Satellite L30-113 does not recognize memory upgrade

Similar Questions

• Satellite L30-113 does not recognize the two modules DIMM RAM

  Hello

  I have a Toshiba laptop Satellite L30 113.
  It has 512 MB of RAM and therefore struggled to run Windows Vista, so I bought another 1 GB of RAM.
  It's DDR2 553 MHZ (PC4200.

  The problem I have is that the laptop does not recognize both DIMMs, i.e. the old 512 MB and the new 1 GB when they are in the whole PC. I tried the two DIMM individually in both slots and there is no problem, but when I install both the system sees just 1 GB. I tried the DIMMs around two ways but without success.

  Did I miss something?
  They should be the same size as in the bad old days?
  What is going on?

  Thank you

  Adam

  > I tried the two DIMM individually in both slots and there is no problem, but when I install both the system sees just 1 GB
  Seems that the two RAM modules are not completely compatible...
  I've read several times on these issues and to be honest it s are not uncommon

  I advise you to buy two identical RAM modules ad then to try again

  I'm afraid there is no other solution for your problem of m.

• Satellite L30-105 does not recognize the 1 GB of additional RAM

  Hi there I hope someone can help me

  I have a Satellite L30-105 PSL33E, which came with 1 GB of ram installed (2 x 512 MB made by TeamViewer)
  and it's terribly slow with vista, not to mention programs.
  The toshiba website says max RAM is 2 GB, so I bought a Kingston 1 GB ram chip to increase the ram to 1.5 GB. I thought should try before moving to 2 GB

  However after installing memory vivid it's show still only 1 GB in windows and in the bios (894 + the rest for video). It has the latest available BIOS on the site 3.10, yet still does not recognize the chip.

  The chip is installed in the lower slot, including the original 512 at the top (closest to the keyboard)

  Are limited to only some of the Satellite of RAM?
  The old subjects indicate if kingston does not work try corsair.
  Other topics suggested to change slots
  Others suggest that it may have only two of the same ram chips in IE 2 x 512 or 2 x 1 GB, you may not have 1 of each

  Can anyone help? everyone knows about similar problems?

  I will not buy any more RAM to try different brands for the same issue to occur

  Hello

  The L30-105 is able to manage the 1024Mo modules in each location it should be able to update the RAM up to 2 GB.

  > Why the RAM 1 GB module cannot be recognized?
  Perhaps the two modules are not compatible with each other
  I would recommend using two identical modules of the same manufacturing
  I use Kingston modules, they are ok for me

• Satellite L30 (PSL33E) does not recognize second memory slot

  I'm trying to upgrade a L30 for a friend. It came with 1 memory module 512 MB PC2 - 4200. I tried to add a 1 GB PC2-5300 SODIMM in the second housing and it does not pick it up. I replaced the 512 with the 1 GB and he found. Put the 512 in the second slot, still sees the 1 GB but not the 512. I tried 2 x 1 GB and he sees one of them. It reports 894MB as I guess he uses 128 MB of video memory.

  I've updated the BIOS, checked all the settings and I don't see why it woun't recognize the second memory location.

  Any ideas?

  Hello

  The second location is defective. It's the only plausible explanation

  But as far as I know Toshiba recommends the use of these modules;
  512 MB DDR2-400/533 (PA3412U - 1 M 51)
  1 GB OF DDR2 400/533 (PA3411U-1M1G)

  Maybe you should test notebook with such 1 GB module to make sure this isn't a problem of compatibility of memory.

• Satellite L100 113 does not start after upgrading memory

  Hello.

  Our Integrator bring to our company KVR800D2S5, but laptop memory modules does not start :(

  I read manual - this laptop supports 533 PC4200 memory modules.

  But SO-DIMM 533 MHz will be delivered in one month...

  The memory modules, we can install to Toshiba L100-113?

  Thank you.

  Hello

  I think that the laptop does not power upward because of a barrette memory faulty or not fully compatible.

  Please visit this memory 3rd party:

  [Memory for Toshiba Satellite L100 113 | http://www.orcalogic.co.uk/asp/prodtype.asp?prodtype=22360&ft=m&st=3]

  As you can see Satellite L100 113 memory can be upgraded up to 2 GB (2 x 1 GB) and you must use the DDR2 533 MHz (PC2-4200) 200 - PIN SODIMM

  Concerning

• Satellite L30-113 does not connect to internet

  Hello

  My laptop was working perfectly until yesterday morning.
  But when I logged in the afternoon it wouldn't connect to the internet.

  Well, click on the connection icon bought the normal boxes as diagnose & repair and the network & sharing center however by clicking on either of these that I get a message back that the service control manager is not running, and click here to start it manually but the machine will not allow this.

  In fact, it seems that a number of functions have stopped working for example I can't open Control Panel.

  Can someone help me because I'm terrified of losing all my work for the past 2 years.

  Hello

  > Actually, it seems that a number of functions have stopped working for example I can't open Control Panel.
  First of all, I doubt this would be a case of warranty. The warranty covers only the hardware problems and it sounds like a software problem.
  I don't have any idea of what OS you are using but if different functions are not accessible and that you are not able to access the Control Panel, then I suppose that your OS is confused why? Who knows.

  You can try to start in safe mode. Switch on the device and press F8, and then choose Safe mode. Windows should boot into safe mode, then you can check if you can access the control panel.
  You can also try to use the last good configuration that would be available using the same menu as safe mode.

• Satellite P20 S203 does not recognize my additional 1 GB memory

  Hi all

  My computer (Satellite P20 S203) does not recognize my second Bank of memory (1 GB). I have two banks of memory of 1 GB installed. BIOS reports only 1 GB, Windows reports that 1 GB and my Linux so he says only 1 GB of memory. I removed each Bank of memory and restarted the computer successfully in each of the two slots, No Problem, but when the two banks of memory are inserted, it always uses only 1 GB. My BIOS is on version 2.10:

  BIOS is the PhoenixBIOS 4.0 Release 6.0

  I know it's an old computer (about 10 years), but what could cause such a problem?

  Thanks a lot for any advice or suggestions!

  Kind regards
  Andy

  Post edited by: fuegi_1

  Hi fuegi_1,

  The upgrade modules, bought exactly?

  To me it sounds like that it s a compatibility problem or your computer laptop doesn't support 2 GB.

  If you use two memory modules, you must only use two modules of the same production.

• Satellite A110-294 does not recognize the wireless card

  Hello

  the question is:
  Why my Satellite A110-294 does not recognize the wireless card?

  I re - install Xp PRO with all the drivers.

  I have try all the drivers Wireless: Wlan intel + proset intel atheros wlan + wlesscmgr

  I don't understand, can you help me?

  Thank you
  André

  Hello

  To my knowledge, the A110-294 uses the Atheros WLan card and therefore the Atheros Wlan dirver should be the right one.

  You can find the latest driver for Atheros WLan here:
  http://APS2.toshiba-tro.de/WLAN/

  Just a question;
  You see the local network card in Device Manager? I mean, you should see an Ethernet controller or an unknown device in the network adapters
  The driver is missing, then the device must be marked with a yellow exclamation point

• Satellite A30 - 30F does not recognize my hard drive

  Hello
  I have a laptop Satellite A30 and when I start it up I get this message:

  For Realtek RTL8139 (X) /8130/ 810 X PCI Fast Ethernet Controller v2.13 (020326)
  PXE - E61: Media test failure, check cable of
  PXE - M0F: Exit PXE ROM

  I think my laptop is trying to boot from LAN because that does not recognize the hard drive, but the drive is ok, I tried on another computer with problem. Sometimes, not always, and I don't know why, I can start from the CD. If I boot from the Windows XP installation disk, I can access the hard drive. I've run fixboot and fixmbr hard disk, but that does not change. The bios recognizes the hard drive. BIOS vertsion is 1.20. I tried to upgrade the BIOS, but I need to Windows, so...

  Thank you very much and sorry for my English :)

  Luis

  Hello!

  To message PXE, you can consult this document:
  http://APS2.toshiba-tro.de/KB0/TSB8A02G90000R01.htm

  I think that your HARD drive or disc HARD controller of the motherboard is faulty, but I don't know m.
  Have you checked the HARD drive with a special tool for this? The Drive Fitness Test can check the HARD drive for bad sectors or something else:
  http://www.HitachiGST.com/HDD/support/download.htm#DFT

  Take the test and post your result!

  Good bye

• Satellite 1900 (PS192E) - does not recognize the CD/DVD

  Hey all,.

  I just bought a Toshiba Satellite 1900 (PS192E) and place an old 20 GB HDD from an old laptop.

  When I boot, the screen is in VGA 16 color mode, it recognizes the DVD player, but does not recognize the CD/DVD when inserted. I tried to install and run the utility "driver robot" Toshibas, but the display is such that I see all of the screen to start the search.

  If there is someone out there who could give me some advice, I would be extremely grateful.

  Thank you very much

  James

  Hello

  OK, you have installed the disk HARD of another laptop but too format the HARD drive? I mean if the HARD drive performed from another laptop, you need to reinstall Windows because now you have other hardware installed.
  What version of Windows is it?

  If you want to install a driver for the graphics card go into Device Manager and select Update driver.

• Satellite Pro 6100 does not recognize the single battery external power

  Whenever I have start Satellite Pro 6100 Win XP Pro with standard battery mounted and connected to the power supply computer laptop does not recognize the ext battery supply single supply and during 'start-up' goes into hibernation.

  By pressing the power on button laptops "wake up" and indicate that the battery is empty or may not even decide when completely loaded, then says connect the station even if still connected, looking under Toshiba console when it runs shows running on battery when still in the power of the ext?

  I have two batteries and both give the above symptoms even when I remove ext of laptop power always runs with power supply by battery but no light orange or green for battery.
  Any ideas?
  Concerning
  Phil

  Hello

  Is your AC adapter malfunctions or there is something wrong with the power supply to electronic s laptop.
  In the first case you could purchase a new compatible AC adapter and could check if the laptop can run successfully.
  The second possibility is a serious hardware problem, but in this case, the laptop must be checked by an authorized technician.

• Tecra R850-11U does not recognize memory full

  My Tecra R850-11U has 8 GB (2 x 4 GB) memory inside. I am under W7 Professional 64-bit, and the machine shows that 4 GB of memory.

  I've updated the bios, but the bios display also 4GB. I have 2 banks of original samsung memory still a change to a Bank of kingston, but it displays no more than 4 GB.

  How can I solve this problem? I like the full memory

  The chipset supports 8 GB of RAM, so you should be able to use the 8GB.
  But if the BIOS does not recognize the 8 GB of RAM then one of the modules might be faulty or not compatible with another module.

  It is just as well as a plausible explanation for me

• Satellite M45-S265 does not recognize WLAN adapter

  I just restore my computer and it does not recognize the WiFi device,
  I tried with the support from Toshiba but I couldn't find an answer, the switch is on but I do not have the Green ligth and in the network of connections is not appear.

  Could you tell me how I can implement this feature? or check the hardware?

  Is a Toshiba Satellite M45-S265

  Thank you

  You see the device wireless in Device Manager?

  Its drivers are installed correctly?

  If the driver is installed, try to disable or reconfigure your firewall

• Satellite C650-1CP - does not recognize DVD

  For some unknown reason, my Satellite C650-1CP stopped reading DVDs (although it works for cd), it does not recognize all simply that a DVD is in the drive.

  I tried several games (including games that worked on my laptop) and none do not work, any suggestions?

  Hello uncleben,.

  Maybe the DVDs are scratched... Have you tried different types of DVD and you are sure that the drives are ok?

  You can also try to remove the server - and lowerfilters in the registry. So follow the instructions in this Microsoft article:
  http://support.Microsoft.com/kb/314060

• Satellite A200-1AE does not recognize the USB 2.0 flash drive

  I have a problem because my satellite A200-1AE with Microsoft Vista does not recognize the USB 2.0 flash drive. He asks me a program/software!
  The same USB works without problem on other computers with vista!

  Someone knows what to do?

  Hello

  First of all, you must disconnect all USB devices and must remove the USB ports and controllers in the Device Manager.
  After this procedure, you must restart the laptop. After a new restart the Vista operating system should recognize the USB ports and should reinstall USB drivers again.

  Then you must update the Vista to the State! All fixes and patches must be installed. Please note that you will have to visit the MS Update site for all patches

  Notes; MS has released a beta of Vista SP1. I installed it on my laptop and it has solved several problems.

  Best regards