Satellite Pro A10 (PSA15E) - no card after replacing HARD drive wireless network

Hello

just a spare hard drive was fitted by an expert, all drivers and update of the BIOS installed on the site of Toshiba, but my wireless network card does not work.
When I try to connect via a router it says that the card is disconnected?

I went into Device Manager and of what follows is listed under devices Details ld:
PCI\VEN_10B7 & DEV_6001 & SUBSYS_600110B7 & REV_01\5 & 36 D 029F7 & 0058F0

Can someone please tell me which card is installed and where / how do get me to it.
I don't understand how it can be unplugged?

I use a 3com officeconnect wireless 11g PC Card which works fine until the hard drive failed.

Help, please... I am due to go to the hospital Monday and I wish I could take it with me.

Thank you

Advertisement

Hello

Sorry if I write this too late. :(

He's old enough for laptop and I don't know with certainty what is the card inside, but all notebooks with wireless network inside card have a small stick of Wi - Fi at the bottom with number of WLAN card. Using this number in Google, you can identify the card.

Anyway, there is not a lot of possibilities because on the Toshiba support page there are two WLAN drivers listed for your model of laptop. Try to install both of them. One of them must be good.

Good luck!

Tags: Toshiba

Similar Questions

  • Satellite Pro A10 PSA15E: NO sound after installing Win XP

    Hello world

    I had to reinstall Win XP Home - which went well, however - now there is no sound and it says no audio device is installed. I tried to install the audio drivers on the Toshiba CD but they go as far as unpacking but then say "not installed" and Setup stops.

    I went to www. support. Toshiba.com and follow the menu to identify which drivers to download? but there are several possibilities for the
    Model A - 10 and I am not sure I have listed below models have.
    A10-S100, A10-S1001, A10-S127, A10-S128, A10-S129, A10-S1291, A10-S167, A10-S169, A10-S1691, A10 S177, A10-S178.

    I would be grateful for your advice.

    Thank you

    Andrew

    @mrafowler

    > I went to www. support. Toshiba.com and followed the menu in order to identify which drivers to download, but there are several possibilities for model A-10

    What you mean? On the European driver Toshiba page, you will find only one series Satellite Pro A10.
    Once again; Do you have a computer or a Sat Pro A10 laptop satellite A10?

    There is a driver of sound for a portable Pro A10. This is a version of audio driver Analog Devices 5.12.01.3542.
    If you are using XP SP2 please check the information provided on the page of the driver Tosh

  • Satellite L300 - cannot install Microsoft updates after replacing HARD drive

    I am repairing a Satellite L300, which had a dead HARD drive. I replaced death 160 GB of HDD with a 500 GB WD, then used the recovery disks to install Windows Vista SP1 at the exit of the State of the box.

    Now, Windows update does not work, won't install autonomous not of Vista SP2 I downloaded, MS Security Essentials moved there also.
    Then I borrowed a 160 GB of work and went through the same process and everything works fine.

    To make it work with a 160 GB HARD drive, but not a 500 GB HARD drive. Why?

    > ... Standalone Vista SP2 I downloaded will not be installed
    Usually after installing recovery image, you have just to connect laptop to internet and after a short period of time, you will get messages about available Windows updates. Just install the offered updates process automatic Waterer and install important updates only.

    Let the system to install all the updates and don t force the installation of some own downloaded stuff.
    Last month I've updated HARD drive (320 GB I think) and installed Win7 on friends L300 and I didn't noticed any problem here.

  • Satellite A135: Vista will not start after replacing HARD drive using the recovery disk

    Toshiba Satellite A135-s7403 HARD drive failed, I have replaced the 80 GB with a WD Scorpio blue 250 GB hitachi. When I try to restore with recovery disk came with the laptop, it passes through two discs 1 and 2 and starts with the start-up of windows for the first time and then runs to the greenish with the spinner blue screen please wait... thne black screens for a second or 2 and then back to spinner, please wait and then it appears the box "installation of windows could not configure windows to run on hardware. This computer' only option is to click OK.

    Where to click ok, you get an another msg that says "windows could not complete the installation, install reinstall windows. I tried like 50 times now. Startup Repair indicates the root = failure cause while the installation program is underway. I know that my drive are good, as I adjusted used then about a month when I upgraded the memory because the original memory 512 MB was not enough o well running vista.

    Hello
    To be honest I n don't know what the problem is there but can you get the original installation disc of Microsoft and try to install the OS, just to see if the OS installation will complete successfully?

  • Satellite L300D-242 - cannot install Vista after replacing HARD drive

    Hi wonder if anyone can help mei have a L300D_242 toshiba satellite that broke down and I bought a new hard drive for it because the original was not good.

    I tried to install a Vista premium 32 bit on the new hard drive, but it does not install until the 4th stage and then stops or hangs until he finishes.

    Does anyone know how to install a new hard drive and windows on this laptop?

    Thank you

    Hello

    What Vista did you use? TOSHIBA recovery disk or a disk of Microsoft Vista?
    Format you the new HARD disk before starting the installation of Vista?

    It is possible that the new HARD drive is not good and therefore the system can not be installed properly
    You can check the drive HARD using a tool called Drive Fitness Test download this as its a freeware program and test your HARD drive.

  • A satellite crashes during installation of XP after replacing HARD drive

    Hello

    I'm trying to install a new hard drive, I boot from a CD of XP.
    Everything goes well until the moment when the system reads "Windows starts now" and then my laptop crashes.

    What I am doing wrong?

    Hello

    First question; What model of laptop do you have exactly?
    Second question; New HARD drive is recognized in the BIOS?

    If you have a series of laptop latest then you should check if the SATA in the BIOS mode was changed to compatible.
    You can install the operating system without previous SATA driver installation.

  • Satellite C670D-109 - installation of recovery after replacing HARD drive image

    Hello

    I have a problem to restore my laptop.
    My hard drive is not working, I do not have the recovery disks, but I managed to save the HDD Recovery folder in a partition of DATA.

    Once installed the new hard drive, it is possible to recover my original without the cd, but with a pen drive usb installation?

    > Once installed the new hard drive, it is possible to recover my original without the cd, but with a pen drive usb installation?
    Unfortunately, you will not be able to start the recovery image installation. The data saved on unusable USB on this path. It must be the startup created by Toshiba recovery disc creator device
    You can only install recovery image using the recovery disk.

    If you n t have it you can order a new one.

  • Satellite Pro A10 PSA15E: Encryption WPA WLan is missing

    I reinstall a Satellite Pro A10 PSA15E-018PC-OF.
    The problem I have is to get the WPA available for the wireless network card.
    Do I did wrong.
    Reinstallation of XP SP2 full.
    Installed Toshiba drivers. I used the drivers Intel Pro set.

    There is nothing wrong! WiFi encryption type depends on the WLan card specifications and not the driver WLan.

    If the equipment (WLan card) does not support WPA encryption, then you will be not able to use it! The update of the driver won't help you!

    You need to replace the WLan card with another that supports WPA or you are going to buy additional WLan USB key that supports this encryption too.

  • Which module WLan can I use in Satellite Pro A10 PSA15E

    Hello.

    I have a Toshiba Satellite Pro A10 PSA15E-09VYL-en and want to add a module internal wireless - any ideas I need one and where?

    Thanks in advance,

    Simon

    Hello

    I discovered that this WLan module can run on your laptop Satellite Pro A10;
    LAN (802 11b Agere) PA3212U-4MPC or PA3273U-2MPC card wireless (802. 11a / b).

    The upgrade of WLan is not very sensitive. There are two antenna cables which must be connected to the wireless network card. The white cable be connected to the hand and the black cable to the auxiliary voltage

    Welcome mate

  • Satellite Pro A10 PSA15e - no more wireless Chip

    Hi all, I'm new to the forum so please be gentle with me!

    I was recently given a Toshiba Satellite Pro A10 (PSA15e-01PJY-EN), unfortunately I did not to any recovery disks! (if someone could send me a copy of the diskette of recovery for this machine, I'd be over the Moon!)

    However, I recently tried to install windows xp home with the disc and used the key on the bottom of the laptop.
    Installation ran ok, but all of a sudden, he cannot see the port intel LAN.

    I ran the likes of Belarc, Device Manager and AIDA... all of a sudden since formatting, nothing can detect the WiFi chip, is this a problem with the fact that I do not use the recovery discs?

    I've not disabled in the BIOS, nor can I actually see it in the BIOS.

    Someone at - it suggestions?

    Thank you very much

    J

    When you install the operating system using Microsoft facilities CD you naked of OS and you must install drivers for each component material, including the wireless network card.

    All drivers and Toshiba tools that you can download at Toshiba support and download page.
    I think that you will also find the document entitled instructions for Installations. You'll find order exact facilities. Following this command, you can perfectly configure and install everything on your laptop.

    Please visit http://eu.computers.toshiba-europe.com
    All that you can find in the archives.

    If you need help more on this topic please let us know.

  • Satellite Pro 2100: How do I reinstall the OS after replacing HARD drive

    I have a Toshiba SP2100 and I want to replace the hard drive, but I don't have any recovery CD
    So, how can I put the o/s back on?

    Try to connect the external HARD drive to the computer via the USB port and try to copy all content from the internal HARD disk external HARD drive. Then you could try to insert the external HARD drive in the laptop.
    But I've never tried this procedure and don t know if it will work.

    But usually after replacing HARD drive you should boot from the Boot CD as recovery CD or the original CD of Microsoft Windows.
    After the installation of clean Windows OS, you can visit the Toshiba drivers and you can download and install the drivers of Toshiba and utilities.

  • Satellite 1410 714 extremely slow after replacing HARD drive

    Hello

    I have a Satellite 1410-714 which has had a hard drive failure. I replaced the drive, but now the computer is extremely slow. Windows has been reinstalled, it was really slow too much and now it takes minutes for windows to start.

    I suspect that something might have broken on the motherboard and the hard disk. I checked mobo replacement parts, but have not found anything for-714, so a 1410 mobo compatible? This model has a processor celeron 1.8.

    Thanks for help.

    Hannu

    Hello

    I can t think the motherboard is broken after replacing HARD drive.
    I suggest updating the BIOS first. Maybe your old BIOS have a few problems with the most recent HARD drive.
    Please check site driver Toshiba for the latest version of BIOS.

    Have you used any anties Virus applications?

  • HP Pavilion 17: mouse pad does not work after replacing hard drive

    Hello

    After replacing hard drive and installing windows 8.1, I can't use my mouse pad.

    I installed the Synaptics driver but it didn't help.

    How can I check that mousepad device is not damaged when replacing the hard drive and which also can I try to fix the mouse pad?

    USB mouse works fine.

    See you soon

    The only way to be sure is to open it up and see if the touchpad cable was disconnected during the upgrade of the hard drive. That's my bet. Easy to forget when you're winding. You don't provide complete model number, but many of the recent models Pavilion 17 require removal of the cover together to get hard disk that requires disconnection of the touchpad cable.

  • After replacing hard drive and reinstall Windows, DVD Player cannot play a Blu - ray disc.

    Original title: dvd player

    recently replaced HDD and reintegrated windows 7.  Now my dvd player cannot play a bluray disc.  Any ideas how to solve this problem?

    Duplicate the content of the thread:

    After replacing hard drive and reinstall Windows, DVD Player cannot play a Blu - ray disc

    My hard drive recently broken and we replaced and reinstalled windows7.  Now I'm watching a Bluray DVD and the drive will not read it.  I tried the fix auto and that said they detected a problem but can not fix this.  Any ideas?

    Hello

    You can check these links and try...

    http://support.Microsoft.com/mats/cd_dvd_drive_problems/en-us

    http://support.Microsoft.com/kb/982116

  • Satellite U840 - how do I reinstall Win 7 after replacing HARD drive

    I had a HARD drive error.

    So I formatted the hard drive (after trying for months to get the process to finally finish that)
    Now, I a U840 Satellite with a clean HARD drive and do not have the installation for Windows 7 discs.

    I searched the net and found nothing of use!
    Help, please

    see you soon
    Nick

    Hello

    You need to create the own recovery in the past disc!
    This recovery disk allows you to install the Toshiba image after the HARD drive is dead or has been replaced.

    In case you have not created this disk, it is possible to order this support:
    http://backupmedia.Toshiba.EU/landing.aspx

Maybe you are looking for