Satellite A300 - 12K unable to connect to the ADSL wireless modem

Similar Questions

• Satellite A300 PSAG8E - unable to connect to the internet

  Hello.

  I have Toshiba Satellite A300 PSAG8E (product for Tuerkiye) laptop.
  My vista ultimate operating system.
  I can't connect to the internet.

  I have the new format recently.
  What should I?

  Hello

  If you use the WiFi network you should check if the wireless network adapter is enabled!
  You can activate using the FN + F8 key combination and, in addition, you should switch WLan antenna on IT (the WLan led should be flashing).

  Finally, configure the settings (SSID right, encryption, etc.) and connect to the router.

  All that s.

• Printer Hp6700: unable to connect to the router wireless D - Link DI-514 when SSID Broadcast is set to no.

  HP6700 printer: unable to connect to the router wireless D - Link DI-514 when the router Broadcast SSID is set to no. My MAC laptop and HP laptop both work with the set SSID on no. If I change the router Wireless SSID Broadcast is YES, then the printer HP6700 can connect to the wireless router. I set up the printer it saying that the SSID and password have been, the same as both of my laptops, but it connects ever, unless I have change the router to broadcast the SSID. Help!

  Have you tried to update the firmware on the DI-514?

  You can also try to set a static IP address on the printer, and then assign the printer to the list of DHCP static in the interface of the router.
  To give a static IP address to your printer:
  -Print a the front of the printer Network Setup Page. Note the IP address of the printer.
  -Enter the IP address in a browser to reveal the internal settings of the printer.
  -Choose the network tab, then wireless along the left side, then on the IPv4 tab.
  -On this screen, you want to set a manual IP address. You must assign an IP address outside the range that the router sets automatically (called the DHCP range). If you do not know the range, change the last set of numbers (those after the last '.') 250
  -Apply the subnet 255.255.255.0 (unless you know it's different, if so, use it)
  -Enter the IP of your router (on the Page of the Network Config) for the gateway.
  -Enter for the first DNS 8.8.8.8 and 8.8.4.4 for second DNS. It's Google DNS. You can choose a different external DNS if you wish.
  -Click 'apply '.
  Now, stop the router and printer, start the router, wait, and then start printing.

  After that you remove and re - add the printer to your Mac.

  Show support by clicking on the blue Kudos star in the post that solved your problem. Doing so will help the other members of the forum their solutions also.

• Satellite Pro L510 - unable to connect to the Internet

  Hi, a newbie on this forum so here goes. I got the "fix Windows 7" virus on my laptop because my virus protection that flows. I downloaded AVG which solved some problems, but still not back to the original values. I reloaded Windows 7, but of course I lost all the software preloaded Toshiba & now cannot connect to the internet (laptop computer purchased through the catch of the day).

  What I need to download software/drivers toshiba etc. to address this problem. Thanks for any input.

  Hello

  > now unable to connect to the internet
  Can you write more than one sentence about your problem?

  Does anyone know how you connect to the Internet via modem, LAN or WLAN? More exactly, what happens if you want to connect, you an error message or probably t can find the router?

  Sorry, but without this information there s no end of discussion

• Satellite C660-1NJ - unable to connect to the wireless network

  Hi guys

  I got a 1nj c660 and I have a wireless connection to a Fritzbox 7170.

  Now, this morning, everything was fine and I connected wonderfully, but now I can't connect no settings have been changed I just stop and start as usual. I used configfree and it shows the network but if I try to connect it says unable to connect to the network. I have Win7 home basic OS.

  I uninstalled the wireless network card and reinstalled, updated the drivers but nothing works, I still get the same error.

  Can someone help will appreciate it greatly!

  Hello

  Are you able to connect to open WLan?
  I mean you can try to disable security options in your Fritzbox and might test whether you are able to connect without the WEP, WPA or other safety standards.
  Of course, you should only done for testing purposes

  If this box works, then it means that the security of your router settings were not consistent with the settings of the Wlan card.

• Satellite L40 - 18Z - unable to connect to the wireless network

  Hello.

  I just bought a Satellite L40 - 18Z. I tried to connect to the internet wireless, but I get the following message: "this computer doesn't have a card installed and configured wireless network."

  When I bought it I was told that it was active wireless.

  Can anyone help?

  Hello!

  Have you checked if the hardware switch wireless on the front of the laptop is on?

  You have yellow exclamation points?
  The wireless adapter is recognized?

  Maybe you should also update the driver and/or BIOS.
  http://EU.computers.Toshiba-Europe.com-online decision-making supported Downloads & => Download drivers

  Good bye

• Re: Satellite L300-1DN - unable to connect to the internet

  Hello guys! I recently bought a Toshiba laptop - Satellite L300-1DN and I can't connect to the internet wirelessly or by cable.

  I tried to turn on the wireless button and my laptop recognized my network without wire from my house, but he just not able to connect. Then I tried to connect the cable, but my laptop itself connected to an 'unidentified network' and the internet still does not not :(

  The internet works perfectly fine for my old laptop and my other roommates. So I guess that is not a problem with my router itself.

  I don't know computers very well, so I'd really appreciate your professional opinion!

  Thank you very much!
  Scarfy

  > One last thing, I tried to connect to an unsecured wireless network and it worked!

  It looks like a problem with your router. Check this box and look on the site of the factory for an updated firmware.

  Make sure the laptop and the router using the same standard WiFi (for example 802.11 g).
  Disable all the functions of economy of the WLAN card in Device Manager.

  Last but not least follow Luke posted.

• Satellite M100-221: unable to connect to the home WiFi AP

  Unable to connect to the home WiFi AP. Impossible to establish connection (when using intel software Bundle, connection hangs on the authentication step.
  When using the connection and windows engine, it connects 3 times will come down on "acquiring network address").

  I downloaded and installed the latest drivers and updates to the BIOS, but it does not solve the problem. Other computers with equivalent settings to connect without any problems.
  Wireless AP DLINK 1000AP + type b Wi - Fi.

  What is the problem?

  Hello

  When I have this kind of problems, sometimes by turning and the AP help.
  Or try to change the authentication or encryption settings.

  Good bye

• Satellite Pro 6100: unable to connect to internet via wireless network

  Have had some problems with the audio device Yamaha for another thread, which now seems to be resolved. Thank you!

  However, do not know why, but now unable to connect to the internet via a wireless network, although the router works well as another computer in the House is connected wireless.

  When you check the available wireless networks it comes up with "no wireless networks were found in range, make sure that your computer's wireless switch is on.
  Where to check it, can anyone help?

  Thank you

  On the left side, there is WLAN switch. Make sure that the switch is in on IT. After doing this using FN + F8 key combination and activate WLAN device.

  After having done that, you should be able to see the WLAN networks available in your area.

• Satellite L300D-10U - unable to connect to the internet using LAN and Win XP

  Hi all

  I had a very big problem with my card.
  I can t connect to the internet.
  I searched the forum but without any determination :(

  I did everything. I have checked ipconfig nothing, check the mode safe mode with local network nothing.
  Someone said too
  "(1) once the Ethernet is connected, power of the DSL Modem. Cycle." ("Some Modem picks up the MAC ADDRESS of the network card on where it was previously connected and restarting it redétecte this new")

  How to disable the modem?
  And another question: can someone tell me what works of LAN drivers in Sat L300D-10U on XP?
  I put t even know that :(

  Help me

  Hello

  The Satellite L300D-10U belongs to the series of PSLC0E and it supports the Realtek LAN card.
  LAN driver can be found on the page of Realtek.

  You ask how to disable the modem? I think you mean how to reset modem DSL
  Well, usually your modem should support an ON / OFF button simply turn it off and then turn it back on.

  If you are unable to access the internet then you should first check if your modem is properly configured and that the right data ISP (internet service provider) was used.

  Sorry, but that's all I can say right now I think you should just check your modem settings, make sure that the NIC is properly recognized and connect the model of the laptop using a LAN cable.

  All that s

• Satellite A500 - 03P: unable to connect to the WLan using Win 7 + event message

  Hi all

  I recently bought the Satellite A500 with the offer included Windows7 while he was available late October 09.

  So I had the Toshibe DVD for the upgrade and followed the steps and Visa home premium upgrade to Windows 7. Now I have two questions.

  (1) I get a system event Notification after start, talk to me about the system event log. The full message is below.

  Unable to connect to a windows service
  Windows could not connect to the System Event Notification service. This problem prevents limited users to logon to the system. As an administrator, you can view the system event log to see why the service failed

  (2) I was able to use this laptop for the internet before the upgrade, both via a USB wireless drive as well to the office via a DSL modem.
  Now I can't access the internet after the upgarde of Windows 7!

  For example the Optus dial-up box pop up appears commandeLorsque I click on 'connect', it does not connect.

  Can anyone help please?

  Thank you
  C I

  Hey Buddy,

  (1) did you check the Configuration of the Service for this service? The Boot System Event Notification Service type must always be set to automatic. This service is absolutely necessary for Windows and shouldn't t be disabled or set to manual startup type.
  Check it!

  (2) to be honest I never heard on the internet BEFORE, but normally, it should also be possible to access the Internet with Windows 7.
  Make sure that the WLAN or LAN card is installed properly and check the TCP/IP settings. If you are missing some driver you can get on the page of Toshiba.

• Satellite Pro A100 - unable to connect to the internet

  I'm unable to connect new Satellite Pro A100 to my youngest daughter to the internet.
  I have a cable modem Netgear DG834 router that works perfectly with my desktop pc and laptops other two of my daughter.
  I checked all the settings, but to no avail.

  Can anyone suggest anything that could restore the balance of my household!

  How have you tried to connect the laptop to the router?
  A you connect using a LAN cable?

  Are the firewall enabled?

  Please publish more details!

• Satellite P500-11F - unable to connect to the Internet

  I have a Satellite P500-11F and I can't connect to the Internet without the cable modem. I don't know why. All software is updated, but the connection is cut off very often.

  My computer can reach the home network and without wire is ok, but I can't open any page on the Web: it tells me that
  Does anyone have this kind of problem with a Satellite P500?

  Thanks a lot for helping me
  Da Silva

  Hey Buddy,

  I assume you mean the WIFI connection, right?
  If so, you should check if the WLAN driver installed proplerly or you can see yellow exclamation in Device Manager?

  I put t know what OS you have, but for most versions of Windows, you can download more recent WLAN driver on the official website of Toshiba. What (s) worth a try:
  http://APS2.toshiba-tro.de/WLAN/

  Check this box!

• Satellite Pro M70: Unable to connect to the WLan with ConfigFree

  Salvation in the Forum.

  I have problems with a satellite Pro M70, about gaining control of wireless connections.

  When I scan with "The Radar" I have ConfigFree for available wireless accesspoints, I get several points available, but it is not able to connect to one of them. I can read their status and see their marker of WEP encryption.

  When I try to connect to one of them, I get a pop-up dialog, that said (translated from Danish) 'suppliers another software is in control of the wireless network card. When you try to configure a connection through the classic way to windows, windows States that "windows is not able to configure this wireless connection - if you have another program to manage wireless connections, you must use it". I guess it refers to ConfigFree...?

  Is the unnamed "other provider" associated Windows or perhaps associated McAfee (Security Suite 2007)?

  If you are familiar with this problem or something like that I'd be please to know.

  Also - where can I enter keys for WEP encryption for my friends in ConfigFree WLAN routers?

  > Trying to make a connection through the classic way to windows, windows States that "windows is not able to configure this wireless connection - if you have another program to manage wireless connections, you must use it". I guess it refers to ConfigFree...?

  It should not be a ConfigFree. According to you, an Intel ProSet utility or a Client Atheros wireless network adapter might be controls the Wlan configuration!

  Please check if one of the two control the WiFi network tools and turn off!

  > where can I enter keys for WEP encryption for my friends in ConfigFree WLAN routers

  You should have three different tabs in the utility Configfree.
  The second device settings provides the list of devices, and you should see the wireless network connection.
  Choose and use the button network connections.
  There you should find some encryption settings!

  Also check the profile settings tab and the option called security settings

• Satellite M645-S4070 - unable to connect to the wireless network

  Hello. I have a Toshiba Satellite M645-S4070.

  Lately, I have no problem connecting to networks wireless in my office. Until this morning when I start my laptop, I can't connect to the internet more. I already use a recovery disk to check if I can solve the problem but nothing is. When it connects to the LAN it runs.

  Thank you.

  Hey,.

  The wireless network adapter is listed correctly in the Device Manager? It is maybe just disabled, and you can enable/disable using FN + F9 key combination.

  You should write more details not connection might mean everything, so first of all, that you should check if the wireless network adapter is recognized and activated correctly.