Want to m6 will not connect to sony tv
After that connection my Sony TV to my laptop via a HMDI cable goes to the HMDI TV set screen, by pressing F4 on my laptop and clicking on double screen, nothing happens on TV, except that he asks me "allow" my device.
My cell phone has detected the TV via the Wi - FI, put a shortcut on my desktop, but nothing happens when it is clicked to be
What is your product number and the operating system?
My laptop Sony VAIO with Vista will not connect and stay connected to my wireless internet. All other laptops in the House are perfectly. Internet disconnects, says local only, then reconnects constantly making internet hard work.
- When is this last work fine?
- Do you receive an error message or error codes?
- Recent changes on the computer?
There could be several causes for this problem.
Try starting with these methods.
- Open Network Diagnostics by right-clicking the network icon in the notification area, and then click diagnose and repair.
- Make sure that all cables are connected (for example, make sure that your modem is connected to a working jack or cable phone connection, either directly or through a router).
- Reset your modem and router. Remove the power cord from the modem or router, wait at least 10 seconds, then plug in the modem and/or router back.
Another reason may be windows disable your network adapter to save power. Turn off the power saving option in the properties of the network (wired network only cards) card:
- Open network connections by clicking the Start button, clicking Control Panel, clicking network and Internet, click network and sharing Center, and then clicking manage network connections.
- Right-click on the connection and then click Properties. If you are prompted for an administrator password or a confirmation, type the password or provide confirmation.
- On the Networking tab, click Configure.
- On the power management tab, clear the allow the computer to turn off this device to save power option, and then click OK.
Temporarily disable the firewall, and check the status.
NOTE: To re-enable the firewall after check you the status. If you are connected to the Internet or a network during the time that your /firewall antivirus software is disabled, your computer is vulnerable to attacks.
Hope that was heloful.
Bindu S - Microsoft Support
Visit our Microsoft answers feedback Forum and let us know what you think
My iPod Touch will not connect to iTunes. When I connect it to my laptop with the cable my laptop USB recognizes the iPod begins to charge and 10 Windows asks me if I want to open it to view files, but it seems to treat it as a camera and I just want to know if I want to get pictures on it and on the laptop.
I made sure I have the latest software updates on the iPod and iTunes and thought this would fix the problem, but iTunes still does not recognize my iPod because it never appears on the Panel for me to sync things for her, etc.
How can I get my iPod to be recognized by iTunes again? Very recently, it stopped connecting.
If your computer does not recognize your iOS device, follow the steps proposed by Apple.
I just bought a satellite C850 - PSKCCA-02D00M
The connection to the LAN works fine however the Realtek RTL8723AE without wireless/Bluetooth will not connect to the network. It can can detect them just does not connect. I used the troubleshooting, and he cannot sort.
All other devices connect very well as Iphones and Kindle
In the config is doctor says that the adapter is enabled in a domain and in the adapter another status is down.
I took back to the initial power and installing and unistalling and reinstalling the adapter using the driver on the website.
Any help is welcome. I don't want to have to take back just for this issue
See you soon
Your WLAN is locked? Can you connect WIFI if you delete the WIFI password for two minutes?
Have you tried to reboot your router?
my new hp laptop windows 8 will not connect to my wireless internet. It will be after I restart, but after a few minutes, it goes with limited access. How can I fix?
We will try to remove your Wi - Fi card and let Windows to install it again. This will reset any options or configuration errors that may have been applied.
Press and hold the Windows key and press W.
In the search bar, type "Device Manager" (without the quotes) and press ENTER.
Once inside the Device Manager, please find and unfold the group named "network adapters".
From there, to identify your wireless card (it will very probably include the word "wireless" or "802.11".
Now, right click on the wireless network device and click "Uninstall".
If you're facing a check box asking if you want to remove the driver as well, please let it be empty.
After the device has been uninstalled, restart your device and try to connect to the wireless again.
I would like to know how that works for you.
My Sony DSC - S85 will not connect to windows 7. He said no driver is available I can't believe what is happening simply because do upgrades of windows I yo buy all new appliances and video equipment.
You're right - the site of Sony says that your camera is not supported under Windows 32 or 64-Bit 7. However there is a simple solution - take the memory stick in and out of the camera and a card reader allows you to transfer your photos to your PC.
If your PC does not have a card reader, you can buy USB very cheap ones. Just make sure it's one that can read the memory stick into your camera.
My new phone will not connect to iTunes on my computer windows laptop. It is said that it requires a newer version of iTunes but the latest version is all ready to date
Is your "new version" iTunes 184.108.40.206? If this is not the case, your 'windows' laptop running Windows XP or Vista?
How is it that my iPod Shuffle will not connect to my radio?
Don't understand the question... How you expect an iPod shuffle to connect to a radio?
Recently I replaced my router wireless with an old faithful that d-Link DSL - 502T cable modem as I have now 2 extreme airport to handle a Wi - Fi. I have now a much faster internet access on my Macbook Pro, but my iPad 2 now will not connect to internet.
Airport utility on the iPad shows that the internet is disconnected, but I don't know how to solve this problem.
The two airports are configured in Bridge mode. Help someone?
If you have LAN - 502T running as the main router.
Bridge the airport should simply pass the DHCP via the Dlink but sometimes it's a failure.
The two AE connected directly to the modem or the other?
I would recommend the static method of intellectual property.
In this method, you must first AE plugged directly to the Dlink and the second AE connected in the first and bridge... it will dhcp to EI and is often a better configuration with Apple gear. Worth a try.
HP lj1022 printer will not connect not not via the USB port after the installation of the new driver upgrade hp lj1020/1022 for Windows 7 (64-bit). Driver seems to install properly until the moment where he is asked to connect the USB cable. Then he hangs up. HP lj 1020 printer appears in the display to the dashboard as the default printer. Computer recognizes the printer as hp printer lj1022 but in another "device not specified Panel when and only when the printer is on and the USB cable is connected." When printing, nothing ever comes from queue.
Diagnosis is only that something is stuck in the queue and remove the task from the queue, but does not. Diagnostic shows no problem.
The lj1022 printer accepts data from two other computers, as well on Windows xP and using the same cables. Three other USB ports have been tested on the new Windows 7 computer without results. The USB ports on the Windows 7 computer accept keyboards, mouse and flash memories wireless dongle without problem. The Windows 7 computer also sends data to a printer wireless with no problems.
Run the following utility below.
I got this HP printer for a while and it worked fine. Our old router is out and we had to get a new one. Installed perfectly and printer continued to work properly. The password for the router was ridiculous, that's why I changed it to something much more simple to remember. Since then, my printer will not connect to wireless internet. I have a ~ and reinstalled the printer but still have the same problem. I thought maybe to try the former password would, but who does not work either.
Anyone has any ideas that might help before chuck it and go and get a new one altogether?
Easy things first. Turn off the router and the printer. Turn on the router and wait 3 minutes. Turn on the printer and see if it connects to your router. Status?
If no joy, temporarily disable all security in the router. Now try to connect the printer to your SSID not guaranteed without password. Status now?
If OK, go back and add WPA2-AES with your simple password. Status now?
My Ipad mini will not connect with my wifi at home. Other devices are able to connect with wifi. I repeatedly entered the wifi password, but this is not ACCEP it. Worked very well. I turned the mini ipad market and nothing. Help!
My Ipad mini will not connect with my wifi at home. Other devices are connecting with the wifi at home. I turned the mini ipad market a few times and nothing. He recognizes wifi but when I touch the password, it continues to request the password. Help! It was working fine earlier in the day.
What has happened with your iPad since earlier today, when it worked? updated App or iOS? nothing at all
Hi, new here.
I have a Toshiba L850 which does not connect to wifi,
Many other devices in the House and the L850 was last week.
You can see my router but will not connect.
It is the 'limited access' connection, but not more.
Said troubleshooting couldn't identify the problem.
When I try and access the Device Manager, I get a "Explorer.EXE" the specified service does not exist as an installed service?
> He sees my router but will not connect.
I guess that your router is secured by encryption (WEP or WPA / WPA2)
Test WiFi connection without the use of WLan encryption settings.
Turn off in the router settings and test the connectivity.
Of course you need to do that just for test purposes because it s not advised to use the unsecured WiFi.
Where you have no problem to connect the laptop to 'open' WLan, I recommend changing the encryption type.
My iPod touch will not connect to WiFi and I followed the steps posted. Also, when he dies he thinks that it is December 31, 1969. What can I do to fix this?
Not knowing what the 'followed the steps posted' have been
The iOS device connects to other networks? If Yes, which tends to indicate a problem with your network.
The iOS device sees the network?
Other devices connect now?
The iOS device has connected before?
Try the following to rule out a software problem:
-Reset the device iOS. Nothing will be lost
Device iOS Reset: Hold down the On / Off button and the Home button at the same time for to
ten seconds, until the Apple logo appears.
-Power off, then back on your router
. - Reset network settings: settings > general > reset > reset network settings
-Restore from backup. See:
-Restore factory settings/new iOS device.
If still problem and it does not connect to any networks make an appointment at an Apple store Genius Bar because it appears that you have a hardware problem.
My Satellite C850 found network 2.4 GHz Wireless and connected flawlessly. However, it is not 'see' the 5 GHz network, even if the router is in the same room and about 2 meters from the hotel. I have a problem, or in this laptop's wireless adapter will not connect to this speed? Any help appreciated, please
I think that the reason why your portable computer does not see the 5 GHz Wlan is simply.
The wireless network card does not seem to bear the 5 GHz.
The WLAN standard 802. 11A supports 5 GHz
If the wireless network adapter supports 802.11 B / G and N or 802.11 G and N, then only 2.4 Ghz are supported.
Maybe you are looking for
I got a bad virus that took on my computer saying that the hard drive was bad. I return my computer finally after downloading avast and Windows security. The only problem is my program in the start menu list is empty (with the exception of Avast and
I would like to know the rules for a program to display in the pane of the Add/Remove program? My understanding is that the software must exist in the registry key "HKEY_LOCAL_MACHINE\SOFTWARE\Microsoft\Windows\CurrentVersion\Uninstall" and it must c
Hello! The print cartridge is flashing on my 940 c and so the printer does not print. I installed new color and black cartridges for only this problem - no solution. I pulled out, put them back and waved them, open the cover, closed the lid... all
I bought the Style cache for my Z3 Compact. Widget Style of coverage has been installed automatically once the phone has been "twinned" with the lid using the NFC. In some situations, I do not use cache-Style and strange things begin to happens - I l
I downloaded the usb tool but it does not recognize the external hard drive that I plugged in usb. I know the drive works as I transferred my files from document ok. any suggestions