  Hello

  I was wondering if someone could help me

  I have a computer toshiba laptop and I had problems with my laptop that I got it 3 months and today I went to restart it and only the power led comes on and the fan starts running, but the screen remains blank

  I tried to connect an external display and nothing lights up there so I was wondering what I need to do to start and help would be great beautiful fully

  Thank you
  Jack

  Its very annoying if laptop start malfunction but the good news is that guarantee is valid and when hardware issues, should be set the unit for free.

  Anyway, try a kind of universal workaround that is sometimes useful to solve different problems.
  You should disconnect the power adapter and should remove the battery.
  Then you should press on and hold button power; Let's say 30-50 dry should be good enough.
  After that connect the two parts and try to turn on the unit.

  I keep fingers crossed that this work around will simply help you

• My satellite will not turn on at all - its just dead

  I have a satellite, it is around the age of 18 months. I used it fine a couple of days, when I tried to turn on today absolutely nothing happened!

  The power light is on when it is connected to the network, but when I press the power button that does nothing, no fans or hard drive sounds, its just dead! Any ideas?

  That s certainly a hardware problem and in my eyes you cannot fix yourself. Don t waste a time one ask a technician for notebook check it's absolutely necessary to know what s wrong.

  Good luck

• My Toshiba Satellite will NOT connect to the WiFi in my house of employers, but connects everywhere else I will!

  My Toshiba Satellite WILL NOT connect to WiFi in my house of employers, but connects everywhere else I go; I have Windows XP Home Edition SP3, and there a router Linksys WRT16ON. My network card is an Atheros AR5001X + Wireless Network Adapter (and says "this device is working properly". I tried disabling, entering all information, penetrates is not in the news was unchecking the "Enable IEEE 802. 1 x authentication"(and whenever I go in there, he checked again) changed on 'Open' and 'AES' TKIP, WPA (which is) and the password is correct, restart the router, moved the laptop around (the router was in my room, now it is in the thnxt room and it Me REPEAT JUST : 'Validation of identity' and 'impossible to find a certificate to connect to the network'.) I can connect with ethernet, but not with this new situation of the House, do I have the wireless. WHAT ME MISS? I did this for weeks and even now, it says I'm connected, the signal strength is very good, often great, but Explorer cannot display this webpage. Can someone tell me what to do? Thank you!  Allie

  Your old Toshiba equipped with an adapter wireless which is likely to be used for Wireless-a, b, wireless and wireless-g (the project).   Your employer has a newer version (not the last and larger, but much more recent than your equipment) router Linksys that is capable of wireless-b, wireless-g and wireless - n.

  Your most likely problem is that your employer has set up his router to "N-only.  Wireless n uses the same radio frequency as wireless-g (this is why detect you the "excellent" signal strength), but uses a different protocol (this is why you can't connect).

  Politely ask your employer to change the mode 'network' from the back of the default router of "mixed".

  The router manual is here: http://homesupport.cisco.com/en-us/support/routers/WRT160N see p. 13 ' Basic Wireless Settings.

  Looking for a certificate message was probably bound to have the box 802.11 x checked.  This box should NOT be checked for home wireless networks.

• I have 6 phone is dead.  Will not turn back on

  I have 6 phone is dead.  Will not turn back on

  See Troubleshooting in the paper support. If your iPhone, iPad or iPod touch won't turn on - Apple Support

• Tecra M9 - sometimes that it will not turn on

  Hello.

  I have a Toshiba Tecra M9 who has a problem. Sometimes it will not turn on. You must remove the battery and press the power button. When it loads will work fine until I have move or take it upward and then hangs and crashes. Then, you must take the battery out so he can turn it back on if it will be in all.

  I tried to reload xp, tried without battery, tried a known good ram in both slots, a different hd and took part to see if I can see something loose, I have now run out of ideas.

  any help would be good

  Thank you

  Hello

  Which is really strange, buddy... In my opinion, that sounds like a hardware problem, what do you think?
  You should contact a technician for laptop (authorized service provider). Guys can verify and Exchange defective equipment parts. Maybe a mailfunction of the motherboard or the CPU

  By the way: you have updated your BIOS? If this is not the case, to do this, first!

• I went to pay my own Bill Bill of my family, now nothing will work if I'm on WIFI, no internet, my IMessage/Facetime will not turn on. I've tried everything. Help?

  I went to pay my own Bill Bill of my family, now nothing will work if I'm on WIFI, no internet, my IMessage/Facetime will not turn on. I've tried everything. Help?

  Honestly, this sounds like a problem of carrier. Are you able to make/receive calls or send and receive text messages? I would first check with the carrier to make sure that your phone is still set up to use mobile data. Something was accidentally deleted when they merged your bills.

• K010 ENVY: my laptop will not turn off

  Hello

  When I shutdown/hibernate/standby/resume my laptop, it will die completely.

  All programs will be closed (when stop or restart) and I think that OS will also close. But the laptop will not turn off. Power LIGHT and fan will stay on.

  And when I try to Hibernate, everything is ok, but I have the same problem.

  Whenever I have to turn it off by holding the power button, otherwise the battery will be discharged.

  After manual turn off, when I turn it on again, everything works correctly:

  -If hibernation: OS will continue to last situation.

  -If start/stop: OS works normally without error or warning.

  After sleep, OS works from the beginning. Because the data stored in RAM and will be deleted after power off.

  Perhaps a portable automatic perevent equipment turned off. All the drivers are up to date.

  Is there a parameter/software to check and fix my problem?

  Thank you

  Hello

  You are welcome

  On some machines, the pilot for 11 series IMEI has been known to cause that kind of question of the judgment, so it may be worth trying an earlier version.

  You can use the following method to install an earlier version of the driver IMEI.

  Download driver IMEI on the link below and save it in your downloads folder.

  http://ftp.HP.com/pub/SoftPaq/sp66001-66500/sp66228.exe

  Disable your wireless card (should be f12 ).

  Open your download folder and run the installer - it warns you that it is an earlier version, but simply continue.

  When finished, restart the laptop.

  If the computer shuts down correctly, turn on your wireless adapter and use the utility on the following link to prevent Windows 10 to update automatically the driver IMEI again.

  https://support.Microsoft.com/en-GB/KB/3073930

  Kind regards

  DP - K

• installed Windows 7 for 30 days works very well. Now I want to activate. Get this error 0x800700D code... Windows 7 not WILL NOT turn ON NOW online

  NEW HP computer bought in September, already updated to Windows 7 with HP upgrade kit. I installed Windows 7 for 30 days works very well. Now I want to activate. Get this error 0x800700D code... Windows 7 not WILL NOT turn ON NOW online. Also can not get a pop window to activate by phone. HP says that I must fully restore Windows Vista x 64 Home Premium AGAIN at the factory all MICROSOFT updates, and THEN... so I can reinstall Windows 7 upgrade. Why now only after 30 days Windows 7 refuses to ACTIVATE! Nothing but run between Microsoft and HP > Please HELP without having to reinstall EVERYTHING on my computer.

  Please go to http://www.microsoft.com/genuine/ and click on the button to validate Windows, and then restart your computer.

  If you were not able to validate, follow these steps:

  1. Download this diagnostic tool, save it to your desktop: http://go.microsoft.com/fwlink/?linkid=56062

  -Online Windows XP: double-click the executable file to run the tool.

  -Online Vista & Win7: right-click on the executable and select run as administrator to run the tool.

  2. after running the tool, click the Windows tab and then click on copy to the Clipboard.

  NB: You can open a new file in Notepad, paste the contents of the Clipboard in it & keep for future reference.

  3 start a new post in the appropriate Microsoft Genine Advantage forum and paste the results of the WGA diagnostic data in a detailed post: http://social.microsoft.com/Forums/en-US/category/genuine

  4 Troubleshooting specialist will analyze the data and recommend an appropriate solution.

  ~ Robear Dyer (PA Bear) ~ MS MVP (that is to say, mail, security, Windows & Update Services) since 2002 ~ WARNING: MS MVPs represent or work for Microsoft

• MSN will not turn on it just says: upgrading, but the upgrade entirely custom install it... GETS about 58% then freezes

  MSN will not turn on it just says: upgrading, but the upgrade entirely custom install it... GETS about 58% then freezes

  Quote your full version of Windows (for example, WinXP SP3;) Vista 64 - bit SP2; Win7 RC. Win7) when you post in a forum or a newsgroup. Please do it in your next reply.

  Your problem has nothing to do with the Windows Update feature. Contact MSN Support. ~ Robear Dyer (PA Bear) ~ MS MVP (that is to say, mail, security, Windows & Update Services) since 2002 ~ WARNING: MS MVPs represent or work for Microsoft

• Have VFC Z216Gx/b, which suddenly will not turn on.

  Have VFC Z216Gx/b, which suddenly will not turn on. AC is on but nothing happens when you press the button 'on '.

  Hello Bob,

  Welcome to the community of Sony.

  Try to perform all the steps here: https://us.en.kb.sony.com/app/answers/detail/a_id/35540/c/65%2C66/kw/35540

  If the problem persists, contact Sony Service support here: http://esupport.sony.com/US/perl/service.pl

  Kind regards

  Miguel

  Note: If my post answered your question, please mark it as an "accepted Solution".

• my laptop will not turn on after a recent windows update

  Windows recently did an automatic update on my laptop and need to reboot to complete. However, it will not turn on at all now. I tried to run the install disc and used to attempt to repair my system and yet it is said that it is not repairable. Ive also tried to restore to a previous point, and yet, he won't do that. Help!

  Hello

  1. the updates are was?
  2. what exactly happens when you try to start the computer? You get the error message?
  3. What are the error messages that you receive when trying to run the system restore or Startup Repair?

  Step 1: Use the option last good Configuration see and check if you are able to boot to the desktop.

  Reference: http://windows.microsoft.com/en-US/windows-vista/Using-Last-Known-Good-Configuration

  Step 2: Check if you are able to boot into safe mode and send back the same.