redownloading itunes previous more low-speed (128) buy newest bitrate (256)

Similar Questions

• DV6 6c65se: hp pavilion dv6 6c65se RAM update more low-speed clock frequency

  Hi I dedided to chenage my original RAM memory to a

  Corsair CMSX8GX3M2A1600C9 NB Vengeance 8 GB (2x4gb) 1600 MHz CL9 DDR3 SO-DIMM two memory Module Kit Performance

  When I changed to RAMto a new and restart a system, I was surprised the classification System went down from 7.6 to 7.4 could someone explain to me why this happened if the old RAM was unbraned in trouble from China? Why my new performance as Corsair is defined by the hardware to work on the low clock speed, also is there nothing in the BIOS to change the clock speed of RAm etc.

  Could someone help me in this regard?

  Thank you

  Hello:

  I can't tell you why the performance of WEI memory went down, but he certainly wouldn't.

  The faster the memory will run in your computer laptop is 1333 MHz, because it is the fastest speed of the processor i7-2670QM FSB can run to, so installation PC3-12800 (1600) memory provides no advantage.

  The original memory regardless who did, should have been 1333 MHz.

  You need a PC with an Intel 7 series chipset and the 3rd generation of processor core to memory to operate at its rated 1600 MHz.

• Low speed on Wireless N

  I'm trying to implement a DV6 on Wireless N. I have a Linksys WRT160N router and get speeds up to 120mbps on a desktop wireless located near 100 feet from the router. I can not get over 54 Mbps on the laptop, even within 10 feet. I checked the properties of the device and verified that the width of the channel is set to AUTO and 802.11n Mode is ENABLED. I noticed the rest of my system below specs. Any help would be appreciated.

  LAPTOP MODEL: HP DV6

  Operating systems: Windows 7 (64-bit)

  RAM: 4 GB

  WiFi ADAPTER: Intel WiFi Link 1000 BGN

  PILOT: 13.0.0.107

  ROUTER: Linksys WRT160N

  FIRMWARE: 3.0.02

  After much research, I believe I have solved the problems with the Wireless N of low speeds, especially with Intel WiFi Link 1000 BGN configurations. Here's what I could learn from Intel support forums.

  "The IEEE * 802.11n draft prohibits using high throughput with WEP or TKIP as the unicast encryption algorithm." If you use these methods of encryption (WEP, WPA-TKIP), your rate will be reduced to 54 Mbit / s. Intel® WiMAX/WiFi Link 5350, Intel® WiMAX/WiFi Link 5150, Intel® WiFi Link 5300, Intel® WiFi Link 5100, Intel® WiFi Link 1000, and Intel® Wireless WiFi Link 4965AGN client drivers connect using a legacy IEEE 802.11 g connection rather than failing to connect altogether which complies with the IEEE 802.11n draft standard. "This means that you must use a connection Wi - Fi Protected Access * (WPA2-AES or WPA2-TKIP).

  I have reset the wireless security on my router to use WPA2-AES, reconfigured my laptop for the same security settings and options was immediately connected to more than 200 Mbit/s.

• Satellite P100 GPU fan turns costantly at low speed?

  Finally something strange happened on my laptop and I wonder if even happened to other users of P100 series laptop. All of the sudden GPU fan began to operate at low speed all the time. Before he reached 60 ° C and then had shrapnel short until it cooled down to 50 ° C and the order. But now it runs at very low speeds and temperatures are around 48 C. It is not noticeable and I'm very happy with what (it should be like that from the start).

  Now I wonder what could have triggered that. Do you have bios that has changed (I have the latest 2.40). At the beginning when I changed the computer bios worked as before, but then at some point I changed muffler in performance mode and since that day, the GPU fan runs constantly. I tried to change it to silent mode, but the GPU fan runs all the time. My laptop is P100-115 (Geforce 7600)

  Hello

  Looks like you re a happy with the use of the fan.
  I think that the new BIOS has been changed and that's why he has better influence on the performance of cooling module and so it works at very low speed. I think it is much better than the rotation of the fan restless.

  As you have already mentioned the Toshiba power saver controls the speed of the CPU and cooling method. If these settings could affect the cooling of laptop.
  But believe me; It of much better to have the constant low temperature and fans completely.

• Low-speed satellite Pro U400-142 - Wireless-N speed problems-

  Hi guys...

  I ve just bought a laptop Toshiba Satellite Pro U400-142...
  I have a belkin N1 Wireless cable router...
  I was really happy that I could get the speed up to 300 Mbps... with this laptop and the router...

  I am very very disappointed that he is only showing 65Mbps... My laptop supports Wireless N such that it has a wifi Intel 5100 card inside...
  Why show a low speed?

  I m in the same room as the wireless router if the signal is excellent...
  I've tweaked on with the settings in the network adapter settings...
  I got it to 130Mbps... for about 10 seconds before it dropped back down to 65Mbps...

  Can someone tell me what is the problem?
  I need to change some settings on my N1 router or what?
  This was one of the main reasons why I bought this laptop.

  concerning

  You have reason seems the wireless network adapter supports the Draft N
  But are you sure that you are using Draft N?

  Is it enabled in the Device Manager-> properties-> Advanced tab card WLan?

  At 802.11 N selected in your router settings?
  Update you the BIOS and WLan card driver?

• Satellite A100 - 192 Windows Vista USB low speed

  Hello

  I installed vista on A100-192, I configured everything correctly, all the drivers installed, but the USB transfer speed is totally low and when hollow transfring usb I have sound and video form. / CPU usage is 100 percent when data transfer from my camera or compact flash. Same thing with the PCMCIA card.
  On windows xp, it worked great!
  I guess it's something about drivers, because when I connect my hard drive usb hollow it works very well/windows sees it as a hard drive, but when I connect something else, and windows sees it as a removable drive - about low speed starts :/

  Any idea on how to solve this problem?

  Best regards
  Krystian

  Hello

  do you have what drivers installed? That you have downloaded the drivers, have you downloaded the correct drivers? Sorry for my question, but I'm sometimes on certain things and then I can't explain the errors that are produced.

  Welcome them

• Problem with deletion and Redownloading iTunes and Quicktime. Error: unavailable network resources

  Original title: trouble with deletion and Redownloading iTunes and Quicktime

  I am trying to remove iTunes in my computer through my control panel, but its telling me that it cannot remove, because of unavailable network resources.  I accidentally deleted quicktime then this all started.  Before iTunes was working.  When I try to re-download the ITunes it says that you must delete old version first.  Please help me someone with a great idea?

  Hello

  Step 1: Check if you are able to uninstall iTunes in the clean boot state.

  From your computer by using a minimal set of drivers and startup programs so that you can determine if a background program is interfering with your game or program. This type of boot is known as a "clean boot".

  Reference:

  How to configure Windows XP to start in a "clean boot" State

  http://support.Microsoft.com/kb/310353

  When you are finished troubleshooting, follow these steps to reset the computer to start as usual:

  1. click on start and then click Run.

  2. type msconfig and click OK.

  The System Configuration Utility dialog box appears.

  3. click on the tab general, click Normal Startup - load all services and device drivers and then click OK.

  4. When prompted, click on restart to restart the computer.

  Step 2: Pass through 'Verify iTunes and related components are completely uninstalled' in the article below: http://support.apple.com/kb/HT1923

  Then try to reinstall iTunes .

• If I put more lower memory card on a computer that has the memory card fast (just for the diagnosis of scenario) can damage the computer?

  Hello

  If I put a memory ddr3 or ddr2 has a speed lower than the an origin whch is on the motherboard (just to diagnose the scenario), which would damage the computer?

  Thank you

  Johan

  Hi Johan,.

  DDR2-400 has a transfer rate of 3200 MB/s. DDR2-533 has a transfer rate of 4266 MB/s.

  High speed DDR2 DIMMS are compatible with low speed DDR2 DIMM, although the motherboard or controller memory CPU will be bound to the limits of the low-performance modules.

• iTune opens more in windows 7. It allows to open.

  iTune opens more in windows 7. It allows to open. What is the cause.

  Uninstall it then re - install a completely fresh copy.

  See here for more information on how to remove iTunes and his partner bloatware then reinstall a new copy.

  See you soon,.
  Jerry

• "Convert higher than 128 kbps AAC bitrate songs?

  Is there still an option in iTunes, while syncing to another device, to "convert higher than 128 kbps AAC bitrate songs?  I've read about it, and I would try it for perhaps more songs on my iPhone when syncing my Mac; a lot of my songs are about 10 MB each, and I think that this would reduce some of them what they give.  But I can't find the option / switch. Thank you...

  I still use iTunes 7.5, so I can't check. I got this information: Chris CA post Sept. 2011 - Ripping the air of smaller size for iPod - https://discussions.apple.com/thread/3345205

• Low speed Intel(r) WiFi Link 5100 AGN - Satellite L500-128

  I bought Toshiba Satellite L500-128 and have already 300N Sitecom Wireless Router

  The new laptop has a wireless lan card with the 802-11 Draft-N support
  I don't know the speed of my new laptop buth is continue about 48 / 54 Mbps

  I have a second computer with a supported 802-11 Draft-N Wireless card and works very well with speed more than 136Mbps

  I tried several things to change in the configuration of the card wireless buth without any results.

  Does anyone have an idea? How to solve this problem?

  Thank you
  Richard

  Hello

  Check if the wireless network adapter using the Draft N standard.
  You can choose this in Device Manager-> properties-> Advanced tab WLan card

  As far as I know that the WLan card is Intel 5100AGN.
  Check if an update of the WLan driver would also help

  Welcome them

• Satellite Pro L20 - RAM runs with low speed

  Dear reader,

  I've recently updated my Toshiba Satellite Pro L20 to 2 GB, DDR2 667 mhz (Corsair ValueSelect) RAM because the old 512 MB of ram would not cut it anymore with all these processes.
  Now, when I check my speed of ram with CPU - Z it says 200 mhz, whereas it should be at 333 mhz. I checked the chipset (Radeon Xpress 200 m) to ensure compatibility and it is compatible with ram to 667 mhz.

  Additional features:
  Toshiba Satellite Pro L20 - PSL2YE-005009DU
  Windows XP Pro SP3
  Intel Celeron M360 1.4 ghz
  2 GB DDR2 667 Mhz
  Radeon Xpress 200 m chipset

  Now to clarify my question. I would run my ram at 333 mhz for many reasons, because if it is not I had been better to buy cheaper, slower RAM.
  How can I use it, I can't access the bios to fix this, how can I access/derivation of the locked bios?

  If you need more info just tell me.

  Kind regards
  Patrick Bos.

  Hello

  Perhaps CPU - Z isn't read correctly... Who knows?

  Also maybe the RAM modules are perhaps not compatible to run at 667 MHz speed. I n t have experience with Corsair Value Select modules

  Last but not least, you can do nothing. There is no option of BIOS or something, where you can change it. In addition this speed of RAM will not bring a solid performance gain.

  By the way: did you check the speed of your old modules?

• [WRE54G v3 - EU] Strong signal but very low speed

  Hello

  I just managed to get my new WRE to work after digging around several useful threads. My laptop connected successfully through the WRE and I got the signal strength excellent (54 Mbit/s as the status of dialogue shown). However, when I tried to browse multiple web pages, they took a long time to load. I ran a test of speed at speedtest.net and I'm barely 100 KB/S download speed (sometimes, it falls as low as 50 KB/S). Before when I connect my laptop in my room through the living room's wireless router, the signal was weak but the download speed was decent.

  Is that what I can do to help increase the download speed? Any idea/useful experience will be greatly appreciated! My router is not Linksys but custom-made by my ISP to support DSL, phone and TV at the same time.

  Thank you!

  What is the Distance between your router - WRE54G and computer. Make sure the Distance between your router and not more then 40 WRE54G fts 40 fts and the distance between your WRE54G and not your computer. Once you have done this right connections, after that, you can check the speed of your computer.

• Expereancing low speed internet after installing windows 7

  I have dell inspiron 1545, core 2 duo inetel. At the time of the new TI was windows vista home basic sp1 32-bit. recently I have installled windows 7 vista is very slow, now I am expereancing very very low internet speed compairing to the previous version of windows vista... Please help me... I have Auntie docomo photon max, which has very good speed of 6.2 MB/s. I think that it doesn't have a speed of at least 1.5 Mbps... Please help me get good internet speed

  Please answer my question

  Ben SAI

  Is it wireless or wired?

  Make sure that you have installed the latest drivers supported W7 network interface for your material, obtained from manufacturer site PCs.

  You can test your speed here typical - http://www.speedtest.net/

  See if this helps or give clues - http://windows.microsoft.com/en-gb/windows/why-internet-connection-slow#why-internet-connection-slow=windows-7

• "The store iTunes so impossible to deal with buy it now."

  Hello! I can't solve this problem, and he has to drive me crazy. Today I don't have use the iTunes Store and I did not try to buy anything. So I don't understand why I should read this banner every 3-5 minutes.

  How can I change it?

  Thank you for attention

  There is a problem with the stores, Apple needs to fix something on their end: https://www.apple.com/support/systemstatus/