Satellite L50 - B - 17 c - regional character keyboard not working properly

Similar Questions

• Satellite P200 accidents + message: graphic card driver does not work properly

  Hello

  hope that this issue has not been covered before, but I've owned a Satellite P200 for 3 years now, and this week, it crashes all the time.

  When it started going down he gave me a few messages in the sense of "your graphics card/driver does not work properly and windows will be arrested to avoid damage.

  It has progressed to the point where now when I turn it on, I have vertical lines running down the screen and the screen flashes on and outside. Within 20 seconds, it restores the BSOD - 'there was a problem and windows will be arrested. Error Page_Fault_In_Non_Paged_Area"then stops.

  I ran a system restore but the problem remains.

  I have a feeling that my graphics card is toast. Is this good? Are there any other options to try? Thanks in advance for any answers.

  Matt

  Hello

  Sounds like the GPU problem.
  But try the graphics card driver update.
  Use the most recent driver for your graphics card.

  In addition, clean the fans of portable computers.
  Dust and debris could prevent the cooling fans to turn with the best speed and this could lead to a higher temperature which would lead to overheating.
  Use a jet of compressed air. I also use it and it helps to get rid of dust and debris.

  If this is not enough, then a problem of graphics chip would be possible.

• Satellite L670 - after Win 8 upgrade WIFI does not work properly

  Afteer upgrade to Win 8, the WiFi of my Satellite L670-128 has stopped working properly.

  The connection only works some time, usually only a few seconds before the connection is lost.
  After a few seconds or minutes the connection is restored, just soon to be lost again.

  Cannot download large files or even to see larger photos on normal web pages. Is there any Win8 driver for Broadcom coming 802.11n network card, or should I throw one 2.5 year old computer in the trash?

  Buy a usb-wlan card is not an option, as wireless mice is already "permanently" reserving one of the three usb ports and wlan card it would be just to the left...

  To my knowledge this L670 series isn t Win 8 taken in charge and this means that there is no special Win 8 drivers for this device, so I put t think you will find an another Win 8 driver for this WLan card.

  But do you really want to throw this laptop in the trash just because the wifi does not work properly running Win 8?
  The device was working properly under Win 7?

  I would recommend running a few Wlan test.
  For example; Disable wireless encryption on your router and Wifi connectivity with the open network do that just for testing purposes, perhaps you will need to change the type of encryption to test.

• keyboard not working properly

  I HAVE a PROBLEM where the letters on the key edge that a number number only of central unit of the screen no letters for example k2 l3 if I hold down the fn key chicken that they wor2

  Hello

  1. What is the brand and model of the keyboard? It's a laptop or a desktop computer?

  2 did you any software or hardware changes to the computer before the show?

  3. who is the antivirus installed on the computer program?

  Method 1:

  Step 1: Safe Mode

  Start your computer in safe mode and check the number.

  To start your computer in safe mode

  http://Windows.Microsoft.com/en-us/Windows7/start-your-computer-in-safe-mode

  Step 2: Clean boot

  If you are not facing the problem in safe mode, and then put your computer in a clean boot and search for the question.

  How to troubleshoot a problem by performing a clean boot in Windows Vista or in Windows 7

  http://support.Microsoft.com/kb/929135

  Note: once you are done with the boot, follow step 7 of article to put your computer to normal startup.

  
   
   
  
  Method 2:
  You can uninstall the drivers from Device Manager and reinstall the same thing again.

  1. click on Start, type Device Manager in the start search box and press enter.

  2 look for the device for which you need to uninstall the driver.

  3 right-click and select Uninstall and follow the on-screen instructions.

  4. restart the computer, if prompted.

  Install the latest driver again and check if that makes things better.

  See the links below for more details on the update of drivers:
  Updated a hardware driver that is not working properly

  http://Windows.Microsoft.com/en-us/Windows7/update-a-driver-for-hardware-that-isn ' t-work correctly

  Update drivers: recommended links

  http://Windows.Microsoft.com/en-us/Windows7/update-drivers-recommended-links

  I hope this helps.

• Satellite L50 - A - 1 6: Synaptics touchpad does not work often

  Hi guys,.

  I have a problem with my touch pad. my laptop is Satellite L50 - A - 1 6.
  Often the key stop working when I use multi touch gestures, and a few seconds later it starts working again.

  But sometimes it stops work and I have to restart the pc.
  I think it's a driver issue, but I have reinstalled the driver, hard reset on my pc, but nothing.
  If use the pc without synaptics drivers, it's all ok, but I can't use the multitouch gestures.

  You have any ideas?

  Sorry for my English

  Thank you bye

  When did you notice this problem of gesture touchpad? Has ID been published since the first day of purchase?

  It would be interesting to know how the touch pad gesture control and multi would work using the original software/driver from Synaptics page:
  http://www.Synaptics.com/en/drivers.php

  The comments appreciated.

• Satellite L50 - A - 16 H - Webcam + microphone does not work

  Hello

  I have a laptop Satellite L50 - A - 16: updating win8.1 64 bit.
  When I got this new laptop everything worked fine, but later it stopped working.
  I sent it to Toshiba for repair and ofcouse they made and works (the MB has been replaced?), but now, I noticed that my webcam and my microphone does not work. If I try to open the camera it says 'connect a camera' or on Skype, he asks the same thing.

  I read in the forums to look at the BIOS to enable, but there is no activation/deactivation button.
  I tried to search for a driver for the Webcam in the Toshiba site but I couldn't find: c
  and the microphone "working normally" but I when I try to call my friends can't hear me.

  I hope someone can help me with this problem, thank you very much :)

  You know what: best thing you can do as the ultimate test is to backup all your data and reinstall the original recovery image. By default the BIOS settings and install recovery image.
  After ding that you will have to re-buy factory and absolutely identical situation after laptop settings.
  Please test and send feedback.

  In my opinion, if the problem persists it could be hardware related issue. Maybe is cam not connected correctly.

• Satellite L50-B-1EE - download the drivers does not work

  I am a user of a NEW Satellite of Toshiba L50-B-1EE and I can't download the drivers. Some admin fix the links because they are broken! EACH of them

  From my experience and I also, use Toshiba laptops I ve never noticed a serious problem with the Toshiba download page, it is so hard to believe there is a general problem with driver download.
  Can you please post a specific link or tell us what version of operating system you are using.

  I want to check download drivers and inform you if there is same problem when I try to download some of them.

• Satellite L50-B-1DZ - wireless network adapter does not work

  So, my network wireless adapter completely stopped working. 2 days ago I couldn't connect to networks wirelessly without problem (although I've disconnected and will need to run the troubleshooter every few hours to reset it...), but yesterday I started to get the message "not connected - no connection is available. In broadcom 802.11n network adapter in Device Manager, the icon has a yellow warning symbol and the error message "this device cannot start. Code 10 ".

  I tried to update the drivers, but it gives just the same error message. I also tried to do a restore of the system since a week ago, but it has not fixed either.

  I found a youtube video that said that the problem can be caused by a software conflict and change value from registry, but that no longer works, and now I'm full of ideas.

  How have you tried to update the driver WLan?
  Have you tried to uninstall the driver first, and then after reboot again to install the new driver downloaded from Toshiba UE driver page?

  Try it!

  You said you reset the system in the past?
  How? Have you used the Toshiba recovery procedure and have you installed already preinstalled system once more?

• After updated recent windows 10 keyboard not work properly in Firefox [and also Chrome but well on board].

  Key press a single key seed to type QWERTY in sequence on each press. The virtual keyboard works very well.

  The keyboard has no problem in other programs [except Chrome]

  Upgrade Windows 10 was last week and everything was fine until today when the Tuesday updates have been installed.

  Have tried to reinstall the keyboard drivers, used a different keyboard and change the settings of the keyboard, but to no avail.

  Obviously something to do with browsers because it only affects Firefox and Chrome [why not explore / Edge?] ... then tried to reset the settings and then reinstall... but again without success.

  Any help would be welcome.

  Found it... took off Zonealarm and all is well again.

  I forgot Zonealarm has also updated that day... don't know why it only affected Firefox and Chrome but not flight attendants.

  ZoneAlarm are behind the curve on Windows 10 and of course always, haven't paid the stable version.

• Satellite L500D PSLK0A Toshiba Recovery Disc Creator does not work properly

  Hello

  I am trying to create a recovery for my Toshiba Satellite L500D PSLK0A-00U009 disc.
  When I run the Recovery Disc Creator he starts to open then it comes up with a box with an exclamation point, he says: 'cannot open target partition. Then the recovery disc creator will open. It seems normal, then when I insert a CD for the process seems to work then it says error and stop and ejects the CD, the error is that the code is: 0E01B5-26-510444 D 9

  I already uninstalled and then program then reinstalled with the help of a download from the Web MyToshiba site and this has not fixed the problem.

  Any suggestions?

  Hello

  Have you tried different discs from different manufacturers?
  How about you, USB flash memory usage? AFAIK, you can create a bootable Recovery USB flash stick too.

• Satellite A300 - 1 5 PSAG4E - multimedia keys are not working properly

  My media keys no longer work correctly. I'm talking abut the top 2 buttons (Mute and Media Player - buttons).

  I just tried to reinstall PPV, but it's the same thing. I have to say that I can use the Mute button, but it will not be this silent icon appears.
  Media player button doesen't work at all.

  I just tried to search on this form for a sollution, but I couldn't find it.
  The rest of the buttons (play/pause, stop, next, previews) are working very well.

  As far as I remember 2 days ago all my multimedia buttons worked perfectly.
  Right now I have not reinstalled OS or any other drivers.
  I use the latest version of the BIOS (downloaded from the toshiba Web site) and Windows 7 Ultimate edition. I have a Toshiba Satellite A300 - 1 5 PSAG4E.

  Can you give me some advice about this pls?

  Post edited by: blunthlox

  Great! Thanks for this feedback!

• Satellite A60-772: SD - R6112 DVD - RW is not working properly

  Hello

  I bought a Satellite A60 772 in September of last year. His Player DVD - RW SD - R6112 worked well upward until March 2005, some time; However, I only used to burn CD - R and CD - RW. Then all about March, I used it maybe twice to burn on DVD - RW using the RecordNow! supplied software.

  There is no problem - so - but shortly after the player refuses to detect even the CD - RW and DVD - RW. I can now use only of the CD - R with it (have not checked with DVD-R). Since then, I have uninstalled and reinstalled several times and even reinstalled once the operating system (e.g. Windows XP Home Edition). I also updated the BIOS about a month ago. Still nothing.

  -Someone - had a similar problem? And if you also have an idea how to solve this problem?

  Hello

  If there is the same situation after the recovery process, I assume that there is some malfunction of the equipment. All that you have done is just. I think the warranty is still valid and the best solution is to contact the Service of your country partner and let check the drive.

  Maybe the reader must be exchanged.

• Satellite A110-906 - Win XP Pro Installation does not work properly

  Dear all, good day!

  I bought a new laptop model Toshiba Satilite A110-906. I want to install windows XP Professional with my CD under license, but I get error after installing copyiny files.
  The error is blue appear with hardware problem.
  PCI.sys error
  When I install Vista, it works fine.
  Any help will be much appreciated!
  Thanks in advance

  Raja

  Don't forget that your original CD of Microsoft Windows contains all the hotfixes and service packs 1 and 2.
  You can use a "nLite" application to create this CD with all updates

• Satellite C855 - 1 GR - keyboard does not work properly

  Hello
  Yesterday I turned my laptop on to find I couldn't hit my password as some of the keys on the keyboard are not working. It's only a few keys, I noticed at the moment F L O R V, NumLock, enter, delete, and the arrow keys do not work either. When I press some keys turns num lock.

  Also when I open upward keys to self-retaining now is turned on, so I can't type anything, he used to come just I had turned off the laptop, but now it turns on if I just too closed.

  Any ideas? Ill use the keyboard of the screen now!

  Sounds like a malfunction of the keyboard.
  Try to connect an external USB keyboard and check if it will work properly.
  In case the USB keyboard would work properly, the internal keyboard needs to be replaced for sure.

• Keyboard does not work properly

  Hello

  I had trouble getting my laptop satellite to initialize. Recovery disks & pressing F keys weren't working so I decided to open the laptop to see if there are any loose connections. To my surprise, the laptop seems to work again once I had the USB keys and put back them in! Unfortunately, before that I did, I opened the keyboard and peeked inside.

  When I booted up and tried to use the keyboard keys half of their work and the other half seem to think that they represent two other keys for example if I type the letter 'E' I get '3' and '-' as a whole. After 5-10 minutes the entire keyboard will become totally unresponsive until I restart again. Of course, I think I've done something here because this problem since I opened the bottom of the keyboard. This could be a hardware failure I have caused or is anyway that this issue can be resolved without replacing anything?

  Thank you very much

  Tom

  Hi Tom

  Theoretically, it might be just a connection lost between the keyboard and the motherboard, but I'm afraid, it can be a serious problem of m.
  Maybe you have damaged the connector of the keyboard cable or something similar, and not the keyboard does not work properly.

  I think the keyboard needs to be replaced to check if only this part is affected