Satellite A200-14F: BSOD when using the FN keys

Similar Questions

• [Need help] New Alienware X 51 BSOD when using the Ports of USB 3.0

  Hello world

  Today, I received my Alienware X 51.  After you set up the system, I plugged my external hard drive USB 3.0 one of the 3 USB ports on the back of the unit.  The system immediately blue armored and closed.  I let the system restart normally, only to find he Blue filtered and restarted again.  After the third BSOD, I deleted all devices on the computer and let it restart.  It has not crashed this time.  Always plug the devices back to demonstrated that when 3 USB hard drive was plugged into the system, the PC crashed.  I am able to reproduce this constantly: hard drive goes in, system hangs.

  I stayed on the phone with Dell technical support tonight, but all they could tell me to do is find another USB 3 device for test ports with.  Since I have none is available, I'm looking at the community of users for more help.  For the record, I managed to extract the files from BSOD dump.  Here is the latest in graphical format:

  

  Anyone seen this before?  My troubleshooting course consisted by uninstalling the driver for the Renesas Electronics USB 3 hub controller supplied with the system and reinstall the drivers using a package available on the Dell (http://downloads.dell.com/Pages/Drivers/alienware-x51.html) website.  It did not work.  I also tried to format the hard drive, but the BSOD persisted.  Needless to say, I am ideas.

  The drive works fine in a USB 2 port.  Of course, I am disappointed that I am not able to use the higher speeds of USB 3 port at this time.

  Anyone seen this before?  Any suggestions on next steps?  What information can provide this help?

  Thank you!

  I am surprised that this post was did not yet a member of Dell since there is a patch to do this, apparently, I had this problem when I arrived to an external hard drive a few days ago

  Remove the current driver for Renesas installed on your Alienware then click on the link below

  http://am.Renesas.com/products/tools/introductory_evaluation_tools/starterkits_evaluation_boards/usb_3_demo_card/index.jsp

  or just click here

  • RENESAS USB3 Host pilot 30230 setup.exe

  installation, this will fix the blue screen issue

• How to disable the Satellite A200-Ah7 screen while using the external monitor

  Is it possible to turn off the monitor on the laptop Toshiba A200-Ah7 while I use a second monitor?

  It's embarrassing to have the laptop monitor on at the same time.

  Thank you.
  Gary

  Hmm, I think that's not possible, but have you tried to press FN + F5 several times?
  Is it only a CRT monitor available?
  The monitor CRT, external display and if only that is available, then you could try to choose this.

  Otherwise, you can close the lid if you do not use the internal monitor

• Satellite L500 - screen resizing when using the touchpad

  I use the touchpad at the moment because my mouse is dead. When I use the keyboard the screen guard resizing - at the time, I was on this page, the screen went from normal to normal to huge-huge and is of normal size currently.

  It's so frustrating that it doesn't happen when I use my mouse.

  Can someone tell me how to stop the touchpad resize the screen?

  Thank you
  PIP

  Hello

  Do you mean the Internet Explorer screen or what?

  I m not very well what's causing this, but it might be possible that you have activated a touchpad option that could cause this.

  Please check the option in the control panel-> mouse->-> settings (or properties) pointing device
  There you should find the Synaptics touchpad options

  Check if you can find some options that may have an impact on this issue.

  If it please be aware that FN + space keys would change the screen resolution too.
  Maybe you enabled it.

• Aspire V3 - 571 G BSOD when using the dedicated graphics card

  Hey,.

  I just got my new laptop, but as the title suggests, whenever I try to run a program that uses the graphics card, it stutters a bit, before finally being BSOD'ing or saying "NVIDIA Windows Kernel Mode Driver display driver, Version 307.17 not responding and has successfully recovered."

  This happens even with own NVIDIA Control Panel program, where it gives you this small window of the NVIDIA logo rotating. I tried with Minecraft, just to make sure it wasn't this one program.

  Everyone has experienced this before or have any advice? Thank you very much in advance!

  PS: I would have presented a ticket of support on this issue, but it asks me to enter the date of purchase, but it keeps screaming at me that I need to enter "valid a date", even if I use the datePicker bit next to the entry field.

  I ended up sending the laptop in for repair, and apparently it was a faulty motherboard, so they changed it. Everything worked smoothly after that.

• Re: Satellite A200 (PSAE6) - need drivers for the functional keys FN

  I have toshiba a200 psae6 and j want F1 drivers functional keys... .F12 and drivers for finger... yesterday j reinstal my laptop, and now I have problems with this driver... j download fingersensor from the support page but does not work... Windows 7 x 32 is on my computer... Sorry for my bad English...

  Hello

  Which Windows operating system you are using?
  If you are using Win XP, you must install the common Modules.

  If you use Windows 7 or Vista, then you have installed to VAP (value added package) to first and then Flash Card Support Utility!

• Satellite A200 (PSAE6) - need drivers for the functional keys FN

  Please give me a link to this driver.j have windows 7 x 32 bits on my computer laptop a20 psae6... a device reinstal sistem and to reinstall driver and doesn t work... my sensor does not work...

  Hello

  You must download the VAP (value added package) and Flash memory card Support utility.
  These two tools are needed to get the keys FN working in Windows 7!
  I have A210. It s a similar series of laptop and I ve chosen drivers that are released for Satellite L500 series.

  These two tools worked for my A210

• Satellite A200 - IE7 windows 'restore down' when using the Tracker pad

  Hi, I recently bought a Satellite A200 - 1VO and when using the laptop without a windows mouse explore 'restore down' at random.

  I found a thread on the site of the Internet USER who said that if his past not with a mouse, it may need tracker drivers up-to-date.
  You can also consider its under warranty.
  Any ideas anyone?

  Hello

  It s a bit confused what you´ve writes down. What do you mean exactly, where´s the problem and what you want to tell us when writing:

  > and when using the laptop without a windows mouse explore 'restore down' at random.
  >
  > I found a thread on the site of the Internet USER who said that if his past not with a mouse, it may need tracker drivers up-to-date.

  Whereas it should be, where´s now the problem?

  Please give clear and understandable feedback, then I and other users you could point to the solution.

  THX

• Satellite A200 PSAE6E: Impossible to install the audio drivers after installing Win XP realtek

  Hello...

  Recently, I repartitioned my laptop HD to install XP and kubuntu (it came with vista)... However, I was not able to install audio drivers for its audio devices...

  The laptop is a toshiba Satellite A200-PSAE6E and everest indicates the following audio controllers:

  ATI hd 2xxx hdmi @ ati radeon hd 2600 - controller high definition audio
  Realtek alc268 @ intel 82801hbm ich8m - audio controller high definition

  First I tried to download the audio drivers high definition realtek web site (32-bit version of windows xp). I tried to run the installation, manually navigating to WDM file during the installation of the pilot and navigation manually the folders where the drivers have been copied during the installation under c:\windows\system32\... all to nothing done...

  Then I tried to download drivers toshiba official of the support web site of europe from toshiba for the realtek chip... I've lived the same behavior (both when you run the Setup program and install manually force pilots)

  Then I tried to download the drivers for ATI HDMI audio device from realtek website... with the same results...

  Windows tells me that it was impossible to find a driver in the any of the archives...

  The only thing that could be the culprit because as far as I can tell, is that I installed service pack 3 RC2...

  Any help would be greatly appreciated,
  Tasos

  P.S. I've tried the two automatic installation through specification of a folder and choose the options "I will manually choose a driver from the list" in the hardware installation wizard... the result is always the same... Note that the audio works perfectly under ubuntu...

  P.S.2 IMPORTANT! I recently discovered that toshiba offers bios versions for the A200 PSAE6E depending on if it is equipped with windows xp or vista...

  This refers to which the operating system has been installed when the system was purchased, or the operating system that is currently used? Can I upgrade the Bios of my laptop with the XP version or this break from things?

  Hello

  Regarding the sound issue.
  A lot of people already asked for it here on the forum and my knowledge the driver sound doesn't work because that some Member States the fixes and patches are missing.

  Please check this thread:
  http://forums.computers.Toshiba-Europe.com/forums//thread.jspa?MessageID=113124

  You will need to install KB888111 and KB835221 hotfix

  With regard to the BIOS;
  Yes, some series of laptops needs a version of XP BIOS if you want to install and use the XP on the laptop. AFAIK the A200 is one of these series of laptops.

  Good bye

• Satellite Pro A300 freezes when on the internet

  Satellite Pro A300 freezes when on the internet & the only way to turn it off is to take out the battery. Bought new Dec 2010 & is under warranty - suggestions?

  Hello

  have you tried to update drivers Lan (wlan)? What browser do you use? I guess, the Internet explorer, try firefox or opera. Also, your computer may be infected with the virus, or blocked by the firewall. Have you installed software before it starts? Is this ok when you bought it? I ask you too, because you do not have a lot of information.
  It is especially the driver, software problem.

• Re: Satellite A200-14F - how to see 4 GB of RAM?

  Ladies and gentlemen.
  There are Satellite A200-14F
  PSAECE-00500ERU
  with 1 GB of RAM

  After rising 2x2gb, it is possible to see only 3 GB of RAM

  Pls let me know what we will do to get all 4 GB

  Thank you

  Hello

  Just a few hours earlier, he had someone ask them the same question:

  http://forums.computers.Toshiba-Europe.com/forums/thread.jspa?threadID=53044&TSTART=0

  If it does not help, do a search on the forum, it has been discussed several times.

  Welcome them

• Satellite Pro A200 PSAE1E: Can't get the shortcut keys don't work on Win XP

  Hello

  I have a Satellite Pro A200 PSAE1E that came with Vista on it, I reinstalled Win XP Pro installed with relevant drivers download Toshiba page but cannot get working shortcut keys.

  I installed the controls and the driver, but that doesn't seem to work. Saw an ad on "common module" somewhere, but can't seem to find any links to download on the download page.

  Can anyone help?

  Thank you very much

  Iain

  The control utility and driver controls allow you to customize and TOSHIBA special button preset settings. But it is not a FN keys!

  You must install the Hotkey utility if you want to use the FN keys.

  Another tip:
  It is important that all Toshiba drivers and utilities are installed in the correct order.
  On the Toshiba driver page, you will find a txt file called installation instructions.
  Please install all drivers and tools in the order mentioned in this instruction!

  Greetings

• Satellite A200-14F - CPU temperature reached 80 c

  Hello

  I have A200-14F. When I'm coding a video two processor cores temperature gets really close to 80 C. for the most part it's C 78 or 79 C.
  I am seriously concerned about this. Is - this safe temperature? I don't think it's safe to work at 80 ºC for about 12 hours.
  Currently I am slow speed of the processor through energy saving settings.

  This temperature is safe for my laptop? Should I fear not overheating? Or should slow enough CPU to lower temperatures than i?

  Concerning

  Hello

  Usually the laptop would shut down automatically to prevent the equipment from damage if the internal temperature would be too high.
  In addition the 80 c is rich but not too high. AFAIK the CPU temperature can reach 100 c max, but I think that your laptop would be closed before CPU should reach this temperature.

  What you could do is to clean the vents. Sometimes the cooling modules may not cool properly because the vents are blocked.

  Good bye

• I a s 6 more and when using the phone, if my face touches the screen it clicks on the logout button and the phone hangs up the call. Is it possible to prevent this without holding the phone away from my face when calling?

  I a s 6 more and when using the phone, if my face touches the screen it clicks on the logout button and the phone hangs up the call. Is it possible to prevent this without holding the phone away from my face when calling?

  iPhones have a proximity sensor which is supposed to automatically turn off the screen when you hold it in your face. If this is not the case you can take the phone and have it checked.

• When I use the arrow keys in firefox to go forward and back, the cursor erases tiny pieces of letters.

  Even within this field of text that I type, everything is normal, but a back using the arrow keys (and then spacing also forward using the arrow keys as I go back to typing) deletes chunks of the text. Once I have started typing again in this area, the components are deleted to normal. This effect can be captured in a screenshot. After inspection, it seems to be a second invisible cursor, a character to the right of the cursor visible. So when the back arrow back, the invisible cursor trails that visible, destroying the text behind. When the spacing before using the arrow keys, the text gets fact sinking in front of the cursor visible.

  Try turning off hardware acceleration.

  • Tools > Options > advanced > General > Browsing: "use hardware acceleration when available.

  If disable hardware acceleration works then check if there is an update available for your graphics display driver.