Satellite A100 - Questions about slow start, not in the DMA mode CD drivers

Similar Questions

• Satellite A100 - 510 PSAA2E cannot start - nothing on the screen

  Hello

  I had Satellite A100-510 (PSAA2E) since May 2006.
  2 weeks before, when I tried to switch the fans started spinning and the LED lit and after about 2 seconds, it restarts without showing anything on the screen.

  There is also no beeps or anything.

  I tried almost everything: remove the hard drive, screen, wireless card, dvd player, change the RAM between the slots...
  It makes no difference if.

  So I think it's a problem of memory or the motherboard is dead, what do you think?

  > So I think it's a problem of memory or the motherboard is dead, what do you think?
  Yes, the mentioned parts could cause this problem

  But it would be the worst case and you must contact the Toshiba ASP for more details

  Before that you would get in contact with ASP, I recommend you try this:

  -Remove the battery, disconnect the adapter.
  -Wait 30-60 minutes
  -Bring the two parties together and try to turn on the laptop

  Maybe if this work around short help

• Satellite A100-786: Win XP does not recognize the Bluetooth

  Hello

  When I had Windows Vista Home premium on my laptop, I used the bluetooth device normally.
  But I had to install Win XP and now he don't even know that I have a bluetooth device!

  Any help would be appreciated.

  Seems that you have not installed the driver of BT stack.
  This driver can be downloaded from the Toshiba page!

  You choose the Satellite A100 series form of the driver and download the BT software.
  Select it with FN + F8, and then follow the instructions on the screen.

• Satellite A100: SD card reader will not read the 2 GB

  Hello

  I wonder if anyone can help. I have a satellite a100-163, which according to the manual should read 2 GB sd cards. When I put one in the slot, he begins the wizzard found new hardware & said while these data are incorrect. 1 GB cards work fine.

  I have to update software?
  Thank you
  Gary

  According to the card SD 2 GB notebook specification must be supported. Do you use high quality products or perhaps some anonymous cheap SD card? Please check if the card is locked.

• Satellite P200 - 1 K 8 - could not get the display and audio drivers to work

  Hello.
  I'm getting desperate. I tried everything I could imagine.

  First of all - do not get the control center catalyst to work, I don't have the graphics driver installed now (I tried both - Toshiba and Mobility Modder modified driver ATi - none works.)
  Second - when I install the audio driver Realtek audio Manager is encoutering the problem and needs to close every time at startup. And Yes, I updated the BIOS to version 5.20 installed XPSP3, chipset driver installed (the most recent Intel homepage or one of Toshiba, anyone, always the same question).

  Help, please. I don't want to spend the rest of my life trying to get XP on my laptop.
  Thanks in advance.

  Can you please send the number of full model of your laptop?

• Satellite A100 - questions about the keys to the left hand and added value package

  Hello:

  The work of doesn´t special keys on left hand. I mean, the keys under the power on button which usually starts the web browser and works with the DVD.

  Another question. The value-added package that was installed on my laptop has got a call from the Toshiba Fash utility maps. When I upgraded to the latest version (previosly I had to uninstall it) this SW is not installed. How can I get it back?

  Thanks in advance.

  Hello

  Value added contains several applications:
  -Toshiba components pilot common
  -Toshiba Utilities
  -Toshiba PC Diagnostic tool
  -Toshiba Power Saver
  -Toshiba Button support
  -Toshiba zooming utility
  -Toshiba Flash cards

  So as you can see, the button support is included in this package. I don't know what the problem is on your laptop, but when the VAP is installed correctly the multimedia buttons and Flash cards should work correctly.

  Try again please remove VAP system, restart the computer and install the latest version available. This latest version works well on the different laptop models (on my Satellite P200D too) and it should work on your too.

• Satellite A100 - question about recovery disk

  When I bought my Toshiba laptop, I received a product with her recovery disk.
  At first, I thought it was the recovery of the whole Windows XP (OS which was preinstalled) but on the back cover of the case, he said only "Windows Office One Note"

  So this product for a recovery notes only?

  Yes, it looks like a recovery disk from Toshiba which would format the whole HARD drive and reinstall the operating system preinstalled together.

• Satellite A100: question about Toshiba HW Setup utility

  When I try to activate the HW setup, a message is displayed with the message: Gemeinsame Module was finished.
  I thought that a program would guide me through Setup of HW as described in the Toshiba Benutzerhandbuch.

  I wanted to really make are:
  1. I need to plug a second monitor on my laptop today in the evening.
  2. when I hit Fn + F5, my screen goes black. Press Fn + F5 again: screen is normally activated.
  I was expecting to see a box where I can choose the configuration of the monitor. (This happened in the past).
  3. in order to check my settings, as I wanted to use HW to install as described in the Toshiba Benutzerhandbuch.
  Result: See above.
  Can you help me please?

  Post edited by: Smiley

  Hello

  I put t know exactly what it is the sense of shared module, but perhaps that it s often resorted to the module.
  This application is necessary for the good state of different tools of Toshiba.
  In this case, I would recommend reinstallation of this application.

• Satellite A100 keyboard input language does not match the physical keyboard

  I'm sorry.

  In fact, it is the first line:

  & é " ' ( - è _ ç Ã* ) =

  Kind regards

  Leonardo

  I have a laptop SATELLITE A 100 (model PSAARE-02X01TFR) with the french (I think) QWERTY keyboard here and may not know how to configure it under Win XP.

  It has these characters on the top row:

  (The numbers are off)

  The second line has:
  q w e r t y u i o p ^ $

  The third:
  q s d f g h j k l: a¹ *.

  The fourth:
  z x c v b n m; , !

  Any idea what and how I have set up?

  Thank you, Leonardo

  Hello!

  As Akuma, you can change the input language of keyboard in Control Panel. It is very easy and takes only a minute to change.
  Check it!

  If you have any other questions, please let us know! :)

  Good bye

• Satellite A100 - Internet becomes slower after 10 minutes

  Hello

  the Satellite A100 worked well for a few years, the internet has become suddenly too slow after 10 minutes of the start.
  The laptop switched on the first time that the internet works very well the 10 first minutes then becomes slower and slower until almost no packets are received but the connection does not completely down.

  Suspected spyware, rootkit, is cleaning up, and then installed from the disk recovery

  Then I tried the same thing. Uninstalled the connection to the local network and then reinstalled from the Device Manager, nothing.
  I figured that the Ethernet port is a failure. Then I used an adapter usb-to-Ethernet D - Link is completely independent of the integrated Ethernet hardware. Nothing, same behavior, working, first fine then Firefox displays a downtime

  The modem, cable, internet are all very well since I have tested with a PC and a laptop Fujitsu (5 years) and they all work very well. Even the D-Link works fine.
  The Toshiba pc diagnostic tool specifically says "Network Fail", but it crashes exactly?

  An idea or a similar experience?

  Hello

  Hmmmmm... It sounds quite complicated.
  What is with WLAN? Have you noticed the same behavior using the WIFI connection?

• About a month ago I posted a question about iMovie and not being able to "share". I solved the problem thanks, so no more emails!

  About a month ago I posted a question about iMovie and not being able to "share". I solved the problem thanks, so no more emails!

  Hi Michael,

  If you want to stop receiving notifications by electronic mail, in the thread, that you have created, then I suggest that you follow the steps below:

  One time connected to the Apple Support communities, visit your mini profile and select manage subscriptions.

  

  Content

  To manage this content, you are currently subscribed and changing your preferences, select the content.

  Select next to see what content you are currently following.  Note that any thread you are responding you subscribe you automatically to this thread.

  You can select to terminate a subscription to a thread.

  

  Learn how to manage your subscriptions

  Take care.

• iMac, 2012, 27″, will not start, not even in safe mode

  IMac my wife, 2012, 27″, El Capitan, will not start, not even in safe mode. The problem started during the installation of Mac Office 365 (2016), although the installation on my machine worked fine.

  The following two photos are sure Mac verbose mode. (Photos are from consecutive boots, that the camera did not focus, but the behavior of the Mac is constant in boots attempts.)

  http://www.jdawiseman.com/2016/20160218_230538_mac_wont_boot.jpg

  http://www.jdawiseman.com/2016/20160218_230059_mac_wont_boot.jpg

  Disc utilities reported an error. Although fsck - fy is not.

  Please, kind of people from the communities of Apple support, what should I try then?

  Thank you.

  Have you tried to boot into recovery mode. Combinations of keys start for Mac - Apple Support

  Select disk utility, then check the disc. Resolve startup issues and perform maintenance on disk with disk utility and fsck - Apple Support

  How much free disk space hard do you?

  What is the error Disk Utility has.

  Kim

• Windows 7 computer said that the DWM.exe could start not due the windowscodecs.dll file is missing.

  Original title: Windowscodecs.dll missing

  IM using a windows machine 7 and one day, he said that the DWM.exe could start not due the windowscodecs.dll file is missing.

  I don't have to go back, any system restore points

  I ran the/scannow sf in command prompt and it says that the file is corrupted.

  I tried to put the machine in safe mode,

  I tried troubleshooting and software update

  and I tried to download external software to replace the file.

  It also affects the Aero theme, so my background is just a black screen!

  What else can I try that actually work?

  Why we just know it is a virtual machine?  Well...

  Have you looked on your system here to check that the file is actually missing (of course that mine has been replaced):

  

  I downloaded a file called on my OneDrive:

  64bitcodecs.dll (64-bit version)

  The link to my a drive is:

  https://onedrive.live.com/?ID=EC673DF6F8DFEE84%212368&CID=EC673DF6F8DFEE84

  You must visit my OneDrive, upload this file to a place, you can find, rename it to WindowsCodecs.dll and then copy and paste in your c:\windows\system32 folder (assuming that Windows is installed on your C drive).

  When you have done so, check again with Explorer that the file is really there (if it was missing before) and if everything looks good, reboot your system and see what things look like.

• Satellite A100 - BIOS and Windows does not start after the BIOS update

  Hello, I extend my Satellite A100 laptop BIOS.

  After update, I can't start my laptop and the BIOS will not start.

  You see the Toshiba logo?

  Was there a power failure when you updated the BIOS?

  Try to remove the battery and the adapter and leave for a few hours. You can also try reinstalling the RAM.

  If this does not help, you will need to send it to a Service Center for repair.

• Satellite A100 - weird way to start up!

  Have just inherited a Toshiba Satellite A100, which is very well apart from a strange fact. When I received it the battery was flat and so I rebooted it, although it was not brimming with ability it hold a charge for about an hour. However, what I find is that I can't boot the pc, unless the charge lead is inserted in the back, even when the battery is fully charged.

  The lead has not to be connected to the power outlet, just inserted in the back. So I plug the wire into the rear load switch on and bingo that it starts up, I then remove the wire on the back and all is well. I'm sure it's not as it should be, but cannot find a way of simply by pressing the switch so he can start without inserting the wire in the back. Strange huh!

  Cheers from
  Mel Jones

  I never heard of something like that. It's really strange question.
  Purchased new, compatible and original battery Toshiba?
  What happens when you press the button walk / stop? Is there a any reaction?

  But you can use laptop when you remove the battery, and you use only the AC adapter?