Satellite Pro L500 keyboard does not

Similar Questions

• Satellite Pro C850 keyboard does not work properly and opens several programs

  My satellite pro C850 1HE keyboard intermittently stops working correctly, and begins to open programs, for example, by pressing F will open the file search, C open computer this kind of thing

  is there a permanent solution to this problem?

  This is not something to do with installed programs is not something to do with the browser settings.
  restarting the computer works in a short time, but that is a long time, it's really annoying because I use this for work and study!

  > is there a permanent solution to this problem?

  The question is what causes this problem? Is it related hardware or software related issue?

  Why n t connect a USB keyboard just to check if the same would happen?

  In case the USB keyboard would work fine, I guess that the internal keyboard failures and the solution would be a simple replacement of the defective part.

• Satellite Pro 6100 keyboard does not work properly after repairs

  Hello

  My 6100 Pro Sam just being away from usual mother board and power Board replacement with Toshiba, but now I have a strange keyboard problem.

  When I turn it on, all the keys are working. After a few minutes, '3' is not working, then 'r' fails, then '5', ' 7 ', ' 8',' 9 ', ' 0' to stop working. At this point, I can feel something very hot under the middle of the keyboard. A reboot and no keys work. Another reboot with the internal keyboard and an external keyboard to the PS2 is still defective (some keys work, others do not), but the outer one works properly.

  Now, if the pc has not obtained if hot as the middle of the internal keyboard, then, I would conclude that the keyboard was defective, but for his failure, slowly and sequentially like this and it fails at the same way every day (since Toshiba rebuild it!).

  Perhaps, internal keyboard controller overheating?
  Anyone know what this could be? :-(

  See you soon,.
  Homer

  Right under the keyboard of your pro 6100 is the VGA graphics controller (the keyboard cable plugs on the same map). It is normal that this part become hot during use.

  It is strange that your problem appears after a while and not immediately.

  It could be just a bad relocation of the keyboard cable (it's a thin layer as a movie negative photo) which easily appears there, but... it may be something more serious, too. (Especially since you had done upgrade where the material had to be changed)

  I consult the service centre once more and ask for instructions how to deal with this. Do not ignore it (using an external keyboard instead of internal dysfunction) because he could end up in something more serious soon...

  Concerning

  chain

  P.S. Please keep us updated on your efforts

• Satellite Pro A - keyboard does not work properly

  Hello

  I'm not able to use my arrow, also when I press SHIFT: I get a capital H and N: HN

  Very annoying, someone who might be able to help me.

  Thank you

  Rob

  Before you use this option, you must activate it with FN + F10 or F11. I put t remember which of these two key combinations is good. Please test.

  Generally, you will find instructions on this subject in s operating manuals.

• Satellite L500 - keyboard does not work

  Hello

  I have Vista L500 with a dead keyboard. This machine has not been abandoned or anything it is spilled on it. I plugged USB keyboard external that works. The laptop keyboard does not work. I flashed the BIOS, update drivers, held shift for 10 sec (read on another forum), reset computer, check the updates of Windows Vista and ran 3 checks of Virus.
  Everything is perfect, just no keyboard?

  What should I check? What is a motherboard problem?

  Thanks for any help :)

  Hello

  Can enter you the BIOS (F2 key) with internal keyboard?
  If it isn't the internal keyboard seems to be defective and must be replaced

  I don t think you can do more. I mean you've tried everything what is possible and if an external keyboard works the installation of the OS should be ok.

  The keyboard can be ordered and replaced from an authorized service provider. Do you know how to contact the guys?

• Satellite M40X-189 - keyboard does not work - long beep consisten

  Hello world

  Thanks in advance for any help provided.
  I have a laptop Toshiba Satellite M40X-189.

  The problem is that the keyboard does not work, and it beeps long consistent. I have to press the keyboard for him to stop, when I get loaded in Windows, the touchpad is ok but I can't type anything with the keyboard. I checked the connection on the keyboard and it went ok.

  Is it possible that the computer tells me that the keyboard is down and replacing it will fix both problems?

  I don't want to spend money on a new keyboard for the same thing happen after installation.

  Anyone who can help me with this problem?

  Thanks again for any help provided.

  In my opinion it looks like a defective keyboard, and I think that a new keyboard to solve this problem.
  External keyboard works on your laptop?

  So in your case I would swap the keyboard.
  In addition, you can contact the nearest ASP and ask for help. Technicians can swap the keyboard for you and order a new one.

  Good luck!

• Satellite A665-S6086 - keyboard does not work after the outpouring of fluid

  I have a Toshiba Satellite A665-S6086 laptop. A couple of months, I spilled the zeroth power and he went on the keyboard. I'm sure that some went through it as well. The computer turns now and I can use an external mouse and external keyboard. Nothing on my keyboard does not work as well as the mouse. I can't go on the internet due to not being able to use the F8 key so.

  The only key/button that works is the power button. The dvd/cd drive works.
  Help, please.

  The external key board I use has no FN key. a f1 to f12, but when I hit the button on the external key board f8 nothing. Please help me get internet light somehow.

  Thank you

  And what kind of help do you expect now? What can we do?
  Why you n t fix it and be happy with the new keyboard?
  How long you want to use your laptop in such a State?

  Contact Toshiba service, let them swap keyboard and clean your laptop. OK it's a bit chilly but you'll well workbook again.

• Satellite A210 - 17l - keyboard does not respond

  Hello

  I have a problem that is driving me crazy.
  When I press F2 or F12 to switch on the keyboard behaves as it should.
  However if trying to load a Boot CD or Usb car via the options F12, the device is recognized
  but click on any other key, the cursor just sits there intermittently at me and the keyboard does not respond.
  What makes strange, is that an external keyboard is recognized but the mirrors one internal.
  I have the latest version of the bios update.

  F2 in the bios - ok keyboard.
  Start in win7 - keyboard ok.
  Insert bootable back disk via F12 option-charges but no keyboard reagent.
  I think a partial corrupt bios
  Someone has ideas about problem or even a solution.

  Posted by mr.pound
  

  but click on any other key, the cursor just sits there intermittently at me and the keyboard does not respond.

  And what should happen on this stage?

  For me, this looks like a problem with your startup disk.
  I installed OS using different disks of Microsoft or USB recovery media and all you have to do is click on most of the time on the button NEXT.

  If the keyboard works in BIOS and Windows, I see no problem with the keyboard there.

• Satellite L450D - 11G - keyboard does not work

  Yesterday my laptop had bad start up and when he did, saying driver error.

  Today I tried it and it turns on but the keyboard does not work.
  Any suggestions?

  >... it says driver error.
  Just or is driver error may be written which driver exactly?
  Start your laptop in SafeMode (F8 at startup) and check if the same keyboard problem occurs again.

  Be so kind and post comments.

• Satellite 200-170-keyboard does not work and the keyboard stops working

  My U200-170 2.5 years, I have the following problem:

  When after the start of the key is opperated the keyboard does not work and the keyboard no longer works (works until the button is pressed) connect a keyboard and a usb mouse. does not work because that device unknown. After Internet received external usb driver work ok. someone at - it an idea to solve this problem.

  Thank you

  AJAN

  Sounds like keyboard problem.
  The operating system uses the pilot to clean keyboard and generally it s not necessary to reinstall the special keyboard driver.
  But one thing is really strange; the yellow exclamation mark in Device Manager

  Eventually it s only a problem of software in such a case, a system restore can be useful...

  Have you checked if the keyboard works in the BIOS?
  Do this!

  If the keyboard does not work in the BIOS, then you will need to replace the internal keyboard with the new.

• Satellite Pro C660D - screen does not turn

  I just got my Satellite Pro C660D back from repair (for a faulty fan), but the screen does not light when I start the laptop.

  She lights up on the front (and I can rotate the block number power sp that the keyboard works).
  Any ideas?

  I agree, I mean the laptop should work just fine after it has been fixed by ASP so I think that something was not right here and the technician must check this!

• Satellite Pro L20 keyboard problems not fixed by the update of the BIOS

  Hello

  When I type in MS Word or another application, certain characters are not displayed. This problem is known.
  I followed the recommendation of the TOSHIBA BIOS V1.30 for PSL25E update. Unfortunatey, it does not help.
  I would be gateful to any Advisor.

  Thank you
  olbur

  Hi Olbur

  I didn't find any official document on this subject, as you say, known issue. Can you please send a link?

  I have the Satellite L20 and there is not much difference for Satellite Pro L20 and I have no such problems, but I'm interesting about this. The L20 keyboard is not the best one, but all the characters are not displayed correctly. Maybe you type fast. ;)

• Satellite Pro M70-113 does not start up - it hangs at the logo screen

  Hello

  I have a toshiba satellite pro m70-113.

  Sometimes when my laptop turns off mode standby automatically, due to inactivity and then if I press a key on the keyboard to wake up nothing happens and I have no other choice but to it stop completely by pressing the button for 5 seconds.
  But when I restart it works well, that is to say, it starts very well.

  But today, when it is in a similar situation, I restarted the laptop, the screen move after the logo screen toshiba. I have the power on several times, but without success. It crashes just on screen toshiba logo.

  After a few restart I pressed ESC while restarting and the toshiba logo changed to the texts POST bios screen.
  And I found that the text will not go forward after having reached:
  Find disk 0:
  Maybe default feel HDD initialization...
  The captured image is here:
  http://img144.imageshack.us/img144/9986/image007sp2.jpg

  Note: this is a capture when, I don't know how the system has just begun works very well and can be seen that the HARD drive is detected normally this time. While the earlier version, it will not proceed after having reached "Found Disk 0:

  So, the problem is that at the time of the problem, the hard drive was not read / initialized or something like that.

  And I remember that when I tried to reboot my laptop and it did not work. It was running on battery and when I switched power supply that worked.

  So it is a problem that has been fixed in a bet to update BIOS, but for another laptop (see laufendspass post) his link on this forum is here:
  http://forums.computers.Toshiba-Europe.com/forums/thread.jspa?threadID=13143&MessageID=48143

  And my current bios version is 1.1 and an update is available for v1.30... (But I have not yet updated)

  Another problem I had met some time was same this post mentions to be corrected during the update of the bios.
  i.e. "corrected: a computer that is turned on to State power and running on battery power, may crash if the user is connected to the AC adapter while it is start.»

  So, for this, all mean that these problems can be solved by an update of the bios v1.30 which is available for my Satellite m70-113?

  Please answer.

  Hi Ashish,

  The fact that the initial POST process cannot access your hard disk suggests you that there is a possible problem with the drive, maybe he is not in place correctly when power is applied to it. The contents of the disc should be OK, then I suggest you take a good backup of your system (or at least your personal data) If you manage to get your notebook to boot successfully.

  I do not think that an update of the BIOS will affect any on that since the problem does not seem to have a certain 'trigger', and if the BIOS cannot access the hard disk then no matter what version of BIOS you are using.

  Kind regards

• "SHIFT" on the Satellite Pro C660 key does not work

  G ' Day,.

  I have a little problem with my laptop Toshiba Satellite Pro C660.
  Unfortunately I had to remove the keyboard and thus dislodged the
  fragile plug to connect to the computer.

  The 'Shift' key refused to work since. All other keys work as usual.
  The only problem is the 'Shift' button does not.
  I tried to gently move the plug but made no difference so now have to
  Use a USB keyboard.

  Can you please help with suggestions for this problem?
  Thank you for your time.

  See you soon,.
  Sunrap.

  I really put t know what you think when you know that there is no connection for each unique key, but for the entire keyboard.

  To be honest I ve changed keyboard several times but never noticed this problem.
  Are the two SHIFT keys off function?

• Satellite Pro L50 - A does not illuminate

  Hello

  I took a few steps on this forum but no luck so far...

  My L50 - A Satellite Pro was working fine up until yesterday, but today, only it just won't turn on. A small orange led light appears when I connect to the power cable...

  That's what I've done so far-

  1 power cable removed
  2. using a needle, pressed force shutdown (stop) at the bottom for 10-12 seconds
  3. then I pressed the start/power button on the front for 60 to 70 seconds
  4. I have connected the feeder and then to new press button start / stop at the front for 60 to 70 seconds

  Yet the laptop does not start!

  any suggestions?

  Thank you

  Hmmmmmm... It is not easy to say what the problem is here.
  Have you used your computer laptop usual ot, you might update something?
  In general, there are steps that you did which could be responsible for your problem?