Satellite Pro L650-1PK: 2 unknown PCI devices

Similar Questions

• Satellite Pro L650 - network driver Pb after re - install Win7

  Good afternoon.

  A laptop computer was infected with a virus, so I re - install Win 7.
  My problem is that all network devices don't have 'no driver for this device.
  I install the drivers I download, but the problem is the same.
  When I view the list of devices, the 3 devices 'unmanned' are:
  -Network controller
  -Ethernet controller
  -Controller PCI (for simplified communications)

  When I view hidden devices, I see 8 network cards "Miniport".

  Please, help me...
  Thank you.

  Best option for you is to reinstall Windows 7 using original recovery image (operating system) you got with your laptop. This recovery image contains all the necessary drivers for all hardware components.

  You have installed the Win7 clean version, right?
  What Satellite Pro L650 you have exactly (L650-xxx)?

• Satellite Pro L650 - 1 L 4: battery will be discharged when the laptop is disconnected

  Hello together,

  I have a problem with my 5 month old laptop Satellite Pro L650 1 L 4.

  When the laptop is unplugged it will pay the battery. About 44% within 24 hours.

  Of course, options like BIOS "Wake we Lan ' and something like which are completely disabled.
  And of course the laptop is turned off completely and not the Sleep Mode.

  Any ideas?

  Kind regards

  Stephan

  Hello

  Please check if the wake-up on LAN is also disabled in the properties of LAN card (Device Manager-> LAN card-> properties-> Advanced tab).
  I also recommend checking the WLan card as well.
  Please also check if attached USB devices don't lose the power of the battery.

  But also a malfunction of the accumulator may be possible... so it has to be checked also...

• Satellite Pro L650 - 1 CG-output HDMI not working not

  Laptop: Toshiba Satellite Pro L650 - 1 CG, Intel i3 - 350 M, ATI 5650, 4 GB RAM, 320 HARD drive

  When I connect my laptop to my HD Toshiba TV and select 'Connect to a projector', all I get on the TV is a black screen.
  Catalyst Control Center can 'see' the TV and I can adjust the options of resolution for both screens, but no matter what options I try, I can't the TV to show a picture / sound.

  The TV is obviously detected SOMETHING, because it goes from a blue screen to black. Device Manager, I can see the HDMI Codec but even though he says he is activated, I can't put it as default. It says below that it's 'unplugged', and when I run the HDMI control program, it says "To use the HDMI control, you must activate it".

  I have all the latest ATI drivers / sound, as well as virtually all the drivers up to date there. In addition, there is nothing wrong with the cable or my TV, my PS3 is using the same connection.

  Hi were reluctant,

  Normally, you can switch between monitors or switch to an external monitor only when you press the FN + F5 key combination.

  In addition, I would recommend turning on the external monitor first, then switch on the laptop. You can also choose the right channel to HDMI in on your TV. Then, press FN + F5 to switch to your TV.

• M40: unknown pci device (sd reader?)

  Hello

  I have reinstalled windows on my M40-149, and I have an unknown pci device listed in Device Manager. I've read other messages here, but I can't find a solution.
  I can t really think of something obvious, it could be, but I noticed that it doesn't do anything when I insert an SD card.
  I have a controller Cardbus Texas Instruments PCIxx21 / x 515, and a Texas Instruments PCIxx21 Integrated Flashmedia Controller is listed in Device Manager. I put t know if there should be one for SD cards but I see no driver for it on this website. So, any help would be greatly appreciated!

  Thank you.

  Hello

  It is listed as a driver for Texas instruments V 2.0.2.1 Cardbus. The download is possible under http://support.toshiba-tro.de/tools/Satellite/sm40/win-xp/cb-drv-sm40-xp-1021.zip.

  Good bye

• Satellite Pro L650 - 17 p - how to disable WIFI?

  Hello

  I have a problem with my new Toshiba Satellite Pro L650 - 17 p. I can't disable the WiFi with FN + F8. FN + F8 works only for Bluetooth, but not for the WLAN. WLAN driver (Broadcom) and value added package are the last of the Toshiba Homepage.
  What can I do?

  Thanks in advance
  Senekha

  Hello

  Normally the WLAN card can be disabled if you press the FN + F8 key combination. Several icons will appear as Bluetooth, WLAN, shut it down, etc...
  You see a symbol for the wireless card?

  WLAN is working now?
  You use the pre-installed Windows version?

  If the wireless network adapter is listed in the Device Manager you must reinstall value-added package I think.

• E430 - unknown PCI device - WIndows 8

  After that I have upgraded to windows 8 Pro (64-bit) and installed all the drivers available on the Lenovo Web site.

  I have still 1 unknown PCI device in my device manager.

  Anyone know what device it could be? And the pilot?

  Additional information:

  Status: The drivers for this device are not installed. (Code 28)

  Location: Bus 2 PCI, device 0, function 0

  ID: Device PCI\VEN_10EC & DEV_5229 & SUBSYS_500017AA & REV_01\4 & c587ecb & 0 & 00E0

  Thanks in advance.

  Nice day...

  This string of material, it looks like the Realtek Cardreader:

  http://www.driveridentifier.com/scan/driver_file_detail.php?inf_file_id=1018629&MD5=17434a91fc66dc3b...

  the link of the Win8 driver in your driver matrix: http://support.lenovo.com/en_US/research/hints-or-tips/detail.page?&DocID=HT073272 currently shows like s. o. the driver Win7 * may * work: http://support.lenovo.com/en_US/downloads/detail.page?DocID=DS028711 but I cannot confirm that.

  Kind regards.

• HP ProBook laptop G3 450: unknown PCI device

  Unknown PCI device

  Slot PCI 8 (Bus PCI 3, device 0, function 0)

  PCI\VEN_10EC & DEV_522A & SUBSYS_8101103C & REV_01

  PCI_VEN_10EC & DEV_522A & SUBSYS_8101103C

  PCI_VEN_10EC & DEV_522A & SUBSYS_FF0000

  PCI_VEN_10EC & DEV_522A & SUBSYS_FF00

  All the ideas that a pilot is necessary?

  @Kyle-Crowther

  http://support.HP.com/us-en/drivers/selfservice/swdetails/HP-ProBook-450-G3-notebook-PC/7834555/swItemId/ob-169267-1

  REO

• Cannot adjust brightness screen on Satellite Pro L650

  Hello
  I am running Windows 7 64 bit on my Toshiba Satellite Pro L650 and I cannot adjust the brightness of the screen. Fn + F6 key and Fn + F7 do not work and there is no entry for it in the control panel.
  I tried to download drivers VAP 1.4.1 as explained in Toshiba newsletter help, but there was no need for this template.

  Could you please help me with this?
  Thank you
  Stone

  Are you using the original OS that you got with your laptop or your own installation of the OS?

  As far as I know it should work with the settings. If you have changed something?
  You can use other fnctions FN?

• Satellite Pro L650 turns off after start; DC In and Power LEDs blink on stop

  A friend Satellite Pro L650 having worked well until yesterday, all of a sudden turned itself off. Now, at startup, it lights up normally for about 10-15 seconds before turning off suddenly. Turned off, the DC in white/blue LED and the orange Power LED Flash on a broad set of intervals of approximately one second. This extinction happens if I leave Windows or press F2 to enter the BIOS setup.

  I guess this blinking is intended to serve as a kind of diagnostic code, but I have yet to track down what it means. Can anyone help?

  To avoid confusion, power without the product stack the same, sudden stop experience, except the two LEDs remain solidly lit this time. With or without battery, trying to turn on again immediately after that a shutdown produced no response at all. Remove the power cable and immediately it reconnect again and turn then produced a brutal power off, but in less than 5 seconds. More wait between attempts to market seems to give a little longer powered on State, but without fault, the machine turns off just suddenly. With its short time 'turned on' we are talking, there cannot be any kind of thermal protection?

  I had an old Satellite L450D lying around that uses coincidentally the same AC PA-1750 adapter, but use it made no difference. Of course, the battery does not have the L650!

  The only previous numbers, that I am aware of this machine have been intermittent case of Windows reporting "Plugged in, not charging", but as my friend use it exclusively on the network, it was not a problem.

  Your thoughts will be greatly appreciated...

  WTF?

  What is an unmoderated forum?

  Can someone help with my problem?

• How to regulate the speed of the fan on Satellite Pro L650 - 15 c?

  I can regulate the speed of the fan in my laptop (Satellite Pro L650 - 15 c)?

  The reinstallation of Windows 7 the fan is always moving up. How can I set this fan?

  greeting of the developing countries

  Hello

  Open windows power management and settings for the management of the power supply you use. You will find the advanced power option. Open it and you will find Toshiba power saver options.

  Open all the available option and check the settings of the cooling method. Set to optimized battery option.
  This should reduce the speed of the cooling fan.

  Please test and validate the results.

• Upgrading RAM on toshiba satellite pro l650

  I have 2 toshiba satellite pro l650. first of all an i did a RAM upgrade 8 GB (2 x 4 GB DDR3 1066 MHz Kingston) 1 year ago and work. Now, I would like to upgrade to the other laptop. I bought 'Impact HyperX HX316LS9IBK2/8 2 x 4 GB 1600 MHz CL9 SODIMM 1.35v DDR3L' but do not work! I thought that they were defective and I branch "QUMOX 8 GB (2 x 4 GB) 204 pins DDR3L-1600 SO-DIMM" but also these don't work on my toshiba! Why not work? What can I do?

  I presume that there is compatibility problem. Best thing you can do is to use two identical RAM modules.
  Can you please put name of full model of your laptop so that we can check what RAM modules are 100% compatible.

• Portege R200 - W2K - unknown PCI device

  Hello
  I have a r200 with w2k and after installing all components, I still have an unknown PCI device...

  Everything works fine, I even installed these drovers that do not exist in w2k toshibas with their good will and yet... considered package previous assignments, about card pci and usb, but all those mentioned, there are fine by me...

  any idea?
  TX
  JF

  Hello

  On this path, it is not easy to tell which device needs to be installed. I found an interesting paper on the Toshiba (knowledge base) page. Check it on http://support.toshiba-tro.de/kb0/TSB57014E000QR01.htm

  Maybe it will help you identify the unknown device.

  Good bye

• Satellite Pro L650 - 1 L 4 - values of the display panel

  Please could someone tell me the specifications/characteristics of the area of display in the Toshiba Satellite Pro L650 - 1 L 4, mainly the values for brightness!

  I want to buy exactly this phone and also need to use outside, so brightness is really important! I've already found a few values for the L650 - 15 p, but they were really bad, and I hope that they are not the same for all types of the L650...) :

  Thank you

  Hey,.

  I found the exact product specifications on German
  Toshiba http://de.Computers.Toshiba-Europe.com/innovation/Product/Satellite-Pro-L650-1L4/1094127 page:

  As you can see the screen 15.6% and a screen resolution of 1,366 x 768 with LED background light.

  All that s what I could find.

• Satellite Pro L650-1QG: incompatibility of keyboard key

  Dear audience,

  I am not satisfied by the keyboard of my Satellite Pro L650 1QG I5-4 settings.
  Before I had a Satellite S5200-701 that has worked well for almost 8 years after, I replaced almost any critical component to half-life.

  Finally the controller was unserviceable and last week the laptop worked no more after this problem has resided for six months but the laptop did not fail until last week prompted me to install and use my new laptop.

  I felt very comfortable with my old laptop and its parameters.

  However, the new laptop has an inadequate setting of its keyboards.
  "ALT GR" is replaced with my old keyboard and hold the 'CTRL' key has exactly the same position as on my old laptop so that it is possible that I write a 'CTRL-Q' when I tried to type 'ALT GR Q' or '@' which happens quite often and stops the program (EXIT).

  How can this problem be solved. Is it possible to get a fix? Either by replacing the CTRL key with a deaf person, or changing the configuration of the computer?

  I'm not sure I can adapt to this problem from any 'normal' keyboard is different and similar to my old laptop and work with a USB keyboard is no solution!

  Thanks, Headlost

  Hello

  > However, the new laptop has an inadequate setting of its keyboards. "ALT GR" is replaced with my old keyboard and hold the 'CTRL' key has exactly the same position as on my old laptop so that it is possible that I write a 'CTRL-Q' when I tried to type 'ALT GR Q' or '@' which happens quite often and stops the program (EXIT).

  I think that there are not many options for you you used a keyboard that has supported a different layout, L650-1QG supports the 102 (Euro) A4 + 10key flat standard black keyboard that can be different from the old Satellite 5200-701 keyboard.

  Don't know if you can replace the keyboards because of the measures so maybe one and the only option for you is the use of the external USB keyboard that would be similar to Satellite 5200 701 keyboard