screen of 3 computers, 1, 1 keyboard & 1 mouse

Similar Questions

• When I start my laptop, I get the screen of my password, however, my keyboard and mouse do not work

  What I have to do. I ahm runing a HDD test through the Setup utility. Error of a hard drive failure. Does this mean that I lost everything on my computer? I need to replace the hard drive?

  HP G60 laptop

  p/n nbo41ua #aba

  You can take it to a repair center and they will return for you. You can also remove the hard drive and connect it to another computer to back up data (recommended for pros).
  
  If you have a high-capacity USB flash drive or external hard drive, you may be able to use the Recovery Manager HP back up files. You must press F11 when the computer is turned on (when you see the HP logo) to enter the Recovery Manager.
  
  There is no guarantee that all or part of your data can be saved from the HARD part is defective drive... Just try to do the first chance you get.

• Using two computers on a single monitor, keyboard and mouse.

  I want to use my two computers with a single screen, keyboard and mouse... says to use the kvm switch.  I use Windows XP on a computer and Windows Vista on the other... what kvm switch do you recommend?

  You can view the free software kvm solution below:

  Input Director
   http://www.InputDirector.com/

  I use between three computers (1-Win7 Pro x 64 single monitor, 1-WinXP Pro x 86 two monitors, 1-WinXP Home x 86 single monitor) and a single keyboard and mouse. It works fine for me, I used it for over a year without any problems. The Win7 Pro and WinXP Pro have both run several virtual machines too.

  There are several other kvm software available (Google is your friend) I tried several before input Director.

  Kind regards

• Qosmio G30 - screen lock, no keyboard, no mouse action

  I'm getting intermittent problems with my G30 gel (not BSOD - simply locking the screen, no keyboard, no mouse action) and the fan at maximum speed. The only way out is to hold the power button until the machine closes its doors. Reboot is so very well. Sometimes, say, 2 - 3 times a week, with 3-4 hours per day use.

  Not much to go, I know! I looked for the time journal entries he goes and sees nothing strange. I had the motherboard replaced a few months after the video card overheated and dies, so am a bit paranoid about heat problems. The only consistency I can find, is that it happens only when it is connected to the internet... I am running Norton antivirus/internet security, and there is nothing in their newspapers either. There is no apparent consistency when it happens (for example the set time after start instead, executing specific program, etc.).

  Anyone else had this? Sorry I can not more than a fix on the problem, but maybe someone can recommend a way of pinning it down better...

  Jonathan Gibbs

  Have you tried a BIOS update?

• When install Vista Home Premium computer hangs on the language selection screen. No visible cursor, the keyboard and the mouse does not.

  Hi, when I try to install vista that Home Premium 32 bits on the computer of my son, through the installation of loading files with the gray bar at the bottom, then goes to the screen language selection, at this stage, I can not select anything using the keyboard or the mouse. There is no cursor visible. Keyboard and mouse both work fine in the bios and on other machines. Have used other keyboards and mice on the machine in question, but that makes no difference. Tried another copy of vista, no difference. Tested on Windows 7 install and everything works fine!

  Very confused, thinking that it must be a driver problem, but how about him? Any help is appreciated!

  Hi Rickydg,

  Thanks for posting. Please contact ASUS and see if there is a BIOS update available for your system. Update the BIOS and then try to install again.

  I hope this helps! Shawn - Support Engineer - MCP, MCDST
  Microsoft Answers Support Engineer
  Visit our Microsoft answers feedback Forum and let us know what you think

• Keyboard and mouse stop working at the login screen, but work very well before he gets to connect.

  My keyboard and mouse suddenly stopped working today, I was pressing F11 to try to get the system to boot from a recovery screen and it wouldn't, but when he returned to my screen connection and requested my password it won't let me not use the mouse or the keyboard, I wonder if I accidentally turned off something and if anyone knows how to turn it on turn it back on. I'm using vista on a HP dv5

  Thank you

  Hello Djc618,

  Thank you for your message.  You have a friend or a family member that can allow you to use a keyboard to see if the material can be defective?  You can also try using your keyboard on another computer, if this does not work then you probably have a bad keyboard.
  We can't wait to hear back on your part.
  See you soon

  Engineer Jason Microsoft Support answers visit our Microsoft answers feedback Forum and let us know what you think.

• When I am working on my desktop HP, the computer freezes. Nothing works (keyboard or mouse). The screen becomes sometimes paler.

  When I am working on my desktop HP, the computer freezes. Nothing works (keyboard or mouse). The screen becomes sometimes paler. And the only way to resolve the pbobleme temporarily to stop temporarily the computer weighing on the button of the tower.

  Hi Louis,.

  Please select your language from the drop-down menu above to post your question in the language of your choice. The forum in which you've posted is for English only. If you can't find your language above, support for additional international sites options are by following the link below:

  http://support.Microsoft.com/common/international.aspx

  Thank you

• I want to hang the Tower up to my big screen and instead of using a keyboard, I bind a tablet that I can use as a keyboard and to manipulate objects on the screen in real time

  I am in the middle of do a remodeling and think about a furture upgrade my PC at home, I want to hang the Tower up to my big screen and instead of using a keyboard, I want to connect a tablet that I can use as a keyboard and to manipulate objects on the screen in real time. Is there a way to do this?

  (1) before the PC upgrade, please read the complete technical documents for all devices

  you want to go to upgrade

  (2) it is the first thing to do to make complete lists of materials you want to change.

  Compare specifications detaily, note important diference between many of the same features

  (3) for more information on some devices and materials, see link below

  http://www.Microsoft.com/en-us/Windows/compatibility/WIN8/CompatCenter/home?language=en-us

• Windows vista problems install keyboard and mouse

  I try to install windows vista ultimate on a new amd system I've built recently. The windows vista screen Boot starts well, but I can't go further with the installation because the keyboard and the mouse do not work.

  To solve the problem, I booted up with a Linux distribution and I can use the keyboard and mouse and everything works fine. Initially, I bought vista using boot camp on my Mac and the keyboard and mouse work well with vista on this configuration.
  I want to upgrade to windows 8 thereafter, but I might need to buy the whole program, rather than the update if I can't do vista works. I don't want to spend money if I can't because I'm broke. Any suggestions?

  Parameters of the BIOS of some computers have a setting "Enable USB Legacy" to allow the keyboard to work without Windows running.

  If you have PS/2 ports buy an adapter or a PS/2 keyboard. Most USB keyboards can be connected to a PS/2 port using a USB to PS/2 adapter.

• Unable to use the keyboard and mouse on the installation window.

  I almost installed windows on my hard drive (normally works on the SSD, I need to format).  When I arrive to prepare it for the first time, I can't move my mouse or my tab on the screen to continue.  What should do?

  Is your keyboard/mouse wired or wireless? You may experience the problem with some wireless mice / keyboards. The problem is that the system requires that you press the lock key to activate the keyboard. You can do this until windows has started, but you must use the front keyboard of the shoe has completeded. This is a stupid and impossible.

  The solution is to borrow or buy a cable PS/2 keyboard / mouse and allows to complete the configuration of your computer. If you need to buy, they are relatively expensive. This type of keyboard is used commonly with desktop computers before wireless keyboards became popular.

• How can I repair my broken Magic Keyboard and Mouse?

  My niece who is 23 years younger than broken me my Apple Magic keyboard and mouse Magic Mouse from Apple for my iMac, and all of them are not in stock because they are used on Mac computers, and I don't want to lose a keyboard and a mouse, another Mac as on my Mac Pro. She said I was due, but I SLEEP, then all of a sudden, I heard the noise. Is there warranty for the keyboard and mouse? How can I replace it with Apple because she says it's worth $ 5, and piano of plastic doll is worth $ 500 and the cheap plastic. Should I go to the Genius Bar because the keys are gone, and the mouse is broken.

  Apple does not cover such damages, regardless of warranty.

  You can buy new online through a variety of websites looking for them online, that they do not have to come from Apple.com. Stores of brick and mortar like best buy or Wal-Mart can take so if an Apple Store is not an option. There are also alternatives and sometimes a lot less expensive replacements through various vendors such as Microsoft and Targus just to name a few.

• MacBook Pro: Integrated keyboard and mouse not responding pluse

  I have a MacBook Pro 13 ", early 2015, installed with OS X 10.11.4.

  I use it mainly to work, with the screen closed, an external display (via Thunderport) and an Apple and change Vertical Mouse 4 - times connected via Bluetooth wireless keyboard.

  Before I get home, I open the screen, disconnect the power cord and power cord screen Thunderbolt and then close it. I leave the keyboard and Bluetooth mouse on as I leave the office.

  It works normally, but yesterday my Mac kept looking for Bluetooth devices home and would not respond to the built-in keyboard and mouse (with the exception of the switch when maintained supported 10 seconds for a forced stop). Reboot doesn't change anything and I tried to reboot with the disk (Cmd + R) utility or reset the NVRAM (Cmd + Option + P + R) and the keys did nothing. Reset SMC (Shift + Ctrl + Option + power) does not seem to do anything either.

  When I connected a keyboard Apple USB C, the keys have been recorded, but it would still find a missing mouse and go anywhere else than the screen "You are looking for a Bluetooth mouse".

  Back at work today, everything works: built-in and Bluetooth devices.

  Any suggestions?

  Update: the built-in keyboard and trackpad now don't work at all, even when Bluetooth devices are connected.

• wired keyboard and mouse not recognized after sleep

  TL; DR after waking from sleep, the wired Mac keyboard and mouse are unresponsive.

  I have a new Mac Mini.

  OS X El Capitan 10.11.2, 16 gb Core i7.

  I had a keyboard and a compatible bluetooth mouse, but I had the problem that after the Mini for sleep, the keyboard and the mouse were not detected.

  I bought an Apple mouse wired and wired keyboard.

  I have the same problem.  If I SLEEP the Mini, when I wake up it (short press on power) or the keyboard or the mouse are recognized.  It's like I have no connected.  If I disconnect it from the usb and the re - attach they are not always recognized.  I have to press power to force power off and restart and then my keyboard and mouse are recognized.

  Sometimes when pressing the power button to wake up from her sleep, I also get a "flickering" image monitor, which improves if I turn on and off to sleep a few times, or restart.

  It is very annoying, any ideas?

  Try turning off blue tooth - it seems to me the pop up screen searching for the mouse Bluetooth turn on the lock.

• Question Z820 keyboard and mouse

  When the powers of the workstation on the keyboard and the mouse are not recognized. I can't enter the bios or Setup screens and then that windows 7 boots again, the keyboard and mouse are not yet available. If they are moved to the 3 USB ports, so I can use them in windows, but not in the bios configuration.

  Edited: I have also reset the CMOS by jumper and button using the PS/2 keyboard access. It seems that all USB 2.0 ports no longer work (front or rear). When I plug a mouse in the red laser flashes once, but that's all, nothing after that.

  The motherboard seems to be defective. Please call HP support.

• PS2 Keyboard and mouse hooked after XP SP3 installed

  Upgrade to SP3.  Keyboard works very well to get into the BIOS.  F8 works very well to get to choose the Safe Mode, and al. or not.  Once XP takes control, the keyboard and mouse are unresponsive.  Mouse move the pointer on the screen, the keyboard will not activate numlock or other keys LED.  Power - off only option.  Tried other keyboards and other mouse.  No go.

  Any ideas?  Perfect condition ' puter til SP3!

  I said nothing about "of special drivers', I suggested seeking & install the updated drivers. If none is available, there is a very good chance that your older equipment of keyboard and mouse is not supported in WinXP SP3.

  Free installation and unlimited compatibility support for WinXP SP3 is available since April 14, 2008 to May 2009. This support will cost U.S.$ 59 or by higher incident now.

  OT: Unlike focus groups, we can't crosspost in these forums, we can only multipost.

  Multiposting vs Crossposting
  http://www.blakjak.demon.co.UK/mul_crss.htm

  Despite what you see in this forum URL or at the top of the forum page, Windows Update forum is not a forum specific to Vista or Win7. We deal here with WinXP, Vista & Win7. [What were thinking?]

  ~ Robear Dyer (PA Bear) ~ MS MVP (that is to say, mail, security, Windows & Update Services) since 2002 ~ WARNING: MS MVPs represent or work for Microsoft