Replace the DIMM on a Perc 6 / i controller?

Similar Questions

• replace the RAM, the need to activate Windows 7 OEM new will affect Media Center DRM?

  Title says it all.

  In order to avoid BSOD that * could * be linked to the RAM, I replace two DIMMs with a different model.  When I swapped the locations for the original DIMMs, I received a message stating that the material had changed and I had to re-activate Windows.  That's happened.
  I am now assuming that completely change the RAM will trigger the message "hardware changes took place.  I use this PC as an HTPC with a Ceton InfiniTV 4 tuner card, and I have a lot of copy - once programs and films recording.  I don't want to lose the ability to play them.
  My guess is that the reactivation will not affect the DRM.  It does not seem to have done with the recent reactivation. It's not like it's a new motherboard or system disk, but I would be sure.
  Thank you.

  (1) change of RAM only is unlikely to trigger an activation request - although if other materials also has changes in the recent past, he can do.

  (2) activation and DRM are totally different things, and should not affect the other.

• PowerEdge 1900 perc 5 / I controller battery replacement

  I have a replacement battery message in the Application to manage Open Dell for a Dell PowerEdge 1900 Perc 5 / i controller. If I replace the battery I lose the current RAID configuration? Also all the procedures available for the replacement of the battery?

  Thank you

  Jeff Hicks

  Here is a link to the manual, page 92 will give you the steps to replace the battery: ftp://ftp.dell.com/Manuals/all-products/esuprt_ser_stor_net/esuprt_poweredge/poweredge-1900_Owner%27s%20Manual_en-us.pdf

  Your RAID configuration is stored on the discs. Turn the power off and replace the battery, then start back. Upon request, accept the configuration of readers and move forward.

  Kind regards

• Is it possible to replace the hard drive with an SSD? or would it be too expensive?

  Is it possible to replace the hard drive with an SSD?

  or would it be too expensive?

  Yes.  There are several alternatives.  I found a way relatively inexpensive, using a map of mSATA (very small SSD) and an adapter to connect it to the connector IDE 44 pin internal of my PowerBook.  It works very well.  Rather than repeat what I posted previously, you can watch these two topics (which also has good info, other users)

  Re: This win to install a SSD drive in a PowerBook G4?

  Re: SSDS  (my post is halfway - "this is how I did with my trusty Pismo...) »)

  FYI - I have used the adapter is even cheaper now

  https://www.Amazon.com/GP/product/B009BA8V4M

• Mac Book Pro is not too hot.  It is time to replace the battery?  Can I replace the battery?

  MacBookPro is not too hot.  It's time to change the battery?  Can I do it myself?

  The Mac runs his fans in a feedback loop, based of the internal temperature measured.

  If the temperature goes up and the fans are not speed up to compensate, you probably have a hardware problem.

  If the Mac becomes too hot, it will make an uncontrolled emergency power off.

  EDIT: Replacing the battery is a completely separable question not related to temperature. Is the Samsung phone batteries that catch fire, not Mac.

• replaced the old iphone

  possible replaced the old Hakki Track iphone

  If you have a question then explain your problem in detail and ask him.

• Text editor ' Save as... '. "broken - replaces the original file as well

  ' Save as... '. "removed some sort items of menu standards a long time ago, but I used this http://osxdaily.com/2012/08/27/enable-save-as-os-x-mountain-lion/ to restore a just as long. This addition of shortcut recently stopped working properly. Creates the new file, it also replaces the original file. Good OOP...

  I removed the keyboard shortcut and discovered that if I open the file menu, hold the Option key to activate twice in save Sub... than that STILL not work correctly. It seems something within the modified OS and buggered how to save under... anything works.

  Does anyone know how to save under... work again? Please do not respond if your answer is to use two copies. This isn't an answer as duplicate is a replacement of several wrong step of the simple and easy as... backup function.

  OS X El Capitan: save documents

• the El Captain replaces the old version?

  How did everyone's like El captain? I had not yet upgraded to Yosemite. I'm going to snow leopard to El captain. It will replace my old version? If this is not the case, should I delete the old version? Thanks for your help

  Yes. When you upgrade, it will replace the old version.

• Apple cannot replace the housing/casing of my iPhone?

  I have a 6 s iPhone, and have a mobile phone plan that allows me to level to halfway through my 24-month plan, also for a long time my camera has extremely minimal Exteriors/Interiors damage. And currently I have scratches and bumps on the housing/casing of my phone and I was wondering if Apple can replace the casing/housing and how much it would cost?

  Apple does not replace the metal casing of the phone. If the phone is damaged and does not, they will allow to make a release of purchase of the warranty, as damage to the housing would be damage user, not covered by the warranty. However, if the device is functioning correctly, Apple generally will not allow an out of warranty replacement for purely aesthetic problems.

• I would like to know how to remove a video that replaces the logo of firefox on my site because I don't want to see it.

  I'm not a web programmer and just wish that the video that Firefox has superimposed instead of their usual logo on my homepage of the browser would leave. It seems that every time I access the Web page, replacing the simple logo. I don't want to continue to see the image in place of the logo. Is it possible that I can safely remove the overlay of video image shows two women of my homepage or have Firefox remove? I haven't watched the video and do not want to look at it, there is no point to make here. I like to keep my navigation very simple and clean interface. My computer is an old Dell PC running Windows 7 Professional, I think 32-bit.

  Thank you!

  The best way to get around that is just to create your own home page and do not use the 'default' on: homepage.
  See - How to set the home page

  You can use this UserStyle - https://userstyles.org/styles/104673/about-home-hide-snippets-and-hide-brand-logo - to hide the two sections of the about: home page House that Mozilla sends messages and videos when they feel the "need".

  Many of us have disabled the changes made to the top [brandLogo part] of the Start Page of Firefox and off advertising "excerpts" [under the reservoir of research] that Mozilla uses all the time now, so we don't see this "thing".

  If you feel adventurous, here's how to 'fix '.
  Type of topic: config in the address bar and press ENTER. Accept the message of 'dragons' to see the Advanced preferences screen. Use the search box at the top to enter the below pref.

  You can assign an empty string to stop your Firefox to retrieve "extracts" and brandLogo changes the browser.aboutHomeSnippets.updateUrl pref. Right-click this pref and select Edit then clear the value as pref in the box that appears, and then click OK. Who will also disable "snippets" that appear under the container of the research on the default home page.

  Then you must open the folder of your profile, via help > Troubleshooting Information > profile folder > > folder view button. Then close Firefox.
  Your profile file open with Firefox closed (Firefox '3-bar' menu key > exit/Quit), wait two minutes, then remove the storage\moz-safe-about + House folder in the profile folder of Firefox to remove the brandLogo and stored in IndexedDB code snippets to make Firefox use the default brandLogo and a defined default code snippet.

  Restart Firefox for these changes to take effect.

  If you later change your mind about these changes, you can reset the pref browser.aboutHomeSnippets.updateUrl via the context menu and Reset to retrieve the default to start to use the storage\moz-chest-fort-about + House record once again.

• How to find the serial number of the processor in the MacBook pro s serial number? I have a dead MacBook that was given for service to a third party. I doubt that they have replaced the original parts. Help, please. Thank you

  How to find the serial number of the processor in the MacBook pro s serial number? I have a dead MacBook that was given for service to a third party. I doubt that they have replaced the original parts. Help, please. Thank you

  As far as I KNOW, the serial number of the MacBook does not have the serial number of the processor.

• How can we replace the display of a keon?

  I am a representative of the Mozilla's Rwanda.

  I gave one of the 3 keons, I got from Remo to a member of my community to work on applications, and the screen is broken on his watch. How can I replace the screen?

  AZ charadi
  Mozilla Rwanda Rep
  https://mozillians.org/en-US/u/AZ/ | https://reps.Mozilla.org/u/AZ/

  AzAnitah said

  I am a representative of the Mozilla's Rwanda.

  I gave one of the 3 keons, I got from Remo to a member of my community to work on applications, and the screen is broken on his watch. How can I replace the screen?

  AZ charadi
  Mozilla Rwanda Rep
  https://mozillians.org/en-US/u/AZ/ | https://reps.Mozilla.org/u/AZ/

  Hi Liz Az,.
  I think it will be better if consult you with the Center nearest mobile maintenance any hardware problem.

• Replace the bookmarks with bookmarks Safai

  I want to completely replace the Firefox bookmarks (15.01) existing by Safari (7.13). I exporten safari in HTML format, but Firefox does not allow me to restore from the file.

  How can I do this?

  Thank you.

  Greg Moberg

  I think you can remove the existing bookmarks in bulk using the dialog library ("show all bookmarks"). In the left column, select the bookmarks Menu, then on the right, select all and either right click > delete or press Delete on the keyboard.

• Blue screen in decline after replacing the screen

  I got my iPhone 6plus screen replaced at an apple store, earlier this week, and now a random regression a blue screen appears from the top of the screen and goes up and down, disappears, then pops up. Meanwhile, the screen is not sensitive to the touch, but when it stops and I double finger restart my phone several times, it works perfectly fine, then at random again. I've already set up another appointment on the apple store. What is an internal error and apple will charge me to fix this?

  It's either a problem with the screen replacement and Apple will not charge your for this or there is also damage to the logic board and you need to replace the entire phone. There will be an extra charge for this.

• Replaced the cable. Now, the screen does not work. What could be?

  The cable coming out of the back of my monitor Apple Thunderbolt Display is fraying. I decided that rather than risk a short at a certain point, I preemptively replace the cable. On iFixit teardown photos, I decided to replace the cable coming out of the back of the screen myself instead of paying almost $200 to get an Apple service provider to do that here in Bangkok. Bought the cable on AliExpress for $12. It replaced. And... no dice. Screen has not come.

  My setup

  [MacBook Air]-[Thunderbolt Display]-[drive Thunderbolt]-[Cinema Display]

  with a key USB drive and Ethernet connected to the back of the Thunderbolt display

  Already tried this

  • First impressions were that the cable was defective. But then I noticed Ethernet came the USB has been mounted, Thunderbolt was mounted drive and after a reboot, the movie screen come also. Obviously, the cable has been working very well.
  • Second thought was that I'd neglected to plug some cables that connect the LCD to the main logic board. I checked. Seemed fine.
  • Third was maybe the serial number of the cable was somehow connected to the main logic board. So I put the old cable. Still no screen.
  • Tried to connect the screen with a Thunderbolt external cable, everything worked as well but still no image on the screen.
  • Tried more than 30 seconds and 3 hours disconnected as a "reset" of the screen. No change.
  • Restarted my laptop. No change.
  • Thunderbolt Display well plugged the drive and then into the MacBook, so change the sequence of the devices. No change.
  • Information reports under "Thunderbolt" the entire chain of devices, but under "Graphics/displays" system displays only the internal screen and Cinema Display.
  • Using the newly purchased cable as a Thunderbolt external cable works fine too.

  Question

  Does anyone have suggestions on what to try next?

  The logic card goes into a sort of locked mode when you replace the cable?

  Is there more than 3 flat cables connection + connection to the land between the Panel and main Board?

  Although there is no reason to think that this has been, how to test LCD screen still work given all these flat cable connectors?

  
  

  Note: There is no Apple here store.  Apple authorized service providers are without help. He suggested to replace the cable and the Panel at a cost that is almost the same as the purchase of a new screen.

  Some of the cables that connect the LCD to the main logic board, are very short. Careful lifting the LCD, because it will go away with strength cables once that raise you it more than 2 to 3 inches on the side of the camera module.

  The shorter cable of all is the LVDS cable. A short cable with gold plated connector. Although I have had reconnected the cable on the side of the logic board, I had wrongly assumed that the other end of the cable was stayed connected because all the band used on. Someone with experience of fixing these things said of his town for this cable to unravel by force and to be sure to check both ends of the cable. When I peeled back the tape, I found that he had indeed been disconnected. Reconnect, fiddling with the tiny workspace to get the logical side of Board of Directors of what properly fixed cable again and we were back in business.

  Apple authorized service providers here in Bangkok have quoted me $200 to replace the cable. I ordered the replacement cable Thunderbolt Display off AliExpress for $12.50. It was really simple to replace the cable, just to keep an eye on this darn LVDS cable opening to the top of the screen!