Touchpad Iconia W510 turns off when the battery dies

Similar Questions

• Satellite U300 turns off when the battery has been removed

  Hello

  I'm on the laptop with the battery in place, and the power supply plugged in.
  That's when I take off the battery (always plugged power) who, after 5 seconds the laptop powers off.

  It's not happened before and now it happens ALL the time every time I have to remove the battery.
  I noticed that when the battery is removed, the battery light is always on – if for some reason any cell phone still thinks the battery is connected.

  For me, it looks like an electronic power supply problem.

  But it s just my personal opinion

  I think that the laptop should be checked by an authorized technician.

  Contact the ASP in your country and ask for verification

  If the warranty is valid then an everything should be done for free

  Good bye

• When I pick up my Windows 7 Acer Aspire power, the computer turns off when the battery shows fully charged

  I HAVE A CHILD OF 1 YEAR ACER ASPIRE WITH WINDOWS 7, WHICH IS CONNECTED TO BE WIRELESS. BUT WHEN I GET MY COMPUTER TURNS OFF THE POWER SUPPLY CORD. THE BATTERY SAYS FULLY CHARGED. IT WORKED AND NOW IT WONT. SOMEONE CAN ME SAY WHAT THE PROBLEM IS. I EVEN WENT BACK THROUGH HIM WITH DEFAULT AND IT DID NOT HELP.

  Hello

  Are you aware of any changes made to the computer, before the show?

  I suggest to change the power management and check for the issue.

  Change, create, or delete a power plan (scheme)

  http://Windows.Microsoft.com/en-us/Windows7/change-create-or-delete-a-power-plan-scheme

  If the above does not help, I suggest you to contact Acer support for assistance.

  http://support.Acer.com/us/en/default.aspx

  I hope this helps.

• PC HP Envy 15 x 360: my laptop turns off when the battery reaches 10%

  Whenever my laptop reaches 10%, will switch to "standby" and won't do anything until I plug the charger. Is this normal? Is it possible to change this?

  Hello

  Yes, it's quite normal. You can set it to tell you and stop at lower % (or 5%) with power option.

  Kind regards.

• (Redirected) Power adapter green light turns off when the laptop battery is plugged into the laptop and does not load.

  Power adapter green light turns off when the laptop battery is plugged into the laptop and will not charge; If the laptop battery is not plugged into the laptop adapter it's still green and will charge the laptop.

  As you have a laptop, better make this laptop in the computer Forum post here:

  http://en.community.Dell.com/support-forums/laptop/default.aspx

  Tip: when you post a message, preferable to always include the computer model.

  Bev.

• Dv7-3165dx notebook computer unexpectedly shuts off when the battery is low

  Dv7-3165dx notebook computer unexpectedly shuts off when the battery is low. Even at 17%.

  This gets really annoying, that I keep losing jobs! Before it used to give me a warning and then Hibernate. Now there is no warning and it turns off without saving anything.

  Help!

  The laptop is a year old.

  I already ran the diagonsitic battery and it said the battery was good.

  OK, I think I finally figured it by changing power options, and I think that the way you reset the battery also helped.

  Here are the parameters:

  reserve battery level (this is when the popup will appear).

  10%

  low battery (this is when the low battery action will be performed).

  8%

  critical battery level (my computer would die at this point.)

  7%

  low battery action: sleep, sleep (this customize to your liking).

  battery low notification: on (hold on).

  critical battery action: sleep, sleep (my computer died already in criticism.)

• Power problems: computer turns off when the power supply cord is unplugged.

  original title: power problems: computer shit turned off when the power supply cord is unplugged.

  I have a HP Pavilion dv2000

  Windows vista home premium/sp2

  AMD Turion (TM) 64/2 1.80 ghz processor

  1 GB memory

  32 bit operating system

  I have 2 problems with this laptop.

  !. I have lost the power cable and bought an expensive one online step (model: PA-1650-02 c. input 100-240v 1.5 put out a(1,5A) 18.5V 3. 5 = a)

  When I first plugg cord battery charge light came on the balance, then he started to come on and outside.

  now its completely off, even with the power cord plugged in. on the lower right part of the screen its showing that cord is connected to the power supply and the battery is fully charged, but as soon as I unplugg the power cord or remove the computer cut right away.

  the second problem is that the left mouse botton does not work, the work aside right very well. I went in the proprties to put it right, click on to, but who does not work either. I've updated the drivers but still nothing.

  Any help will be greatly appreciated.

  Hi aloum,.

  (a) what kind of mouse you are using?

  (b) the left button of the mouse seems to be stuck or it does not meet the click? This only happens with certain applications?

  Step 1: Test the mouse on another computer or another mouse on the test computer

  To determine whether the mouse or the computer is defective, follow these steps:

  1. test the mouse in question on a system that works, you know. If the problem appears to follow the mouse, you may need to return or replace the mouse.

  2 test a mouse you know is working on the computer in question. If the problem seems to stay on the computer, then the problem is most likely related to the software.

  In regard to the battery not holding charge

  Battery problems are often associated with the battery itself. If you encounter this problem, contact your mobile PC manufacturer. If you purchased the battery separately from the notebook computer, contact the manufacturer of the battery.

  Troubleshooting battery problems

  http://Windows.Microsoft.com/en-us/Windows-Vista/troubleshoot-battery-problems

  Thank you, and in what concerns:

  Ajay K

  Microsoft Answers Support Engineer

  Visit our Microsoft answers feedback Forum and let us know what you think.

• Accelerometer turns off when the screen is off

  When testing my application on a Z10 android port the accelerometer turns off when the screen is off. A partial wake lock does not turn the sensor back on. A wake dim screen lock is needed to re - turn on the detector. This behavior forces the screen to be all the time when an application requires the use of these sensors.

  An example would be a pedometer recording the steps throughout the day. In order to operate the screen must be turned on by the application that runs in the background. This will cause a fast draining of the battery and is not an acceptable solution.

  On Android, a partial wake lock is enough to keep the accelerometer running.

  I think this should be reported as a deficiency, a lot of motion carried since Android applications will be blocked by this and my app port is one of them.

  Tested on system Z10, model number STL100-3. Version of the 10.1.0.273 software

  The fix will appear in MR 10.2, 10.2.1 aka.

  I recently submitted a fix for the problem.

• The screen of my laptop turns off when the power cable is connected. If this isn't the case, connected screen is ok. No idea why?

  The screen of my laptop turns off when the power cable is connected. If this isn't the case, connected screen is ok. No idea why?

  Original title: clear the display

  Click Start or press the Windows key and type power can locate the power to change recording settings in the section of the Control Panel from the list above and click on it. At the opening of the Power Options pane, click choose when turn off display available on the left side.

  

  Choose a new setting for brightness in the drop down menu on the battery . Look at all the other parameters that you feel you want to modify, and then click save changes in the lower right to apply the options you have selected energy saving.

  You can now close the Power Options pane when you return.

• printer do not wake off mode 'sleep' and does not turn off when the Start button / stop pressed or pushed.

  HP printer all-in-one B210a win 7 64 bit.

  no error message just don't wake up from power saving mode and does not turn off when the power button is pressed. must be disconnected and then turned back on. works fine until the power saving mode he did go to sleep then not answer the test print command or Toolbox controls.  power saving mode is turned off, but still goes to sleep.

  First, you will need to make sure that the printer is under warranty.  You can do it here.  So, if you are in warranty, you must contact HP at 1-800-474-6836 and the United States in computer science, international users click here.

• Two questions. (1) RIP in media player 11 problems. (2) portable speakers do not turn off when the headset is plugged...

  Hey all. I desperately need help. I have a laptop "Durabook" with Windows XP meidand service pack 3 update.  The internal speakers have never turned off when I plug a headset or headphone cable of the adapter into the outlet. It is an option that I have figured out. All my other laptops have silenced the computer speakers when headphones are connected.

  The most frustrating problem I have is in Media Player when you use the tab OUT, when I insert a cd Ripper in the computer, it is not recognized.  If I close and reopen WMP (Windows Media Player) cd, the cover and all the info of the cd is here and ready to be torn APART. Once the cd ends and ejects I insert another cd and nothing happens. Once again, I've closed and reopened WMP and evrything is ready to be torn APART again.

  Please please help.  I can't be the only one who had this problem.  I removed all anti-virus programs, removed and reinstalled WMP, twice.

  I'd appreciate any help.

  Thank you all

  Carl aka theSTUNG1

  Hi Carl,

  1. don't you make changes before the show?

  Try these steps and check the result.
  Step 1: Check if a parameter to extract music select "Always".
  a. open Windows Media Player 11.
  b. click Extract, click more options.
  c. click the rip music and make sure 'Always' is selection in accordance with article "Rip CD when inserted.
  d. click ok to apply the changes and restart the media player.
  e. check if the problem persists.

  See songs Rip (copy) from a CD to your computer

  Step 2: Make sure the headset is plugged into the socket on the right
  a. connect the headphones to the right sleeve and check the result.
  b. you can also right click on the volume icon and adjust the sound settings.

  See adjust the Volume of the computer

  Visit our Microsoft answers feedback Forum and let us know what you think.

• Turns off when low battery on Presario CQ56 Notebook

  I have Windows 7.  The low battery alarm notification / is not coming on the screen or the sounding (and I checked several times now to check that she is not disabled).  The laptop is simply making a hard closed down just below 7% of the battery instead of hibernation.  Now my battery drains too much faster than before.  I'm not sure if it's as a result of this, because I'm now connect earlier (when I take it is low), or completely different.

  I use Mozilla Firefox (version 12.0) for the web and initially thought it was just a bug in Firefox.  Then it started happening when I was not using the Internet.  I upgraded to Win7 as it started, and he has not made a difference.

  I ran several error checking, virus and malware scans... and all is well.

  Any help would be appreciated!

  Run a check of the battery for HP Support Assistant--> troubleshooting--> power, thermal and mechanical--> Power

  

  Then, run the battery calibration. Which will define the indication 100% to the real and full battery capacity.

  Go to power management and the value that the operating system should do when the battery is approaching a level determined by yourself.  Watch the video on this Microsoft web pagethat explains how this is possible.

• The screen of my laptop turns off when my battery is low. Can I turn this off?

  I have the HP Pavilion n018sa 15. When my becomes low power (10%), the screen shuts off and I have to press the power button until it restarts. Is there a way I can stop my screen turn off without having to plug?

  Hello

  Thanks for posting in the HP Support forum.

  I think that your computer is in hibernation or standby is (or tries), but you see it as screen go off.

  He must manage the bass and critical low levels of power - information management:

  http://Windows.Microsoft.com/en-SG/Windows-Vista/choose-low-and-critical-power-levels-for-your-battery

  You can also stop the computer to go to sleep/hibernate:

  http://Windows.Microsoft.com/en-us/Windows7/sleep-and-hibernation-frequently-asked-questions

  (How can I prevent my computer from automatically sleep or standby extended?)

• Want x 360 15-u111dx: Touchpad turns off when the laptop is on the side

  Hello

  I'm the kind of person who tends to use my laptop on the side while lying on my side. Have a 2-in-1 laptop makes things difficult when I stay in portable mode, but I put the laptop on the side. He starts from the principle I want to use it as a Tablet while it is still in laptop mode. The screen starts automatic rotation and the touchpad deactivates accordingly.

  Fortunately, I know how to disable the auto-rotation when this happens, but I don't know how to re-enable the touchpad when the laptop is on the side. Help!

  Hi there @lisanvo,

  I looked into the different ways that you can use your laptop to see if the function to the HP ENVY x 360 on its side in laptop Mode was possible. I found a paper called HP ENVY x 360 Convertible PC - Maintenance and Service of Guide.

  If you look under external component identification on page 7, , you will see that it gives you three modes that allows this particular model.

  I also found that the tilt sensors and the dock will not to allow you to use that phone in particular in the service that you want to because it's a model that allows you to have capabilities of the tablet.

  I want to thank you for visiting the Forums from HP Support.

  Have a great day!

• 9.3.4's 6 iOS iPhone Wifi turns off when the phone is locked. How to solve this?

  Hey! I have a 6 - iOS 9.3.4 - 16 GB iPhone. My phone WiFi turns off eventually when I lock it... The problem is that I get no notification because of this problem. I'm too lazy to try troubleshooting for this problem, just read a lot of advice, but it had a bad feedback. How would I fix this? Thank you.

  It is not a problem. This is a design feature which is present in all iPhones and all versions of iOS for 9 years. WiFi turns off 30 seconds after the phone goes to sleep to save battery life. If you want to keep it you must connect the phone to the power.