The BIOS update procedure

Similar Questions

• Satellite U400 - doesn't have a Bios update procedure

  Hey guys,.

  I need help!
  I was updating my laptop works Bios and I had the power cord plugged in (no battery, he was at home).
  In any case, we had a power outage in the heart when I was doing the set date.

  Now, when the computer starts all the lights come on and there is no display, then a long beep.

  Can any ideas on how I fix?
  It is still under warenty

  Thank you
  Michael

  Hello

  Unfortunately buddy; There are not a lot to do.
  It seems that the BIOS update procedure has failed because of the failure and the module ROM was flashed properly.
  I hope that the motherboard isn't too bad.

  In your case it s is strongly recommended to contact the local ASP.
  Guys should be able to help you
  I'm not very well if you need a new motherboard or just a new update of the module m ROM
  But the ASP technician needs to know what needs to be done

  Good luck & welcome
  Jaba

• Satellite A100 does not start after the BIOS update

  Hello

  I downloaded the update to the bios toshiba A100 PSAA8 on the toshiba site and applied using the procedure of updating the bios from windows XP MSE. Restart after the start of the update stopped at the toshiba start screen.

  At startup the screen by pressing ESC watch text mode. The message indicated it confirms the update of the bios version. POST messages are:

  _________________________
  Genuine Intel CPU
  No TPM or TPM has problem
  1015 M system RAM passed

  Press to enter in SETUP
  _________________________

  Pressing F2 just clears the last message in line and then no change is found.

  The laptop comes with windows XP media center edition. I don't know why the TPM secure is enabled. It is possible that toshiba is available with the module of TPM enabled in bios updates that logbook. If this is the case, they must clearly identified as 'not applicable' upgrade for machines that are not relevant.

  I found similar messages around the forum without convincing answer.

  Is it possible to fix this without sending? Even if it turns out to be affordable, it make much sense to pay for the problems caused by toshiba.

  Hello

  Please don t blame someone for you mistakes ;)
  As far as I know that only a few sets of laptops come with TPM.
  If you want to do an update of the BIOS on the models at TPM, you will need to contact the ASP!

  Looks like you used a bad BIOS or bad BIOS update procedure.

  The Toshiba page a BISO update the documentation that describes how to upgrade the BIOS on each series laptop!
  You will find on the page of the Toshiba driver compatible BIOS and information over a large number of details!

  > Is it possible to fix this without sending
  Don t think so, and therefore, you will need to contact the Asp help!

  Good luck

• Satellite L300-1 has 3 - after the BIOS update, I get a BSOD

  I have a Satellite L300 1A 3 MODEL PSLB8E. I decided to update the version of the BIOS, thinking that he can resolve my issue of ethernet controller.

  But after the update, my laptop goes on infinite blue screen of death. How can I recover from this injury?

  Can someone please help.

  Hello

  Did you choose the good BIOS update for your model? Was it for Satellite L300 PSLB8E?

  What code you get BSOD?

  After the BIOS update you must always load the default settings. Maybe a bad BIOS setting is causing this BSOD.

• Error message incorrect file size when the BIOS update on Satellite M100

  When you try to install the BIOS update I get the error message: incorrect size of the ROM file. What can I do? Thank you.

  Hello

  Today is your lucky day dude. Seems I found a solution :D
  Pelase take a look at this thread:
  http://forums.computers.Toshiba-Europe.com/forums/thread.jspa?threadID=19974&MessageID=73284

  The user JayJay has provided a link to the Toshiba document that helps to clear this issue.

  It is the original document;
  http://support.toshiba-tro.de/KB0/TSB59014X0000R01.htm

  Please try it and post if it was the key or not. Good luck

• Can't do the BIOS update for Portégé R500 (PPR50E)

  I have a Portege R500 PPR50E with Vista Business pre-installed model. I am wanting to move to Windows 7 and so initially I want to update the BIOS of 1.5 to 1.6. I got the correct file from Toshiba (bios-20080325071859 containing P0058v160.exe), but when I try to run the application, it fails with "this computer is not supported.
  I checked several times that I downloaded the file for the R500.

  Can anyone help?

  Hello

  That s strange.
  Did you change something on you installed Vista?

  In different cases, the BIOS cannot be updated because some essential tools such as the common modules for Win XP has not been installed.
  If you are using vista you don't need common modules but I recommend reinstalling the VAP.
  Then you should try to rerun the update of the BIOS.

  Otherwise use the recovery disk and computer laptop back to factory settings.
  After the laptop has been set to the same State as on the first day of purchase, you can run the BIOS update.

• Satellite L855 does not start after the BIOS update

  I downloaded the BIOS update and followed the instructions there during the installation, but on reboot (including the requested configuration), I get a blank screen. Intermittently, the CPU fan starts and stops. I think that the BIOS update failed, how to solve this problem?

  Thank you
  Neil.

  Hello, Neil

  In General when the BIOS is screwed up you need professional help and you should contact the nearest Toshiba service provider and ask for help.

  See also this thread. Perhaps this methid can help you too.

• Satellite L300D - does not load after the BIOS update

  I had to update my bios & it seems that that wrong has been downloaded about 3% by installing the laptop just die and not to revert to.

  There is no lights & there is no noise from the laptop at all.

  Can any ideas on how I fix?

  The laptop is a Toshiba Satellite L300D

  Hello

  Well, if the BIOS update crashed you can do anything because the ROM module needs to be reflashed. This is possible only with special tools and only an authorized service provider has such tools.

  Then please contact the nearest service Toshiba and ask for help :)

• The BIOS update does not work on the Satellite - cannot load PHLASHNT.sys

  "Cannot load the PHLASHNT.sys driver.
  It gives then a few silly respons to check if you have admin rights or not.
  Under windows, very nice everyone has admin right here, that the problem with this :-/

  Hello Clemens,

  PHLASHNT. SYS is flash Phoenix NT driver that is necessary if you're updating a Phoenix BIOS. However, you don't tell what Satellite phone model you update or what version of the BIOS update you are using (Windows or traditional). Please send additional information so that we can try to help you with your problem.

  Kind regards

• Tecra A11 - 11N - after that the BIOS update programs not loading now

  My model is Tecra A11 - 11N. I ran the BIOS update and now some of my programs, including ITunes, Nokia Ovisuite, payer VLC etc. are not running. I tried to uninstall and reinstall them, but same problems.

  In any case to come back before upgrade?

  Hi evangny,

  I also Tecra A11 in front of me and have installed latest version of BIOS but this didn't affect all installed programs. BIOS and installed programs are different.
  What you can do is load the default settings in the BIOS after the update.

  Can you be a bit more detailed?
  What exactly happens if you try to start these programs? You get an error message?

  You use the version preinstalled Windows from Toshiba?

• After that the BIOS update can not use Debian

  I upgraded to v3.70 Bios and now my Debian has following problem:
  at the start of the adage about stucks kernel:
  PCI: BIOS Bug: f0000000 MCFG area isn't E820 - reserved.

  Did I screw the upgrade (Win startup, run the bios update and follow the instructions)? Or is this normal?
  How can I know Toshiba, they have the bug in the BIOS?

  Stepan

  Hello

  After the BIOS update you can use delivered and supported operating system (recovery image)?

• Satellite A500-138 60 fps instead of 99 fps after the BIOS update.

  Hello!

  Before I have a little problem with my fan, but I do it with the BIOS update. His work!

  Now, I have a little problem of different...
  I am a player of counter-strike and before the BIOS update I have 99.9 FPS now, I have about 60... Who is wrong?

  Its make me crazy...

  Hello

  Seems the CPU and GPU don t run full implementation after the BIOS update.
  Any performance CPU/GPU leads to lower the heat dissipation and this means that the cooling module does not need to execute quickly and very often.

  Check to see if you can change an option is the BIOS.
  You can also try to update a graphics driver and could control Windows 7 power management.
  Power management settings 7 victory could affect CPU and GPU performance to save battery power and reduce the heat dissipation.

• Satellite A500 - it gets stuck one second after the BIOS update

  I knew I shouldn't update BIOS unless I have problems. A message came Toshiba Bulletin Board and I was stupid enough to trust him and I have updated my BIOS. The update has been successful, my computer seems to work very well.

  Except, now when I try to watch a movie, I downloaded every 10 seconds or if it gets stuck for a second and then plays normally and it happens when I play music on itunes. Because I didn't have this problem before, I'm not accusing the update. Is there a way I can go back or how can I return to normal?

  Oh God, what have I done? :(

  You can try to update a sound/display drivers on the [page driver Toshiba | http://eu.computers.toshiba-europe.com/innovation/download_drivers_bios.jsp] Bios update should not cause a problem like yours, but who knows... (You can also try to load the default settings in the Bios)
  Updated version of itunes and try how movies on VLC and Kmplayer

• Satellite C660 - 1 7 - cannot run the BIOS update

  Hello

  I use my Satellite C660 - 1 7 for a year now, and recently I have a Wi - Fi connection problem with my laptop. I can find the network in my laptop, but it loses the connection permanently. It's a little boring.

  Then I tried to update the BIOS update, but each time, he showed "there is an error occurred, please check below the elements." BIOS version more than 200. battery capacity more than 10%. AC is fixed. "Well, I checked, and it is" TOSHIBA 1.40, 2011/1/21 '. "

  Can someone help me please?

  Thank you

  >... but it loses the connection permanently. It's a little boring.
  Do you have this problem with power supply battery only or is the problem when the laptop is connected to the power supply running too?

• Satellite C660 - where can I get the description of detail on the BIOS update?

  Where can I get the description of detail on new changes to the bios, updated as of 02/14/12, version 1.50 - VICTORY for Satellite C660 PSC1NE?

  Hello

  Unfortunately this information is not available for EMEA laptops. Toshiba WE sometimes I found this info, but for the moment, there is no cell phone similar with this version of the BIOS update.

  Anyway, if all is K with your laptop don't change anything.