Upgrade memory smooth for the T series relic

Similar Questions

• Memory required for the upgrade of IDS Sensor 4.1 (5) to 5.0 (IPS)

  pls tell me the desired memory minimum for the sensor IDS version 4.1 upgrade (5) to version 5.0 (IPS)

  Detectors of the series 4200 ID must be at least 512 MB for this upgrade to 5.0.

  Read the release notes for more information:

  http://www.Cisco.com/en/us/products/HW/vpndevc/PS4077/prod_release_note09186a008045ab52.html

  I hope this helps. all the best... the rate of responses if deemed useful...

  Concerning

  REDA

• I plan to upgrade my OS to El Capitan.  What are the processor speed and memory required for the operating system works well?

  I plan to upgrade my OS to El Capitan.  What are the processor speed and memory required for the operating system works well?

  I use a processor 2.3 GHz Intel Core i5 with DDR3 4 GB 1333 MHz memory.

  My last similar attempt on another machine resulted in a very slow computer.

  Thanks, Ron

  Apple says the following:

  General requirements

  • OS X 10.6.8 or later version
  • 2 GB memory
  • 8.8 GB of available storage

  For best performance, I would say not less 4 GB and preferably 8 GB or more.

  Your i5 is well able to support properly.

  http://www.Apple.com/OSX/how-to-upgrade/#Hardware Configuration

• The amount of space (memory) required for the good functioning of Firefox?

  The amount of memory required for the operation of Firefox? Trying to decide between IE and Firefox. Research in the new computer and need to think about which browser to use, and how much space it needs to work properly.

  You need no more than 40 MB for the operation of Firefox.

• What stick memory type for the CP1525nw

  I have a CP1525nw and you want to install the upgrade memory.  I've been through many documentation page but can not find anywhere what kind of SO-DIMM 256 (DDR1 DDR2 and how fast.).  Thanks in advance, youth

  Hello youth,

  The memory of the printer for this printer is HP 256 MB DDR2 144-pin DIMM CB423A. See the link below for the memory of the printer.

  Series of HP LaserJet Pro CP1525 Color printer - accessories, supplies & services

• a question about upgrading memory CF for Cisco 3745

  As we know, the cisco 3745 has 2 locations CF. memory One is internal with a 32 MB of memory by default CF card, another one is external.

  My question is:

  1 is the same as the internal memory card CF CF external memory card?

  2. If I choose the upgrade of the plant CF memory from 32 MB to 128 MB, which slot will be used? Cisco remove the memory of 32MB CF card and install a new 128 MB card in the internal slot or simply add an additional CF memory card through the outside slot?

  Thank you!

  Hello

  the reference for the internal and external numbers are different, which suggests that they are not compatible. So you will have to specify what you want to, for example, MEM3725-32U128CF (which is the internal upgrade) or MEM3725-128CF-EXT (which is the external upgrade).

  In all cases, internal and external cards are not cumulative, in order to get e.g. 128 MB flash, you must either internal, or external card with these 128 MB:

  Q. can partition you the internal Cisco 3700 Series Compact Flash card and the card Compact Flash external to combine or separate them?

  A. No, you cannot join two separate Compact Flash cards or you can their partition.

  HTH,

  GP

• Tecra M4 includes memory shared for the GPU

  Hello

  I saw a great offer for Tecra M4 tablets. The only thing is that the GPU has only 64 MB of RAM. But I don't want to run the Advanced (or premium) version of Vista, including Aero.

  So, my question is, the series M4 includes memory shared to the GPU? If this is the case, then I can increaes the RAM from 512 MB base at least a 1 GB and the GPU can use part of it and therefore to run Aero.

  Also, I suspect that the versions of M4 offer have sub-6600 NVIDIA GPU, they would still allow use of Aero, assuming that the shared memory is possible?

  Thank you

  Hello

  AFAIK the graphics cards on computers notebooks Tecra M4 is not shared memory and you can't change the video RAM.

• Restriction of firmware for the HX Series

  Hello

  HX Series release notes describe the latest version of the firmware shipping below.

  https://download.Lenovo.com/servers_pdf/lenovo_converged_hx_series_release_notes.PDF

  Available hardware implement uEFI 1.1 (TCE106KUS) and 1.72 IMM2 (TCOO10H).

  Can update us the firmware to the latest version? or do we have no restrictions to HX Series? (lik stay level firmware to AVS/Foundation combination)?

  May 2016, uEFI last 2.01 (TCE122W) and 2.50 IMM2 (TCOO16P) are released.

  Release notes, "you must pass the Nutanix OUR version 4.5.2.3 or later in order to enjoy some patches critics." are described. If we ugrade latest uEFI/IMM2, do we need to update OUR Nutanix first, then updated the firmware?

  Because the previous note of support (to Fib 2016) had a similar description, but OUR Nutanix version isn't 4.5.2.3 4.5.2. So I want to know any restrictions (or relationship) for the system and update of uEFI/IMM2 firmware.

  Thank you.

  Hi, Mike.

  Thank you youre replay and ok I understand.

  We should update OUR 4.5.2 or later to the beginning and after that, we are able to update version uEFI/IMM2 version shipping factory at latest. There is no dependency on a specific version of OUR.

• Change the memory allocated for the graphics?

  Hi, I have an Equium A60-181 with graphics ATi Mobility Radeon 7000. For the moment, that this GPU is using 64 MB of my system RAM that result with only 448 MB of RAM (512-64) for Windows. For a video resolution of 1024 x 768 32 bit it's a ridiculous amount of memory since it only really requires 4 MB for this. I'm not interested in games or 3d graphics, so my question is if I can change the memory allocated to recover more memory system?

  see you soon,

  Richard S.

  HI Richard,

  ATi drivers include an improved graphics option devices-> display manager that allows the value of the AMU to change. My SA30 supports load 16 MB, 32 MB, 64 MB and 128 MB.

  The same value UMA adjustable in BIOS Setup Panel.

  HTH

• Should I buy the hard drive removable 750Go for the Y500 series laptop?

  I know that it includes a hard disk of 1 TB inside the laptop

  but you think that it is necessary to buy a?

  OK the y500 series have the Bay ltration that allow to use the removable hard disk, graphics etc.
  I mean that play games (not many) games maybe 2 or 3
  Record a movie in the drive about 250 to 270 GB
  Don't forget the y500 I already have 1 to inside
  The removable hard drive was a 720 GB external drive which can use for ultra Bay

• Upgrade memory to jeopardize the warranty?

  So I can improve memory up to 16 GB, without compromising the warranty?

  And also, is it a permit to install another OS instead of Windows, pre-installed on my laptop?

  Thanks in advance

  Hello:

  You does not cancel the guarantee of installation of memory unless you phyically break something in the process or do not follow the safety instructions before you open the laptop, like removing the battery and the power of a/c.

  HP provides no warranty for the memory that you buy. You would have to live with the warranty offered by the manufacturer of memory.

  You can install any operating system you want on the PC, but HP won't provide any software support for any operating system other than the one that came with the PC.

  I highly recommend you make a set of recovery disks before replacing the operating system.

  Paul

• I reinstalled Windows 7, but the product key is not accepted. Message says that the product key is upgraded only, not for the new installation. What should I do now?

  I have re installed windows7 and product activation key is not accepted. Message says key is valid only for the upgrade. What should I do now?

  Skip entering your product key Windows 7 and complete the installation.

  When you reach the desktop, click Start, right-click on computer

  Click on properties

  Scroll down to the Windows Activation

  Click the link x days before activation.

  Click on the link that says: "show me other ways to activate.

  Enter the product key

  Click next

  Select the Activation of the phone

  Click Next when you enter your key page

  Select your country

  Click Next, call the number listed

  Be sure to explain your situation to the Appeals Officer.

  Provide the installation generated when ID requested by the call agent

  They give a confirmation ID in return, enter it

  Click next to complete the activation.

  However, the requirements for the media upgrade is that you have an operating system already eligible such as Windows XP or Vista installed to use it. Since the Windows 7 end user license agreement.

  15 UPDATES. To use upgrade software, you must first be licensed for the software that is eligible for the upgrade. After the upgrade, this agreement takes the place of the agreement for the software that you upgraded. After upgrade, you can no longer use the software that you upgraded.

  So, if you are always denied, you will just have to reinstall Windows XP or Vista and let it do the verification of eligibility.

  OR

  How to activate Windows 7 manually (activate by phone)
   
  1) click Start and in the search for box type: slui.exe 4
   
  (2) press the ENTER"" key.
   
  (3) select your "country" in the list.
   
  (4) choose the option "activate phone".
   
  (5) stay on the phone (do not select/press all options) and wait for a person to help you with the activation.
   
  (6) explain your problem clearly to the support person.
   
  http://support.Microsoft.com/kb/950929/en-us

• How to install the memory available for the video and why my computer say I have only 2 GB of memory usable on 4 GB

  Windows says experince installed memory usable GB 2.0 GB of video memory available 1296 4.o 0. How can I fix it? Also, so that you know the hard drive is clean only win.7 of 64-bit operating system and programs plant that was installed by acer. It's a s - 3 acer ultrabook. So my main question would be what uses that amount of memory and what can do to free up? And why the video always says it has more than one GB of available memory, but 0 is installed?

  Have you read this magazine for the laptop?
  http://www.notebookcheck.NET/review-Acer-Aspire-S3-391-53314G52add-Ultrabook.81619.0.html

  And this one for the Intel HD4000.
  http://www.notebookcheck.NET/Intel-HD-graphics-4000-benchmarked.73567.0.html

  The intel HD4000 is pretty good, perhaps the best card onboard graphics (not sure
  AMD integrated graphics last how compare), but this is not always suitable to the
  Games of high specification, except on low heat.
  There may be problems with some older games as well because sometimes they do not recognize the
  as a viable option, integrated graphics or because there is no dedicated VRAM.

  You must update all the drivers on the ACER site.
  I don't know what you need from AMD drivers for. There should be nothing AMD on your machine.
  .

• CDP support in TC4.2.0 for the C Series codecs

  Hello.

  I saw in an administrator's guide (TC4.0) EX TC4.2 was to support the CDP.

  I don't see anything in the software and I was wondering if anyone knew if or when CDP support would be available.

  We run Auto SmartPorts on 3750 X stacks for the codecs in the series C with active DHCP, but the macros seem to cause high CPU utilization on batteries with more than 6 switches.

  CDP would be a nice alternative.

  Does anyone have news?

  See you soon

  David

  CDP is available in TE4 and is planned for TC5.

  PS: The TC5 is coming soon.

  Concerning

• How to set the SGA / PGA or memory target for the database

  Hello

  We use on AIX 5.1,6.1, oracle 9i, 10g, 11g

  Currently, we manage the databases on the default memory which was chosen at the time of the creation of the databases.

  Now the application owner want to host multiple databases on the same server, so they ask the

  rough idea on the memory required for each database,

  How we calculate the amount of memory required for each database.

  Thank you

  that recommend the SGA ADVISOR?