Satellite L735-10V - unable to connect to the internet using ethernet
I have problems connecting to the network via ethernet.
connect the ethernet cable and the laptop connects to the net, but after a few seconds it disconnects.
I don't know what the problem is.
I tried to disable TCP/IPv6 and it doesn't work.
Please can someone help me here.
It's just killed me.
It is not easy to say what may be the problem.
Have you noticed the same thing using WIFI?
I had a very big problem with my card.
I can t connect to the internet.
I searched the forum but without any determination :(
I did everything. I have checked ipconfig nothing, check the mode safe mode with local network nothing.
Someone said too
"(1) once the Ethernet is connected, power of the DSL Modem. Cycle." ("Some Modem picks up the MAC ADDRESS of the network card on where it was previously connected and restarting it redétecte this new")
How to disable the modem?
And another question: can someone tell me what works of LAN drivers in Sat L300D-10U on XP?
I put t even know that :(
The Satellite L300D-10U belongs to the series of PSLC0E and it supports the Realtek LAN card.
LAN driver can be found on the page of Realtek.
You ask how to disable the modem? I think you mean how to reset modem DSL
Well, usually your modem should support an ON / OFF button simply turn it off and then turn it back on.
If you are unable to access the internet then you should first check if your modem is properly configured and that the right data ISP (internet service provider) was used.
Sorry, but that's all I can say right now I think you should just check your modem settings, make sure that the NIC is properly recognized and connect the model of the laptop using a LAN cable.
All that s
I have a Mac mini as I try to connect via Ethernet cable to a modem Comcast Arris TG862. I was connected via Wifi without problem (with the exception of the slower speeds). I know that the Ethernet ports on the back of the modem seem to work, since I can listen to my TV, etc. In settings > network Ethernet shows as green and connected and gives me an IP address, but as soon as I turn off Wifi no web page doesn't load.
What I am doing wrong? I thought that it would just connect. On the Ethernet port lights, which I think means data transfer. Otherwise, I need to tell Firefox or Chrome to turn to the Ethernet connection?
The default configuration is to have the WiFi over Ethernet in the Service order.
The order must be set such that the (desired) primary service is at the top of the list and the backup service is below.
If you look at the order of service when it is connected to the network, the higher is the provision of access Internet one (or at least, he thinks Yes).
To set the order, click on the menu of the machine and choose the order of Service. Move Ethernet to the top of the list. This should make it primary unless he loses the connection.
However, it must move up Ethernet and provide a connection when you have turned off the WiFi. When you disable WiFi on the Mac, the Ethernet connection move to the top of the list and show a green connection?
On my laptop, Satellite P50-A14-G, I can't connect to internet via wired connections.
WiFi does not work properly, but not the Ethernet card. It has not any light when I connect the wire, and I realized that on the Panel of the map icon does not appear.
My OS is Windows 8.1 update 1.
Have you checked status LAN card in Device Manager?
Please make sure you that network card installed, listed and active properly.
Unable to connect to the internet via ethernet.
You have published a statement... is not an issue. You have a question?
Do you mean that you try to use Ethernet for Internet connection? OR are you asking how to connect to Internet if Ethernet is not possible?
Unable to connect to the internet using Firefox or IE. I can ping other pc on my network home and can ping websites such as google.com. Other PCs on the home network connect without problems. Nothing has changed in the network or the configuration of IE/Firefox. The only change is that I have installed the update to Vista SP1
Stack TCP/IP Winsock settings in Vista has probably been corrupted.
Journal to this page and scroll down, there are instructions for Vista.
Jack, MVP-Networking. EZLAN.NET
Hi, a newbie on this forum so here goes. I got the "fix Windows 7" virus on my laptop because my virus protection that flows. I downloaded AVG which solved some problems, but still not back to the original values. I reloaded Windows 7, but of course I lost all the software preloaded Toshiba & now cannot connect to the internet (laptop computer purchased through the catch of the day).
What I need to download software/drivers toshiba etc. to address this problem. Thanks for any input.
> now unable to connect to the internet
Can you write more than one sentence about your problem?
Does anyone know how you connect to the Internet via modem, LAN or WLAN? More exactly, what happens if you want to connect, you an error message or probably t can find the router?
Sorry, but without this information there s no end of discussion
original title: wireless connection problem
My son can connect to the internet with his phone and the ps3, but no more with his laptopHe was able to connect before on laptop. No matter what he tries, he can't re - connect his laptop to the internet... It has windows 7Thank you
If you are still unable to connect to the internet with a wireless and wired connection, make sure first that the wireless card is turned on. On most laptops, there is a button in the front of the laptop. If you are still unable to connect to the internet, follow the steps described in this document.
I have a new router, but can't seem to connect to the internet without Ethernet cable. Trouble Shooter diagnostic tells me that "Windows cannot communicate with the device or resource (primary DNS server). I am at a total loss!
Not sure, but this post can help (as seems to be the same or a related problem) - http://answers.microsoft.com/en-us/windows/forum/windows_7-networking/cant-communicate-with-primary-dns-server/9043f785-2f4e-4cc1-adf5-6ba5ca413749?page=1&tm=1388597381623
Good reading and see if it helps.
Original title: Auntie Photon
I use Auntie Photon on windows platform 8, and it shows the device has been disconnected or is not available when clicking on the button connect. For this reason, I am not able to use internet on my Laptop.I also in contact with the customer service and they told me to take the laptop to any engineer to solve this problem.
Thanks for posting on Microsoft Community. I understand that you are not able to connect to the Internet using the dongle Auntie Photon. Let us work together as a team and try to get this fixed number.
Please help me with the following information related to this issue:
- You have installed the required software on your computer which came with Auntie Photon?
- Do you see an error or exclamation point in Device Manager when you connect Auntie Photon dongle? See the steps to check:
- Press Windows Key + X.
- Select Device Manager.
- Check if there is no error or exclamation point under Auntie Photon.
This problem can occur if device drivers are not get detected or due to missing/corrupt device drivers.
Please follow the steps mentioned below:
Method 1: Run the hardware troubleshooter
The convenience store is an automated tool that checks the hardware attached to the computer for known problems and provides details on how to correct them. Follow these steps to run the troubleshooter.
- Press Windows key + W on the keyboard.
- Type the Troubleshooting in the search bar and press Enter.
- In the Troubleshooting window, click show all in the left pane.
- Click hardware and devices.
- Click right on material and devices and and select run as administrator.
- Click Next and follow the on-screen instructions to complete the process troubleshooting.
If the troubleshooter could not find and fix the problem, I would suggest trying the following method and check.
Note: Make sure that the Auntie Photon dongle is plugged.
Step 1: You can try to uninstall and reinstall the drivers of Auntie Photon and check. Follow these steps:
- Press Windows key + X on the screen.
- Select Device Manager.
- Expand the network adapter and right click on driver and select Uninstall.
- Restart the computer.
- Windows will automatically load the drivers.
You can also try to launch the Windows updates and install all the updates that are available including the driver in option and the updates of the firmware.
You can also get in touch with Auntie Support and check the updates to driver for Windows 8.
Please answer us on the State of the question to help you further.
I recently got a laptop (Windows XP) that has wireless when I try to connect to the internet using a lan cable plug on my netbook (win 7 starter) that has wireless it gives me limited connectivity and no internet
Consult the following Microsoft articles and make sure that all settings are correct.
How to configure Internet connection sharing in Windows XP
Troubleshooting Internet connection sharing in Windows XP
I have a Satellite P500-11F and I can't connect to the Internet without the cable modem. I don't know why. All software is updated, but the connection is cut off very often.
My computer can reach the home network and without wire is ok, but I can't open any page on the Web: it tells me that
Does anyone have this kind of problem with a Satellite P500?
Thanks a lot for helping me
I assume you mean the WIFI connection, right?
If so, you should check if the WLAN driver installed proplerly or you can see yellow exclamation in Device Manager?
I put t know what OS you have, but for most versions of Windows, you can download more recent WLAN driver on the official website of Toshiba. What (s) worth a try:
Check this box!
Hello guys! I recently bought a Toshiba laptop - Satellite L300-1DN and I can't connect to the internet wirelessly or by cable.
I tried to turn on the wireless button and my laptop recognized my network without wire from my house, but he just not able to connect. Then I tried to connect the cable, but my laptop itself connected to an 'unidentified network' and the internet still does not not :(
The internet works perfectly fine for my old laptop and my other roommates. So I guess that is not a problem with my router itself.
I don't know computers very well, so I'd really appreciate your professional opinion!
Thank you very much!
> One last thing, I tried to connect to an unsecured wireless network and it worked!
It looks like a problem with your router. Check this box and look on the site of the factory for an updated firmware.
Make sure the laptop and the router using the same standard WiFi (for example 802.11 g).
Disable all the functions of economy of the WLAN card in Device Manager.
Last but not least follow Luke posted.
Mine is an edition of Satellite L20.
I recently installed XP Professional Service Pack 3. I connect to internet using my USB cable with my Sony Ericsson C702 (use the phone as a modem).
Since there is no bluetooth built into my laptop.
So, I bought a Mecer bluetooth dongle. I installed the bluetooth software. Can I transfer data between my laptop and my mobile phone via bluetooth.
Now the problem is I can not connect to the internet via bluetooth. I opened my bluetooth IVT software and paired my laptop and mobile computer. Then I opened my Sony ericsson suit and looked for my mobile finds, my mobile and still once he pairs with my cell phone and when he tries to connect with my mobile phone its shows "device cannot be detected, try again." I tried to reconnect, not matching and pairing it several times, but no use.
I also found one thing, just after it displays "Device cannot be detected," a pop-up message "SEPCSuite.exe has encountered a problem and closes the window with options."
1) send to microsoft
Including 2) send.
What can we do to fix this problem?
See the website of your provider of Bluetooth software to help. This forum is for Toshiba Software only.
I have Toshiba Satellite A300 PSAG8E (product for Tuerkiye) laptop.
My vista ultimate operating system.
I can't connect to the internet.
I have the new format recently.
What should I?
If you use the WiFi network you should check if the wireless network adapter is enabled!
You can activate using the FN + F8 key combination and, in addition, you should switch WLan antenna on IT (the WLan led should be flashing).
Finally, configure the settings (SSID right, encryption, etc.) and connect to the router.
All that s.
Maybe you are looking for
Hello My Macpro 2.1 suddenly cannot start. When turned on, it shows the Apple logo, and whirlly movement, then the screen becomes white lost the signal from the graphics card. This could be the problem with the graphics card? Or the hard drive or CMO
Hello. HP TouchSmart IQ500. System #: FK936AA-ABG Serial No.: 3CR - B32 (hidden for security) Model #: IQ518a What is the position of HP on this machine and Win8? I have one of these machines running Win8 64-bit, but it often gives problems. Problems
When I try to open attachments photo (jpeg), it defaults to the Windows Photo Viewer, says loading but does nothing more immediately to freeze my HP computer. I have then close and restart my computer. Efforts to re - open the attachment has the same
I am trying to create a shared variable with a data type of a 2d double table. I created a custom control that contains a table with a numeric type for this 2d. Manager of distributed system v12 I select 'add a variable', then select 'of the custom c
Original title; No driver :( I'm on win xp family on dell optiplex 760 instead of vista I have struggled with vista but it does not have all the drivers manually, I found the driver ethernet, but other don't download saying I don't meet the minimum r