Sound on Satellite P300-156 problems

Similar Questions

• Satellite P300-156 - problem with drivers ATI 3470

  I have download the new catalyst 9.3, I exceeded the drivers with mobility modder, but always after the installation, the pilots see 3470 drivers only 3450.
  What is happening and why Toshiba is not updating the drivers for Satellite P300 on the site?

  Hello!

  The reason is the reason for which you are trying to use a driver that is designed for desktop graphics cards and not for laptops.
  It s on your own risk to use these drivers because they don t have a protection against overheating.

  In your case I remove and install the most recent that you can find on the Toshiba site:
  http://EU.computers.Toshiba-Europe.com/-online decision-making supported Downloads & => Download drivers

  Good bye

• Satellite P300 - 156 Windows 7 Crash problem

  Hello
  I have the Toshiba Satellite P300 - 156 PSPC4E, model and I've had this laptop for a couple of years now.
  Before installing windows 7, I got the default Windows Vista installed and it worked fine.
  Now since installing windows 7, no matter WHAT game I try and play just causes the cell to go black screen and turn off after about 5-10 minutes of play.
  I thought that this was due to an overheating problem... so I opened the laptop and cleaned all that and then put it back together again.
  (YES I checked all the wires are back where they should be and all the components are working properly)
  It did not work.
  Then I tried updating all my drivers and software ect.
  Still nothing.
  I searched on through pages and pages of search results for the same problems with Windows 7 and the game crashing... but nobody seems to know how to fix it.
  I thought it was just windows 7, but I re installed windows vista and it's always done the same thing on there now.
  I tried to install all the drivers of the model for this laptop toshibas site and not luck.
  My windows vista and windows 7 are two authentic copies.

  All the hardware is functioning normally (as far as im aware) and I really don't see what can cause this problem.

  If someone could give me some advice on what to do it would be greatly appreciated.

  Thank you

  Hello

  Which driver you use display? I m P300 owner but not on my A300, I had a similar problem that the laptop has crashed during a game. It seems that the reason was a 3rd party driver or let's say the driver of the manufacturing of the graphics chip directly. I think that because they are not prétestées on the cell and causing overheating

  So I recommend you to install the latest driver of display on the Toshiba site.

  Finally and above all what version of Windows 7 (32 or 64-bit), you have installed and what version of BIOS?
  From Toshiba Web site also shows the new BIOS versions and several versions 32 bit and 64 bit OS. Maybe you have to day/edit, who knows?

• Satellite P300-156 - and the button Return give the same values

  Hello

  I have a satellite P300-156, and it has a numeric keypad.
  I have problems because the Enter key and the Return key give the same values. I believe that it is incorrect.
  Can anyone help.

  Key on the numeric keypad should give an input it does.
  the Enter key on the main keyboard should give a carriage return value, but it gives an input value.

  Usually this does not cause a problem, but with software like photo shop that makes the distinction between a carriage return and a hard fall it does not work.

  Can someone help me please

  Thank you

  Hello

  To my eyes the entry and return keys are the same keys that provides the same functionality.
  I really put t know why you believe that there is something not right

  By the way; Check if you are using the latest version of the BIOS!

• Satellite P300-156 won't start or by MAIL

  Hello

  I have a Satellite P300-156 I bought a few months as damaged. The screen has been damaged and the case slightly cracked. I replaced the screen and hard drive and main card seems to have no physical damage. I've been running this system for 3 months now without any problem but, today, for some reason, it won't start or even POST. It powers on and the CPU fan starts to turn then stops and does nothing. No display (I tried external). CD player works. No beeps.

  I tried reinstalling RAM even open completely and reinstalling all connections, nothing done. Does anyone have an idea what component is gone? (CPU/GPU/RAM)

  Any help would be greatly appreciated

  Thank you

  Did you update the BIOS or something?
  For me, this is a normal behavior when the BIOS chip is faulty.

• Re: Satellite P300-156: keyboard freezes touch touchpad - mic is not w

  Hello

  I installed Windows 8 on my satellite P300-156 and now I have a big problem.
  My keyboard crashes when you touch the touch pad. In addition, the microphone does not work when the Windows Device Manager indicates that it is ok.

  There is no windows driver for this laptop 8...

  There are no drivers for the laptop because it isn't win 8 supported series.
  But even if there is no Win 8 drivers, the system should not freeze affecting the touchpad module.

  However, the Synaptics touchpad driver for Win 7 or 8 to win can be downloaded from Synaptics page.
  Recommend check it out!

• Re: HARD drive need internal and business BT internal module for Satellite P300-156

  where can I buy HDD case internal and internal module for Satellite P300-156 BT?

  Try an authorized Service Center. There is a list on the Toshiba under Support site

• Satellite P300-156 PSPC4E - stay white media LEDs on after power off

  Hello

  I have a Toshiba laptop Satellite P series P300 156 (PSPC4E) which has just developed a problem

  When I turned off the laptop stops normally, start button / stop itself turns off, but the white Media 6 LED to the right of the power button remains constantly. The only way to get these themselves to turn off is to disconnect the battery.

  Can someone please advise

  Thank you very much

  Hello

  I'm don't know if this will help, but try to set the BIOS to the default settings or try to disable the LED lighting in the BIOS settings.

  Play around with these settings.

• Satellite P300-156 - cannot install any OS

  Hello

  I had a P300-156 for a while.
  It was fine until recently, when the DHCP client stopped workin and wouldn't start.

  So I tried to restore from disk and had no dice with that try.
  So I tried to recover from HARD drive again once any chance the laptop keeps freezing after installation.

  So I tried to install Ubuntu on the laptop but still the same problem, said linux 'buffer I/O sdo error "?
  I'm not sure what in other words, it has however managed to wipe the entire drive.

  And I can not install XP because it does not find the HARD drive.

  The situation is so that I don't have any of the recovery methods and that you can not install another OS.

  Guys im really confused on the topic of what to do here, so if anyone can help please I need.

  Hi James

  I'm not sure if your HARD drive is dead or not, but you should know that your installation of Win XP does not recognize the HDD too if the SATA driver has not been included.
  The fact is that your P300 was equipped with the SATA HDD controller and the SATA driver is needed and if you want to install an operating system.

  The SATA driver is part of the Intel Matrix Storage Manager.
  So if you want to install XP on your P300, you must first include the SATA drive in the XP installation CD.
  This can be done very easily using a free software called nLite.

  This Toshiba doc would be helpful for you because if describes step by step how to include a driver SATA;

  Check this box:
  [How to integrate a SATA AHCI driver into a Windows XP installation CD | http://aps2.toshiba-tro.de/kb0/TSB85017Z0000R01.htm]

  Good bye

• Satellite P300-156 - driver detected on \Device\Ide\IdePort1 controller error

  Hello

  I have recently installed a secondary hard drive in my P300-156 and am having some problems with it. I get 11 event IDS in the event log system "the driver detected a controller on \Device\Ide\IdePort1. error" and suffer with very poor performance with this player.

  The drive is new and works fine in other systems and even works ok if I swap bays my P300-156, but the problem with this is that the drive does not fit in the other Bay, as it is quite thick. The player in question is a Samsung HM100UI 1 TB 2.5 "Sata. I also tried other readers in this Bay, and they work well too.

  I am using windows 7 ultimate and the Intel chipset drivers. It's an Intel ICH8M SATA AHCI controller, the 7.0.0.1013 driver version. Have tried different drivers and the AHCI/IDE mode. Also tried a new installation and the problem persists.

  Am at a loss why this disc problems is there anything else someone can suggest to try?

  Thanks in advance.

  > I also tried other readers in this Bay, and they work well too.

  This means that you had problems with the other drives in the second span?
  If Yes, then I guess some problem of compatibility between the P300 and the HARD drive

• Satellite P300-156: CD/DVD player has stopped working

  Hi people,

  I have a P300-156 and since I bought it, I had a problem with the DVD recorder... ok I know I should take that back!

  Sometimes when I press the eject button, that nothing is happening outside the orange light flashes and continues to blink. When this happens that I lose the drive in my computer and the only way to make it work again is to restart the laptop.

  Usually, it works when I reboot then stops working, but it doesn't also sometimes from the restart.

  Someone at - it ideas.

  Thank you

  Dan

  Hello!

  Have you looked on the Toshiba site for an update of the firmware? Search on the Toshiba site for an update, maybe this will solve your problem.
  http://EU.computers.Toshiba-Europe.com-online decision-making supported Downloads & => Download drivers

  However, I think it could also be a hardware problem that your drive is defective. Then I'd go to a local ASP. A technician can check your laptop.

  Good bye

• Satellite P300-133 - problem installing Win Xp

  Hello

  I have a problem installing win xp to Satellite p300-133.
  To resolve this problem, I have tried the solutions:
  switch to ahci mode in bios and incorporating storage drivers compatibility intel to the installation cd xp with nlite, but none of them solved the problem.

  Laptop computer starts from the cd of xp and xp installation says "program Setup inspects your hardware configuration" and then a blank black screen comes.
  After that, the installation does nothing and waits indefinitely.

  Any ideas on this problem? Thank you.

  Hello

  > switch to compatibility ahci mode in the bios and the integration of the storage drivers Intel to xp with nlite installation cd, but none of them solved the problem.

  The two methods are good!
  You can install the Win XP without drivers Intel Storage Manager (SATA drivers) but in this case the SATA mode must be on compatible mode.
  It works for sure!

  The second method is the installation of the SATA drivers with nLite (drivers can be integrated into the new drive Win XP).

  I put t understand why this doesn t work on your laptop. I think it's a problem with your Win XP drive. Contains this Win XP SP2 or SP3?
  If this isn't the case, then you should use nLite to include min the Win XP SP2.

  Check it!

• Satellite p300-212 problems after downgrade to xp (yellow? and!)

  Hello

  I had the same problem as the guy FOM this thread---> [http://forums.computers.toshiba-europe.com/forums/thread.jspa?messageID=174977𪮁 | http://forums.computers.toshiba-europe.com/forums/thread.jspa?messageID=174977𪮁]
  I lowered my Satellite P300-212 from Vista to XP. I used an installation Win XP CD of Win professional XP including Service Pack 3.
  Then I installed all the drivers from the Toshiba site.
  But I still have a yellow! in the Device Manager to the "Audio device on High Definition Bus". The details of this device show "HDAUDIO\FUNC_01 & VEN_1002 & DEV_AA01 & SUBSYS_00AA0100 & REV_1001\5 & 3B6F18F1 & 0 & 0001"
  So I don't know, what driver I need to take to solve this problem. Rather, modemdriver etc are all installed and work fine!
  In the thread I linked above, the guy only has not copied driver WICH he installed manually. :(

  I hope that someone of you can help!

  Best wishes.

  greatwolfman

  Hello

  You should go to remove device manager and scream this device with the yellow! and?
  Restart the unit.

  In addition you must update Win XP for the last State because there are many patches that are required under Win XP latest series laptop.

• WiFi with the Satellite P300-135 problem

  Hello

  Here's my problem:

  I removed VISTA and installed XP on my Satellite P300 - 135 (PSPC4E). After that, I downloaded all the drivers for XP and installed. But the wireless card is not recognised and in Device Manager there are two features of problem:
  -Device on high definition audio bus modem and
  -Network controller.

  I remember well the type of my wireless card and tried first with Realtek, but it did not work. Then I tried with Intel and Atheros drivers, but they do not have too much work.

  I hope someone can help me, because I don't want to go back to VISTA.

  Hello

  According to the specifications of the laptop Satellite P300-135 has Intel 11 a/b/g (13ch) - Golan WLAN card.
  Have you tried installing WXP driver for WIRELESS Intel network card?

• How can I remove optical drive of the Satellite P300-156?

  Hello

  I just ordered a HD-DVD-R (Toshiba SD-L902A) for my P300-156 drive, but I don't see how I can remove my existing laptop DVD - RW drive.

  Does anyone know how this can be done without opening the case?

  Hello

  To remove the CD/DVD drive, first remove the screws of this CURIOUS.
  The screw is hidden under the keyboard.
  Therefore, you will need to remove the keyboard first.
  The keyboard is fixed with 2 screws. These screws are hidden beneath the thin plastic (door-KB)
  First, you must remove this support KB to get access to these two screws.
  After you remove the keyboard, you will find a screw that holds the ODD. Remove it and disconnecting an optical disc drive to the connector on the system board.

  But note; Be careful and all you are doing is at your own risk AND PERIL!