Screen of V3 - 772 g Acer problem

Hello everyone, I encountered a strange problem with my Acer V3 - 772 g. It seems that the screen "flickers" with bars that cross the screen.

While the majority of the time, it is not visible to the naked eye. In some situations, the problem can be quite apparent and strain in my eyes a little.

Through the lens of a camera, it becomes completely visible, and comparison with photos and videos I've seen of him I can conclude that it is abnormal defintely.

I have tried several attempts to solve this problem, as the installation of the latest drivers, the laptop restore factory setting and even the BIOS update. However, none of them seem to have an effect.

I have, however, found that when the safe boot mode flickering does not occur.

If anyone can give me any suggestions, I would be very grateful.

Thank you.

Hi p1f1313

Then, it seems to be a bad connection from the motherboard to the screen. Acer support is world-wide, so care must always be able to help.

Let us know how you go!

Tags: Acer

Similar Questions

  • My screen on my laptop an Acer is mirror imaged.

    Original title: Mirror image screen.

    My screen on my laptop an acer is mirror imaged including the bios, when I connect it to a monitor everything is ok anyone able to help

    Hi Tamrik,

    As you mentioned that the problem that happens in the system BIOS (Basic Input Output System), then it is probably a BIOS setting or a hardware problem.

    I advise you to contact Acer for warranty support.

    http://support.Acer.com/us/en/default.aspx

    Hope the helps of information.

  • my laptop do not stop proprly .when I do stop my laptop to come in blue screen so how do slove this problem?

    my laptop do not stop proprly .when I do stop my laptop to come in blue screen so how do slove this problem?

    You have an external equipment attached and turned on when stopping?

    All applications are closed before attempting to stop?

    Try to do a clean boot:

    http://support.Microsoft.com/kb/331796

    I would also make sure that all the drivers for hardware and software updates have been applied.

    How long have you been experiencing this problem?

    Have you installed a new hardware or software since you started facing this problem?

    Also perform the following operations:

    Check your hard drive for errors:

    Click Start

    Type: CMD, according to the results, right-click CMD

    Click on "Run as Administrator"

    At the command prompt, type: chkdsk /f /r

    When you restart your system, your computer will be scanned for errors and will try to correct them.

    then

    Click Start
    Type: CMD, according to the results, right-click CMD
    Click on "Run as Administrator"
    At the command prompt, type: sfc/scannow

    This will check for any breach of integrity

    Restart your system

    ----------------------------------

    You can create a new user account and see if the problem exists when you try to stop this user account.

  • Hi performer El Capitan on iMac - Illustrator CC windows do not appear on the screen when checked - what is the problem?

    Hi performer El Capitan on iMac - Illustrator CC windows do not appear on the screen when checked - what is the problem?

    Try the window > Application frame.

    May be required to be on continuously, there seems to be some kind of issue.

  • I want to download Adobe after effects CC, however, a message appears on the screen: at the moment, he had problems. Please try again later. If the problem persists, contact customer support. What should I do?

    I want to download Adobe after effects CC, however, a message appears on the screen: at the moment, he had problems. Please try again later. If the problem persists, contact customer support. What should I do?

    You MUST have a 64-bit computer and operating system... What is your computer?

    -Programs are supposed TO not view or download if they are not installed on your computer

    MINIMUM for After Effects and Premiere Pro http://helpx.adobe.com/premiere-pro/system-requirements.html

  • Scalling v3 - 372 screen Acer problem

    Hey, I recently bought an Acer laptop of v3 - 372 without OS pre-installed, and I installed windows 10, then the drivers from the acer site. The problem I am facing is when played the old games like Heroes 3, which is launched in resolution 800 x 600 - instead of the image being stretched full-screen, I have two black bars on the sides of the screen. I tried to change settings in the Intel HD graphics Panel, but this does not help, any ideas on how to solve it?

    Hello

    Unfortunately the driver "recommended manufacturer" cannot be simply replaced.

    Please read the solution in this topic:

    http://community.Acer.com/T5/V-and-VN-series-laptops/VN7-591G-latest-driver-2016/m-p/434317#M10190

    And follow the instructions from the third stage.

  • Market problem laptop Acer problem

    Hi all

    I wonder if anyone has met, or heard of this problem.

    I have a laptop Acer Aspire 5745 w / 640GB HDD and 8 GB of memory running with Win 7 Home. I have about 3 years.

    A year or 2 there, he began to develop a market problem. I noticed that most of the cooler mornings (tendency to heat my house more than necessary). Sometimes, it makes the power of Win 7 on screen (Windows 7 and swirling colors, creating a window) and stop somewhere along the way. Other times it cannot even do it in front of the Acer splash screen. Sometimes it will go to full boot (Windows desktop) only to hang. I might have to restart the machine more than a few times to market. However, once I turned it completely, I can turn it off and restart without any problem.

    I reinstall the HARD drive and thought it helped, but only for a bit. The problem comes back. Battery seems to be in good shape.

    One thing I noticed this morning, is that if I unplug the PS, the computer started fine. I still need to do some additional tests to confirm or deny this... but it was a discovery of new and interesting.

    I read in some places that the PS/charger can be a source of such problems.

    Any idea or feedback is greatly appreciated.

    Thank you and see you soon...

    Hi stephr1

    Yes, it sounds as if the charger is at fault. If she starts & runs fine on battery - it's the only thing she could be!

    Buy a replacement charger - one who gives the same output/input as the existing one, then this should solve your problems!

  • s7 Acer problem

    Hello! I have an acer s7 391 and I have the following problem. When I enter the app menu, or when I try for example to attach a file to an e-mail in the mail application, the screen is gradually begin to look bad, the contrast and the colors change, and it's a little weird. When I swich to the beginning or to the desktop, the screen is trying to look good again, little by little. as in 5 to 10 seconds.

    The problem is that I noticed that this problem will NOT occur when the computer is in charge. What happenes only when it is on battery power. I already checked for the settings, there is no problem. plugged/unplugged settings are the same, but without effect.

    the service already changed my screen. the problem may be the motherboard or video card? or what it might be? has anyone noticed this problem with his laptop? Thank you!!

    As freeza indicated on your other post on this subject, please contact the service.

    We suggest to contact technical support in your region for further assistance in this matter.
    Acer Service & support

  • s7 Acer problems

    Hello. I recently bought an acer s7 - 391 and I encounter the following issues:

    1. I have changes in contrast when I slide hollow different applications. for example, when I open the music application, the background looks like it's moving, it wobbles, and the quality of the screen becomes very bad... However, colors appear very high. If I come back at the beginning, the quality begins to seem good again, in about ten seconds. What could be? I've updated the graphics card driver later. nothing.

    2. the trackpad is all bad. When I move the cursor on the diagonal, it is not moving directly, but looks like it's the theater of the waves, some forms of "s". ...

    3. the screen has gray spots in the lower corners. It also loses little light...

    4. my keyboard part 2 shots when I press some keys. I type too slowly and as carefully as I can, but it still doesn't work.

    I think I'll go into service with her. did anyone experienced the same problems that I did?

    Thank you!

    Keep sending/taking it repairs until you get all your problems solved.

  • Screen on my Satellite 5200 801 problem

    User program of structural improvements
    "A month ago I encountered a problem with a slightly garbled screen
    on the internal and external screens. More or less visible vertical
    stripes appear on the screen. They are mainly blue on dark background
    (better visible) or yellow on white background (less visible) and have
    approximately the same thickness of 1-2 mm and length of order order
    1 cm. The locations of the bands depend on the position of the details
    actual image currently displayed on the screen.
    ...'

    I have the same problem. It's the faulty video memory chip.

    Anyone know where I can to the system card bye for this laptop?
    Can anyone post any link or any other way to find it or
    compatible motherboard.

    Thank you!

    Hello

    There is no compatible motherboards. You must use the same. If you want to buy a new one there are only two ways: allows the service partner or some independent laptop repair center. If you want to use used one, check online like eBay auctions or some other offers (online or in newspapers). Sorry, but I don't see another possibility.

  • Blue screen T430s-2352 and Code 101 problem

    Hi all

    By the use of a month of my T430s, I have met four times with BSOD(Blue Screen) and the two recent showed the same error message:

    Clock interruption A has not received on a secondary processor within the allotted time interval. And tstop code: 0 x 000000101

    Here is the screenshot:

    Link to photo

    When I use the "BlueScreenView" software to read the .dmp file, it says that it caused by the address "ntoskrnl.exe + 7f1c0".

    And these last two days, when I use Vmware workstation 8, playback of music suddenly blocked for a few seconds and my screen is frozen. I thought the BSOD to come again, so I stop doing everything with my PC but the music came back and went out on the screen. I think maybe the CPU is stuck again but not so severe to cause a BSOD. But I treat it as a sign.

    Moreover, after that I got my T430s, I did a lot of stability, exercise test, including premium 95, Furmark, MemTest Pro. But none of them gave me problems and my T430s survives at all. But the BSOD just happen randomly.

    My Config:

    I7 - 3520M with HD4000

    8G RAM

    SSD

    PS. I enabled Intel Turbo Boost before these two past BSOD.

    Can someone help me?

    Note of the moderator; image (s) for a total of > 50 K converted for the programming of the Forum rules


  • Compatibility update Acer problem

    Windows just did a major update on my Win7 machine and I get a message saying that Acer Updater is not compatible with this version of windows and I need to contact Acer for a solution. Laptop is out of warranty so I can not anywhere with technical support by e-mail. Any suggestions?

    Acer is aware of the issue that has been reported and has worked with Microsoft on a resolution. The link for the update should work now, however, you may need to restart your system for the update to install correctly. If you're still having problems, Acer has posted these updates on our site for download. You can find a link to download updates to our support http://acer.custhelp.com/app/answers/detail/a_id/29568article. If you're still having problems, please continue to post and we will help in any way we can.

  • screen sharing, but not in the page, it's on the screen itself, this is not a problem of tiling and even appears before openening all pages

    Hi, during the opening session on my computer, I got a little split screen, separation is 1/4 to the top of the screen and the screen ends 3/4 through my computer screen. It is not connected to a screen divided through tile, pls don't tell me to undo the tile, it is a different matter. I did not select anything to do this, I went through all properties and nothing seems to fix the problem, I also went for the restart of old, but doesn't change nothing, have tried the restore too, if anyone could help it would be appreciated.

    Please note the split isn't in the windows control panel, but on the whole computer screen, when I scroll to the top of my cursor down spread and the high apears

    Also note pls I told him it was a hardware problem, because I had to select a category, not because it is certainly the case

    Hi johnjimmy,

    ·         Did you do changes on the computer before the show?

    Follow these methods.

    Method 1: Follow the steps in the article.

    Resources for troubleshooting problems in Windows XP

    Method 2: Update the latest drivers to display/graphics.

    How to manage devices in Windows XP

    For reference:

    Change your screen resolution

  • Automatic detection of G257HLBIDX of Acer problems...

    Hello

    I had the G257HLBIDX monitor mount there. I love very strong monitor.

    But...

    The problem I have is that whenever I restart my computer, the monitor will start to turn channels to find my computer. D sub-> DVI-> HDMI until she reached the connection I use the computer.

    For example if I use D - sub to connect my computer to the screen and I restart the computer, and then search for monitor to the DVI and HDMI connection, then go back to D - sub. Sound very anoing because my computer restarts for 5.7 sec and the monitor take 15 or 20 dry to check all channels. So every time I install the update or something the screen check all channels until she reached the original I put it to.

    Is there a way to upgrade my firmware or something like that so I can put the auto detection function disabled? Sound very anoing

    Lafoza,

    We tested one of our G257HL we have, and it's our findings:

    It scans when there is no computer and it parsed once when followed us in VGA and then switch the HDMI connection. He won't go through the process of scanning again when you are connected to the same HDMI connection, that he recall the entry.

    Are you using any type of separator or box that could be causing to scan?

    If not, and you are using more than one computer connected to this monitor?

  • Tablet Acer problem

    Dear Sir/Maam,

    I use Acer Tablet model: A500 that I am facing some problems with the Tablet, then please mail me the details where I can get the Acer Tablet repair in Delhi at the service centre. I want to repair near Pitampura. If you can find someone who can fix it.

    Thanking you,

    Piyush

    [private under the leadership of life]

    My ACER A500 TABLET POWER BUTTON DOES NOT WORK I have WANT to GET REPAIR of EMERGENCY. PLEASE HELP ME I AM FROM DELHI, INDIA.

    [private under the leadership of life]

Maybe you are looking for