Satellite L30 and 2x1GB PC2 - 5300 DDR2 667 compatibility

Similar Questions

• DDR2 PC2-4200 or PC2 - 5300 DDR2

  Hi, I have a DV2045ea (Yes a bit old, I know and I intend to improve the 2 x 512 to 2 x 1 GB Rams.) The intalled ones are 4200, but my question is this laptop takes supported 5300 s because I have a few probs to find 4200 s? Thank you.

  It will downclock if you install DDR2-667 (PC2-5300) memory and will work fine. But the system speed is 533 mhz (PC2-4200) and it does not work faster. My advice is to buy Kingston or Crucial because they ensure compatibility if you buy the module exactly specced for your laptop.

  Here is the crucial page and you can't really go wrong with 2 x 1 GB for $30

  http://www.crucial.com/store/listparts.aspx?model=Pavilion%20dv2045ea&cat=RAM

• Satellite U300 - 13 M - 4 GB DDR2 667 MHz RAM upgrade

  Hello dear experts,

  At the moment, I have 2 x 1 GB Samsung installed DDR2 of memory 667 Mhz strips.

  I would like to extend the 4 GB RAM so I bought Kingston DDR2 667 MHz 2 x 2 GB KVR667D2S5 / 2G modules.

  But the computer is not started.
  It does not start with the single module or with two modules are installed.

  If I install set of Samsung 1x1GB + Kingston 1x2Go, computer starts, but Widnows 7 32 bit see only 1 GB of RAM.

  If I update the BIOS, will it work?
  Or any suggetions?

  Thanks a lot guys!

  In my opinion it has nothing to do with the BIOS update. It's the compatibility issue.

  As you already know that your laptop can be upgraded up to 4 GB and you use 2 x 2 GB modules.
  2 GB compatible RAM has PA3513U-1M2G part number.

  I checked the page Kingston and memory module with KTT667D2 part number / 2G is listed as compatible for your Satellite U300 - 13 M.

  You can check it out here.

• Satellite L30 and Win7 - audio up and down FN not working properly

  After that I have a clean install of Windows 7, of reinstal the Toshiba value added package wich I downloaded from the site.
  All keys special function of Toshiba Satellite L30 - 10T working again except high audio FN one downstairs.

  Do I need additional drivers to get the Volume up and down the function button to work?

  I discovered that the Volume actually works with the fn from top to bottom but its just very slow and there is no visual indication.

  I used to have a green bar on the screen indicating how much volume been turned upwards or downwards.

  How can I get a Visual indicator for volume control?

• Re: Satellite L300-147 how to install DDR2 667 2 GB memory card?

  I have the right part number to install memory for my Satellite phone but don't know how to do it. all the tips and tricks on how/where to open up the laptop and insert the memory card?

  Thank you!

  Chris

  Memory locations are generally accessible from the Base of the laptop.

  Find a door with a screw, remove the screw and lift the door. You should see two memory slots (with a free location according to the model).

  But you must make sure that your laptop can take 2 GB modules. I think that if you have a Celeron processor, the system cannot take more than 1 + 1 GB

• Satellite L30-101: confused about what DDR2 RAM

  I want to set up an another 512 k of RAM DDR 2 but am confused because there are many kinds.

  I was thinking about the Kingston Value RAM. -
  512 MB - SO DIMM 200 pin - DDR II
  Upgrade to generic Type
  DDR II SDRAM technology
  Factor of form SO DIMM 200-pin
  Memory speed 533 MHz (PC2-4200)
  Verifying the integrity of data Non - ECC
  CASE Latency CL4
  Features without buffer memory
  Power voltage 1.8 V
  Lead plating gold
  MFG Part No.: KVR533D2S4/512

  Thanks a lot for any advice.

  Take a look at this page
  http://www.orcalogic.co.UK/ASP/ProdType.asp?ProdType=28694&ft=m&St=3

  but the Kingston modules are really nice

• The series Qosmio G20 does support PC2-5300?

  Hello all,.

  For some time now, I've thought about the possibility of an upgrade of RAM for my Qosmio G20 - 126 and all looking for a more economical way than that which is available via the Toshiba site (~ £100 for a 1 GB RAM Module!) I met articles suggesting that the Qosmio G20-126 is compatible with RAM PC2-5300 (333 MHz). To my knowledge the Qosmio G20-126 comes with 2x512MB PC2-4200 (266 MHz) modules installed, in addition to the direct available from Toshiba RAM upgrades are also PC2-4200. So my question for you, former scholars of the Toshiba support forum is simple; my laptop is REALLY compatible with PC2-5300? and if so there will be problems worthy of consideration (i.e. insufficient power supply etc...)?

  Also, I wonder if there are intrinsic advantages regarding the marked Toshiba RAM upgrades available via the site of Toshiba UK. I found the modules of RAM of the similar (at least as far as I can see) specifications for a third of the price. It would be also interesting to note that the model of module of RAM available here on Toshibas website is (according to Google products alias Froogle) same price when buying from third party suppliers (so it's not simply a question of margins exorbitant of Toshiba, unless of course the sellers are also defined on by the aforementioned increases.)

  Sincere greetings,
  Lee Hyde.
  ([email protected])

  Hello

  The Qosmio G20-126 supports a FSB 533 and, therefore, the PC2-4200 DDR2 266 MHz modules are! (DDR2 266 Mhz-> 533 MHz)
  It is absurd to use the RAM PC2-5300 DDR2 333 MHz due to the FSB. You won't see improvements in speed or performance.

  I wonder why you are surprised that Toshiba recommends the use of own products (memory sticks). I think that each manufacture recommend clean products!
  In addition, it is important to mention that brand memory modules are much faster and the performance is much better than the performance and quality of the nameless memory module.

  Of course, you can use all modules that supports hardware specifications, but the don t wonder about laptop performance and memory problems after the use of modules without a name!

  I use the modules of Kingston and I also recommend using these modules, because quality is really nice

• Satellite L30 - I lost the recovery disk

  Hi guys,.

  I have a Satellite L30 and need to completely reinstall Vista but I lost my recovery CD

  Help, please

  Hello!

  Are you sure it's the recovery disk?
  What is the content of the CD if you find Windows to display the contents of the CD/DVD?

  These messages appear normally if the CD is noisy and so it can t be read properly or in the worst cases the CD/DVD drive is faulty and should be replaced. :(

  Good bye

• Carpet * a DVD/RW on Satellite L30 is unaware of all disks

  I have a Satellite L30 and the dvd drive it recognizes not all discs unless I reboot with the disk in the drive, it is a real pain.
  Do I get the drive replaced or is there a solution?

  The drive recognize recovery DVDs if you try to use it to start upward?
  Can you please test?

• Satellite L30 does not start after the BIOS update

  Hello

  I upgraded my BIOS Satellite L30 and now the laptop will not boot. When I turn on the fan starts and that's it. I think I have updated the book with the bad BIOS... The laptop is only 1 day old... Is it possible to reset the machine to the default BIOS.

  Help, please...

  Hi Scott,.

  Unfortunately there is no easy way for you to go to your BIOS to its previous level. You need to entrust your laptop to a Service approved partner who has the necessary equipment to Flash the BIOS to the previous level.

  Kind regards

• Satellite L30: Connection to a printer via USB Windows XP

  Hi all

  I'm trying to connect my printer (Brother MFC 9070) to my Satellite L30 and it does not work. Can I use the USB interface to connect the printer to the laptop under XP? I've read that USB can be used to connect the printer to Mac OS, but if not, how should I connect the printer as good old parallel interfaces do not exist on the new mobile no more? Who can help?

  Thank you!
  Dieter

  Hello

  Please check this similar topic about connecting printer parallel to the computer via the USB interface.
  http://forums.computers.Toshiba-Europe.com/forums/thread.jspa?threadID=17425

  In this topic, Jeffrey suggested that it s a good idea to test the USB-parallel adapter > before buying because not each adapter will not work.

• Satellite L30: Join to the domain takes 10 min

  We bought a Tosh Satellite L30 and it came with Vista Basic pre-loaded.

  On our domain, we use software only supported up to Windows XP Pro, Windows XP Pro SP2 has been installed (formatted HARD drive)
  I downloaded XP drivers, (I see there is no chipset driver, only one video/audio etc.) and install

  The laptop seems to be OK when I connect locally (name, username/password / local PC), but is joined to the domain when I try to login (name of domain/name username/password), it takes at least 10 minutes to connect.

  Trying to install a relatively small application to a network drive take at about the same time (usually less than a minute.
  I checked the server and it doesn't seem to be rejecting the laptop

  The only clues I receive are in the event Log.
  It comes up with 3 inputs
  IRQARB ACPI BIOS does not contain an IRQ for the device in PCI 4 connector
  IRQARB ACPI BIOS does not contain an IRQ for the device in PCI 2 connector
  Parallel port service could not start

  Is that which is the cause of the problem?
  I have to update the BIOS? IF I do and it goes wrong, what then!

  Any help greatly appreciated
  See you soon
  Neil

  Hello

  > Can I update the BIOS? IF I do and it goes wrong, what then!

  Especially, if the BIOS update fails, the laptop cannot start and assistance of the ASP is required upgrading the BIOS is always risky and should be done with care.

  With regard to the long connection time
  Well, it's not easy to say what causes this waiting long connection

  The search in the Microsoft Knowledge base I have found only this:
  http://support.Microsoft.com/kb/930062

  You may need to install the chipset drivers mainboard that should be found on the page of the Toshiba driver!

• Satellite L30: Cannoto play Saitek x 52 Flight Simulator

  Hello

  Laptops Satellite L30 and cannot play saitek x 52 - no card 3d Accelerator
  Can I spend it?
  Thank you
  Gary

  No, you cannot update the graphics card. The GPU chip is mounted on the motherboard and cannot be deleted.

• Satellite L30 - PCI drivers have an error

  Hello

  I wonder if anyone can help me please.

  I have a satellite L30 and for some reason this morning it is say PCI drivers have an error and I have no internet. I usually connect them via the wireless network. I tried to install the realtek drivers, but it did not, as he says they are all updated.

  Any help on how to solve this problem would be greatly appreciated.

  Tina

  Hello

  go to Device Manager and check if there is a yellow question mark shown there. Also, read this article how to determine, unknown device, peripheral position, or the id of the provider.

  http://forums.computers.Toshiba-Europe.com/forums/Ann.jspa?annID=78

  Perhaps, you try to install the wrong drivers.

• Satellite L30 - battery does not charge

  I have a Satellite L30 and the battery does not seem to charge.

  The battery keeps flickering light with yellow outside. I can use the laptop when I am connected but when if I'm moving to much the battery seems to lose the connection to the AC adapter.

  I don't know if it's the battery or something else.
  Can anyone help?

  Please, remove the battery and use laptop with AC adapter only. I imagine that you will be able to use your laptop properly. When the laptop is ON put the battery back in place and let us know if the battery led will continue to Flash.

  If Yes, I'm pretty sure the battery is dead and you need a new.