Satellite C650 - blue screen when you try to install XP

Similar Questions

• Blue screen when you try to install Windows XP Home Edition on Satellite L350D-11 has

  Hello
  When I try to install Windows XP Home (including SP3) on my new L350D-11 has a blue screen after loading the drivers.
  When booting with Kubuntu Live CD (8.x) appears an error message: / sbin/modprobe out anomalous.

  At least I need Windows XP because of some programs that do not work under Vista. Is it possible to install XP?

  Hello

  Hmm I think the BSOD appears because you didn t add SATA drivers in the Win XP operating system.

  However, you can try to install Win XP on your laptop without the use of the SATA driver, but you can change the SATA AHCI in the BIOS in compatible mode.

  Check it out!

• I get a blue screen when you try to install XP Pro: Stop: 0x0000007B

  I'm doing a new installation of my CD XP pro (SP2) on a sata drive.
  My bios works with AHCI so I have the drivers on a floppy and press F6 when the installation starts. Finally, the screen shows it starts Windows but crashes with:
  A problem has been detected...
  The rest of her talking about the virus check screen, remove newly installed hard drive, check the errors with chkdsk and so on and gives the following Stop error message.
  Stop: 0x0000007B (0xf78D2524, 0xC0000034, 0x00000000, 0x00000000

  I checked the hard drive with a test of surface (past) deleted and reinstalled the partition and formatted NTFS.
  I have the disk sata hard connected to a sata 6 gb in the motherboard connectors, while the sata drive is an old one that is probably at the low speed of sata. Who would have something to do with it?

  Any ideas?

  Here's what I found for the 6 series chipset: http://downloadcenter.intel.com/Detail_Desc.aspx?agr=Y&ProdId=3273&DwnldID=20710&ProductFamily=Desktop+Boards&ProductLine=Intel%C2%AE+6+Series+Chipset+Boards&ProductProduct=Intel%C2%AE+Desktop+Board+DP67BG&lang=eng

• Blue screen when you try to install Windows XP on Intel ThinkPad Edge 520

  Hello

  I have a ThinkPad Edge 520 type 1143-B5G with a clean disk and I need to install Windows XP on it, for reasons of inheritance. I read on the pilot of the technology Intel Rapid store being necessary, but this seems not to apply to the 520, only to 220 and 420. The recommended settings are not available on the 520 (nor is the driver itself), and the driver is listed by n/a for the 520 in the list of drivers of Lenovo. But, I always get a BSOD error just as Windows is starting from the installation DVD, after the DVD instructed all pilots, he can think about.

  Anyone know how to fix this?

  Would BTW - be possible to install XP in a separate partition, main alongside Windows 7, on a drive that already has Windows 7 on it? Or a clean disk is needed for this?

  Kind regards

  / EvA

  Hello and welcome,

  What settings are you looking for?  It seems that there is a problem with the mode of operation of HD.  The E520 BIOS has an option to change the SATA compatibility instead of AHCI mode?  You will not be able to install a version of "Vanilla" of XP without adding the correct AHCI driver or compatibility mode.

  What version of BIOS do you have?  I see this rather cryptic reference in the BIOS 1.20:

  "[Fixes problem] problem reading/writing data to the SATA compatibility mode."

  It is possible to dual-boot XP and 7, but the best way to do is to install XP first and then let the 7 Installer put in place the configuration dual-boot.  You would still have the problem of compatibility (IDE) vs AHCI mode.

  Ah, lookinng a little further, there is a driver AHCI for XP in Lenovo driver matrix.  The readme file includes instructions on installation.

  Intel SATA controller AHCI Driver for Windows

  Readme for Intel SATA controller AHCI Driver for Windows

  Maybe you get.

  Z.

• LifeCam is at the origin of the problems of "Blue screen" when you try to close?

  I get a blue screen when you try to stop, we have identified the "Lifecam can be the cause of the problem?

  Hello

  Thanks for posting your query in the Microsoft Community Forums.

  According to the description of the problem, I understand that you get Blue Screen of Death, when you use Lifecam on Windows 7 computer.

  We're here to help and guide you in the right direction.

  I suggest you to consult the help article and check if it helps.

  Method 1

  I suggest you update drivers lifecam and check if this may help,

  Updated a hardware driver that is not working properly

  Update drivers: recommended links

  Method 2

  Visit the link mentioned for more information below.

  Resolve stop (blue screen) error in Windows 7

  Note: System Restore does not affect personal files, such as e-mail, documents, or photos, so it cannot help you restore a deleted file. If you have backups of your files, you can restore files from a backup.

  Important: when running chkdsk on the drive hard if bad sectors are found on the disk hard when chkdsk attempts to repair this area if all available on which data may be lost

  Note: Reinstall Windows 7 will remove all the programs you have installed and restore the default settings of Windows. You will need to restore your user files, and reinstall all the programs you've installed using the installation disk or the original files.

  It will be useful.

  Let us know if you encounter problems under Windows in the future. We will be happy to help you.

• Re: Windows Update KB kb961371 causes blue screen when you try to connect with BT

  Just thought I'd share what he had me flumoxed for awhile.

  I found that Windows Update has published around July 16, 2009 cause BT crash and Wlindows to go back to a blue screen.

  KB961371 is installed automatically by Windows Update If you have set it to do.

  Unistalling it end the Bluescreens.

  BT Stack Version 6.40.00 (T)

  Windows Vista, but can affect other operating systems

  Update details

  http://support.Microsoft.com/kb/961371

  Ian

  Hey Ian, thanks a lot for this info.
  I'll test it on my machine.

• Intelppm.sys of error blue screen when you try to generate a custom.wim with WDS

  I have 20 Toshiba Portege R700 and when I try to generate a wim file personalized with all my apps, the system crash and a screen beautiful blue appears with the error in intelppm.sys. The image capture starts but never stops and crashes not always at the same size. The BIOS and drivers are up to date. Can someone help me?

  Hello

  What is the file wim and what program you use to create this file?

  Do do you this on the version preinstalled Windows from Toshiba?

• Blue screen when you try to use iTunes "DRIVER_IRQL_NOT_LESS_OR_EQUAL".

  Original title: blue screen of death while using iTunes

  Hello. I get a blue screen of death while using iTunes. Whenever I try to sync my iPod with iTunes, after a few minutes, I get a blue screen of death. The blue screen says something like this:

  DRIVER_IRQL_NOT_LESS_OR_EQUAL

  0x00000002, 0x00000000, 0xC4A00000, 0x80710CCB

  Kawgha, sys address 80710CCB base at 8070. 000

  Is there a solution to this? Thank you.

  Follow these sites

  http://www.PCSTATS.com/ArticleView.cfm?articleid=1647
  http://www.professorshouse.com/living/technology/computers/articles/blue-screen-of-death---how-do-I-fix-it/
  http://support.Microsoft.com/kb/958233

• I got a blue screen when you try to re - install Windows 7.

  All started 3 days ago. I was using just my PC regularly, then I get a BSOD. Whenever I tried to reboot, I get a BSOD after about a minute after loading screen. The BSOD was rdyboost.sys I did a system restore using the windows via memory stick installation. Things were great, that 10 minutes later, I start getting BSOD, once again and each time after that screen as before loading. I tried to reinstall windows, but I have a BSOD at 30% to each hour. My motherboard is ASRock extreme 3 gen z68 3. Is there something wrong with the motherboard in this case? It seems to be a hardware problem, now, I guess. the BSOD now varies from as "changing the code of the system or a critical data structure has been detected" to "ntfs.sys" or * STOP: #.

  I took pictures of the BSOD, but there is no option to transfer to this post. I am trying to install windows 7 pro 64-bit, which was originally about it.

  ~ I need help fast. Thank you. I'm willing to do whatever it is necessary. Should I try to install windows xp and see if I have some luck?

  Solved the problem myself. I did memtest on individual RAM, a strip of RAM was defective. Thanks for the help.

• Blue screen when you try to open the game

  I just finished a new installation of the operating system after formatting the discs. I kept my secondary drive deleted until I had installed everything I wanted to be installed on the primary SSD.   I used disk management to recognize the secondary drive then remember there was still one thing to install on the p [primary drive.  I deleted the secondary image drive installed again, what I had, and the secondary drive active re.  When I re enabled, disk management recognized secondary drive 0 and main (C) drive as disc 1.   I get the Blue error screen at the opening of the games.   Any help is appreciated.

  I have more the problem of disk 1/0, as a fixed.   I got another blue screen but after trying to uninstall and reinstall the sound drivers to correct a cracking noise that's happened with the startup sound.

  The computer tells me that I don't have permission to share the dmp.

  My laptop is a Clevo P150SM

  CPU: Intel Core i7 4700MQ

  GPU: AMD Radeon HD M 8970 4GB

  16 GB OF RAM

  SSD is the C drive and HARD disk is the disk storage and programs.

  DriverView and information system has been downloaded as requested.

• I ve had blue screen when you try to use photoshop to the bridge.

  I have can´t open a file (regardless of format) bridge, Photoshop, as I used to.

  I get error of kennel, in the blue screen. I use Windows 8 and Photoshop CC 2015.

  Can someone help me?

  TKS. Seem likely be solved with 10 Windows Update.

• Receive a blue error screen when you try to install XP.

  Annoying windows BSOD please help I'm setting my hair out now
  
  

  Please help me I'm trying to install windows xp and I get a BSOD saying my bios is not fully acpi complaient I tried all that I disabled off usb parallel ports nothing worked APM legacy my mobo is a8n32-sli Deluxe

  Hi Muhammad_938,

  You will need to contact the computer manufacturer for a BIOS that is fully compatible with ACPI.

  Error "Stop 0x000000A5" when installing Windows XP

  http://support.Microsoft.com/kb/314830

• Blue error screen "stop0x0000003E" appears when you try to install windows vista (R) service pack 2 - that's what I've shown in after I try to install the update? is this a problem or not?

  The problem I have is listed on the feald above, but there are once more my question: blue screen "stop0x0000003E" error when you try to install the service pack of windows vista (R) 2.

  Free unlimited installation and compatibility support is available for Windows Vista until February 26, 2010. Availability of support chat or messaging differs depending on your location. Some questions may require that more support for which he is advanced a charge.  Go to http://support.microsoft.com/oas/default.aspx?prid=13014&gprid=582034 & select appropriate category (i.e., download problem;) Installation problem; Problems after installing a service pack). ~ Robear Dyer (PA Bear) ~ MS MVP (that is to say, mail, security, Windows & Update Services) since 2002 ~ WARNING: MS MVPs represent or work for Microsoft

• When you try to install the trial version of Dreamweaver on my Windows desktop, I just see a white screen and nothing happens, except for the blue squares moving. I'll just wait? For how long?

  When you try to install the trial version of Dreamweaver on my Windows desktop, I just see a white screen and nothing happens, except for the blue squares moving. I'll just wait? For how long?

  It could be the browser problem because the site is up and running, could you please try another browser.

  If same thing happening there so kindly go to Adobe CC 2014 Direct Download Links: Creative Cloud 2014 Release. ProDesignTools and download the desktop here CC application.

  Note: Please follow the instructions very Important, otherwise the download does not start.

  -Pierre

• IM in safe mode because that's the only way to get into my computer it blue screens when I try on a regular basis, how to do a system restore or restart in safe mode?

  Hello I'm in safe mode because it's the only way to get to my desk, it blue screens when I try on a regular basis, how to do a system restore or restart in safe mode?

  Hello

  Do a restore of the system using the same safe as you would in Normal Mode.

  http://bertk.MVPs.org/html/restoresysv.html

  http://www.computer-answers.info/maintenance/Vista/How_to_Use_System_Restore.php

  See you soon.